• Journal of the Korean Home Economics Association
• /
• v.20 no.2
• /
• pp.45-51
• /
• 1982

Degree of separation and adhesion of dye and stain particles has been measured usually by the rate of reflection of light. However, it could be proved that the relation between the quantity of stain and the rate of reflection greatly varied with kinds of stain and states of adhesion. For this study, several pieces of cotton and polyester having different states of stain adhesion were prepared by staining them with two kinds of artificial stain different in color: Ferric Oxide and Ferric Oxynate. Every piece went through soilremoval test which employed two surfactants: Anionic LAS and Cationic M2-100. After the operation, relations between quantity of pre-soilremoval stain and rate of reflection were measured, as well as those between quantity of post-soilremoval stain and rate of reflection. Rate of reflection and quantity of stain were not proportional in measurement to the pieces stained with Ferric Oxide and Ferric Oxynate. The consequence was also the same with cotton and polyester. That held true of the fat-stained textile. With the same quantity of stain, rate of reflection varied according to the magnitude of stain particles, and the state of adhesion influenced the magnitude of stain particles a great deal.

• IE interfaces
• /
• v.16 no.spc
• /
• pp.21-27
• /
• 2003

Objective of this paper is to develop the user mobility model(UMM) which is used for the performance analysis of location update and paging algorithm and at the same time, consider the user mobility pattern(UMP) in zone-based cellular networks. User mobility pattern shows correlation in space and time. UMM should consider these correlations of UMP. K-dimensional Markov chain is presented as a UMM considering them where the states of Markov chain are defined as the current location area(LA) and the consecutive LAs visited in the path. Also, a new two dimensional Markov chain composed of current LA and time interval is presented. Simulation results show that the appropriate size of K in the former UMM is two and the latter UMM reflects the characteristic of UMP well and so is a good model for the analytic method to solve the performance of location update and paging algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.6A
• /
• pp.929-938
• /
• 2001

CDMA 2000 1X EV.(HDR, 1XTREME, LAS-CDMA)에서는 고속데이터 전송을 위한 변조방식으로 M-ary QAM을 제안하고 있다. 그러나, M-ary QAM을 사용한 DS-CDMA 시스템은 고속 데이터 전송이 가능한 반면에 M-ary 수가 증가할수록 잡음(AWGN)과 타 사용자에 의한 다중접속간섭(MAI)의 영향이 커져 비트에러율(BER)이 증가하고 채널용량이 급격히 줄어드는 문제점이 있다. 따라서, DS-CDMA/M-ary QAM 시스템에서 많은 사용자에게 고속의 데이터 서비스를 제공하기 위해서는 잡음을 줄이거나 MAI를 경감시킬 수 있는 성능 개선 기법이 요구된다. 본 논문에서는 성능 개선 기법으로서 다단병렬간섭제거기(MPIC : Multistage Parallel Interference Canceller)와 부분 다단병렬간섭제거기(partial MPIC)를 채용한 비동기 DS-CDMA/M-ary QAM 시스템의 성능 개선을 이론적으로 분석하고 이를 검증하기 위한 컴퓨터 시뮬레이션을 수행하였다. 결과에서, MPIC와 partial MPIC를 채용함으로써 4 QAM, 16 QAM 및 64 QAM을 사용한 DS-CDMA 시스템의 BER과 채널용량이 크게 개선됨을 확인하였다. MPIC를 채용한 경우는 AWGN 채널의 BER에 근접하였다. 또한, MPIC는 partial MPIC보다 BER 성능이 우수하였으며 더 많은 채널용량 개선을 달성하였다. 그러나, MPIC는 partial MPIC 보다 계산량이 훨씬 많고 복잡한 구조를 갖기 때문에 실제 시스템 구현에 있어서 성능과 복잡도 사이에 타협(tradeoff)이 필요하다.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.1
• /
• pp.57.1-57.1
• /
• 2011

It has been suggested that merging plays an important role in the formation and the evolution of early-type galaxies (ETGs). Optical-NIR color gradients of ETGs in high density environments are found to be less steep than those of ETGs in low density environments, hinting frequent merger activities in ETGs in high density environments. In order to examine if the flat color gradients are the result of dry mergers, we studied the relations between merging features, color gradient, and environments of 281 low redshift ETGs selected from Sloan Digital Sky Survey (SDSS) Stripe82. The sample contains 222 relaxed ETGs, 38 ETGs with tidal features, 10 galaxies with dust features and 11 galaxies with tidal and dust features, and Near Infrared (NIR) images are taken from UKIRT Infrared Deep Sky Survey (UKIDSS) Large Area Survey (LAS). We find that r-K color gradients of field sample galaxies are steeper than those of sample ETGs within cluster environments. For the field sample galaxies, a relatively large number of galaxies with peculiar features contribute to the steeper color gradients, while the absence of these peculiar early-type galaxies make color gradients of the cluster sample galaxies intact. In high density environment, ETGs are already evolved and relaxed, resulting flat color gradients. However, in low density environments, a majority of ETGs undergone merging recently which makes the color gradients steep.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 1993.06a
• /
• pp.907-910
• /
• 1993

This paper describes the use of fuzzy control and decision making to simulate the control of traffic flow at an intersection. To show the value of fuzzy logic as an alternative method for control of traffic environments. A traffic environment includes the lanes to and from an intersection, the intersection, vehicle traffic, and signal lights in the intersection. To test the fuzzy logic controller, a computer simulation was constructed to model a traffic environment. A typical cross intersection was chosen for the traffic environment, and the performance of the fuzzy logic controller was compared with the performance of two different types of conventional control. In the hardware verifications, fuzzy logic was used to control acceleration of a model train on a circular path. For the software experiment, the fuzzy logic controller proved better than conventional control methods, especially in the case of highly uneven traffic flow between different directions. On the hardware si e of the research, the fuzzy acceleration control system showed a marked improvement in smoothness of ride over crisp control.

• Membrane Journal
• /
• v.4 no.2
• /
• pp.106-112
• /
• 1994

The ultrafiltration(UF) and reverse osmosis(RO) tests for a model metal plating wastewater prepared with zinc sulfate, showed the zinc ion rejection coefficient of over 99% and the permeate flux of $1.49 {\times} 10^{-3}cm/sec$ at pH = 8.3. The effect of cyanide on the zinc removal was investigated. When the amount of cyanide addition was same the zinc content, the zinc was removed over 99% and the cyanide was excluded about 93%. The addition of the surfactants such a LAS-Na and EDTA-Na was found to reduce the permeate flux down to $0.76 {\times} 10^{-3}cm/sec$ at the RO membrane.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.415-415
• /
• 2010

면방전 구조의 AC-PDP는 페닝 혼합 기체 중에서 Xe 플라스마에서 발생되는 VUV (Vacuum Ultra Violet) 에 의해 들뜬 형광체로부터 가시광이 발생된다. Xe 여기종은 828 nm의 공명준위를 거쳐 147 nm의 진공자외선을 방출하며 823 nm의 준안정준위에서 분자선을 거쳐 173 nm의 진공 자외선을 낸다. 이러한 Xe 여기종의 밀도를 측정하기 위해서는 828 nm와 823 nm의 레이저를 외부에서 인위적으로 조사하여 측정하면 IR (Infrared)의 흡수전과 흡수후의 빛의 세기로 Xe 여기종의 밀도 및 분포를 계산할 수 있다. 본 실험에서는 823 nm에 초점을 두었으며 LAS (Laser Absorption Spectroscopy) 기법을 통하여 He-Ne-Xe(15%, 20 %, 30%) 400Torr의 3종 기체의 Xe 함량에 따른 시공간의 Xe($1s_5$) 여기종 밀도 분포와 방전효율을 관측하였다. 최근 3전극 면방전형 AC-PDP 효율 향상을 위해 3종 기체의 Xe함량비의 방전기체에 대한 연구가 수행되고 있다. 이러한 기초 데이터는 혼합기체 조건에 따른 면방전 구조의 3전극 AC-PDP의 발광 효율을 개선하는 데 유용한 자료로 활용될 것이다.

• Asian-Australasian Journal of Animal Sciences
• /
• v.32 no.8_spc
• /
• pp.1306-1320
• /
• 2019

Goat population world-wide is increasing, and the dairy goat sector is developing accordingly. Although the new technology applied to the goat industry is being introduced slowly because the weight of traditional subsector in the dairy sector, considerable advances have been made in the last decade. Present review focuses on the emerging topics in the dairy goat sector. Research and development of traditional and new dairy goat products are reviewed, including the new research in the use of goat milk in infant formula. The research in alternatives to brine, production of skimmed goat cheeses and the use of different modified atmosphere packaging are also addressed. Special attention is given to antibiotic residues and their determination in goat milk. Functional foods for human benefits are a trending topic. Health properties recently discovered in dairy goat products are included in the paper, with special attention to the antioxidant activity. The dual-purpose use of goats by humankind is affecting the way of how new technology is being incorporated in the dairy goat sector and will certainly affect the future development of dairy goat products.

• Natural Product Sciences
• /
• v.25 no.2
• /
• pp.172-180
• /
• 2019

Infections with Pseudomonas aeruginosa are difficult to treat not only because it is often associated with multidrug-resistant infections but also it is able to form biofilm. The aim of this study was to evaluate the antibiofilm and anti-Quorum Sensing (QS) activities of Thymbra capitata essential oils (EOs) against Beta Lactamase (BL) producing P. aeruginosa and the reference strain P. aeruginosa 10145. GC/MS analysis showed that thymol (23.25%) is the most dominant compound in T. capitata EOs. The MICs of T. capitata EOs against P. aeruginosa (BL) and P. aeruginosa 10145 were 1.11%. At sub MIC (0.041, 0.014 and 0.0046%), the EOs of T. capitata remarkably inhibited the biofilm formation of both strains tested and complete inhibition of the biofilm formation was reported at 0.041%. The EOs of T. capitata were found to inhibit the swarming motility, aggregation ability and hydrophobic ability of P. aeruginosa (BL) and P. aeruginosa 10145. Interestingly, the EOs of T. capitata reduce the production of three secreted virulence factors that regulated by QS system including pyocyanin, rhamnolipids and LasA protease. The potent antibiofilm and anti-QS activities of T. capitata EOs can propose it as a new antibacterial agent to control pseudomonas infections.

• Journal of Powder Materials
• /
• v.29 no.4
• /
• pp.309-313
• /
• 2022

In this study, additive manufacturing of a functionally graded material (FGM) as an alternative to joining dissimilar metals is investigated using directed energy deposition (DED). FGM consists of five different layers, which are mixtures of austenitic stainless steel (type 316 L) and low-alloy steel (LAS, ferritic steel) at ratios of 100:0 (A layer), 75:25 (B layer), 50:50 (C layer), 25:75 (D layer), and 0:100 (E layer), respectively, in each deposition layer. The FGM samples are successfully fabricated without cracks or delamination using the DED method, and specimens are characterized using optical and scanning electron microscopy to monitor their microstructures. In layers C and D of the sample, the tensile strength is determined to be very high owing to the formation of ferrite and martensite structures. However, the elongation is high in layers A and B, which contain a large fraction of austenite.