• 한국환경농학회지
• /
• 제30권2호
• /
• pp.99-104
• /
• 2011

BACKGROUND: Application of urea may increase $CO_2$ emission from soils due both to $CO_2$ generation from urea hydrolysis and fertilizer-induced decomposition of soil organic carbon (SOC). The objective of this study was to investigate the effects of increasing urea application on $CO_2$ emission from soil and mineralization kinetics of indigenous SOC. METHODS AND RESULTS: Emission of $CO_2$ from a soil amended with four different rates (0, 175, 350, and 700 mg N/kg soil) of urea was investigated in a laboratory incubation experiment for 110 days. Cumulative $CO_2$ emission ($C_{cum}$) was linearly increased with urea application rate due primarily to the contribution of urea-C through hydrolysis to total $CO_2$ emission. First-order kinetics parameters ($C_0$, mineralizable SOC pool size; k, mineralization rate) became greater with increasing urea application rate; $C_0$ increased from 665.1 to 780.3 mg C/kg and k from 0.024 to 0.069 $day^{-1}$, determinately showing fertilizer-induced SOC mineralization. The relationship of $C_0$ (non-linear) and k (linear) with urea-N application rate revealed different responses of $C_0$ and k to increasing rate of fertilizer N. CONCLUSION(s): The relationship of mineralizable SOC pool size and mineralization rate with urea-N application rate suggested that increasing N fertilization may accelerate decomposition of readily decomposable SOC; however, it may not always stimulate decomposition of non-readily decomposable SOC that is protected from microbial decomposition.

• Environmental Engineering Research
• /
• 제24권2호
• /
• pp.202-210
• /
• 2019

In order to maximize the utilization of sewage sludge, a waste from wastewater treatment facility, the residual sewage sludge generated after lipid and carbohydrate extraction for biodiesel and bioethanol production was used to produce bio-oil by pyrolysis. Thermogravimetric analysis showed that sludge pyrolysis mainly occurred between 200 and $550^{\circ}C$ (with peaks formed around 337.0 and $379.3^{\circ}C$) with the decomposition of the main components (carbohydrate, lipid, and protein). Bio-oil was produced using a micro-tubing reactor, and its yield (wt%, g-bio-oil/g-residual sewage sludge) increased with an increase in the reaction temperature and time. The maximum bio-oil yield of 33.3% was obtained after pyrolysis at $390^{\circ}C$ for 5 min, where the largest amount of energy was introduced into the reactor to break the bonds of organic compounds in the sludge. The main components of bio-oil were found to be trans-2-pentenoic acid and 2-methyl-2-pentenoic acid with the highest selectivity of 28.4% and 12.3%, respectively. The kinetic rate constants indicated that the predominant reaction pathway was sewage sludge to bio-oil ($0.1054min^{-1}$), and subsequently to gas ($0.0541min^{-1}$), rather than the direct conversion of sewage sludge to gas ($0.0318min^{-1}$).

• 한국환경과학회지
• /
• 제30권6호
• /
• pp.429-439
• /
• 2021

Food waste is both an industrial and residential source of pollution, and there has been a great need for food waste reduction. As a preliminary step in this study, waste reduction is quantitatively modeled. This study presents two models based on kinetics: a simple kinetic model and a mass transport-shrinking model. In the simple kinetic model, the smaller is the reaction rate constant ratio k₁, the lower the rate of conversion from the raw material to intermediate products. Accordingly, the total elapsed reaction time becomes shorter. In the mass transport-shrinking model, the smaller is the microbial decomposition resistance versus the liquid mass transfer resistance, the greater is the reduction rate of the radius of spherical waste particles. Results showed that the computed reduction of waste mass in the second model agreed reasonably with that obtained from a few experimantal trials of biodegradation, in which the microbial effect appeared to dominate. All calculations were performed using MATLAB 2020 on PC.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2005년도 춘계학술대회논문집
• /
• pp.836-839
• /
• 2005

The in-plane vibration response of a clamped circular plate should be predicted in many applications. Up to now, papers on the in-plane vibration of rectangular plate are published. However, analytical derivation on the in-plane vibration of the clamped circular plate is not carried out. Therefore, the in-plane vibration of the clamped circular plate is the concern of this paper. In order to derive the equations of motion for the clamped circular plate in the cylindrical coordinate, the kinetic energy and potential energy for the in-plane behavior are obtained by us ing the stress-strain-displacement expressions. Application of Hamilton's principle leads to two sets of differential equations. These displacement equations were highly coupled. It is possible to obtain a simpler set of equations by introducing Helmholtz decomposition. Substituting them into the coupled differential equations, we obtain the uncoupled equations of motion. In order to solve them, we assume that the solutions are harmonic. Then, they lead to the wave equations. Using the separation of variable, we obtain the general solutions for the equations. Based on the solutions, the displacements for r and $\theta$ direction are assumed. Finally we obtain the frequency equation for the clamped circular plate by the application of boundary conditions. The derived equation is compared with the finite element analysis for validation by using the some numerical examples.

• Fibers and Polymers
• /
• 제5권4호
• /
• pp.289-296
• /
• 2004

The kinetic parameters, including the activation energy E, the reaction order n, and the pre-exponential factor Z, of the degradation of the copolymers based on the poly(L-lactide) (PLLA) or poly(p-dioxanone-co-L-lactide) (PDO/PLLA) and diol-terminated poly(ethylene glycol) (PEG) segments have been evaluated by the single heating methods of Friedman and Freeman-Carroll. The experimental results showed that copolymers exhibited two degradation steps under nitrogen that can be ascribed to PLLA or PDO/PLLA and PEG segments, respectively. However, copolymers exhibited almost single degradation step in air. Although the values of initial decomposition temperature were scattered, copolymers showed the lower maximum weight loss rate and degradation-activation energy in air than in nitrogen whereas the higher value of temperature at the maximum rate of weight loss was observed in air.

• 한국응용과학기술학회지
• /
• 제8권2호
• /
• pp.145-151
• /
• 1991

Hazadous properties were evaluated for Alkyl nitrates such as hexyl nitrate, decyl nitrate, dodecyl nitrate and 2-methyl pentyl nitrate, 2-hexyl ethyl nitrate. The thermochemical properties such as heat of vaporization, boiling point, flash point and kinetic parameter for aliphatic nitrate were measured to determine the hazadous properties of these compounds. The boiling points and heat of vaporization increase as the increase of alkyl chain length in alkyl nitrates. Flash point is a linear function of boiling point as same as alkanes. The rate equation in isothermal decomposition are 1/2 order and compensation effect is found between logarithm of frequency factor the activation energy, then the decomposition preceeds with simlar reaction mechanism for each nitrate.

• Nuclear Engineering and Technology
• /
• 제51권3호
• /
• pp.746-754
• /
• 2019

Vitrification of radioactive liquid waste (RLW) provides a feasible solution for isolating radionuclides from the biosphere for an extended period. In vitrification, base glass and radioactive waste are added simultaneously into the melter. Determination of heat and mass transfer rates is necessary for rational design and sizing of melter. For obtaining an assured product quality, knowledge of reaction kinetics associated with the thermal decomposition of waste constituents is essential. In this study Thermogravimetry (TG) - Differential Thermogravimetry (DTG) of eight kinds of nitrates and two oxides, which are major components of RLW, is investigated in the temperature range of 298-1273 K in the presence of base glasses of five component (5C) and seven component (7C). Studies on thermal behavior of constituents in RLW were carried out at heating rates ranging from 10 to $40\;K\;min^{-1}$ using TG - DTG. Thermal behavior and related kinetic parameters of waste constituents, in the presence of 5C and 7C base glass compositions were also investigated. The activation energy, pre-exponential factor and order of the reaction for the thermal decomposition of 24% waste oxide loaded glasses were estimated using Kissinger method.

• 한국식품과학회지
• /
• 제13권3호
• /
• pp.188-193
• /
• 1981

Potassium biphthalate buffer와 쌀, 버섯, 쇠고기에서의 pantothenic acid 열분해속도(熱分解速度)에 미치는 온도(溫度)와 pH의 영향(影響)을 검토하였다. 완충액시료와 식품시료에서의 pantothenic acid 열분해반응(熱分解反應)은 $60{\sim}140^{\circ}C$에서 1차(次) 반응(反應)을 나타내었다. 또한 Arrhenius식(式)으로부터 구한 활성화에너지(Ea)는 $15,700{\sim}17,300\;cal/mole$이었다. 식품시료와 완충액시료의 $D_{120}$을 비교해 본 결과 식품시료가 약 18시간(時間)으로 완충액시료의 15.4시간(時間)보다 높은 것으로 식품시료가 열(熱)에 보다 안정함을 나타내었다. 식품시료와 완충액시료가 모두 $p{\geq}6.46$인 경우에 pH가 증가함에 따라 반응속도상수(反應速度常數)는 증가하였으며 Ea는 감소하였다. 이 실험 결과를 바탕으로 두 pH 범위에서 반응속도상수(反應速度常數)의 온도(溫度) 및 pH 변화에 따론 예측(豫測)모형(模型)을 설정하였다.

• 대한화학회지
• /
• 제54권2호
• /
• pp.192-197
• /
• 2010

형광체나 반도체의 소자로 사용되는 전이금속화합물 중에서 나노(nano) 크기를 가지는 스피넬 화합물을 합성하였다. 스피넬 화합물의 크기, 합성여부, 열적분석과 화합물의 특성을 확인하기 위하여 열 중량 분석기(TGA), X-선 회절 분석기(XRD), 적외선 흡수 분광기(IR)를 사용하였다. Scherrer식을 이용하여 화합물의 평균 입자 크기가 13~16 nm임을 예측할 수 있었다. 본 논문에 사용된 실험방법은 졸-겔(sol-gel)법을 사용하였으며, 소성 온도는 낮은 온도에서 진행 되었다($350^{\circ}C$). Kinetic 함수인 활성화 에너지와 전환인자를 계산하기 위해서 Kissinger방법과 Arrhenius식을 이용하여 계산하였다. $ZnCo_2O_4$와 $NiCo_2O_4$의 활성화 에너지는 163.42 kJ/mol와 147.01 kJ/mol 값을 가지는 있음을 확인하였다. 그리고 spinel 화합물들의 열역학적 함수(${\Delta}G^{\varphi}$, ${\Delta}H^{\varphi}$, ${\Delta}S^{\varphi}$)를 결정하였다.

• 한국환경과학회지
• /
• 제26권7호
• /
• pp.859-868
• /
• 2017

In this study, the reductive dechlorination of triclosan using zero-valent iron (ZVI, $Fe^0$) and modified zero-valent iron (i.e., acid-washed iron (Aw/Fe) and palladium-coated iron (Pd/Fe)) was experimentally investigated, and the reduction characteristics were evaluated by analyzing the reaction kinetics. Triclosan could be reductively decomposed using zero-valent iron. The degradation rates of triclosan were about 50% and 67% when $Fe^0$ and Aw/Fe were used as reductants, respectively, after 8 h of reaction. For the Pd/Fe system, the degradation rate was about 57% after 1 h of reaction. Thus, Pd/Fe exhibited remarkable performance in the reductive degradation of triclosan. Several dechlorinated intermediates were predicted by GC-MS spectrum, and 2-phenoxyphenol was detected as the by-product of the decomposition reaction of triclosan, indicating that reductive dechlorination occurred continuously. As the reaction proceeded, the pH of the solution increased steadily; the pH increase for the Pd/Fe system was smaller than that for the $Fe^0$ and Aw/Fe system. Further, zero-order, first-order, and second-order kinetic models were used to analyze the reaction kinetics. The first-order kinetic model was found to be the best with good correlation for the $Fe^0$ and Aw/Fe system. However, for the Pd/Fe system, the experimental data were evaluated to be well fitted to the second-order kinetic model. The reaction rate constants (k) were in the order of Pd/Fe > Aw/Fe > $Fe^0$, with the rate constant of Pd/Fe being much higher than that of the other two reductants.