• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.45 no.1
• /
• pp.50-54
• /
• 2000

The elongation of mesocotyl and coleoptile plays important roles in the seedling emergence and stand establishment of dry direct-seeded rice. Experiments were carried out to elucidate the effects of seed-presoaking treatments of GA$_3$ and some inorganic salts on the mesocotyl, and coleoptile elongation of rice. Seed-soaked GA$_3$ promoted the elongation of mesocotyl, but little effect on the coleoptile elongation. The stimulation effects of GA$_3$ were found to be enhanced by addition of CaCl$_2$ However, the sole treatment of CaCl$_2$ showed no stimulating effect on the mesocotyl and coleoptile elongation. Mesocotyl elongation was most prominent in the combined treatments of 50ppm GA$_3$ with 100 mM CaCl$_2$. The synergistic effects of GA$_3$ and CaCl$_2$ on mesocotyl elongation varied with varietal groups. The stimulating effects of GA$_3$ were enhanced significantly by the addition of CaCl$_2$ in japonica varieties, Dongjinbyeo, Ilpumbyeo and Milyang 95, and tall indica variety, Labelle, but not in semidwarf Tongil type varieties, Tongilbyeo, Milyang 23, and Nampungbyeo, and semi-dwarf indica, Short Labelle. The promoting effects of GA$_3$ on the mesocotyl elongation were decreased in proportion to the lowered osmotic potential by PEG 6000 on the contrary to CaCl$_2$ This implies that the synergistic effects of CaCl$_2$ with GA$_3$ on mesocotyl elongation was not caused by osmotic potential lowered by CaCl$_2$ addition but by the salt itself. Salts such as Ca(NO$_3$)$_2$, MgCl$_2$ BaCl$_2$, NaCl, KCl and KNO$_3$ showed the synergistic effects with GA$_3$ on mesocotyl elongation as well. The degree of synergistic effects showed no differences among salts tested, implying that there is no specificity of ions constituting the salts.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.4
• /
• pp.479-488
• /
• 2011

Nanofiltration was performed with polyaluminium chloride solutions at different pH conditions to understand effects of inorganic compounds on aluminum hydrolysis products, i.e., three distinctive groups of aluminum species: polymeric Al at low pH; $Al(OH)_3$ at neutral pH; and ${Al(OH)_4}^-$ at high pH. The PACl solution was prepared to be approximately 4.0mM and adjusted to the designated pH. The influence of inorganic compounds on Al species fouling was investigated with 4.9mM $CaCl_2$ and 3.5mM $MgSO_4$ because $Ca^{2+}$, $Mg^{2+}$, $Cl^-$, ${SO_4}^{2-}$ are the most common inorganics in the drinking water. NF membrane fouling was measured by flux decline rate. The impact of $CaCl_2$ was not significant on the individual Al hydrolysis products fouling. However, the flux decline rate was drastically changed in the presence of $MgSO_4$. The concentration of particulate matters was considerably increased possibly due to interaction between Al species and ${SO_4}^{2-}$ where $MgSO_4$ was introduced. The particulates were accumulated on the membrane and enhanced the hydraulic resistance of the cake layer. In addition, conductivity removal of the membrane was decreased when Al-hydroxide was dominant due to reduction of membrane surface charge. The rejection of $Ca^{2+}$and $Mg^{2+}$ were considerably different, which implys that composition of inorganics paly a role on conductivity removal.

• Macromolecular Research
• /
• v.15 no.2
• /
• pp.95-99
• /
• 2007

The most recent developments in two areas: (a) synthesis of inorganic particles with control over size and shape by polymer additives, and (b) synthesis of inorganic-polymer hybrid materials by bulk polymerization of blends of monomers with nanosized crystals are reviewed. The precipitations of inorganics, such as zinc oxide or calcium carbonate, in presence and under the control of bishydrophilic block or comb copolymers, are relevant to the field of Biomineralization. The application of surface modified latex particles, used as controlling agents, and the formation of hybrid crystals in which the latex is embedded in otherwise perfect crystals, are discussed. The formation of nano sized spheres of amorphous calcium carbonate, stabilized by surfactant-like polymers, is also discussed. Another method for the preparation of nanosized inorganic functional particles is the controlled pyrolysis of metal salt complexes of poly(acrylic acid), as demonstrated by the syntheses of lithium cobalt oxide and zinc/magnesium oxide. Bulk polymerization of methyl methacrylate blends, with for example, nanosized zinc oxide, revealed that the mechanisms of tree radical polymerization respond to the presence of these particles. The termination by radical-radical interaction and the gel effect are suppressed in favor of degenerative transfer, resulting in a polymer with enhanced thermal stability. The optical properties of the resulting polymer-particle blends are addressed based on the basic discussion of the miscibility of polymers and nanosized particles.

• Korean Journal of Environmental Agriculture
• /
• v.30 no.4
• /
• pp.419-423
• /
• 2011

BACKGROUND: Inorganic component is made up largely of salt, because the criteria are difficult to split into domestic and imported ingredients, organic examined the fatty acid composition is to see a possible use as a marker using gas chromatography-mass spectrometry (GC-MS). The 14 domestic samples and 8 imported samples were collected from China, India and other countries were investigated on item of 37 fatty acids. METHODS AND RESULTS: The major components were six species, myristic acid ($C_{14:0}$), palmitic acid ($C_{16:0}$), palmitoleic acid ($C_{16:1}$), stearic acid ($C_{18:0}$), oleic acid ($C_{18:2,n9}$), linoleic acid ($C_{18:2,n6}$) among detected twenty fatty acids including 9 unknowns. The content of palmitic acid were highest as 25.2 to 50.8% of total fatty acids contents. Domestic has seen the most amount of salt in the Taepyeong salts $250.8{\mu}g$/100g, imports $135.2{\mu}g$/100g salt in Chinese Weifang salts showed the lowest content. CONCLUSION(s): The total fatty acid content has seen the most amount of salt in 352.3 ug/100g Christmas island salts showed the lowest content of $164.0{\mu}g$/100g, as a result it is difficult to distinguish the domestic salts and imported by the composition of fatty acid.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.64.2-64.2
• /
• 2010

In order to improve the overall power conversion efficiency in dye-sensitized solar cells (DSSCs), it is very important to secure the sufficient surface area of photocatalytic nanoparticles layer for absorbing dye molecules. It is because increasing the amount of dye absorbed generally results in increasing the amount of light harvesting. In this work, we proposed a new method for increasing the specific surface area of photocatalytic titanium oxide ($TiO_2$) nanoparticles by using an inorganic templating method. Salt-$TiO_2$ composite nanoparticles were synthesized in this approach by spray pyrolyzing both the titanium butoxide and sodium chloride solution. After aqueous removal of salt from salt-$TiO_2$ composite nanoparticles, mesoporous $TiO_2$ nanoparticles with pore size of 2~50 nm were formed and then the specific surface area of resulting porous $TiO_2$ nanoparticle was measured by Brunauer-Emmett-Teller (BET) method. Generally, commercially available P-25 with the average primary size of ~25 nm $TiO_2$ nanoparticles was used as an active layer for dye-sensitized solarcells, and the specific surface area of P-25 was found to be ~50 $m^2/g$. On the other hand, the specific surface area of mesoporous $TiO_2$ nanoparticles prepared in this approach was found to be ~286 $m^2/g$, which is 5 times higher than that of P-25. The increased specific surface area of $TiO_2$ nanoparticles will absorb relatively more dye molecules, which can increase the short curcuit current (Jsc) in DSSCs. The influence of nanoporous structures of $TiO_2$ on the performance of DSSCs will be discussed in terms of the amount of dye molecules absorbed, the fill factor, the short circuit current, and the power conversion efficiency.

• Journal of Korean Society for Atmospheric Environment
• /
• v.15 no.4
• /
• pp.385-392
• /
• 1999

This study was carried out to investigate the constituents of inorganic ions of precipitation in Mokpo and Yeochon area from Jan. 1996 to Dec. 1997. The volume-weighted mean pH of precipitation was 5.7(4.8~7.8) at Mokpo, and 5.6(5.1~7.4) at Yeochon area, respectively. The non-seasalt(nss) anion concentrations were found in order of $nss-SO^{2-}_4>NO^-_3>nss-Cl^-$ at two areas. The portion of $nss-SO^{2-}_4;and;NO^-_3$ was 71~84% out of anions. The the non-seasalt cation concentrations were found in order of $NH^+_4>nss-Ca^{2-}>nss-Mg^{2+}>nss-K^-$ at two areas. The portion of $NH^+_4;and; nss-Ca^{2+}$ was 85~92% out cations. Compared regionally the year concentraton of $nss-SO^{2-}_4$, the result of Yeochon was 3 times higher than that of Mokpo in 1996, while the results of two regions were almost similar in 1997. The reason was that Yeochon was restricted area of the use of 0.5% sulfur B-C oil, controlled air pollution emission area, controlled semitotal amounts of air pollution emission area and partial operating of factories in 1997. There were no ions having high correlation with $H^+,;but;nss-SO^{2-}_4,;NO^-_3,;NH^+_4;and;nss-Ca^{2+}$ showed high correlation coefficient each other. It seems that these ions have little correlation with $H^+$ because they are washed out on binding state. Factor analysis showed that the first factor was complicated factor containing anthropogenic and soil resource, the second factor was sea-salt resource and the third factor was independent behavior of hydrogen at Mokpo. While, the first factor was complicated factor containing anthropogenic and sea-salt resource, the second factor was $Ca(NO_3)_2$ salt and the third factor was $NH^+_4;and;SO^{2-}_4$ synergied by resource and combination at Yeochon.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.50 no.5
• /
• pp.325-331
• /
• 2005

Seedlings of two rice genotyopes, cvs. Ilpumbyeo and Gancheokbyeo, were exposed to 0, 50 and 100 mM NaCl in nutrient solution for nine days. Plants were collected at the interval of 3 days and organic and inorganic solutes in leaves and roots and antioxidative enzyme activity in leaves were determined. Under salinity, the accumulation of soluble sugars occurred considerably in the older leaves of stressed seedlings compared to younger leaves and roots. The endogenous Na+ contents markedly increased at higher NaCl concentration in leaves and roots of seedlings, though it was higher accumulated in roots. Salinity resulted in an excessive proline accumulation in the stressed plants. A more pronounced increase was observed in Gancheokbyeo leaves. SOD activity in Impumbyeo cannot found any remarkable change, whereas, in Gancheokbyeo, its activity was rapidly decreased. CAT and POD activities increased with an increase in NaCl concentration in both genotypes. In sum­mary, the high capacity of rice seedlings to overcome an unfavorable growth condition such salt stress appears to be related to an adequate partition of organic solutes between shoots and roots and to changes in absorption, transport and re-translocation of salts.

• Journal of the Korean Ceramic Society
• /
• v.42 no.3 s.274
• /
• pp.198-204
• /
• 2005

Fluosilicate salts based hydration heat reducer(SWP-HR), used in this study, is composed of fluosilicate salts, soluble silica, aromatic polymer condensate and nitrate salt based inorganic compound with latent heat property. Effects of SWP-HR addition on the hydration heat and anti-crack property of cement mortar were investigated. Adiabatic hydration temperature and drying shrinkage length of SWP-HR added cement mortar had a tendency to decrease compared to those of cement mortar without SWP-HR addition. Also, it was confirmed through crack pattern experiment of plate-form specimen for elucidating crack-reducing characteristic that anti-crack property of SWP-HR added cement mortar was improved.

• Journal of the Korean Applied Science and Technology
• /
• v.30 no.2
• /
• pp.233-243
• /
• 2013

The inorganic pearlescent pigment have high physical and chemical stability, thus it is used in a variety field, which has better light stability, solvent resistance and thermostability. In this paper, we were synthesized the pearlescent pigment for cosmetics which was coated cobalt chloride for base of blue color metal oxide on mica titania substrate using hydrothermal synthesis method. To complement the color of the pigment by cobalt, pearl pigment were coated by different metal salt and cobalt ratio, to implement a variety of color value, depending on the kind of metal salts were synthesized. Synthesized pearlescent pigments appear various color as kind of added metal salt precursor and molar ration of cobalt and other metals. We controlled coating and color by composition of metal salt and type of metal salts, and that confirm the pigment characteristics of color changes through the analysis of color difference meter. Synthesized pigment was characterized by SPM, SEM, XRD, and EDS.

• Journal of Environmental Science International
• /
• v.28 no.3
• /
• pp.321-328
• /
• 2019

This study aimed to analyze the growth and physical responsees of Dracaena braunii in response salt accumulation in ornamental water culture and to examine the effect of activated carbon on this growth response. The experiment was conducted in a plant growth chamber and the indoor environmental conditions of the chamber were set at $23{\pm}1^{\circ}C$ temperature, $70{\pm}3%$ humidity, and 1,000 lux brightness. The observation of the growth response of plants in the presence of activated carbon showed that the pH with activated carbon maintained sub-acidic to neutral (6.27~7.32) conditions and showed decreased electric conductivity in the media. As the treatment with added activated carbon showed good growth and physical responses, this indicated that absorption effect of activated carbon had a positive influence on the growth of plants. However, as the absorption effect of activated carbon may decrease over time and the use of high concentrations of activated carbon might cause nutrition shortage, various concentration of activated carbon and their absorption effects need to be investigated in the future.