• Clean Technology
• /
• v.20 no.1
• /
• pp.72-79
• /
• 2014

In this study, we investigated reaction rate constant and activation energy of $CO_2$ lignite gasification by using waste catalysts (I, II, III) and $K_2CO_3$. The gasification experiments were conducted with the lignite which was mixed physically with the catalysts of 1 wt%, 5 wt%, 10 wt% by thermogravimetry with TGA at $800^{\circ}C$, $850^{\circ}C$ and $900^{\circ}C$. The experimental data was analyzed with kinetic models (VRM, SCM and MVRM). MVRM was the most suitable among the three models. It was confirmed that gasification rate increased with increasing temperature and the activation energies of $CO_2$ gasification of lignite with mixed waste catalysts were lower than that of lignite alone at all temperatures. Especially, 10 wt% of waste catalyst III showed the lowest activation energy, 92.37 kJ/mol, among all lignite-char with catalysts.

• KSBB Journal
• /
• v.7 no.1
• /
• pp.73-78
• /
• 1992

The solubilizations of Australian lignite by the fungus Poria cocos, Trichodermareesei, Candide tropicalis, and niger were investigated. Three different types of chemical pretreatment methods were used for increasing biosolubility of lignite. Nitric acid and hydrogen peroxide were proven to be proper chemical pretreatment materials of Australian lignite. Poria cocos showed much better solubilization ability than other strains. Interpretation of the nature of coal solubilization by Poria cocos was based primarily on infrared, ultraviolet and nuclear magnetic resonance spectrum analyses.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.23 no.4
• /
• pp.11-20
• /
• 2015

In the present work, a basic study on the in-situ biogenic methane generation from low grade coal bed was conducted. Lignite from Indonesia was used as a sample feedstock. A series of BMP (Biochemical Methane Potential) tests were carried out under the different experimental conditions. Although nutrients and anaerobic digester sludge were added to the coal, the produced amount of methane was limited. Both temperature control and particle size reduction showed little effect on the increase of methane potential. When rice straw was added to lignite as an external carbon source, methane yield of 94.4~110.4 mL/g VS was obtained after 60 days of BMP test. The calorific value of lignite after BMP test decreased (4.5~12.1 %) as increasing the content of rice straw (12.5~50 wt % of lignite), implying that anaerobic digestion of rice straw led to partial degradation of lignite. Therefore, rice straw could be used as an external carbon source for the start-up of in-situ biogas generation from low grade coal bed.

• Korean Journal of Environmental Agriculture
• /
• v.29 no.2
• /
• pp.93-101
• /
• 2010

For the study of possibility of practical use as an organic farm materials of the mixtures with lignite and amino acid solution, this experiment was carried out to investigate the effects of the mixtures on the growth and the yield of rice plant, chinese cabbage, and red pepper, and the effects of the mixtures on chemical properties of soil. Also, when the mixtures of the lignite plus amino acid solution and the chemical fertilizer were applied to these three crop cultivation area, authors want to know how can the loss in quantity of chemical fertilizer affects the growth and the yield of these crops. As the results, growth of rice plant applied with the mixtures of lignite and amino acid solution was better than that applied with the recommended rate of chemical fertilizer. Especially, the growth of rice plant appeared to be good at the treatment of 150 kg/ha of the mixed lignite with amino acid solution and at that of its mixtures and standard fertilization. Growth of chinese cabbage and red pepper was good at the application of 600 kg/ha of the mixed lignite with amino acid solution and at that of its mixtures and standard fertilization. Yield of rice and chinese cabbage was good at the treatment of 150 kg/ha of the mixed lignite with amino acid solution and at that of its mixtures and standard fertilization, and yield of red pepper was good at the application of 600 kg/ha of the mixed lignite with amino acid solution and at that of its mixtures and standard fertilization. The organic matter content increased and while the exchangeable cation decreased when the lignite mixed with amino acid solution and the loss in quantity of chemical fertilizer applied at paddy field. Incase of these treatments, pH and available phosphorus increase at upland field, but did not change at paddy field.

• Journal of environmental and Sanitary engineering
• /
• v.14 no.2
• /
• pp.18-24
• /
• 1999

The purpose of this study was carried out to estimate removal possibility of IBMP and IPMP causing odor in raw water. As a result of Freundlich isotherm. IBMP was superior to IPMP in adsorptive capacity. Adsorptive capacities of activated carbon were found to be in order of Lignite, Coconut shell, and Charcoal. These were well fitted with Freundlich isotherm. According to adsorption breakthrough tests for Lignite GAC, breakthrough time of IPMP and IBMP were 5.7hr and 5.5hr, respectively. Because adsorptive capacities of target material were very different with pore size distribution, it seemed that Lignite and Coconut shell based activated carbons were recommended in order to remove door compounds.

• Journal of Animal Environmental Science
• /
• v.5 no.2
• /
• pp.101-106
• /
• 1999

This study was conducted to develop a lignite coal heater which can be used to livestock facilities and to test performance of the heater developed. Experimental results are as following: 1. Heating capacity of the heater was 85,000 kcal/h. 2. The concentrations of CO gas in the exhaust gas were the maximum of 759 ppm and the average of 319 ppm; for the concentrations of NOx, the maximum of 212 ppm and the average of 57 ppm ; for the concentrations of SO2 gas, the maximum of 302 ppm and the average of 99 ppm. As the values were less than the allowable concentration limites, they did not violate the air environment law. 3. Problems such as frequent interruption of fuel supply and bridge state were happened. Therefore, it was required that these should be resolved in the future.

• 한국연소학회:학술대회논문집
• /
• 2012.11a
• /
• pp.111-114
• /
• 2012

The ignition behavior of single coal particles of five kindes of coal with different ranks (low volatile bituminous, low volatile sub-bituminous, high volatile bituminous, lignite) with particle size of $150-200{\mu}m$ was investigated at high heating rate condition. Particles were injected into a laminar flow reactor and the ignition behavior was observed with high speed cinematography. Sub-bituminous were observed to ignite homogeneously; however, low volatile bituminous coal and lignite undergo fragmentation prior to igntion. The observation was analyzed with previous work.

• Journal of Hydrogen and New Energy
• /
• v.27 no.1
• /
• pp.63-70
• /
• 2016

In this study, ash free coals(AFCs) were produced with lignite and anthracite coals in a microwave. The AFCs were analyzed with proximate analysis, fourier transform infrared spectrometry (FTIR), X-ray diffraction analysis, and thermogravimetric analysis (TGA). The extraction yields of the AFCs were 16.4 wt%, 7.6 wt% at lignite and anthracite coal, respectively. The chemical and physical properties of the AFCs were similar regardless of the original coal types. Oxidation behavior of the AFCs was investigated by supplying a mixture of 3g of AFC and 3g of electrolyte into the coin-type molten carbonate fuel cell (MCFC). For the evaluation of AFC fuel performance, electrochemical analysis of the steady-state polarization and step-chronopotentiometry were conducted based on the standard hydrogen fuel (69 mol% $H_2$, 17 mol% $CO_2$, 14 mol% $H_2O$). The AFCs showed similar electrochemical oxidation behaviors regardless of the original coal types. The overvoltage of the AFCs was larger than the hydrogen fuel, although OCV of the AFCs was higher.

• Korean Chemical Engineering Research
• /
• v.51 no.4
• /
• pp.506-512
• /
• 2013

Biomass and low-grade coals are known to be better potential sources of energy compared to crude oil and natural gas since these materials are readily available and found to have large reserves, respectively. Gasification of these carbonaceous materials produced syngas for chemical synthesis and power generation. Woodchip, sawdust and lignite were gasified with steam in a thermobalance reactor under atmospheric pressure in order to evaluate their kinetic rate information. The effects of gasification temperature ($600{\sim}900^{\circ}C$) and partial pressure of steam (20~90 kPa) on the gasification rate were investigated. The three different types of gas-solid reaction models were applied to the experimental data to predict the behavior of the gasification reactions. The modified volumetric model predicted the conversion data well, thus the model was used to evaluate kinetic parameters in this study. The observed activation energy of biomass, sawdust and lignite gasification reactions were found to be in reasonable range and their rank was found to be sawdust > woodchip > lignite. The expression of apparent reaction rates for steam gasification of the three solids was proposed to provide basic information on the design of coal gasification processes.

• Journal of the Korean Chemical Society
• /
• v.4 no.1
• /
• pp.78-80
• /
• 1957

Up to now, only superficial studies on the combustion velocity of smokeless fuels have been reported, while it should be a basical factor on the utilization of low quality coals and some other smokeless solid fuels. It was, therefore, difficult to choose raw material coals in manufacturing gaseous fuels. With the intent to solve above problem, we have determined combustion velocity of domestic anthracites, graphites, coalites of lignite and cokes from Japanese bituminous coal. The results show that the cokes from Japanese bituminous coal which has been used as raw material in the manufacturing gaseous fuels such as water gas, or producer gas in Korea can be replaced by some sources of domestic anthracite or coalite of lignite.