• Journal of Korean Society for Geospatial Information Science
• /
• v.18 no.4
• /
• pp.93-99
• /
• 2010

Since the facility management for various facilities in urban area are conducted by general managers who have poor knowledge for surveying technology, it is not easy to trace the exact location of the facility in a short time with the GIS map only by themselves in the field. In order to improve it, VRS-RTK or SBAS DGPS system integrated with UMPC and PDA which is uploaded GIS field software are being used recently however lot of difficulties are still existed with the GPS positioning in urban area due to the lack of visible satellites, no reception of correction data and multipath error by the interruption of the high buildings and houses etc. Therefore, in this study, we applied with Network DGPS system which allows better reception of satellite signal and correction data even in dense housing areas with the use of GNSS receiver and CDMA mobile phone. Based on the analysis of field data, it was confirmed that standard deviations of the Network DGPS positioning are 0.3 to 0.84m with a very high positioning rate even in dense housing areas. Therefore, it was concluded that the Network DGPS system could be used widely to fast and accurate positioning for various facilities management works in dense housing areas in the future.

• Journal of Korean Society for Geospatial Information Science
• /
• v.24 no.3
• /
• pp.11-18
• /
• 2016

Since GNSS signals get blocked by buildings in urban canyons or narrow alleys, it is very difficult to secure a enough number of visible satellites for satellite navigation in those poor signal-reception environments. In those situations, one cannot get their coordinates or obtain accurate positions. In this study, a couple of strategies for improving positioning accuracy in urban canyons were developed and their performance was verified. First of all, we combined GPS and GLONASS measurements together and devised algorithms to quality-control observed signals and eliminate outliers. Also, a new multipath reduction scheme was applied to minimize its effect by utilizing SNR values of the observed signals. For performance verification of the developed technique, a narrow alley of 10m width located near the back gate of the Inha University was selected as the test-bed, and then we conducted static and kinematic positioning at four pre-surveyed points. We found that our new algorithms produced an 45% improvement in an open-sky environment compared with the positioning result of a low-cost u-blox receiver. In the alleys, 3-D accuracy improved by an average of 37%. In the case of kinematic positioning, especially, biases showing up in regular receivers got eliminated significantly through our new filtering algorithms.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.8
• /
• pp.662-673
• /
• 2019

This paper investigates the most recent status of multi-GNSS, including technical features, types of ranging signals provided, and satellite constellation. Furthermore, a series of multi-GNSS positioning experiments in SPP mode were carried out to assess the achievable accuracy and continuity with an application to various positioning scenarios. A week of GNSS measurements each in 2018 and 2019 was acquired from the national geographical information institute and processed. The results show that a single GNSS-based scenario often encounters positioning blockage in the harsh operational environment, while multi-constellation cases are able to remedy this situation. The accuracy of multi-GNSS with a combination of GPS and Galileo is superior to that of other GNSS compositions due to the larger SISRE (Signal In Space Ranging Errors) of GLONASS and Beidou. Due to the different characteristics of GNSS SISRE, an issue has been raised to optimally integrate satellite measurements to maximize accuracy of multi-GNSS positioning.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.11
• /
• pp.1588-1595
• /
• 2021

Android-based smartphones receive the global navigation satellite system (GNSS) signals to determine their location and provide the GNSS raw measurement to users. The available GNSS signals on the current Android devices are GPS, GLONASS, Galileo, BeiDou, QZSS. This research has analyzed the performance of multi-GNSS position accuracy based on the pseudorange of the smartphone for maritime users. Smartphones capable of receiving dual-frequency are installed on a ship, and multi-GNSS raw information in maritime environment was measured to present the results of comparing the GNSS pseudorange-based dual-frequency positioning performance for each smarphone. Furthermore, we analyzed whether the results of the positioning performance can meet the HEA requirement of IMO for maritime navigation users. As the results of maritime experiment, it was confirmed that in the case of the smartphones supporting the dual-frequency, the position accuracy within 6 meters (95%) could be obtained, and the HEA position accuracy performance within 10 meters (95%) required by IMO could be achieved.

• Journal of Navigation and Port Research
• /
• v.37 no.3
• /
• pp.263-267
• /
• 2013

This paper describes the progress and the plan of 'Wide Area Differential GPS (WA-DGPS) Development' project supported by Korean Ministry of Oceans and Fisheries. The project develops the main algorithms of the WA-DGPS which guarantees the improved accuracy, availability, and integrity all over the Korean peninsula. After the establishment of WA-DGPS ground infrastructure system, a real-time demonstration using pseudolite installed on the ground will be conducted in the final year. Also, the development of Korean Satellite-based Augmentation System (SBAS) is expected to be started from 2014, and the algorithms and the results in the WA-DGPS project will be used in the SBAS development.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.5
• /
• pp.2045-2049
• /
• 2018

An antenna arrays for a satellite navigation systems require more antenna elements to mitigate multiple jamming signals. In order to maintain the small array size while increasing the number of antenna elements, miniaturization technique is essential for antenna design. In this work, an electrically small circular microstrip patch antenna with a 3 dB hybrid coupler is designed as an element antenna, where the 3 dB hybrid coupler can yield the circularly polarized radiation characteristic. The miniaturized element antenna typically has too large capacitance in GPS L1 and GLONASS G1 bands, making it difficult to match with a single stand-alone non-Foster matching circuit (NFMC) in a stable state. Therefore, we propose a new matching technique, referred to as the hybrid matching method, which consists of a NFMC and a passive circuit. This passive tuning circuit manages reactance of antenna elements at an appropriate capacitance without a pole in the operating frequency range. The antenna array is fabricated, and the measured results show a reflection coefficient of less than -10 dB and an isolation of greater than 50 dB. In addition, peak gain of the proposed antenna is increased by 22.3 dB compared to the antenna without the hybrid matching network.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2017.05a
• /
• pp.61-62
• /
• 2017

In this study, a circular polarization patch antenna operates at the wide bandwidth of 1.5GHz~1.7GHz was designed. To obtain the wide bandwidth and high gain, the high air substrate was applied. The impedance bandwidth is improved by adjusting the sizes of patch, the distance between main patch and ground plate, the length of internal slots, the position of feeding point, the length of external stub, etc. The antenna is designed by simulation for an operation in the frequency range of 1.5GHz~1.7GHz band, and the antenna characteristics such as return loss, gain, radiation patterns are examined.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.5
• /
• pp.2004-2010
• /
• 2018

We propose a small active antenna to receive Global Navigation Satellite System (GNSS) signals, i.e., Global Positioning System (GPS) L1 (1,575MHz) and Russian Global Navigation Satellite System (GLONASS) L1 (1,600 MHz) signals. A two-stage low-noise amplifier (LNA) with more than 27 dB gain is implemented in the bottom layer of a three-layer antenna package. In addition, a hybrid coupler is used to combine signals from pair of proximately coupled orthogonal feeds with $90^{\circ}$ phase difference to achieve the circular polarization (CP) characteristic. Three layers of high permittivity (${\varepsilon}_r=10$) substrates are stacked and effectively integrated to have a small dimension of $64mm{\times}64mm{\times}7.42mm$ (including both circuit and antenna). The reflection coefficient of the fabricated antenna at the target frequency is below -10 dB, the measured antenna gain is above 26 dBic and the measured noise figure is less than 1.4 dB.

• Journal of Positioning, Navigation, and Timing
• /
• v.7 no.4
• /
• pp.189-203
• /
• 2018

In this paper, a Software Defined Radio (SDR) architecture was designed and implemented for rapid prototyping of GNSS receiver. The proposed SDR can receive various GNSS and direct sequence spread spectrum (DSSS) signals without software modification by expanded input parameters containing information of the desired signal. Input parameters include code information, center frequency, message format, etc. To receive various signal by parameter controlling, a correlator, a data bit extractor and a receiver channel were designed considering the expanded input parameters. In navigation signal processing, pseudorange was measured based on Coordinated Universal Time (UTC) and appropriate navigation message decoder was selected by message format of input parameter so that receiver position can be calculated even if SDR is set up various GNSS combination. To validate the proposed SDR, the software was implemented using C++, CUDA C based on GPU and USRP. Experimentation has confirmed that changing the input parameters allows GPS, GLONASS, and BDS satellite signals to be received. The precision of the position from implemented SDR were measured below 5 m (Circular Error Probability; CEP) for all scenarios. This means that the implemented SDR operated normally. The implemented SDR will be used in a variety of fields by allowing prototyping of various GNSS signal only by changing input parameters.

• Journal of Positioning, Navigation, and Timing
• /
• v.10 no.4
• /
• pp.279-289
• /
• 2021

GNSS receivers capable of tracking multiple Global Navigation Systems (GNSSs) simultaneously are widely used. In order to estimate accurate user position and velocity, it is necessary to consider the key elements that contribute to the interoperability of the different GNSSs. Typical examples are the time system and the coordinate system. Each GNSS is operated based on its own reference time system depending on when the system was developed and whether the leap seconds are applied. In addition, each GNSS is designed based on its own coordinate system based on earth model constant values. This paper addresses the interoperability issues from the viewpoint of Single Point Positioning (SPP) users utilizing multiple GNSS signals from GPS, GLONASS, BeiDou, and Galileo. Since the broadcast ephemerides of each GNSS are based on their own time and coordinate systems, the time and the coordinate systems should be unified for any user algorithm. For this purpose, this paper proposes a method of converting each GNSS coordinate system into the reference coordinate system through Helmert transformation. The error of the broadcast ephemerides was calculated with the precise ephemerides provided by the International GNSS Service (IGS). The effectiveness of the proposed multi-GNSS correction and transformation method is verified using the Multi-GNSS Experiment (MGEX) station data.