• 전자공학회논문지CI
• /
• 제44권4호통권316호
• /
• pp.45-49
• /
• 2007

송신 시스템과 수신 시스템에 동일한 주파수를 사용하는 pulse-modulated 방식의 RFID (Radio Frequency IDentification) 시스템에서 송신 시스템과 수신 시스템 사이의 isolation특성은 중요한 문제점이다. 제안된 방법은 송신 시스템에 스위치와 믹서 오실레이터를 사용하여 RFID 시스템의 송신 시스템과 수신 시스템 사이의 isolation 특성을 개선하였다. 제안된 시스템은 송신 시스템에서 up-convert된 출력 신호와 수신 신호의 주파수를 다르게 하여 isolation 특성을 개선한 것이다. 이 방법을 사용하여 20 dB의 isolation 특성 개선 효과를 얻었다.

• 의료ㆍ복지 건축 : 한국의료복지건축학회 논문집
• /
• 제23권4호
• /
• pp.67-75
• /
• 2017

Purpose: This study is for the facility eligibility and improvement evaluation analysis for the patient care environment of 7 facilities which has national inpatient isolation units. Methods: For the evaluation, first of all, the patient care environment of national inpatient isolation units are scrutinized by the checklist which is used on from 2014 with the 4 fields of criteria : architectural planning and layout, general requirement and condition for operating the negative pressured isolated patient room, HVAC system, and waste water discharging system. Finally, the evaluation results are compared with that of 2014. Results: The result shows that the average value of facility eligibility is 89.3 percent and which is 8.9 percent higher than the value before the MERS occurred. Implications: It is clear that facility remodeling of 7 institutions is being performed continuously, and the result of facility eligibility evaluation is reflected on design of a new 21 national inpatient isolation units those are going to be constructed from 2016. Therefore, it is expected that this study is used as a practical reference to establish the criteria of patient care environment management and safety management for both infectious disease outbreak and general service condition.

• Journal of electromagnetic engineering and science
• /
• 제16권4호
• /
• pp.206-209
• /
• 2016

This letter proposes a reconfigurable directional coupler that uses a variable impedance mismatch reflector to achieve high isolation characteristics in the antenna front end. The reconfigurable coupler consists of a directional coupler and a single-pole four-throw (SP4T) switch with different load impedances as a variable load mismatch reflector. Selection of the load impedance by the reflector allows cancellation of the reflected signal due to antenna load mismatch and the leakage from the input to isolation port of the directional coupler, resulting in high isolation characteristics. The performance of the proposed architecture in separating the received (Rx) signal from the transmitted (Tx) signal in the antenna front end was verified by implementing and testing the reconfigurable coupler at 917 MHz for UHF radio-frequency identification (RFID) applications. The proposed reconfigurable directional coupler showed an improvement in the isolation characteristics of more than 20 dB at the operation frequency band.

• 의료ㆍ복지 건축 : 한국의료복지건축학회 논문집
• /
• 제27권3호
• /
• pp.61-69
• /
• 2021

Purpose: Senior long-term care facilities are vulnerable to a cluster infection because of frequent physical contact, large group dining, communal living, and room sharing. This study aims to provide architectural improvement plans for a quarantine system in the facilities. Methods: Actual quarantine action data, guidelines from governments and institutes, in-depth interviews with facility staff are analyzed. Results: To prevent a cluster infection in the senior facilities, it is necessary to provide an architectural plan focusing on increasing the number of single rooms and isolation rooms, providing isolation rooms for staff, separation of a soiled room from a clean room, planing an entry vestibule and a visitor's room. Implications: It is important to analyze the existing condition of facilities that had been going through cohort isolation and provide the architectural solution to strengthen infection control.

• Earthquakes and Structures
• /
• 제24권3호
• /
• pp.193-204
• /
• 2023

The concept of meta-material-based isolation systems (MMIS) for structural columns has been revisited in the present study in order to enhance the stability of rubber pads by using steel shim reinforced rubber (SSRR) layers. Analytical calculations have shown a significant improvement in the stability of MMIS with SSRR pads. Finite element analysis has also been conducted to further show the reduced response of a bridge with the modified MMIS under excitations having frequencies within the corresponding attenuation zone (AZ) as compared to the response of a conventional bridge without MMIS. FE analysis further shows the stress generated on the bridge with MMIS systems are within safe limits. Finally, a generalized procedure has been developed to design bridge columns with the proposed modified MMIS.

• 한국안전학회지
• /
• 제37권3호
• /
• pp.45-51
• /
• 2022

This paper focuses on a recently proposed asymmetric base-isolation coupling control system (ABiCS) for the vibration control of adjacent twin buildings. The ABiCS consists of inter-story diagonal dampers, a connecting damper between the two buildings, and a seismic isolation device at the base floor of one building. To investigate the control characteristics of ABiCS, a parametric study was performed by numerically simulating the 20-story twin buildings. In the parametric study, the control capacities of the inter-story diagonal dampers, connecting damper, and seismic isolation device were considered as varying parameters. The parametric study results indicate that the connecting damper between the two buildings reduces the responses of both buildings only at optimal or near-optimal capacity. In addition, adjusting the stiffness of the base isolation is found to be the most effective method for improving seismic performance and achieving cost-effectiveness. Accordingly, we presented a scenario-based performance improvement approach in which reducing the stiffness of the base isolation device could be an effective technique to improve the seismic performance of both buildings. However, note that checking the maximum allowable displacement of the base isolation device is essential.

• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2006년도 추계학술발표회 초록집
• /
• pp.77-77
• /
• 2006

• 전기학회논문지
• /
• 제60권9호
• /
• pp.1727-1732
• /
• 2011

In order to realize a high performance(low loss, high isolation) microwave power divider/combiner, we have designed the power combiner/divider precisely in accordance with the different hight of central part. In the case of the high central part of the hight of $h_r$=10.2, a compensating part of the conical line is inserted in the conical conversion transmission line, and in the case of low central part of the hight of $h_r$=5.0, the conical conversion transmission line is remodeled into the 2-stage bend structure. In both case, the reflection characteristics are improved to 30dB over the operating frequency range of 5GHz bandwidth. A resistance is inserted between the peripheral ports so as to try to improve the isolation characteristics of the device. For the 16-divider/combiner, the isolation characteristics are improved to 10dB over the operating frequency range of 5GHz bandwidth.

• 품질경영학회지
• /
• 제51권4호
• /
• pp.715-734
• /
• 2023

Purpose: Authors suggest a new alternative of preparedness capabilities for health care institutes to react to the new types of communicable diseases and the pandemic situations through the quality improvement and advancement of Negative Pressure Isolation Stretcher (NPIS). Methods: We employed FOCUS-PDCA, a representative quality improvement model. First, we identified and materialized necessary components of existing NPIS to be improved. Second, we fabricated an advanced NPIS prototype. Third, we carried out a performance test by the accreditation institute and an empirical evaluation at the communicable diseases trauma center, to locate the improvement pain points of the prototype. Finally, we draw a conclusion on quality improvement points to be considered during the production stage. Results: The suggested, NPIS outperforms the existing one in terms of communicable disease controls, patient treatments and the safety during the patient transfer, and the ease of use. Additionally, the suggested NPIS turns out to be a proper alternative to satisfy the requirements of long range transfer of patients with communicable disease. Conclusion: Authors developed a quality improved, NPIS prototype. There are several points that still remain to be improved. Additionally, we expect that the concurrent use of the suggested NPIS with the existing one will fortify the preparedness capabilities on reacting to the communicable diseases.

• 한국소음진동공학회논문집
• /
• 제21권9호
• /
• pp.858-867
• /
• 2011

As applying an active control technique to a pneumatic vibration isolation system, the settling time for the payload excitation could be remarkably reduced as well as the improvement of isolation performance for the ground vibration. Some previous researches were dealt with the settling time through the simulation or experiment but, the discussion on the simulation or experimental results including moving parts, such as a XY-stage, on the isolation table rarely exists. As considering the moving part, the dynamic model could be time varying system and in such a case the force imposed on pneumatic vibration isolation table could be described by inertial forces of moving parts according to Newton's 3rd law, the action and reaction law. In this paper, the simulation procedure of the 3-DOF active pneumatic vibration isolation system including moving parts by TDC(time delay control) technique is proposed and the effectiveness through simulation results are also shown.