• Journal of the Korean Wood Science and Technology
• /
• v.24 no.4
• /
• pp.93-99
• /
• 1996

In order to investigate the extent of fixation of new water-borne preservatives in blocks of pinus densiflora sapwoods the streaming potential through the column with preservative treated wood was measured at various conditions. The rates of leachability of ingredients in the treated wood were estimated by the measurement of electric conductivity of the solution with the leached components. The solution was also analyzed by Atomic absorption spectrophotometer (AA). As a results, the experimental data indicated that the fixation of CCB, CCFZ and ACQ in wood were relatively unstable. The fixation rates of CCB, CCFZ were improved by increasing heat and drying time. The amounts of the leached ingredients were apparently higher in CCB and CCFZ than in CCA, while the rate of leaching of ACQ was not changed at various drying temperature.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.295-298
• /
• 2004

It was revealed that leaching of elements were partly inhibited because seawater contains plenty of dissolved ions than fresh water. On the other hands, the low activity coefficient and the formation of complex with chloride and sulfate play roles in enhancing element leachability. However, the pH buffaring capacity of seawater is the most important factor that makes the leaching of elements and its chemical behavior in the seawater system different from those in the fresh water environments. In general, the leaching from the weathered ash was smaller than that from the fresh ash. However, it was revealed that the leaching of Si, Fe, Al, Mn, phosphate, and some other elements were independent of ash weathering. They were dependant only on the pH of the solutions.

• Journal of environmental and Sanitary engineering
• /
• v.16 no.1
• /
• pp.53-60
• /
• 2001

In this study, the heavy metals in tannery sludge were solidified by using cement and power plant fly ash. Solidification characteristics were discussed with the compressive strength and chromium leaching characteristics of solids. The compressive strength of cement mortar was increased by the amount of fly ash up to 24.3~33.8%, which was considered the results of pozzolanic reaction. When the content of fly ash was 20%, cement mortar showed the highest value $295kg/\textrm{cm}^2$ for 28 days curing. At early curing days, solidified chromium tannery sludge solids were showed lower compressive strength because of the retard on the hydration of cement, but the compressive strength was recovered to be more than $140kg/\textrm{cm}^2$ for 28 days curing regardless with the amounts of fly ash. Also, the results of leaching tests by KSM and TCLP method were showed that the solidified chromium sludge have leached out 0.3~2.2% and 11~17%, respectively.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.03a
• /
• pp.739-742
• /
• 2002

Immobilization of contaminants in contaminated soils by solidification processes is an attractive potential remediation process. In this study, the treatability of lead, copper, toluene, and COD was investigated by leaching test. Industrial sand was adopted as the test material and was contaminated with lead copper, and toluene to 100mg/kg, 500mg/kg, 200mg/kg respectively. P solidifying agent was used as the binder(20% by weight of contaminated soil) in the solidification treatment. The leachability of contaminants leached from the solidified soil was evaluated using column test. The percentage of contaminants leached from the solidified soil was significantly reduced by reaction of waste species with cement components and encapsulation reaction of binder. Based on the tests, it is ascertained solidification process can be a very effective method to control the elution of contaminants from the contaminated soil.

• Journal of Korean Society on Water Environment
• /
• v.27 no.6
• /
• pp.862-867
• /
• 2011

Pozzolanic-based stabilization/solidification (S/S) is an effective and economic remediation technology to immobilize heavy metals in contaminated soils. In this study, quick lime (CaO) was used to immobilize cadmium and zinc present in waste mine contaminated clayey sand soils. Addition of 5% quicklime to the contaminated soils effectively reduced heavy metal leachability after 2 bed volume operation below the drinking water regulatory limits. Lime addition was revealed to increase the immobilization for all heavy metals in tested pH ranges, so it could be an optimal choice for short-term remediation of heavy metal contaminated soil. The mass balances for these column tests show metal reduction of 92% for Cd and 87% for Zn of total resolved mass in case of 5% lime application.

• The Korean Journal of Pesticide Science
• /
• v.6 no.4
• /
• pp.309-319
• /
• 2002

Soil adsorption study was carried out to define the mobility of pesticides or to evaluate leaching potential in soils. Five pesticides including ethoprophos, procymidone, iprobenfos, isoprothiolane, and butachlor were subjected to optimized adsorption experiment protocol for three types of cultivation soils. Freundlich adsorption coefficients (K) were ranged $0.35{\sim}0.95$ for ethoprophos, $0.98{\sim}2.2$ for iprobenfos, $1.2{\sim}4.3$ for procymidone, $1.5{\sim}3.5$ for isoprothiolane and $7.9{\sim}19$ for butachlor in three soils. Based on Koc values, ethoprophos was classified as mobile, iprobenfos, isoprothiolane and procymidone as moderately mobile and butachlor as slightly mobile. Two evaluation methods, Groundwater Ubiquity Score (GUS) index and standard indices of soil-chemical adsorption and biodegradation, were used for the estimation of pesticide leaching potential. Leachability of isoprothiolane and iprobenfos were evaluated as moderate, ethoprophos as a little potential, while butachlor and procymidone showed very low leaching potential. The leaching potential of pesticides was essentially determined on the basis of intrinsic properties of the pesticides and environmental properties. Among the soil properties, organic matter gave a great influence on the leachability of soils. Therefore, leachabilities of pesticides were expected less in loam with relatively higher organic matter than clay loam with lower organic matter.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.2
• /
• pp.185-192
• /
• 2010

The objective of this study was to investigate the effectiveness of stabilization for army firing range soil highly contaminated with Pb (total Pb: 29,000 mg/kg) using calcined waste oyster shells. The calcination was conducted to activate quicklime from calcite. In order to evaluate the effectiveness of calcination, both natural oyster shells (NOS) and calcined oyster shells (COS) were applied to the Pb contaminated soil. Stabilization was conducted by mixing the contaminated soil with oyster shell media at 5-20 wt% and cured for 28 days. Following 28 days of curing, Pb leachability was measured based on the Korean Standard Test method (0.1 N HCl extraction). The treatment results showed that the COS treatment outperformed the NOS treatment. All of the NOS treatments failed to meet the Korean warning standard of 100 mg/kg. However, the Pb concentrations were significantly reduced to 47 mg/kg and 3 mg/kg upon 15 wt% and 20 wt% COS treatments, respectively which passed the Korean warning standard. Moreover, -#20 mesh materials were more effective than the -#10 mesh materials in effectively reducing Pb leachability. The scanning electron microscopy (SEM)-energy dispersive X-ray spectroscopy (EDX) results indicated that Pb immobilization was strongly linked to Al and Si.

• Resources Recycling
• /
• v.29 no.5
• /
• pp.48-54
• /
• 2020

Sulphuric acid (H₂SO₄) leaching and hydrolysis were experimented for the recovery of titanum dioxide (TiO₂) from the water-leached residue followed by soda-roasting spent SCR catalysts. Sulphuric acid leaching of Ti was carried out with leachate concentration (4~8 M) and the others were fixed (temp.: 70 ℃, leaching time: 3 hrs, slurry density: 100 g/L, stirring speed: 500 rpm). For recovering of Ti from the leaching solution, hydrolysis precipitation was conducted at 100 ℃ for 2 hours in various mixing ratio (leached solution:distilled water) of 1:9 to 5:5. The maximum leachability was reached to 95.2 % in 6 M H₂SO₄ leachate. on the other hand, the leachability of Si decreased dramatically 91.7 to 3.0 % with an increase of H₂SO₄ concentration. Hydrolysis precipitation of Ti was proceeded with leaching solution of 8 M H₂SO₄ with the lowest content of Si. The yield of precipitation increased proportionally with a dilution ratio of leaching solution. Moreover, it increased generally by adding 0.2 g TiO₂ as a precipitation seed to the diluted leaching solution. Ultimately, 99.8 % of TiO₂ can be recovered with the purity of 99.46 % from the 1:9 diluted solution.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.9
• /
• pp.3009-3016
• /
• 2012

This study evaluated the use of iron-impregnated SBA-15 (Fe/SBA-15) as a catalyst for the oxidative degradation of persistent phenol analogues, such as 2-chlorophenol (2-CP), 4-chlorophenol (4-CP), 2-nitrophenol (2-NP), 4-nitrophenol (4-NP) and 2,4,6-trichlorophenol (2,4,6-TCP) in water. The oxidation reactions were carried out with reaction time, concentration of the phenols, amount of the catalysts, reaction temperature, pH of the reaction mixture as the process variables with or without using hydrogen peroxide as the oxidizing agent. The conversion achieved with Fe/SBA-15 at 353 K for 2-CP, 4-CP, 2-NP, 4-NP, 2,4,6-TCP was 80.2, 71.2, 53.1, 62.8, 77.3% in 5h with a reactant to $H_2O_2$ mole ratio of 1:1, and 85.7, 65.8, 61.9, 63.7, 78.1% in the absence of $H_2O_2$, respectively. The reactions followed pseudo first order kinetics. The leachability study indicated that the catalyst released very little iron into water and therefore, the possibility of secondary pollution is negligible.

• Journal of Industrial Technology
• /
• v.20 no.A
• /
• pp.57-62
• /
• 2000

This experiment was done to investigate the leaching and adsorption properties of heavy metals on porphyry. The comparison with respect to the leachability of heavy metals from porphyry between the Korea Standard Leaching Test (KSLT) and the Toxicity Characteristic Leaching Procedure (TCLP) was carried out. The fractional composition of leachate and the total concentration of heavy metal of porphyry were studied through Sequential Extraction Procedure (SEP) and EPA Method 3050. Adsorption experiment of porphyry has pointed out that the optimum dosage of porphyry for 50ppm Pb was over 10g/L, the effective particle size for absorption was below 200 mesh and the optimum pH was about 7. From the Freundlich' adsorption equation, 1/n was 1.0722, and k was 0.0041. After adsorption, the fractional composition of Pb was changed. The exchangeable, carbonate, reducible fractions were increased, and the organic fraction was not changed, and the residual fraction was decreased.