• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.7
• /
• pp.666-673
• /
• 2008

To construct the accurate radio satellite navigation system, the efficient communication each satellite with the ground station is very important. Throughout the communication, the orbit of each satellite can be corrected, and those information will be used to analyze the satellite satus by the operator. Since there are limited resources of ground station, the schedule of antenna's azimuth and elevation angle should be optimized. On the other hand, the satellite in the medium earth orbit does not pass the same point of the earth surface due to the rotation of the earth. Therefore, the antenna pass schedule must be updated at the proper moment. In this study, Q learning approach which is a form of model-free reinforcement learning and genetic algorithm are considered to find the optimal antenna schedule. To verify the optimality of the solution, numerical simulations are conducted.

• Journal of Satellite, Information and Communications
• /
• v.8 no.1
• /
• pp.40-44
• /
• 2013

In this paper, we describe on the position error of GBAS. In reality, there are many sources which make errors into the calculation of receiver position. It is well known that the DOP of GBAS is an important position error source and is dependent on the numbers and positions of the transmitters. Here, we develop an algorism to calculate the DOP of the GNSS with 2-line transmitters into Korean area. The result is useful to predict the DOP of the positions where transmitters and receivers are located.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.1
• /
• pp.47-54
• /
• 2014

Precise Point Positioning (PPP) algorithms using GPS code pseudo-range measurements were developed and their accuracy was validated for the purpose of implementing them on a portable device. The group delay, relativistic effect, and satellite-antenna phase center offset models were applied as fundamental corrections for PPP. GPS satellite orbit and clock offsets were taken from the International GNSS Service official products which were interpolated using the best available algorithms. Tropospheric and ionospheric delays were obtained by applying mapping functions to the outputs from scientific GPS data processing software and Global Ionosphere Maps, respectively. When the developed algorithms were tested for four days of data, the horizontal and vertical positioning accuracies were 0.8-1.6 and 1.6-2.2 meters, respectively. This level of performance is comparable to that of Differential GPS, and further improvements and fine-tuning of this suite of PPP algorithms and its implementation at a portable device should be utilized in a variety of surveying and Location-Based Service applications.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.12
• /
• pp.1245-1255
• /
• 2012

There are various anti-jamming algorithms for the GNSS system which is vulnerable to jamming, and the methods using array antenna show the best performance. Among them, the DOA estimation algorithms to identify the location of the jammer is very important. However, in case of the rotorcraft, the wireless channel which amplitude and phase changes with time is generated by the rotation of the rotor and it affects the performance of existing anti-jamming algorithms. In this paper, we modeled the effect of the rotor in four scenarios according to the correlation of antennas and assured that the performance of DOA estimation algorithms are degraded and saturated regardless of JNR due to the rotor effect. When we use the averaging method to solve this problem, the performance is improved as increasing samples for estimating. And in case of using moving average method with averaging, it shows similar performance. In addition, it reduces the required memory and moderates the variation of DOA estimation.

• Journal of Advanced Navigation Technology
• /
• v.20 no.5
• /
• pp.394-400
• /
• 2016

It is well known that the encrypted ranging signal, such as GPS P(Y) code, is immune to spoofing attack. However, in order for users to use the signal, there needs permission from the operator. And also there are many restrictions for use because of security issues. In this paper, a ground reference station equipped with high-gain directional antenna and a user receiver were simulated. In the reference station, the encrypted code can be demodulated from the high-gain signal. And then the code can be used to detect spoofing attack in the user receiver. This paper proposes the spoofing detection method using the encrypted signal and deals with simulation results.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.39 no.5
• /
• pp.313-319
• /
• 2021

The national geodetic reference frame of Korea was adopted in 2003, which is referenced to ITRF (International Terrestrial Reference Frame) 2000 at the epoch of January 1, 2002. For precise positioning based on the satellites, it should be thoroughly maintained to the newest global reference frame. Other than plate tectonic motion, there are significant events or changes such as earthquakes, antenna replacement, PSD (Post-Seismic Deformation), seasonal variation etc. We processed three years of GNSS (Global Navigation Satellite System) data(60 NGII CORS stations, 51 IGS core stations) to produce daily solutions minimally constrained to ITRF. From the time series of daily solutions, the sites with unexpected discontinuity were identified to set up an event(mostly antenna replacement). The combined solution with minimum constraints was estimated along with the velocity, the offsets, and the periodic signals. The residuals show that the surrounding environment also affects the time series to a certain degree, thus it should be improved eventually. The transformation parameters to ITRF2014 were calculated with stability and consistency, which means the national geodetic reference frame is properly aligned to the global reference frame.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.3
• /
• pp.113-119
• /
• 2014

The positioning accuracy of GNSS surveys deteriorates due to various error factor, and many users sometimes ignore Phase Center Variation (PCV) of antennas. IGS provides an ANTEX file which contains PCV correction information to correct for PCVs. But it is not directly applicable because PCV correction information is provided at 5-degree intervals in the azimuth and elevation directions for the case of receiver antennas, and at 1-degree intervals in the nadir angle for the case of satellite antennas. So, we devised new and optimal ways of interpolating PCV in any desired line of sight to the GNSS satellite. We used spherical harmonics fitting methods in terms of the azimuth and elevation angle for interpolation, and found an optimal degree and order. It is shown that the best accuracy was obtained from the 8 by 8 spherical harmonics. If one requires lower burden on computing resources, the order and degree less than 8 could produce resonable accuracy except for 1st and 5th order.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.9
• /
• pp.963-968
• /
• 2008

A new method to deal with GPS indoor positioning by means of time synchronized switching GPS repeater has been developed by authors[1]. But the developed indoor positioning system has problems. Therefore, we proposed a method for indoor positioning using GNSS Repeater-Assisted. To solve the 3-dimensional user's position, the 4 or more retransmission antennas are needed in the previously proposed methods. If a GPS repeater periodically transmits the signal like as pseudollite, the information for assisting an acquisition and tracking can be informed to receiver. Then, the user position can be calculated using the induced weak signal. The advantage of the proposed algorithm is use of only 1 re-transmission antenna because the re-transmitted signal are not used for positioning but used for assisting an acquisition and tracking weak signals induced indoor. We analyze the propose algorithms through the experiment and performed the test of feasibility.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.41-45
• /
• 2006

To get accurate positions of GPS antennas, one should apply phase center variations (PCV) corrections in the data processing. Until recently, relative calibrations, originally proposed by National Geodetic Survey of United States, were the international standard. However, in late 2006, International GNSS Service will switch to absolute calibration methods. In this study, we compared the position differences caused by different PCV models, and their effects on the calculations of Precipitable Water Vapor (PWV) in the atmosphere. Data from ${\sim}40$ permanent GPS stations in Korea were processed and we found that the vertical position differences reach up to 5 cm, depending on the model selected. Also the PWV values varied quite significantly: the maximum bias in the computed PWV values was ${\sim}4$ mm.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.2
• /
• pp.57-65
• /
• 2015

Global Navigation Satellite System (GNSS) including Global Positioning System (GPS) is an important element for navigation of both the military and civil Unmanned Aerial Vehicle (UAV). Contrary to the military UAVs, the civil UAVs use the civil signals which are unencrypted, unauthenticated and predictable. Therefore if the civil signals are counterfeited, the civil UAV’s position can be manipulated and the appropriate movement of the civil UAV to the target point is not achieved. In this paper, spoofing on the autonomous navigation UAV is implemented through field experiments. Although the demanded conditions for appropriate spoofing attack exists, satisfying the conditions is restricted in real environments. So, the Way-point of the UAV is assumed to be known for experiments and assessments. Under the circumstances, GPS spoofing signal is generated based on the Software-based GNSS signal generator. The signal is emitted to the target UAV using the antenna of the spoofer and the effect of the signal is analyzed and evaluated. In conclusion, taking the UAV to the target point is hardly feasible. To implement the spoofing as expectation, the position and guidance system of the UAV has to be known. Additionally, the GPS receiver on the UAV could be checked whether it appropriately tracks the spoofing signal or not. However, the effect of the spoofing signal on the autonomous UAV has been verified and assessed through the experimental results. Spoofing signal affects the navigation system of the UAV so that the UAV goes off course or shows an abnormal operation.