• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2004년도 제22회 춘계학술대회논문집
• /
• pp.703-712
• /
• 2004

A variant of the magnetoplasma jet engine (magjet) is here proposed for airbreathing flight in the hypersonic regime. As shown in Figure 1, the engine consists of two distinct ducts: the high-speed duct, in which power is added electromagnetically to the incoming air by a momentum addition device, and the fuel cell duct in which the flow stagnation temperature is reduced by extracting energy through the use of a magnetoplas-madynamic (MPD) generator. The power generated is then used to accelerate the flow exiting the fuel cells with a fraction bypassed to the high-speed duct. The analysis is performed using a quasi one-dimensional model neglecting the Hall and ion slip effects, and fix-ing the fuel cell efficiency to 0.6. Results obtained show that the specific impulse of the magjet is at least equal to and up to 3 times the one of a turbojet, ram-jet, or scramjet in their respective flight Mach number range. Should the air stagnation temperature in the fuel cell compartment not exceed 5 times the incoming air static temperature, the maximal flight Mach number possible would vary between 6.5 and 15 for a magnitude of the ratio between the Joule heating and the work interaction in the MPD generator varied between 0.25 and 0.01, respectively. Increasing the mass flow rate ratio between the high speed and fuel cell ducts from 0.2 to 20 increases the engine efficiency by as much as 3 times in the lower supersonic range, while resulting in a less than 10% increase for a flight Mach number exceeding 8.

• 한국군사과학기술학회지
• /
• 제17권4호
• /
• pp.463-470
• /
• 2014

Stealth technology of combat aircraft is most significant capability in recent air battlefield. As the detector of IR missiles is being developed, IR stealth capability which is evaluated by IR signature level become more important than it was in previous generation. Among IR signature of aircraft from various sources, aerodynamic heating dominates in long-wavelength IR spectrum of $8{\sim}12{\mu}m$. Skin temperature change by aerodynamic heating which is derived by effects of Mach number and structure. The 4th and 5th generation aircraft are selected for calculation of the skin temperature, and its height and velocity in numerical conditions are 10,000 m and Ma 0.9~1.9 respectively. Aircraft skin temperature is calculated by computing convection of fluid and conduction, convection and radiation of surface. As the aircraft accelerates to higher Mach number, maximum skin temperature increases more rapidly than average temperature and temperature distribution changes in more sharp, interactive ways. The 4th generation aircraft whose shape is more complex than that of the 5th generation aircraft have complicated temperature distribution. On the other hand, the 5th generation aircraft whose shape is relatively simple shows plain temperature distribution and lower skin temperature in terms of both average and maximum value.

• 한국추진공학회지
• /
• 제18권5호
• /
• pp.54-61
• /
• 2014

본 연구에서는 비정렬격자계를 사용하는 2차원 축대칭 DSMC 법을 사용하여 로켓 노즐에서 사출되는 플룸을 해석하였다. 오리피스의 출구 전압에 대한 배압의 비율이 높은 경우와 낮은 경우의 플룸에 대하여 해석을 실시하여 저고도와 고고도를 대표하는 두 가지 조건에서 플룸 유동의 차이를 관찰하였다. 저고도 플룸은 Mach disc 등 복잡한 유동 구조를 보인 반면 고고도 플룸은 단순 팽창만을 보였으며, 유동이 상류 방향으로 심하게 꺾였다. 또한 고도 20 km의 대기 조건에서 소형 로켓 노즐에서 사출되는 플룸에 대한 해석을 수행하여 연속체 해석 결과와 비교하였으며 과소팽창되는 로켓 플룸의 유동구조가 잘 나타났다. 또한, 플룸 내부에 국지적인 천이 유동이 발생할 수 있음을 확인하였다.

• 한국추진공학회지
• /
• 제26권1호
• /
• pp.88-97
• /
• 2022

본 연구에서는 직접 연결식 초음속 연소기의 지상 시험 장치에 고온, 고압 공기 공급을 위한 연소식 공기 가열기를 설계 및 제작하였으며, 목표 설계점 만족 여부를 검증하기 위한 실험을 수행하였다. 연소식 공기 가열기 노즐 출구의 상부 경계, 하부 경계 및 중앙에 쐐기를 설치하여 마하수가 2.0 수준을 만족하는 것을 확인하였으며, 연소실 내부 압력 또한 설계점과 비교하여 만족할만한 수준으로 나타났다. 온도의 경우 열전대의 노출되는 정도와 느린 응답 특성에 의해 측정된 온도의 편차가 크게 나타났다. 이후 연소식 공기 가열기 후방에 격리부를 연결하고 동일한 방법으로 마하수를 측정하였으며, 격리부 출구 중앙의 마하수는 1.8~1.9 정도로 소폭 감소하였다.

• 대한기계학회논문집B
• /
• 제38권12호
• /
• pp.1009-1015
• /
• 2014

본 연구는 NACA0012 천음속 에어포일 유동에 있어서 비평형 응축이 Force 계수(압력, 양력 및 항력계수)에 미치는 영향을 TVD 수치해석을 통하여 연구하였다. 정체점 온도 298 K, 받음각 ${\alpha}=3^{\circ}$인 경우, 주류 마하수 0.78~0.81에서는 정체점 상대습도의 증가함에 따라 양력은 단순 감소한다. 반면 Lift force break 마하수 영역의 주류 마하수에서는 정체점 상대습도의 증가에 따라 양력은 오히려 증가한다. 받음 각 ${\alpha}=3^{\circ}$, 정체점 상대습도가 0%인 경우, 주류 마하수의 증가에 따라 항력은 급격하게 증가하지만, 응축의 영향이 큰 60%인 경우에는 주류 마하수의 증가에 조금 증가할 뿐이다. 동일한 주류 마하수인 경우 비평형 응축에 따른 전 항력의 감소는 받음각과 정체점 상대습도가 증가할수록 크게 된다. 응축이 없는 ${\Phi}_0=0%$인 경우는 주류 마하수가 크고 받음각이 클수록 Wave drag은 크게 되나 응축의 영향이 비교적 큰 ${\Phi}_0=50%$ 이상인 경우는 오히려 Wave drag이 작아지는 것으로 나타났다. 한편, 정체점 상대습도가 낮고, 주류 마하수가 클수록 충격파 직전의 최대 마하수는 커지는 것으로 나타났다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제35권7호
• /
• pp.938-945
• /
• 2011

Unsteady flow simulations through a transonic turbine vane were carried out for an isentropic Mach number of 1.02 and a Reynolds number of $10^6$. The main objective of the study is to investigate the effect of unsteadiness due to vortex shedding on the flow in transonic regime. The steady and the time-averaged unsteady results by employing three different turbulence models: shear stress transport (SST), k-${\omega}$, and ${\omega}$ Reynolds stress models were compared. The comparisons were emphasized on the isentropic Mach number along the blade and total pressure loss at the cascade exit. The results showed that both steady and unsteady calculations have good agreement with experimental data along the blade surface. However, at cascade exit, the unsteady calculations have much better agreement with experimental data than steady calculations. Based on these, we conclude that the unsteady flow calculations are essential for these types of problems.

• International Journal of Aeronautical and Space Sciences
• /
• 제18권1호
• /
• pp.38-47
• /
• 2017

This paper presents experimental data on water droplet breakup in high-speed air flows. Exact-time-dependent evolution of wave and droplet interaction as well as breakup processes were optically visualized using a shadowgraph technique. Droplet experiments were conducted in a shock tube. Five flow conditions were used with an incident shock wave Mach number from 1.40 to 2.19 with Weber number based on the droplet initial diameter from 2300 to 38000, respectively. This corresponds to post-shock flow speeds varying from subsonic to supersonic. The considered droplet diameters were 2.0 mm to 3.6 mm. Some interesting wave patterns in the near wake were found. The present data shows that with an increase in the Weber number the droplet acceleration coefficient decreases and the level of decrease was weaker for the case of higher Mach numbers. This state of affair is different to the existing data in literature. Possible reasons are discussed.

• 대한기계학회논문집B
• /
• 제25권7호
• /
• pp.989-996
• /
• 2001

High-speed and low-speed flows are simulated numerically by flowfield-dependent mixed explicit-implicit (FDMEI) method. This algorithm depends on implicitness parameters of convection, diffusion, diffusion gradients, and source terms which are calculated from the changes of local Mach, Reynolds, Peclet, and Damkohler numbers between adjacent nodes. Convection phenomena or shock waves are resolved from Mach number-dependent implicitness parameters whereas diffusion or viscous actions are simulated by Reynolds number or Peclet number-dependent implicitness parameters. Fluctuation components of all variables are properly accommodated spatially and temporally in the FDMEI procedure. To illustrate, some benchmark example problems are presented for comparisons of the FDMEI results with other available data. These results appear to be encouraging and point toward the need for further investigations of the FDMEI theory.

• Journal of Advanced Marine Engineering and Technology
• /
• 제28권5호
• /
• pp.717-727
• /
• 2004

In this study, we simulate the aerodynamic sounds generated by a two-dimensional circular cylinder in a uniform flow are simulated by applying the finite difference lattice Boltzmann method (FDLBM). The third-order-accurate up-wind scheme (UTOPIA) is used for the spatial derivatives. and the second-order-accurate Runge-Kutta scheme is applied for the time marching. The results show that we successively capture very small acoustic pressure fluctuations with the same frequency of the Karman vortex street compared with the Pressure fluctuation around a circular cylinder The propagation velocity of the acoustic waves shows that the points of peak pressure are biased upstream due to the Doppler effect in the uniform flow For the downstream. on the other hand. it quickly Propagates. It is also apparent that the amplitude of sound Pressure is Proportional to $r^{-1/2}$, r being the distance from the center of the circular cylinder. To investigate the effect of the lattice dependence furthermore a 2D computation of the tone noise radiated by a NACA0012 with a blunt trailing edge at high incidence and low Reynolds number is also investigated.

• 대한기계학회논문집B
• /
• 제25권10호
• /
• pp.1384-1391
• /
• 2001

Three-dimensional flow analysis is implemented to investigate the flow through transonic axial-flow compressor rotor(NASA R67) and to evaluate the performances of Abid's low-Reynolds-number k-$\omega$ and Baldwin-Lomax turbulence models. A finite volume method is used fur spatial discretization. The equations are solved implicitly in time by the use of approximate factorization. The upwind difference scheme is used for inviscid terms and viscous terms are approximated with central difference. The flux-difference-splitting method of Roe is used to obtain fluxes at the cell faces. Numerical analysis is performed near peak efficiency and near stall. The results are compared with the experimental data for NASA R67 rotor. Blade-to-Blade Mach number distributions are compared to confirm the accuracy of the code. From the results, it is concluded that Abid'k-$\omega$ model is better for the calculation of flow rate and efficiency than Baldwin-Lomax model. But, the predictions for Mach number and shock structure are almost the same.