• 설비공학논문집
• /
• 제12권7호
• /
• pp.649-658
• /
• 2000

Thermodynamic modeling of low-pressure scroll compressor was developed by combining continuity and energy conservation equation. Suction gas heating was considered using energy balance inside the low pressure shell. Pressure, temperature and mass of refrigerant-22 as a function of orbiting angle were calculated by solving the governing equations using fourth order Rung-Kutta scheme. Motor efficiency was taken by experiments with a variation of frequency. The developed model was applied to the analysis of an inverter driven scroll compressor with a variation of frequency, pressure ratio and operating conditions. The model was verified with the experimental results at the same operating conditions. The developed model was adequate to predict performance of the inverter driven scroll compressor as a function of operating conditions. Calculated parameters from the model were discharge temperature, mass flow rate, power input, COP, and thermodynamic properties with respect to orbiting angle. To enhance the performance of a scroll compressor, it is essential to diminish leakage at low frequency level and improve the mechanical efficiency at high frequency level.

• 대한기계학회논문집B
• /
• 제29권7호
• /
• pp.846-853
• /
• 2005

In this paper, mass transfer in turbulent flow around a rotating circular cylinder is investigated by Direct Numerical Simulation for Schmidt numbers Sc=1 and 1670. Correlation between Sherwood and Reynolds number predicted agrees well with other experimental results over both Sc. Reynolds analogy identified at Sc=1 definitely causes a strong correlation between concentration fluctuation and streamwise velocity. For Sc=1670, it is found that positive small values of concentration fluctuations are observed more frequently than the case of Sc=1 particularly out of the range of Nernst diffusion layer in the viscous sub-layer. This fact is fully confirmed by detailed statistical study using a probability density function of concentration fluctuations.

• 대한기계학회논문집A
• /
• 제24권7호
• /
• pp.1847-1853
• /
• 2000

A computer simulation technique for 2-dimensional laser generated ultrasonic waves was developed for visualization and investigation of ultrasonic propagation in solids. The technique is similar to a finite difference method (FDM) and a mass-particle model method, but uses a new nodal calculation method based on fundamental consideration of an elastic wave equation. By this method, the propagation behavior oflaser generated ultrasonic wave in thermoelastic and ablation mode is visualized and shows good agreement with previous experimental result or the numerical analysis result by Green function.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 추계학술대회논문집
• /
• pp.72-77
• /
• 2003

In this paper, an experimental verification of system identification technique for constructing finite element model is conducted for a three-story test structure equipped with an active mass driver (AMD). Twenty Gaussian white noises were used as the input for AMD, and the corresponding accelerations of each floors are measured. Then, the complex frequency response function (FRF) for the input, the force induced by the AMD, was obtained and subsequently, the Markov parameters and system matrices were estimated. The magnitudes as well as phase of experimentally obtained FRFs match well with those of analytically obtained FRFs.

• 대한후두음성언어의학회지
• /
• 제8권2호
• /
• pp.225-231
• /
• 1997

The persistent and recurrent dysphonia after microlaryngeal surgery was noted in tweleve patients. We reviewed the results of laryngostroboscopy, psychoacoustic evaluation, aerodynamic study and acoustic analysis according to the treatment modality. The causes of persistent dysphonia were attributed to vocal cord scarring, recurrent mass lesion, residual mass lesion, persistent inflammation, and hyperfunctional voice disorder. We noticed the better vocal function in the group treated with voice therapy or surgical therapy than the group treated with voice rest and medication. Therefore, we concluded that vocal function can be improved with the use of active, multidisciplinary approach which includes voice therapy, medical treatment and selected surgical resection according to the laryngeal lesions.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 추계학술대회 논문집 Vol.17
• /
• pp.187-190
• /
• 2004

In this study, PST thin films were etched with inductively coupled $Cl_2/(Cl_2+Ar)$ plasmas. The etch characteristics of PST thin films as a function of $Cl_2/(Cl_2+Ar)$ gasmixtures were analyzed by using quadrupole mass spectrometer (QMS). Systematic studies were carried out as a function of the etching parameters, including the RF power and the working pressure. The maximum PST film etch rate is 56.2 nm/min, because a small addition of $Cl_2$ to the $Cl_2/Ar$ mixture increased the chemical effect. It was proposed that sputter etching is the dominant etching mechanism while the contribution of chemical reaction is relatively low due to low volatility of etching products.

• Bulletin of the Korean Chemical Society
• /
• 제16권3호
• /
• pp.238-243
• /
• 1995

A pulsed molecular beam source having short pulse duration (typically 70 ${\mu}s)$ and narrow velocity distribution (${\Delta}$v/v=8% for helium) has been costructed utilizing a commercial fuel injector. Beam characteristics of helium and ammonia seeded in helium expansions are accomplished by the use of an electron impact time-or-flight mass spectrometer. The comparisons between experimental data and theoretical calculations show that the proper beam speed is important to predict the evolution of stream temperature and valve shutter function. The decreasing tendency of pulse duration with increasing cluster size leads to the conclusion that the cluster beam property is described as a function of cluster mass and disinct cluster temperature.

• 한국정밀공학회지
• /
• 제14권10호
• /
• pp.164-169
• /
• 1997

The aim of this paper is to present some results of sensitivity analysis in frequency domain. The sensitivity fonctions in frequency domain is not depend on the external excitation but depend on the frequency of the system's resonance. The sensitivity functions are determined as function of partial derivatives of system transfer functions taken with respect to system design parameters. The logarithmic sensitivity function is the dimensionless sensitivity funciton available, making it useful to compare the influence of various parameters on system variables. Two degree of fredom system is used to illustrate the procedure for sensitivity analysis proposed in this paper.

• 천문학회보
• /
• 제45권1호
• /
• pp.50.3-50.3
• /
• 2020

We present deep UBVIc and Hα photometry for the young open cluster IC 1590 which is at the center of the HII region NGC 281. From Ha index, 39 Hα emission stars and 15 Hα emission candidates are selected. The reddening law toward IC 1590 is slightly abnormal (RV,cl = 3.6 ± 0.2). The distance modulus of IC 1590 obtained from the reddening-free (Q', QVλ) diagrams is 12.4 ± 0.1 mag (d = 3.02 ± 0.14 kpc), which is consistent with distance d = 2.91 ± 0.42 kpc from the parallax of Gaia DR2 catalogue within the error range. We also determined the age and mass function of IC 1590 using the stellar evolution models and PMS evolutionary tracks. The median age of PMS stars is 2.4 ± 2.2 Myr. The initial mass function (IMF) of IC 1590 is the Salpeter-type IMF with a slope of �� = -1.26 ± 0.14 for m > 1 M⊙ stars.

• Steel and Composite Structures
• /
• 제46권1호
• /
• pp.107-114
• /
• 2023

A new intelligent adaptive control scheme was proposed that combines observer disturbance-based adaptive control and fuzzy adaptive control for a composite structure with a mass-adjustable damper. The most important advantage is that the control structures do not need to know the uncertainty limits and the interference effect is eliminated. Three adjustable parameters in LMI are used to control the gain of the 2D fuzzy control. Binary performance indices with weighted matrices are constructed to separately evaluate validation and training performance using the revalidation learning function. Determining the appropriate weight matrix balances control and learning efficiency and prevents large gains in control. It is proved that the stability of the control system can be ensured by a linear matrix theory of equality based on Lyapunov's theory. Simulation results show that the multilevel simulation approach combines accuracy with high computational efficiency. The M-TMD system, by slightly reducing critical joint load amplitudes, can significantly improve the overall response of an uncontrolled structure.