• 한국전기전자재료학회논문지
• /
• 제29권12호
• /
• pp.835-840
• /
• 2016

In this study, the electrostatic capacity and dielectric loss tangent for $20{\mu}m$ thick thermal conductivity silicone rubber which is heated at 80 degrees for 8 hours has been measured at temperature of $30^{\circ}C{\sim}170^{\circ}C$, frequency of 0.1~1 MHz. The results of degradation evaluation by this study are as follows. In low frequency, it found that the electrostatic capacity decreased with increasing temperature. On the other hand, it confirmed that the range of the electrostatic capacity narrowed with increasing frequency. It confirmed that there are the carboxylic acid structure and C-O bonding at range of wave number 1,000cm-1 to 1,300cm-1.

• E2M - 전기 전자와 첨단 소재
• /
• 제13권9호
• /
• pp.13-17
• /
• 2000

• Progress in Superconductivity
• /
• 제4권2호
• /
• pp.137-143
• /
• 2003

In measuring the microwave surface resistance of high-Tc superconductor (HTS) films using the dielectric-loaded cavity resonator method, one of the most important factors that limit the measurement sensitivity is the measurement error in the loss tangent ($tan\delta$) of the dielectric rod placed inside the cavity. We have measured the effective surface resistance ( $R_{S}$ $^{eff}$) of$ YBa_2$$_Cu3$$_{7-{\delta}}$ (YBCO) films and the $tan\delta$ of rutile ($TiO_2$) using the 'two-tone'method suggested by Kobayashi et at. [IEEE, MTT-S Digest, 495, (2001)], which enables simultaneous measurements of both the $R_{S}$ $^{eff}$ fof HTS films and the $tan\delta$ of the rutile with high sensitivity. A rutile-loaded cavity resonator with the $TE_{012}$ and $TE_{021}$ resonant frequencies at 13.67 - 14.01 GHz is used for this purpose. At temperatures where the two modes do not couple with other modes, the $R_{S}$ $^{eff}$ of YBCO films and $tan\delta$ of rutile measured by the two-tone method appear to match well with the corresponding values measured using the reported $tan\delta$ values of sapphire within 10 %. Usefulness of the 'two-tone' method for microwave characterization of HTS films and dielectrics is discussed.d.ielectrics is discussed.ussed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
• /
• pp.297-297
• /
• 2007

The $(B_{0.5},Sr_{0.5})TiO_3$ ceramics, which added with low sintering materials $Li_2CO_3$ and ZnBO, was investigated for LTCC(low temperature co-fired ceramic) applications. To compare sintering temperature of $(B_{0.5},Sr_{0.5})TiO_3$ respectively, we added 1, 2, 3, 4, and 5wt% of $Li_2CO_3$ and ZnBO to $(B_{0.5},Sr_{0.5})TiO_3$. For confirming the sintering temperature, the respective specimens were sintered from $750^{\circ}C$ to $1200^{\circ}C$ by $50^{\circ}C$. The case of $Li_2CO_3$ greatly lowered the sintering temperature of $(B_{0.5},Sr_{0.5})TiO_3$ ($1350^{\circ}C$) below $900^{\circ}C$. The addition of ZnBO improved the loss tangent of $(B_{0.5},Sr_{0.5})TiO_3$. The crystalline structure of $LiCO_3$ doped $(B_{0.5},Sr_{0.5})TiO_3$ and ZnBO doped $(B_{0.5},Sr_{0.5})TiO_3$ was analyzed with the X-ray diffraction (XRD) analysis. The dielectric permittivity and loss tangent of $Li_2CO_3$ doped BST and ZnBO doped BST were measured with the HP 4284A precision. From the electrical characterization, we respectively obtained the dielectric permittivity 1361, loss tangent $6.94{\times}10^{-3}$ at $Li_2CO_3$ doped $(B_{0.5},Sr_{0.5})TiO_3$ (3wt%) and the dielectric constant 1180, loss tangent $3.70{\times}10^{-3}$ at ZnBO doped $(B_{0.5},Sr_{0.5})TiO_3$(5wt%).

• 한국전기전자재료학회논문지
• /
• 제23권7호
• /
• pp.521-524
• /
• 2010

Low loss perovskite niobates and tantalates have been placed on a short list of functional materials for future technologies. In this study, we fabricated Ag(Ta,Nb)$O_3$ thick films on the $Al_2O_3$ substrates by the screen printing method. The Ag(Ta,Nb)$O_3$ powders were fabricated by the mixed oxide method. The sintering temperature and time were $1150^{\circ}C$ and 2 hrs, respectively. The results of XRD analysis showed that the specimens employed in this study had the pesudo cubic structure. The dielectric permittivity and loss tangent of the films have been characterized from 1 kHz to 1 MHz. Also the dielectric permittivity and loss tangent were measured from 303 K to 393 K. The electrical properties of the film are also discussed.

• 한국철도학회논문집
• /
• 제19권1호
• /
• pp.1-10
• /
• 2016

본 논문은 고속열차 객실 내 유리창의 차음 성능을 향상시키기 위한 기반연구로, 접합유리에 사용되는 고분자 필름의 물성과 음향학적 특성을 분석하여 그 상관관계를 살펴보고자 하였다. 기존에 사용되고 있는 PVB(polyvinyl butyal) 필름 및 다른 단량체 비율을 가지는 PVB 유도체, 그리고 유리 사이 차음재로 사용가능 한 PC(polycarbonate)의 동적기계적 특성을 분석(DMA)하였다. DMA 분석을 통해 상온에 가까운 온도범위에서 유리전이온도($T_g$)를 가지며 tan ${\delta}$(loss tangent) 값이 큰 것으로 나타난 PVB-HEMU 시편의 댐핑(damping) 성능이 가장 우수할 것으로 예측하고, 이를 고속철도 차량의 접합유리창과 동일한 구조에서의 투과손실 시험과 해석을 통해 검증하고자 하였다. 접합필름의 종류에 따른 유리창 투과손실 값을 투과손실 측정(인텐시티법)과 FE 해석을 이용해 도출하고, 고분자 필름의 물성과 음향성능 간 상관관계 분석을 위한 기초자료를 구축하였다.

• E2M - 전기 전자와 첨단 소재
• /
• 제9권10호
• /
• pp.1033-1039
• /
• 1996

Electrical and mechanical properties of polymer sheet at cryogenic temperature have been investigated. Tensile stress(and strain at break) in liquid nitrogen(77K) of 79.7MPa(l.2%) and 117.4MPa(2.05%) are evaluated for films of Polypropylene (PP) and Kapton, respectively. Dielectric loss tangent(tan .delta.) of PP and Kapton films is almost independent of the frequency and tensile stress. Also, field strength of PP film at 77K decreases with increasing the tensile stress.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.292-293
• /
• 2006

We have Investigated dielectric properties depending on bias voltage in organic lightemitting diodes using 8-hydroxyquinoline aluminum($Alq_3$) as an electron transport and emissive material. We analyzed the dielectric properties of organic light emitting diodes using impedance characteristics measurement by the auto-balancing bridge technique and equivalent cirrcuit of ITO/$Alq_3$/Al. Impedance characteristics was measured complex impedance Z and phase ${\theta}$ in the frequency range of 40 [Hz] to $10^8$ [Hz]. We obtained complex electrical conductivity, dielectric constant, and loss tangent ($tan{\delta}$) of the device at room temperature. From these analyses, we are able to interpret a conduction mechanism and dielectric properties contributed by an interfacial and orientational polarization.

• 대한조선학회논문집
• /
• 제45권1호
• /
• pp.73-80
• /
• 2008

An improved method to measure the dynamic viscoelastic properties of elastomers is proposed. The method is based on the analysis of forced oscillation of a cylindrical sample loaded with inertial mass. No special equipment or instrumentation other than the ordinary vibration measurement apparatus is required. Typical measurement of the viscoelastic properties of a silicone rubber $Silastic^{(R)}$ S2 were measured over the wide frequency range from 10 Hz to 3 kHz under the action of wide region of deformation from $10^{-4}%$ to 5%. It was shown that modulus of elasticity and loss tangent fall on the single curves when the ratio of load mass to sample mass changed from 1 to 20.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 추계학술대회 논문집 Vol.18
• /
• pp.293-294
• /
• 2005

We have investigated dielectric properties depending on frequency in organic light -emitting diodes using 8-hydroxyquinoline aluminum ($Alq_3$) as an electron transport and emissive material. We analyzed the dielectric properties of organic light-emitting diodes using impedance of characteristics. impedance characteristics was measured complex impedance Z and phase $\Theta$ in the frequency range of 40 Hz to $10^8$ Hz. We obtained complex electrical conductivity, dielectric constant, and loss tangent (tan$\delta$) of the device at room temperature. From these analyses, we are able to interpret a conduction mechanism and dielectric properties contributed by an interfacial and orientational polarization.