• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.23 no.1
• /
• pp.167-181
• /
• 2024

Utilization of a driving simulator in the development of autonomous driving technology allows us to perform various tests effectively in criticial environments, thereby reducing the development cost and efforts. However, there exists a serious drawback that the driving simulator has a big difference from the real environment, so a problem occurs when the autonomous driving algorithm developed using the driving simulator is applied directly to the real vehicle system. This is defined as so-called Sim2Real problem and can be classified into scenarios, sensor modeling, and vehicle dynamics. This Paper presensts on a method to solve the Sim2Real problem in autonomous driving simulator focusing on IMU sensor. In order to reduce the difference between emulated virtual IMU sensor real IMU sensor, IMU sensor emulation techniques through precision error modeling of IMU sensor are introduced. The error model of IMU sensors takes into account bias, scale factor, misalignmnet, and random walk by IMU sensor grades.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.10
• /
• pp.53-59
• /
• 2004

A calibration technique for a redundant IMU with low-grade inertial sensors is proposed. In order to calibrate the redundant IMU that can detect and isolate a faulty sensor, the fundamental coordinate frames in the IMU are defined and the IMU error is modeled based on the frames. Equations to estimate the error coefficients of the redundant IMU are formulated, and a test sequence using the 2-axis rate table is also presented. Finally, a redundant IMU with cone configuration is implemented using the low-grade inertial sensors and the performance of the proposed technique is verified by some experiments.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.28 no.1
• /
• pp.65-72
• /
• 2010

In this study, the performances of a medium grade IMU which is aimed for Mobile Mapping System and a low grade IMU for pedestrian navigation are analyzed through simulations under GPS signal blockage. In addition, an analysis on the accuracy improvement of barometer, electronic compass, or multi-sensor(combination of barometer and electronic compass) to correct medium grade or low grade IMU errors in the situation of GPS signal blockage is performed. With the medium grade IMU, the three dimensional positioning error from INS exceeds the demanded accuracy of 5m when the block time is over 30 seconds. When we correct IMU with barometer, compass, or multi-sensor, however, the demanded accuracy is maintained up to 60 seconds. In addition, barometer is more effective than the electronic compass when they are combined. In case of low grade IMU like MEMS IMU, the three dimensional positioning error from INS exceeds the demanded accuracy of 20m when the block time is over 15 seconds. When we correct INS with barometer, compass, or multi-sensor, however, the demanded accuracy is maintained up to 15 seconds in simulation results. On the contrary to medium grade IMU, electronic compass is more effective than the barometer in case of low velocity such as pedestrian navigation. It is expected that the analysis suggested a method to decrease position or attitude error using aided sensor integration when MMS or pedestrian navigation is operated under 1he environment of GPS signal blockage.

• Journal of the Korea Convergence Society
• /
• v.11 no.3
• /
• pp.119-126
• /
• 2020

The purpose of this study is to identify trends in the type and method of Inertial Measurement Unit (IMU) by investigating studies on the type and method of convergence study of the IMU by systematic review. The study was conducted using PRISMA (Preferred Reporting Items for Systematic Reviews and Meta-Analyses) guidelines. 23 studies that meet the selection criteria were selected from 630 studies identified by three databases. As a result of this study, showed that various research using IMU was being conducted around the world, and the type of IMU was strap, full body suit, belt, wrist watch, shoes and glove. Among them, the number of strap-type IMUs was the largest at 11. The IMU's strengths were simplicity, real-time data collection and ease of application, which were used as measurement methods such as task, walking, and range of joint. The result of this study is expected to be used as basic data for experts in the medical and rehabilitation fields that conduct IMU research.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.32 no.2
• /
• pp.163-171
• /
• 2014

Based on the GPS/IMU integration, the car navigation has unstable conditions as well as drastically reduces accuracies in urban region. Nowadays, many cars mounted the camera to record driving states. If the ground coordinates of street furniture are known, the position and attitude of camera can be determined through SPR(Single Photo Resection). Therefore, an estimated position and attitude from SPR can be applied measurements in Kalman filter for updating errors of navigation solutions from GPS/IMU integration. In this study, the GPS/IMU/SPR integration algorithm was developed in loosely coupled modes through extended Kalman filters. Also, in order to analyze performances of GPS/IMU/SPR, simulation tests were conducted in GPS signal reception environments and the GCPs (Ground Control Points) distributions. In fact, the position and attitude gathered from GPS/IMU/SPR integration are more precise than the position and attitude from GPS/IMU integration. When IPs (image points), corresponded to GCPs, were concentrated in the center of image, the position error in the optical axis respectively increased. To understand effects from SPR, we plan to carry additional test on the magnitude of GCP, IP and initial exterior orientation errors.

• ETRI Journal
• /
• v.27 no.4
• /
• pp.418-426
• /
• 2005

A calibration technique for a redundant inertial measurement unit (IMU) containing low-grade inertial sensors is proposed. In order to calibrate a redundant IMU that can detect and isolate faulty sensors, the fundamental coordinate frames in the IMU are defined and the IMU error is modeled based on the frames. Equations to estimate the error coefficients of the redundant IMU are formulated, and a test sequence using a 2-axis turntable is also presented. Finally, a redundant IMU with cone configuration is implemented using low-grade inertial sensors, and the performance of the proposed technique is verified experimentally.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.24 no.2
• /
• pp.186-192
• /
• 2014

This study presents the remote control of a board robot using an IMU sensor based on Bluetooth communication. The board robot is a kind of riding robot controlled throng wireless communication by a user. The user wears the proposed IMU sensor controller, and changes a direction of the robot by the angles of IMU sensor. Bluetooth is used for wireless communication between the board robot and its user. The IMU sensor in the remote controller is used for recognition of a number of actions, which are measured as analog signals. The user actions have five commands ('1'right '2'neutrality '3'left '4'operation '5'stop), which are transmitted from the user to the board robot through Bluetooth communication. Experimental results show that proposed IMU interface can effectively control the board robot.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.44 no.6
• /
• pp.492-501
• /
• 2016

Three-Loop autopilot is generally used for the acceleration control of guided missiles. Because the acceleration command to the three-loop autopilot is given as values at the center of gravity, feedback information of IMU should be obtained at the same position. However, the position of IMU might not be located at the center of gravity due to the sub-system assignment. This paper presents the stability analysis of three-loop autopilot with respect to the arbitrary position of IMU and variation rate of center of gravity. Gain and phase margins are calculated for several trim points for general anti-tank missiles.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2022.07a
• /
• pp.491-492
• /
• 2022

본 연구에서는 실내 공간 정보 획득을 위한 IMU/INS 항법장치에 관한 연구를 위한 선행연구를 수행 하였다. 최근의 GPS를 이용한 내비게이션의 경우 보통 5~10m의 위치 오차가 일어나지만 아파트나 대형시설과 같이 실내, 터널, 공장지대 및 산악 지대등 상당한 지역은 GPS의 사각지대 또는 오차 범위를 벗어난 지역으로 존재하고 있다. 따라서 GPS는 실내에서는 사용이 불가능 하므로 다른 방안이 제시되어야 한다. 현재 고속 연산을 위한 고성능 마이크로프로세서의 발전은 센서 분야에 적용되어 저 전력, 고 정밀, 소형의 IMU/INS, ARS/AHRS 센서가 개발되고 있다. 본 연구에서는 IMU(inertial measurement unit)와 INS(Inertial Navigation System)을 이용하여 IMU자체의 자이로 센서와 가속도 센서를 이용한 GPS의 위성신호가 감지되지 않는 지형에서도 속도의 적분값과 회전방향을 이용하여 위치인식이 가능하도록 정보를 계산하여 자기의 위치를 추적하는 방안을 연구하였다.

• Journal of rehabilitation welfare engineering & assistive technology
• /
• v.9 no.4
• /
• pp.285-291
• /
• 2015

In this paper, we propose a classification algorithm for postures of sitting person by using IMU(inertial measurement unit). This algorithm uses PCA(principle component analysis) for decreasing the number of feature vectors to three and SVM(support vector machine) with RBF(radial basis function) kernel for classifying posture types. In order to collect the data, we designed neckband-shaped earphones with IMU, and applied it to three subjects who are healthy adults. Subjects were experimented three sitting postures, which are neutral posture, smartphoning, and writing. As the result, our PCA-SVM algorithm showed 95% confidence while the dimension of the feature vectors was reduced to 25%.