• Journal of Korea Water Resources Association
• /
• v.56 no.12
• /
• pp.919-928
• /
• 2023

Rainfall characteristics in Korea are concentrated during the summer flood season. In particular, when a large amount of turbid water flows into the dam due to the increasing trend of concentrated rainfall due to abnormal rainfall and abnormal weather conditions, prolonged turbid water phenomenon occurs due to the overturning phenomenon. Much research is being conducted on turbid water prediction to solve these problems. To predict turbid water, turbid water data from the upstream inflow is required, but spatial and temporal data resolution is currently insufficient. To improve temporal resolution, the development of the Turbidity-SS conversion equation is necessary, and to improve spatial resolution, multi-item water quality measurement instrument (YSI), Laser In-Situ Scattering and Transmissometry (LISST), and hyperspectral sensors are needed. Sensor-based measurement can improve the spatial resolution of turbid water by measuring line and surface unit data. In addition, in the case of LISST-200X, it is possible to collect data on particle size, etc., so it can be used in the Turbidity-SS conversion equation for fraction (Clay: Silt: Sand). In addition, among recent remote sensing methods, the spatial distribution of turbid water can be presented when using UAVs with higher spatial and temporal resolutions than other payloads and hyperspectral sensors with high spectral and radiometric resolutions. Therefore, in this study, the Turbidity-SS conversion equation was calculated according to the fraction through laboratory analysis using LISST-200X and YSI-EXO, and sensor-based field measurements including UAV (Matrice 600) and hyperspectral sensor (microHSI 410 SHARK) were used. Through this, the spatial distribution of turbidity and suspended sediment concentration, and the turbidity calculated using the Turbidity-SS conversion equation based on the measured suspended sediment concentration, was presented. Through this, we attempted to review the applicability of the Turbidity-SS conversion equation and understand the current status of turbid water occurrence.

• Food Science and Biotechnology
• /
• v.17 no.5
• /
• pp.1010-1015
• /
• 2008

The effects of heat treatment on the physicochemical properties and mineral composition of sun-dried salt were investigated. The salts parched at high temperature were appeared the higher alkalinity and the lower oxidation-reduction potential (ORP) than the samples without heat treatment. The commercial salts (bamboo salt and yellow loess salt) and the sun-dried salt parched at high temperature had relatively higher sodium ion content (418-450 ppm) compared to that (418.0 ppm) of refined salt. The increase of calcium ion occurred in the salts parched at high temperature compared to the sun-dried salt without heat treatment, but the magnesium ion was vice versa. The commercial salt, yellow loess salt had highest turbidity (0.973) whereas sun-dried salt showed lowest level (0.097) among the tested samples. Turbidity of heat treatment samples decreased as solubility increased. The maximum concentration of dialyzed salt was reached after 4 hr regardless of various processed salts, but those had no difference significantly among the tested samples. The X-ray diffraction patterns of the parched sun-dried salts showed different peak intensity with common salts, and they were similar to the patterns of oxide salts, especially MgO. The maximum value (2.56%) of MgO appeared in the sun-dried salt parched at $1,400^{\circ}C$.

• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.2
• /
• pp.267-274
• /
• 2008

This study is about efficiency of pretreatment process and operating factor to membrane process at continuous coagulation/ultrafiltration process in water treatment. The capacity of pilot plant was $0.06{\beta}(C)/d$. The raw water used was from Nakdong stream which was characteristized by high organic matter and high turbidity. The result of the test was that coagulation is good process as to high removal rate to organic matter and turbidity but It caused problem to membrane pore blocking. This paper is to determine the membrane fouling potential under different membrane flux, backwash pressure and linear velocity. Backwash pressure and flux is important parameter on operation of membrane system. Those are directly affected on membrane system. When backwash pressure increased from 150 kPa to 200 kPa, the result showed that fouling (pressure increase rate) changed from 3.69 kPa/h to 0.93 kPa/h and the recovery rate changed from 90.7 % to 82.0 %. Linear velocity had slightly effect on fouling. Linear velocity increased from 0.2 m/s to 0.5 m/s, the corresponding pressure rate changed from 0.93 kPa/d to 0.77 kPa/d.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.47 no.3
• /
• pp.55-62
• /
• 2015

Paper mulberry fibers have been used as fibrous raw materials for manufacturing traditional handmade paper, hanji for a long time. Compared to wood pulp fibers, pulp fibers from mulberry bast tissue have some benefits in physical and chemical properties due to their high D.P (degree of polymerization), M.W (molecule weight) and long fiber length. Specially, Korean handmade hanji shows outstanding characteristics in mechanical tensile strength, folding endurance, flexibility and long sustainable conservation properties. Therefore, hanji is widely applied to daily supplies, hygienic goods, medical supplies, clothing industries and so on. Recently, the potential demand of mulberry pulp fibers is more and more increased on the strength of high application fields. This study was focused on the possibility of wastewater recycling in unit operation systems for the development of automated mass production line. The properties and environmental loads of wastewater from debarking, cooking, bleaching and screening process were analyzed by means of COD, conductivity, turbidity and solid materials. The wastewater from debarking and cooking process was comparatively high in pollution load, and would be treated by additional approaches of chemico-physical method.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.4
• /
• pp.493-501
• /
• 2007

The membrane pilot plant has being operated in the Hyeondo pumping station to find the optimal operation technique of Gong-Ju membrane water treatment plant (WTP) which is constructing in $250m^3/d$ scale. The pilot plant was consisted of two trains which can treat $30,000m^3/d$ per train. First train was operated for one year under the condition of flux $1m^3/m^2{\cdot}d$ while the effects of flux variation and addition of powdered activated carbon(PAC) were evaluated in second train. The turbidity of membrane product water of first train which is operated on Flux $1m^3/m^2{\cdot}d$ was always below 0.05 NTU regardless of raw water turbidity. And also, the trance-membrane pressure(TMP) was maintained at $0.3{\sim}0.5kgf/cm^2$ for about 9 months and increased rapidly to $1.8kgf/cm^2$ which is maximum operating TMP. However, TMP was rapidly increased to $1.8kgf/cm^2$ within 2 months as flux was increased from 1 to $2m^3/m^2{\cdot}d$, especially, within 10 days under high turbidity(30~50NTU). This reault means that if Gongju membrane WTP is operated in flux $1m^3/m^2{\cdot}d$, chemical cleaning period can be maintained over 6 months. Only 10% of dissolved organic carbon (DOC) was removed in membrane process while the removal efficiencies of manganese and iron were 60% and 77% respectively. However, because only solid manganese and iron were removed in membrane process, an additional process for treating soluble manganese is required if souble manganese is high in raw water. 70% of 70ng/L 2-MIB which is causing taste & odor was removed in powdered activated carbon (PAC) tank with 50mg/L PAC which is design concentration of Gongju WTP. In addition, TMP was reduced with addition of 50mg/L PAC regardless of flux. Because TMP was not influenced even if 100mg/L PAC was added, the high taste and odor problem can be controled by additional injection of PAC.

• Journal of the Mineralogical Society of Korea
• /
• v.24 no.2
• /
• pp.91-99
• /
• 2011

The turbidity in several wells of Samdong-myeon, Ulsan, exceeded potable groundwater standard (1 NTU). Mineralogical analysis showed that the fine suspended particles are ferrihydrite spheres with a size of less than $0.5\;{\mu}m$ and helical iron-oxidizing bacterial filaments, and their aggregates. Ferrihydrite was almost amorphous only showing two electron diffraction rings, and contained Si and P. Helical bacterial filaments were almost replaced by ferrihydrite. The helical bacteria have played an important role in the ferrihydrite formation by becoming the loci for ferrihydrite precipitation as well as oxidizing ferrous iron. The physicochemical conditions of low pH, low redox potential, high Ca concentration, and high alkalinity are consistent with the hydrogeochemical characteristics of carbonate groundwater, implicating that the inflow of deep ferriferous carbonate groundwater and its oxidation have caused the ferrihydrite turbidity in several wells of the study area.

• Membrane Journal
• /
• v.22 no.4
• /
• pp.243-250
• /
• 2012

The effect of water back-flushing period (filtration time, FT) was investigated in hybrid process of alumina microfiltration and photocatalyst for advanced drinking water treatment in this study, and compared with the previous studies with carbon microfiltration or alumina ultrafiltration membranes. The FT was changed in the range of 2~10 min with fixed 10 sec of BT. Then, the FT effects on resistance of membrane fouling ($R_f$), permeate flux (J) and total permeate volume ($V_T$) were observed during total filtration time of 180 min. As decreasing FT, $R_f$ decreased and J increased as decreasing FT, which was same with the previous results with carbon microfiltration or alumina ultrafiltration membranes. The treatment efficiency of turbidity was high beyond 98.1%, and the effect of FT was not shown on treatment efficiency of turbidity, which was same with the previous result of carbon microfiltration. The treatment efficiency of organic matters was the highest value of 89.6 % at FT 8 min, which was a little higher than those of the previous results, and the effect of FT was not shown on treatment efficiency of organic matters.

• Journal of Soil and Groundwater Environment
• /
• v.13 no.6
• /
• pp.85-92
• /
• 2008

Water in Soyang River is an essential source for citizens of Chuncheon and Seoul areas. In 2006, turbid water in Soyang River aggravated by the typhoon Ewiniar, sustained for over 280 days unlike conventional years, then which interrupted water supply of Chuncheon and Seoul areas. Soil erosion derived from high cool lands constituting about 55% of Soyang River area is considered one of main causes for the turbid water, including imprudent development of mountainous area, road expansion, and road construction for forestry. According to analysis of turbidity, precipitation and reservoir level in Soyang River region for June 2006${\sim}$August 2008, the turbidity showed a peak correlation (r = 0.28) at a lag time of 49 days and especially did an excellent correlation (r = 0.60) with the reservoir level at a lag of 4 days. In the meantime, a critical turbidity of 31 NTU at Soyanggang Dam was estimated, over which would cause turbid water at Paldang Dam. In addition, a master recession curve was suggested, from which sustaining time of turbid water can be predicted.

• Applied Chemistry for Engineering
• /
• v.16 no.1
• /
• pp.74-80
• /
• 2005

The effective removal of turbid-inducing particulates and algae-inducing phosphorous was systematically investigated by the variation of physico-chemical parameters such as pH, alkalinity, and coagulant types. Al(III)-based and Fe(III)-based coagulants exhibited high removal efficiency of turbidity and phosphorous at optimal pH ranges of 7~9, in which zeta potential nearly approached to zero. The removal rate of turbidity rapidly increased with the increase of coagulant dosages, whereas the removal rate of phosphorous gradually increased due to an equivalent reaction of phosphorous with metallic ions. The generation of flocs during coagulation was visualized by high speed camera (Motion Scope 2000, Redlake Co.), and the images of singular flocs were captured by optical microscope. The flocs generated by Fe(III)-based coagulant was more compact than those induced by Al(III)-based coagulant, and the settlabiltiy of Fe(III)-induced flocs was superior to that of Al(III)-induced flocs.

• Applied Biological Chemistry
• /
• v.41 no.2
• /
• pp.166-174
• /
• 1998

The effects of some organic acids on the shelf life of cooked noodle and the change in textural properties were studied. Organic acids used were vinegar, lactic, citric and malic acid. The pH of noodle was adjusted to $4.7{\pm}0.25$ by dipping it in each solution for 30 seconds. Total microbial count and turbidity of the treated samples were measured storage for 4 days at $15^{\circ}C$. The total count was high in order of control, malic, citric, lactic acid and vinegar. High turbidity was observed in order of control, lactic, malic, citric acid and vinegar. Hardness, adhesiveness, cohesivenes and springiness were measured for 30 days at $35^{\circ}C$ using Rheometer along with concurrent sensory evaluation. The acid treated samples showed higher values in hardness and cohesiveness than control but lower in adhesiveness and springiness. After 30 days storage, the malic or citric acid treated sample led to a somewhat higher gumminess than control. Based on the sensory evaluation the malic acid treated noodle significantly exhibited the highest score followed by citric, lactic acid, control and vinegar.