• Wind and Structures
• /
• 제23권3호
• /
• pp.231-251
• /
• 2016

This paper presents the experimental results of the wind tunnel tests for three symmetric, rectangular, tall building models on a typical open terrain considering the torsional motion-induced vibrations. The time histories of the wind pressure on these models under different reduced wind speeds and torsional amplitudes are obtained through the multiple point synchronous scanning pressure technique. Thereafter, the characteristics of both the Root Mean Square (RMS) coefficients and the spectra of the base shear/torque in the along-wind, across-wind, and torsional directions, respectively, are discussed. The results show that the RMS coefficients of the base shear/torque vary in the three directions with both the reduced wind speeds and the torsional vibration amplitudes. The variation of the RMS coefficients in the along-wind direction results mainly from the change of the aerodynamic forces, but sometimes from aeroelastic effects induced by torsional vibration. However, the variations of the RMS coefficients in the across-wind and torsional directions are caused by more equal weights of both the aerodynamic forces and the aeroelastic effects. As such, for the typical tall buildings, the modification of the aerodynamic forces in the along-wind, across-wind, and torsional directions, respectively, and the aeroelastic effects in the across-wind and torsional directions should be considered. It is identified that the torsional vibration amplitudes and the reduced wind speeds are two significant parameters for the aerodynamic forces on the structures in the three directions.

• Wind and Structures
• /
• 제23권3호
• /
• pp.211-229
• /
• 2016

In recent years, the frequency and duration of supply interruption in electric power transmission system due to flashover increase yearly in China. Flashover is usually associated with inadequate electric clearance and often takes place in extreme weathers, such as downbursts, typhoons and hurricanes. The present study focuses on the wind-induced oscillation of conductor during the process when a downburst is passing by or across a specified transmission line. Based on a revised analytical model recently developed for stationary downburst, transient three-dimensional wind fields of moving downbursts are successfully simulated. In the simulations, the downbursts travel along various motion paths according to the certain initial locations and directions of motion assumed in advance. Then, an eight-span section, extracted from a practical 500 kV ultra-high-voltage transmission line, is chosen. After performing a non-linear transient analysis, the transient displacements of the conductors could be obtained. Also, an extensive study on suspension insulator strings' rotation angles is conducted, and the electric clearances at different strings could be compared directly. The results show that both the variation trends of the transient responses and the corresponding peak values vary seriously with the motion paths of downburst. Accordingly, the location of the specified string, which is in the most disadvantageous situation along the studied line section, is picked out. And a representative motion path is concluded for reference in the calculation of each string's oscillation for the precaution of wind-induced flashover under downburst.

• Geomechanics and Engineering
• /
• 제29권3호
• /
• pp.291-300
• /
• 2022

Tunnel boring machines combined with the earth pressure balanced shield method (EPB shield TBMs) have been adopted in urban areas as they allow excavation of tunnels with limited ground deformation through continuous and repetitive excavation and support. Nevertheless, the expansion of TBM construction requires much more minor and exquisitely controlled surface settlement to prevent economic loss. Several parametric studies controlling the tunnel's geometry, ground properties, and TBM operational factors assuming ordinary conditions for EPB shield TBM excavation have been conducted, but the impact of excessive excavation on the induced settlement has not been adequately studied. This study conducted a numerical evaluation of surface settlement induced by the ground loss from face imbalance, excessive excavation, and tail void grouting. The numerical model was constructed using FLAC3D and validated by comparing its result with the field data from literature. Then, parametric studies were conducted by controlling the ground stiffness, face pressure, tail void grouting pressure, and additional volume of muck discharge. As a result, the contribution of these operational factors to the surface settlement appeared differently depending on the ground stiffness. Except for the ground stiffness as the dominant factor, the order of variation of surface settlement was investigated, and the volume of additional muck discharge was found to be the largest, followed by the face pressure and tail void grouting pressure. The results from this study are expected to contribute to the development of settlement prediction models and understanding the surface settlement behavior induced by TBM excavation.

• 한국초지조사료학회지
• /
• 제18권4호
• /
• pp.351-354
• /
• 1998

Centipedegrass는 미국 동남부지역에서 잔디용으로 많이 이용하고 있는데 토양을 가리지 않고 잘 자라며 잎이 연녹색이어서 잔디로서 선호도가 높다. 그러나 이 식물의 유전자원이 지니고 있는 유전변이 폭이 매우 한정되어 있어 활용 가능한 유전변이의 폭을 확대하기 위해 Centipedegrass의 종자에 감마선 10Kr을 조사한 뒤 계통을 조성하고 이를 다시 감마선 10Kr을 조사하여 계통을 조성하는형태로 순환 조사하여 순환 처리회수를 각각 0회, 4회, 5회, 6회, 8회 하여 얻은 계통집단 TC 201, TC 202, TC 241, TC 306, TC 318에 대하여 이들 계통집단이 지니고 있는 식물 형태적 특성의 평균과 변이의 범위 폭을 측정하여 비교한 결과 이미 품종으로 고정되어 있는 TC318을 제외하고 감마선을 종자에 순환처리한 계통집단에서 총지하경수, 총지하경길이, 최장지하경장, 엽장 및 엽폭의 변이폭이 감마선 조사로 확대되었음을 확인하였다. 이러한 변이의 범위 확대 정도는 지하경과 같은 생식기관에서 뚜렷하였는데 방사선 순환조사 정도와 관련하여 일정한 방향성은 인정되지 않았다.

• 한국환경과학회지
• /
• 제22권2호
• /
• pp.173-185
• /
• 2013

In order to clarify the impact of wildfire and its thermal forcing on atmospheric wind and temperature patterns, several numerical experiments were carried out using three dimensional atmospheric dynamic model WRF with wildfire parametrization module SFIRE. Since wind can accelerate fire spread speed, the moving speed of fireline is faster than its initial values, and the fireline tends to move the northeast, because of the wind direction and absolute vorticity conservation law associated with driving force induced by terrain. In comparison with non-fire case, the hydraulic jump that often occurs over downwind side of mountain became weak due to huge heat flux originated by surface wildfire and wind pattern over downwind side of mountain tends to vary asymmetrically with time passing. Therefore temporal variation of wind pattern should be catched to prevent the risk of widfire.

• Ocean and Polar Research
• /
• 제34권4호
• /
• pp.395-401
• /
• 2012

Ten-year AVHRR sea surface temperature data obtained in the Yellow Sea are put into EOF analyses. Temperature variation is predominated by the first mode which is associated with the seasonal fluctuation of temperature with annual range decreasing with the bottom depth. Since such a strong annual signal may mask the upwind or downwind flows occurring intermittently during the winter, only the data obtained during this season are put into EOF analyses. Every winter shows similar results. The first mode, explaining more than 90% of total variance, appears to be a part of the seasonal variation of temperature mentioned above. In the second mode, the time coefficient is well correlated with northerly winds to which the responses of the trough and shallow coastal areas are opposite to each other. A simple theoretical consideration suggests the following physical explanation: The northerly wind stress anomaly creates an upwind (downwind) flow over the trough (coastal) areas, which then induces a temperature increase (decrease) by advection of heat, and vice versa for the southerly wind stress anomaly. Hence, this paper provides further evidence of the intermittent upwind or downwind flows occurring in the Yellow Sea every winter.

• 대한전자공학회논문지SD
• /
• 제42권5호
• /
• pp.47-54
• /
• 2005

본 논문에서는 Crosstalk에 의한 coupling capacitance의 변화량, ${\Delta}Cc$이 기본값인 Cc보다 더 커질 수 있음을 제안한 테스트 회로를 이용하여 실험적으로 증명하였다. 또한 ${\Delta}Cc$가 Aggressive line의 위상에 매우 의존함을 보였으며 위상이 같은 경우보다 반대인 경우에 ${\Delta}Cc$가 크게 됨을 보였다. 실험 결과의 타당성을 검증을 위해 HSPICE 시뮬레이션을 수행하여 실험치와 잘 맞음을 나타내었다.

• Journal of Welding and Joining
• /
• 제32권6호
• /
• pp.47-55
• /
• 2014

The purpose of the study is to produce a mechanically improved weld and minimum variation of color through comparing unpulsed and pulsed GTAW (Gas Tungsten Arc Welding) for pure titanium (CP grade7) tube. Pulsed GTAW using 60 A peak current and 20 A background current (1:9) achieved the wider window of welding conditions having part and full penetration without burn-through than the case of unpulsed GTAW. Moreover, the pulsed welding reduced a discoloration on the back bead of the weld and the size of microstructures (basket weave and serrated ${\alpha}$). That is because the pulsed welding has it's a low heat input and severe weld flow induced from electric current variation. Furthermore, the pulsed welding improved the bending property of the welded Ti tube. The enhanced bending property for the pulsed GTAW was due to the insignificant discoloration on the weld surface with maintaining the metal polish.

• 수산해양기술연구
• /
• 제22권4호
• /
• pp.56-60
• /
• 1986

The purpose of this study is to find the light intensity which induced maximum gathering rate and to observe the variation of the gathering rate both in daytime and at night by using rock trout, He.'~agrammos otakii (Jordan et starks). An experimental tank (360L x SOW x 55H cm) was set up in a dark room. An illumination system was attached to the end of one side of the tank to control horizontal light intensity. Six artificial light sources were prepared by combination of two light bulbs (5 W, 150 W) and seven filters. During the experiment water depth was maintained 50 em level in the tank. The tank was marked into six longitudinal sections each being 60 em long to observe the distribution of fish. The fish were acclimatized in dark condition for 50 minutes prior to the main experiment. Upon turning on the light, the number of fish in each section was counted 40 times every 30 seconds. and the gathering rate was obtained from the average number of fish in each section. The light intensity inducing maximum gathering rate was O. 7 lux (0. 5~1. 1 lux) in the daytime and 5. 2/ux (3.2-7.7 lux) at night. The variation of the gathering rate of fish in illumination time was sma II and showed the decreasing trend.

• Earthquakes and Structures
• /
• 제9권1호
• /
• pp.93-109
• /
• 2015

Based on the reconnaissance of buildings in Dujiangyan City during 2008 Wenchuan earthquake, China, structural damage characteristics and the spatial distribution of structural damage are investigated, and the possible reasons for the extraordinary features are discussed with consideration of the influence of urban historical evolution and spatial variation of earthquake motions. Firstly, the urban plan and typical characteristics of structural seismic damage are briefly presented and summarized. Spatial distribution of structural damage is then comparatively analyzed by classifying all surveyed buildings in accordance with different construction age, considering the influence of seismic design code on urban buildings. Finally, the influences of evolution of seismic design code, topographic condition, local site and distance from fault rupture on spatial distribution of structural damage are comprehensively discussed. It is concluded that spatial variation of earthquake motions, resulting from topography, local site effect and fault rupture, are very important factor leading to the extraordinary spatial distribution of building damage except the evolution of seismic design codes. It is necessary that the spatial distribution of earthquake motions should be considered in seismic design of structures located in complicated topography area and near active faults.