• Journal of Magnetics
• /
• v.20 no.2
• /
• pp.176-185
• /
• 2015

We present the design optimization of the magnetic pole and slot design options that minimize the cogging torque of permanent-magnet (PM) brushless generators for small wind turbine generators. Most small wind-turbines use direct-driven PM generators which have the characteristics of low speed and high efficiency. Small wind-turbines are usually self-starting and require very simple controls. The cogging torque is an inherent characteristic of PM generators, and is mainly caused by the generator's geometry. The inherent the cogging torque can cause problems during turbine start-up and cut-in in order to start softly and to run a power generator even when there is little wind power during turbine start-up. Thus, to improve the operation of small turbines, it is important to minimize the cogging torque. To determine the effects of the cogging torque reductions, we adjust the slot opening width, slot skewing, mounting method of magnets, magnet shape, and the opening and combinations of different numbers of slots per pole. Of these different methods, we combine the methods and optimized the design variables for the most significant design options affecting the cogging torque. Finally, we apply to the target design model and compare FEA simulation and measured results to validate the design optimization.

• Journal of radiological science and technology
• /
• v.20 no.2
• /
• pp.34-43
• /
• 1997

There are 4 types of equipment in diagnostic radiography. These are single phase, three phase, inverter type and condenser type X-ray generators. It is very confusing to make an adequate exposure factor and to know the usage of different type of X-ray generators. In this experiment, I explored a comparative study of outputs in 4 different type of X-ray units. I expect that this experiment could be helpful for manufacturer to make both the X-ray equipment better, In terms of Ideal exposure factors, thereby reducing the patient dose. Experimental results are as follow : 1) X-ray output The ratio of X-ray output of single, three phase and inverter type of X-ray generator was 1 : 1.6 : 2 without absorber and 1 : 2 : 2.6 with 20 mm aluminium absorber. 2) Beam quality The X-ray beam quality of single phase generator was proved to be softer than three phase and inverter type of generators by 0.4 mmAL and 0.55 mmAl HVL respectively. 3) Reproducibility Linearity of X-ray output Retroducibility of X-ray output met the regulation below CV 0.05 and linearity also met the regulation below 0.1 in 4 types of diagnostic X-ray generators. 4) The comparison of incident dose Three phase X-ray generator was 20% higher than two other X-ray generators in radiation dose to make same film density.

• Journal of the Korean Society of Visualization
• /
• v.18 no.1
• /
• pp.67-73
• /
• 2020

Flexible structures have been adopted in heat transfer systems as vortex generators. The flexible vortex generators immersed in a flow show a self-sustained oscillatory motion, which enhances fluid mixing and heat transfer. In the present study, the vortex generators in a two-dimensional channel flow are numerically investigated, and they are symmetrically mounted on the upper and lower walls with an inclination angle. The momentum interaction and heat transfer between the flexible vortex generators and the surrounding fluid are considered by using an immersed boundary method. The inclination angle is one of the important factors in determining the flapping kinematics of the flexible vortex generators. The flapping amplitude increases as the inclination angle increases, thereby enhancing fluid mixing. The heat transfer is enhanced up to 80% comparing to the baseline channel flow.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.4
• /
• pp.688-693
• /
• 2009

The response characteristics of power system frequency are determined by generator droop characteristics and load damping properties. The characteristics of governor droops are termed by generators constant, while those of load damping by load constant. In this paper, the generator constant and the load constant are assessed by measured data at the event of generator trips.

• Bulletin of the Korean Mathematical Society
• /
• v.47 no.2
• /
• pp.275-286
• /
• 2010

The algebraic structure of the natural integral cohomology operations is explored by means of examples. We decompose the generators of the groups $H^m(\mathbb{Z},\;n)$ with $2\;{\leq}\;n\;{\leq}\;7$ and $2\;{\leq}\;m\;{\leq}\;13$ into the operations of cup products, cross-cap products and compositions. Examination of these decompositions and comparison with other possible generators demonstrates the existence of relations between integral operations that have withheld formulation. The calculated groups and generators are collected in a table for practical reference.

• Journal of the Korean Mathematical Society
• /
• v.40 no.2
• /
• pp.251-272
• /
• 2003

Multidimensional integrals are expressed in terms of lower dimensional integrals and function evaluations. An iterative process is used where a trapezoidal and three point identities are used as generators for higher dimensional identities. Bounds are obtained utilising the resulting identities. It is demonstrated that earlier Ostrowski type results are obtained as particular instances of the current work.

• Journal of applied mathematics & informatics
• /
• v.28 no.3_4
• /
• pp.1017-1023
• /
• 2010

We prove that a maximal ideal M of D[x] has two generators and is of the form where p is an irreducible element in a PID D having infinitely many nonassociate irreducible elements and q(x) is an irreducible non-constant polynomial in D[x]. Moreover, we find how minimal generators of maximal ideals of a polynomial ring D[x] over a DVR D consist of and how many generators those maximal ideals have.

• Journal of the Korea Society for Simulation
• /
• v.10 no.2
• /
• pp.25-32
• /
• 2001

The Multiple Recursive Generator(MRG) has been considered by many scholars as a very good random number generator. For the long period md excellent statistical properties, the method of the combination with random number generators is used. In this paper, we thought the two-combined MRGs. Using the frequency and serial test, and runs test, we studied the importance of the initial seeds likewise other random number generators.

• Proceedings of the KIEE Conference
• /
• 2003.07a
• /
• pp.649-651
• /
• 2003

In the framework of competitive electricity market, the Market Power due to the transmission congestion, lack of demand-side response, various uncertain factors etc. have been significant problem. This paper reviews the market rules of Korea power system and the uplift scheme for constrained on/off generators. Then, this paper points out several problems and the mitigation measures of local market power concerning the compensation for constrained-off generators.

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.469-471
• /
• 2005

Wind farms employs induction generators which are two type, one is Squirrel cage for fixed speed wind turbines and the other is Wound induction generator (doubly fed induction generator DFIG) for variable speed wind turbines. this paper describes grid connection scheme of wind power system using two type induction generators and simulation results show the characteristics of two type induction generators.