• Journal of Soil and Groundwater Environment
• /
• v.11 no.1
• /
• pp.7-13
• /
• 2006

The effects of electrolytes were investigated on the removal efficiency when several different electrolytes were used to change the electrode reaction in an electrokinetic (EK)-Fenton process to remediate phenanthrene-contaminated soil. Electrical potential gradient decreased initially due to the ion entrance into soil and then increased due to the ion extraction from soil under the electric field. Accumulated electroosmotic flow was $NaCl>KH_2PO_4>MgSO_4$ at the same concentration because the ionic strength of $MgSO_4$ was the highest and $Mg(OH)_2$ formed near the cathode reservoir plugged up soil pore to inhibit water flow. When hydrogen peroxide was contained in electrolyte solution, removal efficiency increased by Fenton reaction. When NaCl was used as an electrolyte compound, chlorine ($Cl_2$) was generated at the anode and dissolved to form hypochlorous acid (HClO), which increased phenanthrene removal. Therefore, the electrode reaction of electrolyte in the anode reservoir as well as its transport into soil should be considered to improve removal efficiency of EK-Fenton process.

• Journal of Animal Environmental Science
• /
• v.1 no.2
• /
• pp.165-171
• /
• 1995

Aerobic treatment of animal slurries represents an increasingly popular option for farmers in the management of animal wastes. This study was performed to find out the chemical characteristics of dairy slurry associated with liquid-solid separation. Total solids concentration varies widely depending on the slurry manure handling systems. Hydrogen ion exponent(pH), volatile solids(VS), ammonia nitrogen(NH$_3$-N), nitrate nitrogen (NO$_3$-N), and chemical oxygen demand(COD) essentially depends on the total solids content of animal liquid wastes. Total solids content of the dairy slurry ranges from 6.6 to 7.5% depending on the feed slurry and separator. Separated liquids from dairy slurry have been successfully downed for up to about 21, 900mg/$\ell$ of the COD value. It has also been found that separated slurry decreased from 37.8 to 26.0mg/$\ell$ of the NO$_3$-N concentration.

• Korean Journal of Veterinary Research
• /
• v.25 no.2
• /
• pp.133-144
• /
• 1985

The changes of acid-base status in vitro of the venous blood for 24 hours in ten Korean native goat were investigated. The acid-base parameters were measured within ten minutes after collection of the blood, and every hour during the first six hours and finally after twenty four hours of storage. Blood samples were stored at two different temperatures ($0-4^{\circ}C$ and $21-24^{\circ}C$). Twelve goats were induced acute acid-base disturbances by intravenous infusion of either hydrochloric acid or sodium bicarbonate and inhalated with $CO_2$ gas mixture (20% $CO_2$, 80% $O_2$) or hyperventilation were performed by means of respirator. The results were as follows; 1. Blood samples could be stored during the first two hours in ice water ($0-4^{\circ}C$) and one hour at room temperature without significant changes in pH. The magnitudes of changes were similar to those of cow, and lower than those of men and dogs. 2. The mean values of acid-base parameters in normal goat were arterial pH, 7.40; $P_{CO_2}$, 35.4mmHg; $HCO_3{^-}$, 21.8mEq/L. 3. Both the base excess and the bicarbonate showed high correlation (r=0.99) during the metabolic disturbance and were represented as $B.E.=1.38\;HCO^-{_3}-29.7$. 4. The slope of blood buffer curve obtained from the in vivo experiment was 16.3mEq/L/pH. 5. The magnitudes of changes in hydrogen ion concentration per unit change of $P_{CO_2}$ were 0.8nM/mmHg in hypercapnia and 1.0nM/mmHg in hypocapnia. 6. The ranges of acid-base parameters in normal goat urine were pH, 6.0-8.1; $P_{CO_2}$, 42-61mmHg; $HCO_3{^-}$, 2-110mEq/L. The concentration of potassium was higher (60-200mEq/L), and that of sodium was lower (8-70mEq/L) than those of human urine.

• Journal of the Microelectronics and Packaging Society
• /
• v.28 no.4
• /
• pp.85-89
• /
• 2021

AlGaN-based UV-C light-emitting diodes (LEDs) were applied for p-type activation by electrochemical potentiostatic activation (EPA). The p-type activation efficiency was increased by removing hydrogen atoms through EPA treatment using a neutral Mg-H complex that causes high resistance and low conductivity. A neutral Mg-H complex is decomposed into Mg^- and H⁺ depending on the key parameters of solution, voltage, and time. The improved hole carrier concentration was confirmed by secondary ion mass spectroscopy (SIMS) analysis. This mechanism eventually improved the internal quantum efficiency (IQE), the light extraction efficiency, the leakage current value in the reverse current region, and junction temperature, resulting in better UV-C LED lifetime. For systematic analysis, SIMS, Etamax IQE system, integrating sphere, and current-voltage measurement system were used, and the results were compared with the existing N₂-annealing method.

• Nuclear Engineering and Technology
• /
• v.55 no.10
• /
• pp.3543-3548
• /
• 2023

Shutdown chemistry evolution is performed in nuclear power plants at each refueling outage (RFO) to establish safe conditions to open system and minimize inventory of corrosion products in the reactor coolant system (RCS). After hydrogen peroxide is added to RCS during shutdown chemistry evolution, corrosion products are released and are removed by filters and ion exchange resins in the chemical volume control system (CVCS). Shutdown chemistry evolution including RCS clean-up time to remove released corrosion products impacts the critical path schedule during RFOs. The estimation of clean-up time prior to RFO can provide more reliable actions for RCS clean-up operations and transients to operators during shutdown chemistry. Electric Power Research Institute (EPRI) shutdown calculator (SDC) enables to provide clean-up time by Co-58 peak activity through operational data from nuclear power plants (NPPs). In this study, we have investigated the results of EPRI SDC by shutdown chemistry data of Co-58 activity using NPP data from previous cycles and modeled the estimated clean-up time by EPRI SDC using average Co-58 activity of the NPP. We selected two RFO data from the NPP to evaluate EPRI SDC results using the purification time to reach to 1.3 mCi/cc of Co-58 after hydrogen peroxide addition. Comparing two RFO data, the similar purification time between actual and computed data by EPRI SDC, 0.92 and 1.74 h respectively, was observed with the deviation of 3.7-7.2%. As the modeling the estimated clean-up time, we calculated average Co-58 peak concentration for normal cycles after cycle 10 and applied two-sigma (2σ, 95.4%) for predicted Co-58 peak concentration as upper and lower values compared to the average data. For the verification of modeling, shutdown chemistry data for RFO 17 was used. Predicted RCS clean-up time with lower and upper values was between 21.05 and 27.58 h, and clean-up time for RFO 17 was 24.75 h, within the predicted time band. Therefore, our calculated modeling band was validated. This approach can be identified that the advantage of the modeling for clean-up time with SDC is that the primary prediction of shutdown chemistry plans can be performed more reliably during shutdown chemistry. This research can contribute to improving the efficiency and safety of shutdown chemistry evolution in nuclear power plants.

• Korean Chemical Engineering Research
• /
• v.61 no.1
• /
• pp.26-31
• /
• 2023

For durability improvement of polymer electrolyte membrane fuel cell (PEMFC) polymer membrane, accelerated durability evaluation methods that can evaluate durability in a short time have been researched and developed. However, the lifespan of fuel cells for large commercial vehicles such as trucks and buses is more than three times that of passenger cars, and the chemical accelerated stress test (AST) time is also longer, reaching 1,500 hours or more. Therefore, in this study, as a method to evaluate the chemical durability of a membrane within a short time, it was examined whether the durability could be predicted by the pristine membrane characteristics. Hydrogen crossover current density (HCCD) and short resistance (SR) were estimated as initial characteristics, and AST time was predicted through the Fenton experiment, which was possible as an out-of-cell experiment for 3 hours. As the HCCD and fluoride ion emission concentration increased, the AST time tended to be linearly shortened, but there was a deviation (R² ≒0.65). When the SR decreased, the AST time showed a linear increase, and the accuracy was high (R² =0.93), so the AST time could be predicted with the initial SR of the membrane.

• Applied Biological Chemistry
• /
• v.22 no.2
• /
• pp.101-108
• /
• 1979

The viscosity of mucilage of Abelmoschus Manihot, Medic root decreased by the influence of various mechanical, physical and chemical conditions. It was experimented by viscosity decrease of mucilage connected with hydrogen ion concentration, bacterial multiplication, disinfection with 70% ethanol, some antibiotics, such as streptomycin, penicillin, ganamycin and chloramphenicol and mucilage derived from autoclaved Abelmoschus Manihot, Medic root. The results obtained were as follows: 1. It was clear that the viscosify of mucilage decreased notably under the influence of infected bacteria and bacterial multiplication. 2. By the inoculation of Bacillus subtilis ATCC 6633 and Escherichia coli ML 1410 to the mucilage the viscosify decrease fast but the viscosity of mucilage derived from autoclaved, Abelmoschus Manihot, Medic root. 3. The small quantity of reducing sugar in the mucilage was detected. 4. Hydrogan ion concentration in the mucilage remained $6.5{\sim}8.0$ in spite of the viscosity decrease.

• Resources Recycling
• /
• v.27 no.6
• /
• pp.53-58
• /
• 2018

Solvent extraction of Li(I) from weak HCl solution was investigated by the mixture of TBP/MIBK with other neutral extractants such as Cyanex 923, TOPO and TOP. The TBP/MIBK organic phase was loaded with 0.1 M $FeCl_3$ at different HCl concentrations (1-9 M). Extraction of Li(I) from weak HCl solution is related to the stability of $FeCl_3$ in the organic mixture. As HCl concentration increased in preparing the loaded TBP phase, the stripping percentage of Fe(III) during the extraction of Li(I) became reduced and thus Li(I) could be extracted by ion exchange reaction with hydrogen ion in the organic. The concentration of TBP in the extractant mixture affected the stability of $FeCl_3$. Compared to TBP, Fe(III) was easily stripped from the loaded MIBK and thus no Li(I) was extracted by the mixture with MIBK. The nature of neutral extractant with TBP/MIBK showed little difference in the extraction of Li(I) and stripping of Fe(III).

• Korean Chemical Engineering Research
• /
• v.61 no.3
• /
• pp.356-361
• /
• 2023

In order to improve the durability of the proton exchange membrane fuel cell (PEMFC), it is important to accurately evaluate the durability of the polymer membrane in a short time. The test conditions for chemically accelerated durability evaluation of membranes are high voltage, high temperature, low humidity, and high gas pressure. It can be said that the protocol is developed by changing these conditions. However, the relative influence of each test condition on the degradation of the membrane has not been studied. In chemical accelerated degradation experiment of the membrane, the influence of 4 factors (conditions) was examined through the factor experiment method. The degree of degradation of the membrane after accelerated degradation was determined by measuring the hydrogen permeability and effluent fluoride ion concentration, and it was possible to determine the degradation order of the polymer membrane under 8 conditions by the difference in fluoride ion concentration. It was shown that the influence of the membrane degradation factor was in the order of voltage > temperature > oxygen pressure > humidity. It was confirmed that the degradation of the electrode catalyst had an effect on the chemical degradation of the membrane.

• Applied Biological Chemistry
• /
• v.46 no.3
• /
• pp.251-256
• /
• 2003

The polyphenol fractions of Korean ginseng were purified using Sephadex LH-20, MCI gel, Bondapak $C_{18}$ TLC, and HPLC from the 60% acetone soluble fraction. Fraction I showed 48.16%, 79.71% and 43.55% inhibition at 150 ppm against lipid oxidation in the presence of copper ion, superoxide and hydrogen peroxidation. Electron donating abilities of fraction II showed 35.17% inhibition at 200 ppm. Fraction III showed 48.49% and 25% inhibition at 150 ppm against lipid oxidation in the presence of ferrous ion and hydroxy radical ion. The phospholipase $A_2$ inhibitory effect of fraction III was 48.9% at the concentration of $60\;{\mu}g/ml$. The cytotoxic effects of fraction II was the highest (73.29% at 0.25 mg/ml) among the tested polyphenol fractions.