• Journal of Microbiology and Biotechnology
• /
• v.18 no.4
• /
• pp.670-675
• /
• 2008

A laccase was isolated from the culture filtrate of the basidiomycete Fomitella fraxinea. The enzyme was purified to electrophoretical homogeneity using ammonium sulfate precipitation, anion-exchange chromatography, and gel-filtration chromatography. The enzyme was identified as a monomeric protein with a molecular mass of 47 kDa by sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) and gel-filtration chromatography, and had an isoelectric point of 3.8. The N-terminal amino acid sequence for the enzyme was ATXSNXKTLAAD, which had a very low similarity to the sequences previously reported for laccases from other basidiomycetes. The optimum pH and temperature for 2,2'-azino-bis(3-ethylbenzothiazoline-6-sulfonate) (ABTS) were 3.0 and $70^{\circ}C$, respectively. The enzyme also showed a much higher level of specific activity for ABTS and 2,6-dimethoxyphenol (DMP), where the $K_m$ values of the enzyme for ABTS and 2,6-DMP were 270 and $426{\mu}M$, respectively, and the $V_{max}$ values were 876 and $433.3{\mu}M/min$, respectively. The laccase activity was completely inhibited by L-cysteine, dithiothreitol (DTT), and sodium azide, significantly inhibited by $Ni^+,\;Mn^{2+}$, and $Ba^{2+}$, and slightly stimulated by $K^+$ and $Ca^{2+}$.

• Food Science and Biotechnology
• /
• v.17 no.2
• /
• pp.324-329
• /
• 2008

The effect of ultra-high pressure homogenization on the emulsifying properties of whey protein was investigated in a model emulsion made with whey protein isolate and soya oil under various pH. The emulsifying properties, the average diameter of the oil droplets ($d_{vs}$), and the protein load, were measured for each emulsion produced at different homogenization pressures (50 to 200 MPa) and pH values (4.6 to 8.0). According to the results of variance analysis and response surface, the pH had more influence on oil droplet size and protein load than homogenization pressure. The model equations, which were obtained by response surface analysis, show that pH and homogenization pressure had the major effect on oil droplet size and protein load. Higher homogenization pressure decreased the average droplet size and the protein load. Homogenization at high pressure, as opposed to low pressure, causes no overprocessing, but the effect was pH-dependent. The average diameter of the oil droplets increased slightly by decreasing the pH from 8.0 to 6.5 and then increased dramatically toward the isoelectric point of whey protein (i.e., at pH 4.6). Moreover associated droplets were found at acidic pH and their size was increased at high temperature.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.6
• /
• pp.239-243
• /
• 2005

The effect of pH and particle size on the dispersion stability of ultra-fine $BaTiO_3$ suspensions in aqueous medium have been investigated by means of zeta potential, sediment experiments, and powder properties (particle analysis, specific surface area) etc. Zeta potential as a function of pH for two particles of different size increases from -75 to +10 mV with decreasing pH from 8.5 to 1.4. The curve of zeta potential for small particle (150 nm) has slow slope than that of large particle (900nm), giving IEP (isoelectric point) value of pH=1.6 for small particle and pH=1.9 for large particle respectively, which means that it is more difficult to control zeta potential with pH fur small particle than large particle. The dispersion stability of $BaTiO_3$ particles in aqueous medium was found to be strongly related with the agglomeration of colloidal suspensions with time through the sedimentation behaviors of colloidal particles with time and pH value.

• Journal of Environmental Health Sciences
• /
• v.30 no.4
• /
• pp.314-319
• /
• 2004

Glycinin of more than $97\%$ purity was modified using maleic anhydride. Glycinin samples of $0\%,\;65\%,\;and\;95\%$ lysine residue modifications were used to determine the changes in turbidimetric characteristics of the protein due to maleylation. The solubility behavior of the protein as a function of pH was changed with maleylation. The isoelectric point of $65\%\;and\;95\%$ modified glycinin shifted to pH 4.0 and pH 3.5-4.0, respectively, as compared to pH 4.6 for native glycinin. Maleylated glycinins exhibited increased solubility at pH above 4.6. Turbidity of native glycinin decreased substantially by the addition of NaCl, but the stabilizing effect of NaCl decreased when the protein was chemically modified. The effect of NaCl on $65\%$ modified glycinin was intermediate between native glycinin and $95\%$ modified sample. Thermal aggregation of native glycinin was completed within 5 min of heating at $80^{\circ}C$. Maleylation contributed significantly to the thermostability of the protein at pH of 7.0 and 9.0, exhibiting little turbidity. Addition of NaCl suppressed thermal aggregation of native glycinin, but turbidity actually increased for the samples of $65\%\;and\;95\%$ modification.

• Microbiology and Biotechnology Letters
• /
• v.18 no.5
• /
• pp.517-524
• /
• 1990

The solubilization and desolubilization of proteins in CTAB/hexanol/isooctane reverse micellar system were investigated for the selective separation of proteins. Several proteins were used, including bovine serum albumin (BSA), pepsin, trysin and ribonuclease-a. Most proteins could be solubilized into reverse micelles in the pH range above the isoelectric point of each protein, where the net charge of protein was opposite to that of surfactant. However BSA was solubilized above pH 10, which is serveral pH units above the pI 4.9. The kinds of anions in aqueous phase influenced on protein solubilization while no significant trend was observed with different cations, Protein solubilization decreased with increase of the ion size in the order of F -, C1-, Br- and I -. The size of CTAB micelles did not change significantly with increasing ionic strength, but the solubilization decreased. Protein desolubilization showedropposite behaviors to the solubilization. Several model mixtures such as pepsin/ trypsin, pepsin/ribonuclease-a and BSAlribonucleaee-a were successfully separated from each other without changing enzymatic activities.

• Journal of the Korean Ceramic Society
• /
• v.30 no.10
• /
• pp.829-837
• /
• 1993

Chemically and geometrically homogeneous mixing of Si3N4 powders with sintering additives(YAG, 3Y2O3$.$5Al2O3) was attempted via coprecipitation method. X-ray dot maps for the additive elements(Al and Y) showed that the additives are evenly distributed in the powder mixture prepared by coprecipitation method(CP). TEM observation of the coprecipittion-treated Si3N4 powders revealed that they are covered with extremely fine crystallites of additive. The shift in isoelectric point(IEP) of Si3N4 powders from pH 6.7 to pH 7.9 after coprecipitation mixing gave another evidence for coating of Si3N4 powders with YAG additives. SIMS analysis for composition on the surface and in the matrix of mixed powders showed that the YAG additives are highly enriched on the surface of coprecipitation-treated Si3N4 powders. Especially when a small amount of additive was used, the effect of homogeneous additive distribution on densification was preceptible: After pressureless-sintering of powder compacts containing 5 mol% YAG at 1800$^{\circ}C$ for 0.5h, a sintered density of 96.5% theoretical was obtained from the specimens prepared bycoprecipitation in comparison with 93.8% from the mechanically-mixed one.

• Microbiology and Biotechnology Letters
• /
• v.23 no.4
• /
• pp.454-460
• /
• 1995

Acetylxylan esterase II was produced by Escherichia coli HB101 harboring the recombinant plasmid pKMG7 which contained the estII gene of Bacillus stearothermophilus. Optimal medium for the production of the acetylxylan esterase by E. coli HB101/pKMG7 was determined to contain 0.5% galactose, 1% yeast extract and 1% NaCl. The enzyme produced was purified to homogeneity using a combination of 20-50% ammonium sulfate precipitation, DEAE-Sepharose CL-6B chromatography and Sephacryl S-200 gel filtration. The temperature and pH optimum of the esterase were 45$\circ$C and pH 6, respectively. The essential amino acids for the esterase activity were found to be methionine, serine, and cysteine. Molecular weight of the esterase was determined to be 28 kDa by SDS-polyacrylamide gel electrophoresis, and 120 kDa by gel filtration. This suggests that the functional enzyme is a homomeric tetramer. The esterase had an isoelectric point of pH 3.4. The N-terminal amino acid sequence of the enzyme was Ala-Leu-Phe-Glu-Ser-Arg-Phe-Phe-Ser-Glu-Val-Leu-Gly-Leu.

• Journal of Veterinary Clinics
• /
• v.16 no.1
• /
• pp.31-36
• /
• 1999

The aim of this study is to determine the phagocytosis-promoting factor(s) for feline peripheral blood polymorphonuclear cells (PMN) by culture supernatant from mono-nuclear cells (MNC) treated with egg white derivatives (EWD). The phagocytic activity of PMN was analyzed by a flow cytometry system. The EWD did not show direct effect on the phagocytic response of PMN. The phagocytic activity of PMN was enhanced by culture supernatant from MNC but not PMN treated with EWD. Therefore, it was suggested that the enhanced phagocytic activity of feline PMN could be mediated by humoral factor(s) released from MNC treated with EWD. Thus, the phagocytosis-promoting factor(s) in supernatant fraction from MNC culture treated with EWD were isolated by reverse phase high pressure liquid chromatography. The resulting supernatant fraction on 29.02 minutes of retention time showed high phagocytic activity of PMN. The molecular weight of this supernatant fraction was 16 to 18 kDa when analyzed by capillary electrophoresis. The isoelectric point was pH 5.76 when assessed by ion-exchange chromatography. These results suggest that EWD stimulates feline MNC to elaborate a phagocytosis-promoting factor, 16 to 18 kDa of molecular weight, which could be an important mediator for the enhancement of phagocytic activity of feline peripheral blood phagocytes. Further study will be needed to elucidate this phagocytic factor.

• Journal of Microbiology
• /
• v.37 no.3
• /
• pp.148-153
• /
• 1999

Laccase produced by Coriolus hirsutus was purified to electrophoretic homogeneity by acetone precipitation, Sephacryl S-2000 HR chromatography, DEAE Sepharose CL-6B chromatography, and Mono Q HR 5/5 chromatography. The purification of laccase was 46.6-fold with an overall yield of 23.7%. Laccase from this fungus was a monomeric glycoprotein with 16% carbohydrate content, and has an isoelectric point of 4.2, and molecular mass of 78 kDa, respectively. The N-terminal amino acid sequence of the enzyme showed significant homology to hoste of laccases from Coriolus versicolor, Pycnoporus cinnabarius, and an unidentified basidiomycete, PM1. The highest rate of 2,2-azino-bis(3-ethylbenzothiazoline-6-sulfonate) (ABTS) oxidation by laccase was reached at 45$^{\circ}C$, and te pH optima of the enzyme varied depending on the substrate in the range of 2.0 to 4.5. The enzyme was stable at 60$^{\circ}C$ for 5 h and lost 80% activity at 80$^{\circ}C$ in 30 min. The enzyme oxidized a variety of usual laccase substrates including lignin-related phenol, and had the highest affinity toward ABTS. Under standard assay conditions, the apparent Km value of the enzyme toward ABTS was 8.1 ${\mu}$M. The enzyme was completely inhibited by L-cysteine and sodium azide, but not by potassium cyanide, SDS, ad thiourea.

• Journal of Plant Biology
• /
• v.39 no.3
• /
• pp.173-177
• /
• 1996

A novel calcium binding protein (CaBP) was purified to electrophoretic homogeneity from Dunaliella salina. In the course of purification experiment, this CaBP was identified as a monomer and its molecular weight was about 21 kDand isoelectric point (pI) value was about 4.1 using isoelectrofocusing. This CaBP was able to bind Ca2+ even in the pressence of an excess MgCl2 and KCI both in solution. In the SDS-PAGE, the Ca2+-bound form was slower than the Ca2+-free form in the nondenaturing PAGE. This means that the CaBP undergoes conformational change in the Ca2+-bound condition. Furthermore, UV absorption spectrum and fluorescence intensity of this CaBP was investigated. UV absorption peak was appeared at about 258 nm and decreased somewhat in Ca2+-bound condition. In the measurement of fluorescence, maximum intensity was appeared at 303 nm and decreased in Ca2+-bound state, similarly as UV absorption spectrum. These show distinct changes upon Ca2+-binding, which indicate of structural and/or dynamic changes largely reminiscent of other members of the EF-hand Ca2+-binding protein family.