• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.3 s.345
• /
• pp.48-58
• /
• 2006

This paper presents 8x8 two dimensional DCT/IDCT processor of adder-based distributed arithmetic architecture without applying ROM units in conventional memories. To reduce hardware cost in the coefficient matrix of DCT and IDCT, an odd part of the coefficient matrix was shared. The proposed architecture uses only 29 adders to compute coefficient operation in the 2-D DCT/IDCT processor, while 1-D DCT processor consists of 18 adders to compute coefficient operation. This architecture reduced 48.6% more than the number of adders in 8x8 1-D DCT NEDA architecture. Also, this paper proposed a form of new transpose network which is different from the conventional transpose memory block. The proposed transpose network block uses 64 registers with reduction of 18% more than the number of transistors in conventional memory architecture. Also, to improve throughput, eight input data receive eight pixels in every clock cycle and accordingly eight pixels are produced at the outputs.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.23 no.2
• /
• pp.176-184
• /
• 2013

Quantification of road noise is a challenging issue in the development of tire noise since its transfer paths are complicated. In this paper, a simplified model to estimate the road noise is developed. Transfer path of the model is from wheel to interior. The method uses the wheel excitation force estimated throughout inverse method. In inversion procedure, the Tikhonov regularization method is used to reduce the inversion error. To estimate the wheel excitation force, the vibration of knuckle is measured and transfer function between knuckle and wheel center is also measured. The wheel excitation force is estimated by using the measured knuckle vibration and the inversed transfer function. Finally interior noise due to wheel force is estimated by multiplying wheel excitation force in the vibro-acoustic transfer function. This vibro-acoustic transfer function is obtained throughout measurement. The proposed method is validated by using cleat excitation method. Finally, it is applied to the estimation of interior noise of the vehicle with different types of tires during driving test.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.20 no.3
• /
• pp.239-246
• /
• 2007

In this paper a new equivalent static analysis method of dynamic behavior during progressive collapse is presented. The proposed analysis method uses the equivalent nodal load for the element stiffness which represents the dynamic behavior influence caused by the deletion of elements during progressive collapse analysis. The proposed analysis method improves the efficiency of progressive collapse analysis haying the iterative characteristic because the inverse of the structural stiffness matrix is roused in the reanalysis. By comparing the results obtained by this analysis method with those of GSA code analysis and time history analysis, it is shown that the results obtained by this analysis method more closely approach to those of time history analysis than by GSA code analysis.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.231.1-231.1
• /
• 2015

Surface energy, being an important material parameter to control its interactions with the other surfaces plays a key role in bio-related application. Carbon films are found very promising due to their characteristics such as wear and corrosion resistant, high hardness, inert, low resistivity and biocompatibility. The present work deals with the deposition of carbon films using unbalanced facing target magnetron sputtering technique. The discharge characteristics were studied using optical emission spectroscopy and correlated with the film properties. Surface energy was investigated through contact angle measurement. The ID/IG ratio as calculated from Raman spectroscopy data increases with the increase in power density due to the higher number of sp2 clusters embedded in the amorphous matrix. The deposited films were smooth and homogeneous as observed by Atomic force microscopy having RMS roughness in the range of 1.74 to 2.25 nm. It is observed that electrical resistivity and surface energy varies in direct proportionality with operating pressure and has inverse relation with power density. The surface energy results clearly exhibited that these films can have promising applications in cell cultivation.

• Journal of the Institute of Convergence Signal Processing
• /
• v.9 no.4
• /
• pp.295-303
• /
• 2008

In general, transform domain adaptive filters show faster convergence speed than the time domain adaptive filters, but the amount of calculation increases dramatically as the filter order increases. This problem can be solved by making use of the subband structure in transform domain adaptive filters. In this paper, to increase the convergence speed on the generalized subband decomposition FIR adaptive filters, a structure of the adaptive filter with subfilter of dyadic sparsity factor in wavelet transform domain is designed. And, in this adaptive filter, the equivalent input in transform domain is derived and, by using the input, the convergence properties for the LMS algorithm is analyzed and evaluated. By using this sub band adaptive filter, the inverse system modeling and the periodic noise canceller were designed, and, by computer simulation, the convergence speeds of the systems on LMS algorithm were compared with that of the subband adaptive filter using DFT(discrete Fourier transform).

• Journal of Korea Water Resources Association
• /
• v.37 no.12
• /
• pp.1009-1018
• /
• 2004

A systematic method using an optimal estimation algorithm is presented for simultaneous estimation of diffuse pollution distributed along a stream reach and model parameters for a stream water quality model. It was applied with the QVAL2E model to the South Han River for optimal estimation of kinetic constants and diffuse loads along the river. Initial calibration results for kinetic constants selected from a sensitivity analysis reveal that diffuse source inputs for nitrogen and phosphorus are essential to satisfy the system mass balance. Diffuse loads for total nitrogen and total phosphorus were estimated solving the expanded inverse problem. Comparison of kinetic constants estimated simultaneously with diffuse sources to those estimated without diffuse loads, suggests that diffuse sources must be included in the optimization not only for its own estimation but also for adequate estimation of the model parameters. Application of optimization method to river water quality modeling is discussed in terms of the sensitivity coefficient matrix structure.

• Journal of Korean Society of Forest Science
• /
• v.68 no.1
• /
• pp.1-10
• /
• 1985

This study was carried to analyze the structural change of interrelationships between the forestry including forest product processing and the other industrial sectors. The interindustry tables (19 setors) were drawn with the aid of the interindustry table published in 1970, 1975 and 1980 in connection with the forestry and forest product processing. In addition, the input coefficient and inverse matrix coefficient were calculated in the light of the 19 sector of interindustry tables. Owing to the change of economic structure during the period of 1970-1980, the importance of forest in Gross National Product has been decreasing. But it has shown that forestry is a kind of original industry having a great deal of intermediate demand which is constantly increasing. Therefore, forestry could be regarded as a supply industry to other industries. In addition, the import coefficient of forestry products in larger than that of other industries and it keeps increasing.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.4
• /
• pp.860-868
• /
• 2011

Feistel and SPN are the two main structures in a block cipher. Feistel is a symmetric structure which has the same structure in encryption and decryption, but SPN is not a symmetric structure. In this paper, we propose a SPN block cipher so called SSB which has a symmetric structure in encryption and decryption. The proposed SSB is composed of the even numbers of N rounds. Each round consists of a round key addition layer, a subsitution layer, a byte exchange layer and a diffusion layer. The subsitution layer of the odd round is inverse function of one of the even round. And the diffusion layer is a MDS involution matrix. The differential and linear attack probability of SSB is $2^{-306}$ which is same with AES. The proposed symmetric SPN block cipher SSB is believed to construct a safe and efficient cipher in Smart Card and RFID environments which is in limited hardware and software resources.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.12
• /
• pp.764-770
• /
• 2014

It is expected that the techniques of optical imaging through turbid media enables non-invasive imaging through human skin and biological tissues. In recent years, many researches have shown that imaging through turbid media can be made possible by measuring the transmission matrix (TM) of the turbid medium and utilizing it for image recovery. However, this TM based image recovery requires a huge amount of data acquisition and post signal processing of them. Very recently, there were new results that this problem of huge data acquisition and processing can be resolved by using the compressed sensing (CS) framework. CS is a relatively new signal acquisition and reconstruction framework which makes possible to recover the signal of interest correctly with significantly smaller number of signal measurements. In this paper, the TM-based image recovery in imaging through turbid media is reviewed and the recent progress made by using CS is introduced.

• The Journal of the Korea Contents Association
• /
• v.11 no.12
• /
• pp.884-892
• /
• 2011

The analysis of the tourist industry in relation to the general industries is of high use as a means to measure an economic effectiveness as the interest in the policy of service industry increases. From the Input-Output Tables of both 2007 and 2008, Inverse Matrix Coefficients, Imports Requirement Coefficients, and Value Added Requirement Coefficients have been derived. As a result of analysis, the main indexes of the industry-related analysis have almost no differences as compared with those of the 1980s. In spite of the reduction in the scope of the tourist industry in this paper, it is estimated that the reason why the above-mentioned result has been derived is that the influence of today's tourist industry grows bigger than that of the past. In the future studies, the agreement on the classification of tourist industry is requested. In addition, all kinds of calculations have to be derived in general, and the general parts of the tourist industry have to be analyzed in details.