• Journal of Physiology & Pathology in Korean Medicine
• /
• v.29 no.4
• /
• pp.289-294
• /
• 2015

In order to make digital processing of facial color, standardization methods of photographing and observational requirements and gloss-detecting are done through preceding papers and actual experiences. Examiner's observational informations should be contained with original and temporary color, normalcy and deviation range and gloss. And these are interrelated with time, interior and exterior temperature, emotional state, so should be recorded too. Picturing procedure should be controlled in simple and practical but objective way. Just water cleansing, 15 to 20 minute resting, prohibiton of moisturizing of examinee are common for examiner. Temperature and moisture, width, light source requirement, brightness, polarizing filter of parlor and camera-to-object distance, posture of examinee are should be recorded. In addition, pre and post-revision of color and manifestation of color space after taking images are needed coping with construction of diagnostic database.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.53 no.6
• /
• pp.7-16
• /
• 2011

This study discussed the applicability of satellite SAR (Synthetic Aperture Radar) imagery with regard to reservoir monitoring, and tried the extraction of reservoir storage from multi-temporal C-band RADARSAT-1 SAR backscattering images of Yedang and Goongpyeong agricultural reservoirs, acquired from May to October 2005. SAR technology has been advanced as a complementary and alternative approach to optical remote sensing and in-situ measurement. Water bodies in SAR imagery represent low brightness induced by low backscattering, and reservoir storage can be derived from the backscatter contrast with the level-area-volume relationship of each reservoir. The threshold segmentation over the routine preprocessing of SAR images such as speckle reduction and low-pass filtering concluded a significant correlation between the SAR-derived reservoir storage and the observation record in spite of the considerable disagreement. The result showed up critical limitations for adopting SAR data to reservoir monitoring as follows: the inappropriate specifications of SAR data, the unreliable rating curve of reservoir, the lack of climatic information such as wind and precipitation, the interruption of inside and neighboring land cover, and so on. Furthermore, better accuracy of SAR-based reservoir monitoring could be expected through different alternatives such as multi-sensor image fusion, water level measurement with altimeters or interferometry, etc.

• Journal of Multimedia Information System
• /
• v.4 no.1
• /
• pp.9-18
• /
• 2017

Ubiquitous computing is a novel paradigm that is rapidly gaining in the scenario of wireless communications and telecommunications for realizing smart world. As rapid development of sensor technology, smart sensor system becomes more popular in automobile or vehicle. In this study, a new vehicle detection mechanism in real-time for blind spot area is proposed based on imaging sensors. To determine the position of other vehicles on the road is important for operation of driver assistance systems (DASs) to increase driving safety. As the result, blind spot detection of vehicles is addressed using an automobile detection algorithm for blind spots. The proposed vehicle verification utilizes the height and angle of a rear-looking vehicle mounted camera. Candidate vehicle information is extracted using adaptive shadow detection based on brightness values of an image of a vehicle area. The vehicle is verified using a training set with Haar-like features of candidate vehicles. Using these processes, moving vehicles can be detected in blind spots. The detection ratio of true vehicles was 91.1% in blind spots based on various experimental results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.4
• /
• pp.346-360
• /
• 1992

This paper proposed a method of identity decision of moving object by the fuzzy inference. Moving object is extracted by the difference picture method and identity decision parameters of moving object are chosen area, perimeter. A/p ratio and vertex. In the brightness variation of 600 Lux-1600Lux, we determined the maximum error often parameters and then generated a fuzzified data. Fuzzified data are generated from the reference image and then decided the identity of extracted parameter by the fuzzy inference using fuzzy production rule. In order to verify validity of proposed method, experiment are performed with a toy car. As a result, it was shown that decision error was less than 4%

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1661-1663
• /
• 2007

The contrast of display is one of the important specifications. Even if the contrast indicates luminance range which is a capability of the display and is greater in lower luminance or higher luminance, we consider that the greater contrast gets not the better performance. It is not the same value in human visual system. In practice, it is difficult to achieve the full dynamic range seen by human beings using electronic equipment. Therefore, we consider ambient condition and human perception to calculate perceptual contrast using the CIECAM02. In this paper, we propose perceptual contrast that is calculated using the brightness of CIECAM02.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.864-867
• /
• 2006

Thermal infrared images of Landsat-5 TM and Landsat-7 ETM+ sensors have been unrivalled sources of high resolution thermal remote sensing (60m for ETM+, 120m for TM) for more than two decades. Atmospheric effect that degrades the accuracy of Sea Surface Temperature (SST) measurement significantly, however, can not be corrected as the sensors have only one thermal channel. Recently, MODIS sensor onboard Terra satellite is equipped with dual-thermal channels (31 and 32) of which the difference of at-satellite brightness temperature can provide atmospheric correction with 1km resolution. In this study we corrected the atmospheric effect of Landsat SST by using MODIS data obtained almost simultaneously. As a case study, we produced the Landsat SST near the eastern and western coast of Korea. Then we have obtained Terra/MODIS image of the same area taken approximately 30 minutes later. Atmospheric correction term was calculated by the difference between the MODIS SST (Level 2) and the SST calculated from a single channel (31 of Level 1B). This term with 1km resolution was used for Landsat SST atmospheric correction. Comparison of in situ SST measurements and the corrected Landsat SSTs has shown a significant improvement in $R^2$ from 0.6229 to 0.7779. It is shown that the combination of the high resolution Landsat SST and the Terra/MODIS atmospheric correction can be a routine data production scheme for the thermal remote sensing of ocean.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.1
• /
• pp.107-112
• /
• 2016

Fastener is a very important component that is used in various areas in industry. Recently, various color fasteners are introduced. According to this, online inspection is required in this area. In this paper, an algorithm for the automatic extraction of the surface of color fastener using color information and dynamic programming is presented. The outer boundary of fastener is found using the difference of color that enables robust processing. The inner boundary of fastener is found by dynamic programming that uses the difference of brightness value within fixed area after converting image to polar coordinate. Experiments are done using the same parameters.

• Journal of Environmental Science International
• /
• v.23 no.6
• /
• pp.1013-1020
• /
• 2014

Based on the survey of the parks in Tai'an by questionnaire survey, on-the-spot investigation and in-depth interview, the paper analyzes the tendencies of visitors in modern landscape lighting design forms and methods from two terms: primary attributes and the preferences of artistic lighting design. To increase the safety of the parks is a pressing need for visitors. Visitors have a pressing need for increasing the safety of the parks' lighting and artistic quality. Most visitors think the parks' lighting has blind spots and the brightness is not enough. Visitors' night activities in the park will be insecure. As to artistry aspects, people prefer strong artistic style of lamps and lanterns to the common, such as ethnic style and animal image; Tourists prefer to use white light and yellow light to illuminate trees, because these colors make people feel more warm and amiable. This research provides basic data for lighting design of parks.

• Journal of Information Technology Applications and Management
• /
• v.12 no.1
• /
• pp.231-239
• /
• 2005

This paper describes a new algorithm for pixel-based skin color detection to differentiate human form in color images by the ratio of R to H. In order to detect skin color efficiently, we examine the distribution of the R, G and B color elements combining to constitute the skin color in various color images. It shows that R is located in a narrower area than G and B on the RGB color space. And skin color is more related to R than G and B. Meanwhile, when the color image is transformed to the HSI color space, the S is variously changed in accordance with skin colors. The I is changed in accordance with the quantity and angle of light. But the H is less influenced by other conditions except for color. On the basis of the aforementioned study, we propose that the threshold for skin color detection is decided by the ratio of R to H. The proposed method narrows down the range of threshold, detects more skin color and reduces mis-detection of skin color in comparison to detection by R or H. In experimentation. it shows that the proposed algorithm overcomes changes of brightness and color to detect skin color in color images.

• Journal of Information Display
• /
• v.7 no.2
• /
• pp.16-21
• /
• 2006

The effect of improvement on the surface morphology of screen-printed carbon nanotube (CND) films was studied by using the optically clear poly-dimethylsiloxane (PDMS) elastomer for surface treatment. After the PDMS activation treatment was applied to the diode-type CNT cathode, the entangled carbon nanotube (CNT) bundles were broken up into individual free standing nanotubes to remarkably improve the field-emission characteristics over the as-deposited CNT film. Also, the cathode film morphology of a top gated triode-type structure can be treated by using the proposed surface treatment technique, which is a low-cost process, simple process. The relative uniform emission image showed high brightness with a high anode current. This result shows the possibility of using this technique for surface treatment of large-size field emission displays (FEDs) in the future.