Transactions of the Korean Society of Mechanical Engineers B (대한기계학회논문집B)

The Korean Society of Mechanical Engineers (대한기계학회)
권호 표지
DOI QR코드

DOI QR Code

Hysteresis Effects in Pool Boiling of Water

이력현상이 물의 풀비등에 미치는 영향

  • Published : 2001.08.01
Download PDF
⟨ Previous Next ⟩

Abstract

The effect of hysteresis in saturated pool boiling of water from stainless-steel surfaces has been investigated experimentally. Several sets of test sections of different surface conditions, geometries, orientations, diameters, lengths, and water types were tested at atmospheric pressure. The experimental results show that hysteresis effects in pool boiling heat transfer are not significant, but some appreciable trends are observed in accordance with parameters change. At higher heat flux regions, the curve for heat flux decrease is shifted to the left side of the curve for heat flux increase. To clarify hysteresis in pool boiling and to give some improvement on published correlations, four empirical correlations are obtained in terms of tube diameter, surface roughness, and tube wall superheat.

Keywords

References

  1. Corletti, M. M. and Hochreiter, L. E., 1991, 'Advanced Light Water Reactor Passive Residual Heat Removal Heat Exchanger Test,' Proceedings of the 1st JSME/ASME Joint International Conference on Nuclear Engineering, Tokyo, Japan, pp. 381-387
  2. Kang, M. G., 1998, 'Experimental Investigation of Tube Length Effect On Nucleate Pool Boiling Heat Transfer,' Annals of Nuclear Energy, Vol. 25, No. 4-5, pp. 295-304 https://doi.org/10.1016/S0306-4549(97)00056-X
  3. Chun, M. H. and Kang, M. G., 1998, 'Effects of Heat Exchanger Tube Parameters on Nucleate Pool Boiling Heat Transfer,' Trans. ASME Journal of Heat Transfer, Vol. 120, pp. 468-476
  4. van Stralen, S.J.D. and W. M. Sluyter, 1969, 'Investigations on the Critical Heat Flux of Pure Liquids and Mixtures under Various Conditions,' International Journal of Heat and Mass Transfer, Vol. 12, pp. 1353-1384 https://doi.org/10.1016/0017-9310(69)90022-2
  5. Bergles, A. E. and Chyu, M. C., 1982, 'Characteristics of Nucleate Pool Boiling From Porous Metallic Coatings,' ASME Journal of Heat Transfer, Vol. 104, pp. 279-285
  6. Marto, P. J. and Lepere, V. J., 1982, 'Pool Boiling Heat Transfer From Enhanced Surfaces to Dielectric Fluids,' ASME Journal of Heat Transfer, Vol. 104, pp. 292-299
  7. Park, K. A. and Bergles, A. E., 'Ultrasonic Enhancement of Saturated and Subcooled Pool boiling,' International Journal of Heat and Mass Transfer, Vol. 31, No. 3, pp. 664-667 https://doi.org/10.1016/0017-9310(88)90049-X
  8. Maracy, M. and Winterton, R. H. S., 1988, 'Hysteresis and Contact Angle Effects in Transition pool Boiling of Water,' International Journal of Heat and Mass Transfer, Vol. 31, No. 7, pp. 1443-1449 https://doi.org/10.1016/0017-9310(88)90253-0
  9. 강명기, 2000, 튜브 설치 방향이 풀비등 열전달에 미치는 영향, 대한기계학회논문집 B권, 제24권 제1호, pp. 143-151
  10. Ginoux, J. J., 1978, Two-Phase Flows and Heat Transfer with Application to Nuclear Reactor Design Problems, Hemisphere Publishing Corporation, pp. 103-105
  11. Hahne, E. and Grigull, U., 1977, Heat Transfer in Boiling, Hemisphere Publishing Corporation,, pp. 453-469