• 한국인터넷방송통신학회논문지
• /
• 제16권1호
• /
• pp.15-20
• /
• 2016

공간다중화 방식을 사용하는 MIMO 시스템은 다이버시티 기법을 사용하는 MIMO 시스템과 비교할 때 높은 전송률을 달성하지만 다이버시티 이득이 낮아 데이터 전송 신뢰도를 높이기 위하여 MIMO 수신단에서 공간정보스트림을 분리해야한다. 본 논문에서는 격자부호에 의한 채널 용량 검출 기법, 사용자 3인인 간섭채널과 선형검출기법인 ZF(Zero Forcing)와 MMSE(Minimum Mean Square Error) 검파 기법을 비교했다. 이때 채널은 Diagonal 채널이 된다. 즉, Diagonal 채널은 $[H]_N[H]_N^{-1}=[I]_N$로 역행렬이 element-wise inverse로 Jacket 행렬의 성질을 만족함을 확인했다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 추계학술대회 논문집 전기물성,응용부문
• /
• pp.217-219
• /
• 2005

To detect partial discharge of 154kV joint box, we have made experiment by using the HFCT sensor. Generally the signals which are detected in partial discharge test of underground power transmission cable are accompanied with both noises of high voltage and noises of surrounding power cable. The most noise in near to end part of joint box is corona, beside other noises flowed from surrounding area. Partial discharge test is difficulty due to these noises. First, we test reliability on both injection of calibration signal in NJB and removal of low frequency. After that, we had analyzed frequencies by measuring signals in IJB with 300[m] distance from NJB. Also we had measured S/N ratio by using the indirected injection method of calibration signal in IJB. In this experiment, two measurement methods were difference of detection acquisition, but these had the equal frequency properties.

• 조명전기설비학회논문지
• /
• 제23권11호
• /
• pp.52-60
• /
• 2009

High reliability is essential for power transformers, and their fault causes are reportedly more related to mechanical causes than electrical ones. The transformer soundness judgment currently depends only on the electrical insulation characteristic and the chemical test of the insulation oil, so that there are few fundamental measures against the frequent mechanical damages and failures in transformers. The mechanical soundness judgment techniques are conducted through processes that include structural analysis and vibration resistance treatment during the manufacturing process of each manufacturer, but the vibration is not tested during the design, manufacturing, and operating processes since there are no detailed technical standards and procedures on the vibration problem, which are important in terms of maintenance. Therefore, in this study, vibration phenomena were measured from the 32 power transformers in operation in the substations under the Daejeon Power Transmission District Office of the Korean Electric Power Corporation (KEPCO). The vibration was measured at 24 sections ($6{\times}4$) on one side, and only the maximum values were selected from the measured vibration values. This was because the maximum vibration values more significantly affect the soundness of the transformer than the average vibration values. The vibration classes were given considering the maximum vibration based on ISO 10016-1 (2001).

• 한국정보통신학회논문지
• /
• 제13권6호
• /
• pp.1215-1221
• /
• 2009

본 연구에서는 무선 센서네트워크 환경에서 요구하는 데이터 전달의 신뢰성 향상을 위해 기능성 노드를 제안한다. 생체신호 모니터링을 위해 기존의 지속적인 생체신호 전송시 발생하는 데이터 손실을 줄이기 위해 비정상적인 QRS-complex 검출이 가능한 센서노드를 이용하고, Ad-hoc 네트워크 환경에서 비정상적인 QRS-comoplex 발생시에만 데이터를 전송함으로써 무선 센서네트워크 내에 발생되는 데이터량을 줄일 수 있었다. 본 연구에서 Ad-hoc 환경에서의 기능성 노드를 사용함으로써 그 결과 의료 목적을 위한 무선 센서네트워크에서 전체 패킷발생을 줄여 센서노드의 전력소모를 크게 줄이고 시스템의 신뢰도를 크게 높이는 것으로 확인되었다.

• Journal of Information Processing Systems
• /
• 제12권3호
• /
• pp.489-501
• /
• 2016

As interest in the Internet increases, related technologies are also quickly progressing. As smart devices become more widely used, interest is growing in words are missing here like "improving the" or "figuring out how to use the" future Internet to resolve the fundamental issues of transmission quality and security. The future Internet is being studied to improve the limits of existing Internet structures and to reflect new requirements. In particular, research on words are missing here like "finding new forms of" or "applying new forms of" or "studying various types of" or "finding ways to provide more" reliable communication to connect the Internet to various services is in demand. In this paper, we analyze the security threats caused by malicious activities in the future Internet and propose a human behavior analysis-based security service model for malware detection and intrusion prevention to provide more reliable communication. Our proposed service model provides high reliability services by responding to security threats by detecting various malware intrusions and protocol authentications based on human behavior.

• International Journal of Aeronautical and Space Sciences
• /
• 제14권4호
• /
• pp.398-407
• /
• 2013

Optical tomography was used to measure the pattern of spray cross-section. The maximum-likelihood estimation (MLE) algorithm was used to reconstruct the spray cross-section from the measured transmission rate of the spray. A swirl-type injector was used to form an optically dense spray, and the test was carried out in a high-pressure chamber, to control the pressure condition of the test site. Before the experiment, the reliability of the MLE-based reconstruction algorithm was verified, by comparing it with a conventional filtered back projection reconstruction (FBP) method. The MLE algorithm showed superior reconstruction of the image. In the spray patternation experiment, the results of the optical tomography and optical line patternator, which uses Mie scattering signal information, were compared. While measuring the cross-section of optically dense spray, the intensity of the scattering signal had attenuated to an uncorrectable level, which led to incorrect spray pattern measurement by the optical line patternator. However, reliable results were obtained by optical tomography, under the same condition. Finally, the pattern of the optically dense spray was measured at various chamber pressures, of up to 3 MPa. As the chamber pressure increased, the hollow cone-shaped swirl spray shrank, and the attenuation coefficient value of the inner region increased.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 E
• /
• pp.2268-2270
• /
• 1999

The underground transmission line have been consistently developed to increase its voltage level for satisfying the customer's demand through supplying the high reliability power. The underground XLPE cable and its accessories of 500kV level have been already developed internationally, but the XLPE cable have been installed 154kV level in Korea up to now. Thus, our company has developed 230kV XLPE cable and its accessory in 1998 for preparing 345kV level system in Korea and being qualified as international cable maker of developing oversea markets. In this paper, newly our developed 230kV system will be introduced using the type test result according to IEC 840 and additional specification.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.431-431
• /
• 2013

Flexible Organic Light Emitting Diode (OLED) displays are required for future devices. It is possible that plastic substrates are instead of glass substrates. But the plastic substrates are permeable to moisture and oxygen. This weak point can cause the degradation of fabricated flexible devices; therefore, encapsulation process for flexible substrate is needed to protect organic devices from moisture and oxygen. Y.G. Lee et al.(2009) [1] reported organic and inorganic multilayer structure as an encapsulation barrier for enhanced reliability and life-time.Flowable Oxide process is a low-temperature process which shows the excellent gap-fill characteristics and high deposition rate. Besides, planarization is expected by covering dust smoothly on the substrate surface. So, in this research, Bi-layer structured is used for encapsulation: Flowable Oxide Thin film by PECVD process and Al2O3 thin film by ALD process. The samples were analyzed by water vapor transmission rate (WVTR) using the Calcium test and film cross section images were obtained by FE-SEM.

• 드라이브 ㆍ 컨트롤
• /
• 제11권4호
• /
• pp.61-67
• /
• 2014

When a manual transmission equipped car stops on an incline where the nose of the car is higher than the rear, hill-start control or hill-holder could prevent the vehicle from rolling backward as the car moves forward. The easy-hill assist valve consists of a check valve and a needle type ON/OFF solenoid valve connected in parallel; it is a hydraulic actuator that can maintain brake pressure using an electrical signal from the ECU. As the EHA valve is a safety-related component of the brake system, high reliability as well as superior dynamic performance is required for it to be applied in commercial vehicles. This paper presents the design of the EHA valve as a piece of equipment that can simulate the brake actuation pressure with a pressurizing piston. Following specific test standards, the experimental results validate the implemented functions of the test equipment, proving the test stand to be effective for the performance and endurance of the EHA valve.

• 한국인터넷방송통신학회논문지
• /
• 제11권4호
• /
• pp.17-22
• /
• 2011

수중 환경은 육상 환경과 많은 차이를 보이며 무선 통신에 사용되는 자원과 제약 조건들도 다르다. 일반적으로 수중 통신 환경은 육상 통신 환경보다 열악하고, 파도, 조류와 같은 해수의 흐름으로 인한 노드의 이동성 때문에 오류 발생 가능성이 기존의 지상 무선 센서 네트워크 보다 높다. 따라서 수중 무선 센서 네트워크의 통신 환경을 고려하여 노드 간 데이터 전송률을 향상시키기 위한 기법들에 대한 요구가 높아지고 있다. 본 논문에서는 수중 무선 센서 네트워크의 통신 환경을 고려하여 클러스터 헤드 노드의 오류 발생 시 이를 빠른 시간 내에 복구하기 위한 체크포인팅 기법을 제안한다. 또한 실험을 통해 제안 기법이 네트워크 운영의 신뢰도를 향상 시킬 수 있을 뿐만 아니라, 에너지 소모량과 오류 복구 지연 시간 측면에서 제안 기법을 적용하지 않았을 때보다 좋은 성능을 보인다는 것을 검증한다.