• E2M - 전기 전자와 첨단 소재
• /
• 제9권3호
• /
• pp.277-283
• /
• 1996

The temperature dependent characteristics of hydrogenerated amorphous silcon thin film transistor (a-Si:H TFT) with a bottom gate of N-Type <100> Si wafer were investigated. Drain current on the hysteresis characteristic curve showed an exponential variation. Hysteresis area of TFT increased with the gate voltage increased and decreased with the small gate voltage. According to the variation of gate voltages, drain current of TFT increased by temperature increase, and hysteresis characteristics mainly depended on the temperature increase. The hysteresis current showed negative characteristics curve over 383K. The hysteresis occurance area and the differences of forward and reverse sweep were increased at the higher temperature. Hysteresis current of I$_{d}$(on/off) ratio decreased at the lower temperature and increased at the higher temperature.e.

• Geomechanics and Engineering
• /
• 제28권2호
• /
• pp.107-116
• /
• 2022

The steady state of unsaturated soil takes a long time to achieve. The soil seepage behaviours and hydraulic properties depend highly on the wetting/drying rate. It is observed that the soil-water characteristic curve (SWCC) is dependent on the wetting/drying rate, which is known as the dynamic effect. The dynamic effect apparently influences the scanning curves and will substantially affect the seepage behavior. However, the previous models commonly ignore the dynamic effect and cannot quantitatively describe the hysteresis scanning loops under dynamic conditions. In this study, a dynamic hysteresis model for SWCC is proposed considering the dynamic change of contact angle and the moving of the contact line. The drying contact angle under dynamic condition is smaller than that under static condition, while the wetting contact angle under dynamic condition is larger than that under static condition. The dynamic contact angle is expressed as a function of the saturation rate according to the Laplace equation. The model is given by a differential equation, in which the slope of the scanning curve is related to the slope of the boundary curve by means of contact angle. Empirical models can simulate the boundary curves. Given the two boundary curves, the scanning curve can be well predicted. In this model, only two parameters are introduced to describe the dynamic effect. They can be easily obtained from the experiment, which facilitates the calibration of the model. The proposed model is verified by the experimental data recorded in the literature and is proved to be more convenient and effective.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 Techno-Fair 및 추계학술대회 논문집 전기물성,응용부문
• /
• pp.83-85
• /
• 2007

In magnetic field analysis of electrical machines, hysteresis phenomena of B-H curves should be taken into account in order to obtain more accurate results. In this paper, the hysteresis modeling using the micromagnetics for the magnetic field analysis is investigated. In the micromagnetics, usually, it takes much CPU times. Therefore, the method for representing hysteresis phenomena by minimum modeling is investigated in order to applying it to the magnetic field analysis. First, the micromagnetics is described. Then, the method of minimum modeling is shown. Finally, the hysteresis curve obtained by the minimum modeling is demonstrated. The effect of parameters of micromagnetics on the shape of hysteresis curve is investigated.

• 한국도로학회논문집
• /
• 제8권2호
• /
• pp.95-104
• /
• 2006

일반적으로 도로의 하부인 노상층은 불포화토 상태로 존재하기 때문에 함수비의 변동을 예측하기 위해서는 불포화 함수특성곡선(soil-water characteristic curve)의 추정은 필수적이다. 따라서, 국내 대표적인 노상토인 다짐된 화강풍화계열 노상토를 대상으로 함수특성을 정량화하기 위하여 pressure plate 장치를 활용하여 건조 및 습윤 이력과정의 실험을 각각 수행한 후 이를 토대로 불포화토 함수특성에 대한 해석을 수행하였다. 실험결과, 화강 풍화 노상토의 함수비를 좌우하는 흡수력이 건조와 습윤 과정에 있어 서로 다른 수치를 나타내었고 흡수력에 따른 불포화 투수계수와 습윤용적 그리고 확산 등의 흐름특성을 통하여 이력(hysteresis)을 확인하였다. 이를 토대로 도로하부의 연중흡수력을 추정하였다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2006년도 춘계 학술발표회 논문집
• /
• pp.28-33
• /
• 2006

Shallow failures of slopes in weathered soils are caused by infiltration due to prolonged rainfall. These failures are mainly triggered by the deepening of the wetting band accompanied by a decrease in suction induced by the water infiltration. In this paper, hysteresis on soil-water characteristic curve(SWCC) of granite and gneiss weathered soils are investigated using transient flow analysis respectively. Each case was subjected to artificial rainfall intensities and time duration depending on the laboratory-based drying and wetting processes. The results show that the unsaturated seepage on weathered slopes are very much affected by the initial suction of soils and unsaturated permeability of the soils. In addition, a granite weathered soil has a lower air-entry value, residual matric suction, and wetting front suction and less hysteresis loop than a gneiss weathered soil.

• 한국전기전자재료학회논문지
• /
• 제28권10호
• /
• pp.658-664
• /
• 2015

This paper presents an electrical feature analysis of hysteresis curves in memristor differential and intergral control circuit. After making macro model of the memristor device, electric characteristics of the model such as time analysis, frequency dependent DC I-V curves were performed by PSPICE simulation. Also, we made a circuit of memristor-capacitor based on nano-wired memristor device and analyzed the simulated PSPICE results. Finally, we proposed a memristor based differential or integral control circuit, analyzed hysteresis curve characteristic in the control circuit.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2009년도 제40회 하계학술대회
• /
• pp.871_872
• /
• 2009

This paper presents study of hysteresis model for magnetic hysteresis analysis by Preisach model. In ferromagnetic material, magnetization is non-linear and varies according to magnetic field which is called B-H curve. As hysteresis phenomenon affect on performance of motor, magnetic hysteresis analysis is essential and needed for designing motor that satisfies specification. Therefore, in this paper, methods for calculating magnetization are presented and discussed.

• 대한기계학회논문집B
• /
• 제25권8호
• /
• pp.1037-1045
• /
• 2001

The effect of hysteresis in saturated pool boiling of water from stainless-steel surfaces has been investigated experimentally. Several sets of test sections of different surface conditions, geometries, orientations, diameters, lengths, and water types were tested at atmospheric pressure. The experimental results show that hysteresis effects in pool boiling heat transfer are not significant, but some appreciable trends are observed in accordance with parameters change. At higher heat flux regions, the curve for heat flux decrease is shifted to the left side of the curve for heat flux increase. To clarify hysteresis in pool boiling and to give some improvement on published correlations, four empirical correlations are obtained in terms of tube diameter, surface roughness, and tube wall superheat.

• 대한전기학회논문지
• /
• 제43권7호
• /
• pp.1135-1143
• /
• 1994

We fabricate a bottom gate a-Si:H TFT on N-Type <100> Si wafer. According to the Variation of gate and drain voltage, the hysteresis characteristic curves were measured experimentally. Also, we proposed model equation and showed that the model predict the hysteresis characteristic successfully. Drain current on the hysteresis characteristic curve showed an exponential variation. Hysteresis area of TFT increased with the drain voltage increase and decreases with the drain voltage decrease.

• 마이크로전자및패키징학회지
• /
• 제12권3호
• /
• pp.219-226
• /
• 2005

When a ferroelectric film has an inhomogeneous distribution of charged defects, a voltage shift in the polarization curve is induced by the internal field generated in the film. The direction and the magnitude of voltage shift in the P-V hysteresis curves obtained by the Sawyer-Tower method are different from those obtained by the virtual ground method. In this study, the asymmetric behavior in the P-V hysteresis curves of inhomogeneous ferroelectric films was investigated with a physical model and the polarization curves obtained by the Sawyer-Tower and the virtual ground methods are compared.