• 대한금속재료학회지
• /
• 제50권1호
• /
• pp.52-58
• /
• 2012

Hydrogen-delayed fracture (HDF) was analyzed from the deposited weld metals of 600-MPa and 800-MPa flux-cored arc (FCA) welding wires, and then from the diffusible hydrogen behavior of the weld zone. Two types of deposited weld metal, that is, rutile weld metal and alkali weld metal, were used for each strength level. Constant loading test (CLT) and thermal desorption spectrometry (TDS) analysis were conducted on the hydrogen pre-charged specimens electrochemically for 72 h. The effects of microstructures such as acicular ferrite, grain-boundary ferrite, and low-temperature-transformation phase on the time-to-failure and amount of diffusible hydrogen were analyzed. The fracture time for hydrogen-purged specimens in the constant loading tests decreased as the grain size of acicular ferrite decreased. The major trapping site for diffusible hydrogen was the grain boundary, as determined by calculating the activation energies for hydrogen detrapping. As the strength was increased and alkali weld metal was used, the resistance to HDF decreased.

• 청정기술
• /
• 제2권1호
• /
• pp.60-68
• /
• 1996

고정층 반응기에서 망간광석을 이용하여 저농도의 일산화탄소 산화제어반응에 대하여 고찰하였다. 고려된 실험변수는 일산화탄소 농도 (500ppm~10000ppm), 산소 농도(500ppm~99.8%)와 촉매의 온도($50{\sim}750^{\circ}C$)이다. 또한 망간광석의 특성은 Thermogravimetric Analysis(TGA), 일산화탄소에 의한 환원, Temperature Programmed Reduction(TPR)실험을 이용하여 규명하였다. 망간광석의 일산화탄소 산화력은 순수이산화망간에 비해서 단위 면적당 높은 산화력과 $750^{\circ}C$까지 가열된 후에도 산화력이 유지될 수 있는 안정된 촉매작용을 보였다. Temperature Programmed Desorption(TPD), TPR 실험과 TG 등의 분석결과 산소의 농도가 낮거나 무산소하에서 망간광석의 격자내 산소가 쉽게 제공될 수 있음을 알 수 있었다. 일산화탄소의 농도가 500~3500ppm일 때 일산화탄소의 반응차수는 0.701이며 3500~10000ppm구간에서 일산화탄소의 농도에 무관한 0차 반응이었다.

• 한국대기환경학회지
• /
• 제18권2호
• /
• pp.127-137
• /
• 2002

Phenolic compounds in air are toxic even at their low concentrations. We had evaluated a total of five phenolic compounds (Phenol, o-Cresol, m-Cresol, 2-Nitrophenol and 4-Chloro-3-methylphenol) in artificial air using a combination of ATD/GC/MS. To compare the adsorption efficiency of these phenolic compounds, three adsorbents (Tenax TA, Carbotrap and Carbopack B) were tested. Tenax TA adsorbent was most effective of all the adsorbents used for the efficiency test. Five phenolic compounds were found to be very stable on adsorbent tubes for 4 days at room temperature. Detection limit of five phenolic compounds ranged from 0.05 to 0.08 ppb (when assumed to collect 10 L air). The calibration curve was linear over the range of 22∼ 164 ng. The reproducibility was less than 4%. Sampling of duplicate pairs (DPs) was made to demonstrate duplicate precision and sampling efficiency.

• International Journal of Automotive Technology
• /
• 제6권6호
• /
• pp.591-598
• /
• 2005

A three-way catalyst system of a natural gas vehicle (NGV) has characteristics of higher fuel consumption and higher thermal load than a lean-bum catalyst system. To meet stringent emission standards in the future, NGV with the lean-bum engine may need a catalyst system to reduce the amounts of HC, CO and NOx emission, although natural gas system has low emission characteristics. We conducted experiments to evaluate the conversion efficiency of the NOx reduction catalyst for the lean-burn natural gas engine. The NOx reduction catalysts were prepared with the ${\gamma}-Al_{2}O_3$ washcoat including Ba based on Pt, Pd and Rh precious metal. In the experiments, effective parameters were space velocity, spike duration of the rich condition, and the temperature of flowing model gas. From the results of the experiments, we found that the temperature for maximum NOx reduction was around $450^{\circ}C$, and the space velocity for optimum NOx reduction was around $30,000\;h^{-1}$ And we developed an evaluation model of the NOx reduction catalyst to evaluate the conversion performance of each other catalysts.

• 한국수소및신에너지학회논문집
• /
• 제28권1호
• /
• pp.9-16
• /
• 2017

Hydrogen forms metal hydrides with some metals and alloys leading to solid-state storage under moderate temperature and pressure that gives them the safety advantage over the gas and liquid storage methods. However, it has disadvantages of slow hydrogen adsorption-desorption time and low thermal conductivity. To improve characteristics of metal hydrides, it is important that activation and thermal conductivity of metal hydrides are improved. In this study, we have been investigated hydrogen storage properties of Hydralloy C among Ti-Mn alloys. Also, the characteristics of activation and thermal conductivity of Hydralloy C were enhanced to improve kinetics of hydrogen adsorption-desorption. As physical activation method, PHEM (planetary high energy mill) was performed in Ar or $H_2$ atmosphere. Hydralloy C was also activated by $TiCl_3$ catalyst. To improve thermal conductivity, various types of ENG (expanded natural graphite) were used. The prepared samples were compacted at pressure of 500 bar. As a result, the activation properties of $H_2$ PHEM treated Hydralloy C was better than the other activation methods. Also, the amounts of hydrogen storage showed up to 1.6 wt%. When flake type ENG was added to Hydralloy C, thermal conductivity and hydrogen storage properties were improved.

• Applied Science and Convergence Technology
• /
• 제26권6호
• /
• pp.174-178
• /
• 2017

The reactions of thermal hydrogen atoms H(g) with the Ge(100) surface were examined with temperature-programmed desorption (TPD) mass spectrometry. Concomitant $H_2$ and $CH_4$ TPD spectra taken from the H(g)-irradiated Ge(100) surface were distinctly different for low and high H(g) doses/substrate temperatures. Reactions suggested by our data are: (1) adsorbed mono(${\beta}_1$)-/di-hydride(${\beta}_2$)-H(a) formation; (2) H(a)-by-H(g) abstraction; (3) $GeH_3$(a)-by-H(g) abstraction (Ge etching); and (4) hydrogenated amorphous germanium a-Ge:H formation. While all these reactions occur, albeit at higher temperatures, also on Si(100), H(g) absorption by Ge(100) was not detected. This is in contrast to Si(100) which absorbed H(g) readily once the surface roughened on the atomic scale. While this result is rather against expectation from its weaker and longer Ge-Ge bond as well as a larger lattice constant, we attribute the absence of direct H(g) absorption to insufficient atomic-scale surface roughening and to highly efficient subsurface hydrogenation at moderate (>300 K) and low (${\leq}300K$) temperatures, respectively.

• 대한화학회지
• /
• 제42권6호
• /
• pp.607-617
• /
• 1998

$TiO_2(001)$ 박막을 Mo(100) 기판에 약 90${\AA}$ 두께로 적층 성장시키고 그 위에 Au를 증착시켜서 Au의 성장모드, 클러스터의 열적 변화, 열적 안정성, 증착량에 따른 Au 4f 전자 결합에너지의 변화를 오제 전자분광법, 열탈착 분광법, 이온 산란 분광법, X-선 광전자 분광법을 이용하여 연구하였다. Au는 $TiO_2(001)/Mo(100)$ 박막에 3차원적인 성장을 하며 낮은 온도에서 성장된 Au 클러스터는 높은 온도에서 성장된 것보다 보다 그 크기가 작고 온도가 높아지면서 클러스터는 비가역적으로 뭉친다. $TiO_2(100)/Mo(100)$에 증착된 Au의 열탈착은 1000 K부터 일어나며, 증착된 Au의 증착량이 많아질수록 더 높은 온도에서 나타난다. 선도 언저리 해석법으로 얻은 Au 클러스터의 탈착에너지는 약 50 kcal/mol이다. Au의 $TiO_2$ 박막에 대한 초기 흡착상수는 기판의 온도 200-600 K 사이에서는 거의 일정하였다. 400 K에서 $TiO_2$ 박막에 2.0 MLE 보다 적은 양의 Au가 증착된 경우에는 Au 4f의 전자 결합에너지가 벌크 Au에 비해서 증가한다. 0.1 MLE의 경우에는 그 결합에너지가 벌크 Au에 비해서 +0.30 eV 이동하였다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2009년도 제38회 동계학술대회 초록집
• /
• pp.80-80
• /
• 2010

Graphene has attracted tremendous attention for the last a few years due to it fascinating electrical, mechanical, and chemical properties. Up to now, several methods have been developed exclusively to prepare graphene, which include micromechanical cleavage, polycrystalline Ni employing chemical vapor deposition technique, solvent thermal reaction, thermal desorption of Si from SiC substrates, chemical routes via graphite intercalation compounds or graphite oxide. In particular, polycrystalline Ni foil and conventional chemical vapor deposition system have been widely used for synthesis of large-area graphene. [1-3] In this study, synthesis of mono-layer graphene on a Ni foil, the mixing ratio of hydrocarbon ($CH_4$) gas to hydrogen gas, microwave power, and growth time were systemically optimized. It is possible to synthesize a graphene at relatively lower temperature ($500^{\circ}C$) than those (${\sim}1000^{\circ}C$) of previous results. Also, we could control the number of graphene according to the growth conditions. The structural features such as surface morphology, crystallinity and number of layer were investigated by scanning electron microscopy (SEM) and atomic force microscopy (AFM), transmission electron microscopy (TEM) and resonant Raman spectroscopy with 514 nm excitation wavelength. We believe that our approach for the synthesis of mono-layer graphene may be potentially useful for the development of many electronic devices.

• Bulletin of the Korean Chemical Society
• /
• 제29권5호
• /
• pp.1007-1012
• /
• 2008

Spray pyrolysis has been found as an excellent method for the preparation of mesoporous barium sulfate at higher temperature. Ethylene glycol, a reducing agent, and solvents had good inhibition effect for the preparation of $BaSO_4$ nano particles. The $BaSO_4$ solution was sprayed at 500 & 800 ${^{\circ}C}$ using different solvents such as methanol, ethanol, propanol and n-butyl alcohol. $N_2$ adsorption-desorption isotherm revealed that $BaSO_4$ is micropore free, possessing narrow mesopores size distribution and high BET surface areas of 72.52 $m^2\;g^{-1}$ at 800 ${^{\circ}C}$ using propanol as an additive. Scanning electron microscopy (SEM) indicates that the morphology of $BaSO_4$ nano material shows uniform shell like particles. Transmission electron microscopy (TEM) proved that the resulting BaSO4 nano particles were uniform in size and the average particle size was 4-8 nm. The surface functionality and ethylene glycol peaks were assessed by Fourier transform infrared resonance (FTIR) spectroscopy. Low intensity ethylene glycol specific absorption peak was observed in propanol which proved that propanol had good inhibition effect on the structural morphology of nano particles.

• 한국지하수토양환경학회지:지하수토양환경
• /
• 제26권5호
• /
• pp.1-8
• /
• 2021

A series of pot experiments were conducted to quantitatively estimate inhibitory effects of reclaimed soil on the growth of Lentil (Lens culinaris) with two soils remediated by land farming (DDC) and low temperature thermal desorption(YJ), respectively. After cultivation in a growth chamber for 8 days, plants were harvested for the analysis of 8 indices including chlorophyll-a and carotenoid in leaves, shoot fresh weight, root dry weight, root length, number of later roots, specific root length (SRL) as well as germination rate in comparison to control experiment conducted on nursery soil. Root length was estimated by SmartRoot program from the digital images of the roots. The results showed germination rate on YJ and DDC soil decreased 29 and 71%, respectively. In comparison to the control, the averaged value of the 8 indices for YJ and DDC soil showed overall growth inhibition was 48 and 68%, respectively. When the same experiment was conducted with 25% (W/W) vermiculate amended soil, plant growth on each soil was comparable to that of the control. The results implies reclaimed soils requires additional processes and/or amendments to reuse for plant growth.