• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.26 no.5
• /
• pp.481-489
• /
• 2000

This research was focused on overall examination of tissue alteration, wound healing promotion. After the hair on the dorsal surface was shaved, $5{\times}5mm$ oval skin defect was formed. Experimental wounds of right side were irradiated on every day for 90 second with Ga-Al-As semi-conductor laser. Left side wounds served as control group. The rats were sacrificed on the 1st, 3rd, 5th, 7th, 14th, 21th day. For light microscopically, parafin section were stained with H&E, MT. The outcomes were as follows : 1. On 1st day, experimental and control group were seen acute inflammatory cell infiltration, edema. 2. On the 3rd days, both groups were seen crust development, collagen, blood vessel proliferation. 3. On the 5th days, experimental group were reduced edema and inflammatory cell infiltration than control group. 4. On the 7th days, both groups were observed edema, inflammatory cell infiltration disappearance and keratinocytes motility from wound defect. 5. On the 14th days, experimental group appeared collagen, blood vessel proliferation and hair follicle than control group. 6. On the 21th days, both groups were seen normal status re-epithelization. According to the above results, The wound-healing stimulated by laser radiation involves an increased rate of epithelial growth. LLLT was confirmed that it has fibroblast, blood vessel proliferation, influence initial wound healing process.

• Journal of Advanced Marine Engineering and Technology
• /
• v.32 no.5
• /
• pp.707-716
• /
• 2008

The objective of this study was to analyze the effect of mixed fuel composition and mass fraction on spray inner structure in evaporating transient spray under the variant ambient conditions. Spray structure and spatial distribution of liquid phase concentration were investigated using a thin laser sheet illumination technique on the three component mixed fuels. A pulsed Nd:YAG laser was used as a light source. The experiments were conducted in a constant volume vessel with optical access. Fuel was injected into the vessel with electronically controlled common rail injector. Used fuel contains i-octane($C_8H_{18}$), n-dodecane($C_{12}H_{26}$) and n-hexadecane($C_{16}H_{34}$) that were selected as low-, middle- and high-boiling point fuel, respectively. Experimental conditions are 42 MPa, 72 MPa and 112 MPa in injection pressure, $5\;kg/m^3$, $15kg/m^3$ and $30kg/m^3$ in ambient gas density, 300 K, 500 K, 600 K and 700 K in ambient gas temperature, 300 K and 368 K in fuel temperature and different fuel mass fraction. Experimental results indicated that the multi-component fuels made two phase region mixed vapor and liquid so that it would are helpful to improve combustion, for the fuels of high boiling point component could accelerate evaporation very much according as low boiling point fuel was added to high boiling point fuel.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.35 no.4
• /
• pp.439-445
• /
• 2011

Forensic Engineering is the art and science of professionals qualified to serve as engineering experts in courts of law or in arbitration proceedings. Buses using compressed natural gas (CNG) trend to be extended in use internationally as optimal counterplan for reducing discharge gas of light oil due to high concern about environment. However, CNG buses have to be equipped with composite pressure vessels (CPVs); since the CPVs contain compressed natural gas, the risks in the case of accident is very high. Hence, the investigation of such accidents is usually associated with engineering analysis. Among the possible reasons for such CNG explosion accidents is vehicle fire and vessel fracture. By conducting formal inspection and engineering tests, in this study, the cause of vessel explosion is investigated by analyzing the failure mechanism by fractography and by comparing the material properties of a reference part with those of a problem part by adopting instrumented indentation technique.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.529-535
• /
• 2017

In this paper the laminate design parameters are researched to maximize the performance index of a composite pressure vessel. The pressure-resistant performance and the light-weight concept with contained internal space are implied in the performance index. To maximize the performance index, the three design variables that the thickness of each of helical and hoop layers and the length of hoop layer are considered under the assumption of fixed internal space. To optimize the variables, the response surface method is introduced for construction of the surrogate model and the ANOVA(analysis of variance) is performed to evaluate the effects of the variables. The optimization problem is formulated to maximize performance index under the burst pressure constraint. To verify the effectiveness of the research, numerical analyses are performed for the optimum model.

• Nuclear Engineering and Technology
• /
• v.25 no.3
• /
• pp.413-423
• /
• 1993

This paper reports an experimental study of direct containment heating (DCH) which would occur if the primary system pressure is still high at the time of vessel breach during a light water reactor core melt accident. The experiments were conducted in 1/30-scale cavity models of Kori unit 1 and 2 and Young Kwang unit 3 and 4 nuclear power plants. One 1/20-scale model of the Kori plant was also used to investigate the scaling effect. The primary variables in the experiments were initial vessel pressure, vessel breach size and cavity geometry. It is observed that higher initial pressure and larger breach size enhance the melt dispersal fraction. Also, the cavity geometry appears to affect the dispersal rate greatly. A simple correlation of melt dispersal fraction is proposed in terms of nondimensional effective period. This correlation shows good agreement with the present experimental data, the KAIST data and the BNL data.

• Journal of the Korean Wood Science and Technology
• /
• v.37 no.1
• /
• pp.19-28
• /
• 2009

Some wood anatomical characteristics of seven chestnut cultivars (Tanzawa, Ibuki, Arima, Ginyose, Tsukuba, Riheiguri, and Mansung) grown in Korea were examined in this study. We investigated the radial variation of wood components such as diameter and number of earlywood vessel element and ray density in cross section and number and height of ray in tangential section. Discs were taken from the stem of seven chestnut cultivars at breath height and cut into the radial strip. Cross, radial, and tangential sections, 10 to $20{\mu}m$ thick, were sliced with a sliding microtome. These sections were stained, dehydrated, and mounted with Canada balsam according to common procedure. Measurement and observation were performed with a light microscopy. In all chestnut cultivars, radial and tangential diameter of vessel element increased but number of vessel element per $mm^2$ decreased with increasing tree age. Ray spacing (per mm) in cross section from pith to bark showed no significant variation, while number of ray per $mm^2$ increased but ray height decreased with the increase of tree age. Conclusively, the results obtained in present study were thought to be some valuable information for separating juvenile and adult wood as well as identifying chestnut cultivars.

• Ocean and Polar Research
• /
• v.40 no.4
• /
• pp.281-288
• /
• 2018

The transmission of solar light according to the distribution of chromophoric dissolved organic matter (CDOM) was measured in the Pacific Arctic Ocean. The Research Vessel Araon visited the ice-covered East Siberian and Chukchi Seas in August 2016. In the Arctic, solar [ultraviolet-A (UV-A), ultraviolet-B (UV-B), and photosynthetically active radiation (PAR)] radiation reaching the surface of the ocean is primarily protected by the distribution of sea ice. The transmission of solar light in the ocean is controlled by sea ice and dissolved organic matter, such as CDOM. The concentration of CDOM is the major factor controlling the penetration depth of UV radiation into the ocean. The relative CDOM concentration of surface sea water was higher in the East Siberian Sea than in the Chukchi Sea. Due to the distribution of CDOM, the penetration depth of solar light in the East Siberian Sea (UV-B, $9{\pm}2m$; UV-A, $13{\pm}2m$; PAR, $36{\pm}4m$) was lower than in the Chukchi Sea (UV-B, $15{\pm}3m$; UV-A, $22{\pm}3m$; PAR, $49{\pm}3m$). Accelerated global warming and the rapid decrease of sea ice in the Arctic have resulted in marine organisms being exposed to increased harmful UV radiation. With changes in sea ice covered areas and concentrations of dissolved organic matter in the Arctic Ocean, marine ecosystems that consist of a variety of species from primary producers to high-trophic-level organisms will be directly or indirectly affected by solar UV radiation.

• The Korean Journal of Physiology and Pharmacology
• /
• v.6 no.1
• /
• pp.33-39
• /
• 2002

It has been suggested that $Ca^{2+}$ sensitization mechanisms might contribute to myogenic tone, however, specific mechanisms have not yet been fully identified. Therefore, we investigated the role of protein kinase C (PKC)- or RhoA-induced $Ca^{2+}$ sensitization in myogenic tone of the rabbit basilar vessel. Myogenic tone was developed by stretch of rabbit basilar artery. Fura-2 $Ca^{2+}$ signals, contractile responses, PKC immunoblots, translocation of PKC and RhoA, and phosphorylation of myosin light chains were measured. Stretch of the resting vessel evoked a myogenic contraction and an increase in the intracellular $Ca^{2+}$ concentration $([Ca^{2+}]_i)$ only in the presence of extracellular $Ca^{2+}$. Stretch evoked greater contraction than high $K^+$ at a given $[Ca^{2+}]_i.$ The stretch-induced increase in $[Ca^{2+}]_i$ and contractile force were inhibited by treatment of the tissue with nifedipine, a blocker of voltage-dependent $Ca^{2+}$ channel, but not with gadolinium, a blocker of stretch-activated cation channels. The PKC inhibitors, H-7 and calphostin C, and a RhoA-activated protein kinase (ROK) inhibitor, Y-27632, inhibited the stretch-induced myogenic tone without changing $[Ca^{2+}]_i.$ Immunoblotting using isoform-specific antibodies showed the presence of $PKC_{\alpha}$ and $PKC_{\varepsilon}$ in the rabbit basilar artery. $PKC_{\alpha},$ but not $PKC_{\varepsilon},$ and RhoA were translocated from the cytosol to the cell membrane by stretch. Phosphorylation of the myosin light chains was increased by stretch and the increased phosphorylation was blocked by treatment of the tissue with H-7 and Y-27632, respectively. Our results are consistent with important roles for PKC and RhoA in the generation of myogenic tone. Furthermore, enhanced phosphorylation of the myosin light chains by activation of $PKC_{\alpha}$ and/or RhoA may be key mechanisms for the $Ca^{2+}$ sensitization associated with myogenic tone in basilar vessels.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.12 no.1
• /
• pp.72-81
• /
• 1990

Because failure of microvascular flap grafting has sometimes been attributed to vascular obstruction in the anastomotic site, this study investigated the healing process after microvascular anastomoses. The healing process of anastomotic sites were observed by the use of the light and the scanning electron microscope after microvascular anastomoses of the right common carotid artery in rats. The experimental animals were sacrificed on the 4th day, 1st, 2nd, 4th and 6th week. Throughout the whole experimental period, arterial patency rate was 78% (11/14). At the early stage, it was possible to recognize histologically disappearance of endothelial cell and rupture of part of the media. Subintimal hyperplasia and the growth of media appeared around the suture line at the 2nd week. Endothelial cell regeneration occurred and the depth of vessel wall was normalized at the 4th week. By the scanning electron microscope, at the early stage, the anastomotic site was covered with many platelets, red blood cells, fibrins and macrophages. At the 4th week, the insertion site of the thread was completely covered with normal endothelial cells which were parallel to longitudinal axis of vessels and complete reendothelialization over the anastomotic site seemed to take about 6th week.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.04a
• /
• pp.65-69
• /
• 2009

Generally Lighting system consists of lamp and luminaire. When a fluorescent lamp is installed in luminaire, power and light output is changed by ambient temperature. Particularly electrodeless lamp depends on the changes that are mercury pressure with amalgam temperature and magnetic properties with ferrite temperature. It has finally influence on optical efficiency. In this study, the temperature change of ferrite and cold spot, vessel are measured at transitional state and then same characteristics are measured with increase of ambient temperature. At transitional state, luminous flux is related to temperature change of cold spot that compare with behavior of mercury pressure and light output. At increase of ambient temperature, we analyzed change that efficiency and electrical, optical characteristics of electrodeless lamp are related to ferrite core and cold spot temperature.