• Clinical and Experimental Reproductive Medicine
• /
• v.22 no.2
• /
• pp.149-153
• /
• 1995

In IVF-ET program, intracytoplasmic sperm injection(ICSI) has been performed with testicular sperm extraction(TESE) in case of no normal spermatozoon could be retrieved from the epididymis. We wished to see whether the quality of testicular sperm affect the fertilization and pregnancy rate in TESE-ICSI cycles(n=40). These cycles were classified into three groups by the total number of normal motile spermatozoa(TNMS) in the TESE sample: i) good sperm(GS) group(n=12), TNMS > 10,000; ii) moderate sperm(MS) group(n=19), 1,000 < TNMS < 10,000; iii) poor sperm(PS) group(n=9), TNMS < 1,000. Among 423 injected oocytes, 307(72.6%) oocytes were normally fertilized and 43 zygotes were cryopreserved. The fertilization rates of GS group(79.3%) and MS group(75.9%) were significantly(p<0.005) higher than PS group(60.2%). After the embryo transfer(n=40), clinical pregnancy was obtained in 14 cycles(35.0%) and on-going pregnacy in 13 cycles(32.5%). The clinical and on-going pregnancy rates were similar in each group. From these results it can be concluded that testicular spermatozoa are successfully used with ICSI in IVF-ET program in spite of very poor quality of TESE sample.

• Journal of the Korean Geotechnical Society
• /
• v.26 no.2
• /
• pp.33-43
• /
• 2010

Geothermal energy is gaining wide attention as a highly efficient renewable energy and being increasingly used for heating/cooling systems of buildings. The standing column well (SCW) is especially efficient, cost-effective, and suitable for Korean geological and hydrological conditions. However, a numerical model that simulates the SCW has not yet been developed and applied in Korea. This paper describes the development of the SCW numerical model using a finite-volume analysis program. The model, through hydro-thermal coupled analyses, simulates heat transfer through advection, convection, and conduction. The accuracy of the model was verified through comparisons with field data measured at SCWs in the U.S. and Korea. Comparisons indicated that the SCW numerical model can closely predict the performance of a SCW. The numerical model was used to perform a comprehensive parametric study in the companion paper.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.27 no.4
• /
• pp.373-379
• /
• 1994

Final biomass yields(cells/ml) and growth rates(divisions/day) of 4 clones of marine diatoms isolated from the Korean coastal waters were measured in media with 6 different levels of added cadmium concentrations. A neritic diatom, GS-12(Chaetoceros sp.), showed no growth at 0.1ppm cadmium, and its $IC_{50}$ for final biomass yield and growth rate was 0.03 and 0.02ppm, respectively. Two clones isolated from tidal pool, NC-37 and NC-29, showed enhanced tolerance to cadmium toxicity. Extremely high tolerance to cadmium addition was found in J-21 from a eutrophicated bay, with its high $IC_{50}$ for biomass yield(1.07ppm) and growth rate(1.92ppm). Present results implied a habitat related pattern of coastal diatom clones in the cadmium tolerances. Except GS-12, the other three diatom clones are considered to be highly tolerant to cadmium stresses.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.9 no.4
• /
• pp.247-259
• /
• 2007

In this study, we examined the flux of carbon and water using an eco-hydrological model, Regional Hydro-Ecologic Simulation System (RHESSys). Our purposes were to develop a set of parameters optimized for a well-designed experimental watershed (Gwangneung Research Watershed, GN) and then, to test suitability of the parameters for predicting carbon and water fluxes of other watershed with different regimes of climate, topography, and vegetation structure (i.e Gangseonry Watershed in Mt. Jumbong, GS). Field datasets of stream flow, soil water content (SWC), and wood biomass product (WBP) were utilized for model parameterization and validation. After laborious parameterization processes, RHESSys was validated with the field observations from the GN watershed. The parameter set identified at the GN watershed was then applied to the GS watershed in Mt. Jumbong, which resulted in good agreement for SWC but poor predictability for WBP. Our study showed that RHESSys simulated reliable SWC at the GS by adjusting site-specific porosity only. In contrast, vegetation productivity would require more rigorous site-specific parameterization and hence, further study is necessary to identify primary field ecophysiological variables for enhancing model parameterization and application to multiple watersheds.

• Economic and Environmental Geology
• /
• v.49 no.4
• /
• pp.281-290
• /
• 2016

Coastal areas, used as human utilization areas like leisure space, medical care, ports and power plants, etc., are regions that are continuously changing and interconnected with oceans and land. Regular monitoring of coastal changes is essential at key locations with such volatility. But the survey method of terrestial LiDAR(Light Detection and Ranging) system has much time consuming and many restrictions. For effective monitoring coastal changes, KIOST(Korea Institute of Ocean Science & Technology) has constructed a shipborne mobile LiDAR system. The shipborne mobile LiDAR system, installed in a research vessel, comprised a land based LiDAR(RIEGL LMS-420i), an IMU(MAGUS Inertial+), a RTKGNSS(LEICA GS15 GS25), and a fixed platform. The shipborne mobile LiDAR system is much more effective than a land based LiDAR system in the measuring of fore shore areas without shadow zone. Because the vessel with the shipborne mobile LiDAR system is continuously moved along the shoreline, it is possible to efficiently survey a large area in a relatively short time. We conducted test measurements in the Anmok-Songjung beach around the Gangneung port. Effective monitoring of the changes using the constructed shipborne mobile LiDAR system for seriously eroded coastal areas will be able to contribute to coastal erosion management and response.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.550-553
• /
• 2001

In this study, unity current gain frequency f$\_$T/ of GaAs MESFET is predicted with different temperatures up to 400 $^{\circ}C$. Temperature dependence parameters of the device including intrinsic carrier concentration n$\_$i/ effective mass, depletion width are considered to be temperature dependent. Small signal parameters such as gate-source, gate dran capacitances C$\_$gs/ C$\_$gd/ are correlated with transconductance g$\_$m/ to predict the unity current gain frequency. The extrinsic capacitance which plays an important roles in high frequency region has been taken into consideration in evaluating total capacitance by using elliptic integral through the substrate. From the results, f$\_$T/ decreases as the temperature increases due to the increase of small signal capacitances and the mobility degradation. Finally the extrinsic elements of capacitances have been proved to be critical in deciding f$\_$T/ which are originated from the design rule of the device.

• Bulletin of the Korean Mathematical Society
• /
• v.33 no.4
• /
• pp.545-551
• /
• 1996

It is well known in the theory of distributions and proved in [GS, S] that $$ (i) (Bochner-Schwartz) Every positive definite (tempered) distribution is the Fourier transform of a positive tempered measure \mu. $$ $$ (ii) (Schwartz kernel theorem) Let B(\varphi, \psi) be a bilinear distribution. Then for some u \in D'(R^n \times R^n) B(\varphi, \psi) = u(\varphi(x)\bar{\psi}(y)) for every \varphi, \psi \in C_c^\infty. $$ $$ (iii) A translation invariant positive definite bilinear distribution B(\varphi, \psi) is of the form B(\varphi, \psi) = \smallint \varphi(x)\psi(x) d\mu(x) for every \varphi, \psi \in C_c^\infty (R^n), where \mu is a positive tempered measure.

• Membrane Journal
• /
• v.2 no.1
• /
• pp.1-20
• /
• 1992

Classical membrane processes like microfiltration (MF), ultrafiltration (UF) and reverse osmosis (RO) are being applied in the last years more frequently in environmental and effluent process problems. Newer technologies and developments like pervaporation (PV) and gas sepaxation (GS) recently found commercial applications in the treatment of waste waters and gas streams. The incentive here is either the clean-up from organic components to comply with federal emission regulations or the recovery of the organics for economical reasons. Processes still in their development stage are combinations of chemical reactions with membrane processes to separate and treat $SO_x$ and $NO_x$ laden waste gas streams in the clean-up of stack-gases. In this paper we will first give a short overview of the more recent developments in MF, UF and RO. This is followed by a closer look on newer technologies applied in environmental problems. The applications looked at are the recovery of organic components from solvent laden gas streams and the separation of organic volatiles from aqueous waste waters via pervaporation. Technical solutions, the advantages and disadvantages of the processes and. where possible, cost estimations will be presented.

• Journal of the Korean Society of Visualization
• /
• v.15 no.2
• /
• pp.48-58
• /
• 2017

To analyze bubbles generated by an ABB (Air Bubble Barrier), we developed image processing procedure and statistical analysis method. Air was discharged from 5 mm nozzle as swarm form at the bottom of 1 m3 water tank. Flow rates of discharged air are ranged from 2 L/min to 20 L/min and these are corresponding to Reynolds number of 1766-17663. Rise velocity of bubble is extracted by using image process pretending intrusive method. Mean equivalent velocity was calculated using void fraction weighting factor. Bubble diameter is obtained and compared with correlations in the literature. Also, we present a correlation according to the result of this study. Mean velocity and mean diameter of bubbles increase with increasing gas Reynolds number. But these parameters show an asymptotic trend when they approach to high Reynolds number.

• Korean Journal of Animal Reproduction
• /
• v.11 no.3
• /
• pp.181-188
• /
• 1987

This stduy was carried out to investigate the effects of Isoimmunization by sperm and seminal plasma on density of immunoglobulins in reproductive tract fluids and serum of immunized rabbits. The results obtained were summarized as follows: 1. Antibody titers against sperm and seminal plasma antigen ranged from 8 to 64 to 512, respectively. 2. All immunoglobulins; IgG, IgA and IgM were detected with Indirect ELISA method in the uterine and oviductal fluids as well as the sera of immune rabbits. 3. Concentrations of IgGs in the uterine and oviductal fluids of rabbits immunized with sperm and seminal plasma were higher than those of the control rabbits, but not showed any differences in sera. 4. Amount of IgA in the sera and oviductal fluids of control animals was more than that of the immune animals, while that of IgA in the uterine fluids of control and seminal plasma-immunized animals was higher as compared to sperm immune animals. 5. Average concentration of IgM in the uterine fluids of control and seminal plasma-immunized rabbits was higher than that of sperm-immunized ones. In the oviductal fluids, average concentrations of IgM of immune rabbits was higher than that of immune rabbits.