• Publications of The Korean Astronomical Society
• /
• v.13 no.1 s.14
• /
• pp.39-54
• /
• 1998

We have developed solar observational system in the department of Astronomy & Space Sciences of KyungHee University, in order to monitor solar activities and construct solar database for space weather forecasting at maximum of 23rd solar cycle, as well as an solar education and exercise for undergraduate students. Our solar observational system consists of the full disk monitoring system and the regional observation system for H a fine structure. Full disk monitoring system is made of an energy rejection filter, 16cm refractor, video CCD camera and monitor. Monitored data are recorded to VHS video tape and analog output of video CCD can be captured as digital images by the computer with video graphic card. Another system for regional observation of the sun is made of energy rejection filter, 21cm Schmidt-Cassegrain reflector, H a filter with 1.6A pass band width and $375\times242$ CCD camera. We can observe H a fine structure in active regions of solar disk and solar limb, by using this system. We have carried out intense solar observations for a test of our system. It is found that Quality of our H a image is as good as that of solar images provided by Space Environmental Center. In this paper, we introduce the basic characteristics of the KyungHee Solar Observation System and result of our solar observations. We hope that our data should be used for space weather forecasting with domestic data of RRL(Radio Research Laboratory) and SOFT(SOlar Flare Telescope).

• The KSFM Journal of Fluid Machinery
• /
• v.14 no.6
• /
• pp.68-75
• /
• 2011

This study simulated the effect of steam injection on the performance and operation of a gas turbine combined heat and power (CHP) system. A commercial simple cycle gas turbine was analyzed. A full off-design analysis was carried out to investigate the variations in not only engine performance but also the operating characteristics of the compressor caused by steam injection. Variation in engine performance and operation characteristics according to various operation modes were examined. First, the impact of full steam injection was investigated. Then, operations aiming to guarantee a minimum compressor surge margin, such as under-firing and partial steam injection, were investigated. The former and latter were turned out to be relatively superior to each other in terms of power and efficiency, respectively.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.24 no.68
• /
• pp.85-94
• /
• 2001

Most of customers want to know how to develop the computer system they want to get to use according to the their requirements. This study presents a Computer Integration management System for Quality (CISQ) model for system-integration organizations, which need to demonstrate their capability to consistently provide computer integrated system that meets customer satisfaction and applicable regulatory requirements. The Plan.Do.Check.Act(PDCA) cycle called by Doming wheel expresses the basic concept of continuous improvement action in order to emphasize on achieving business goal. It is useful for providing full competence of a system-integration organization to integrate management systems based on the international management system, and to take an advantage in its market. This study specifies International Certification Network Business Excellence Concept(IBEC) approach to ensure a harmonized integration of the variety of management systems and thereby produce synergy effect. The end part of this study specifies a Assessment Model including an assessment concept adding to the compliance audit according to the CISQ for the continuous improvement. A simple application on Failure Modes and Effects Analysis(FMEA) in testing phase in project life cycle has been done.

• Journal of the Korea Society of Computer and Information
• /
• v.23 no.11
• /
• pp.103-109
• /
• 2018

This paper presents an idea and framework to automate a full cycle business process management and re-engineering by integrating traditional business process management systems, process mining, data mining, machine learning, and simulation. We build our framework on the cloud-based platform such that various data sources can be incorporated. We design our systems to be extensible so that not only beneficial for practitioners of BPM, but also for researchers. Our framework can be used as a test bed for researchers without the complication of system integration. The automation of redesigning phase and selecting a baseline process model for deployment are the two main contributions of this study. In the redesigning phase, we deal with both the analysis of the existing process model and what-if analysis on how to improve the process at the same time, Additionally, improving a business process can be applied in a case by case basis that needs a lot of trial and error and huge data. In selecting the baseline process model, we need to compare many probable routes of business execution and calculate the most efficient one in respect to production cost and execution time. We also discuss the challenges and limitation of the framework, including the systems adoptability, technical difficulties and human factors.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.15 no.4
• /
• pp.147-155
• /
• 2007

Mobile air conditioning systems work under widely changing operating conditions. To understand the system behavior under such dynamic conditions, a test facility that can impose transient loads as well as conducting dynamic measurements is needed. To test mobile air conditioning systems including their dynamic performance under various drive cycle patterns without using full scale vehicles in a wind tunnel, a new test facility, called "dynamic simulator," is described. It can replicate real vehicle operating conditions by interacting with the system being tested based on the measured system performance and subsequently adjusting the air properties returning to the test system based on the results of a numerical cabin model. A new dynamic simulator has been designed, constructed, and verified for performing dynamic tests. It was successful in controlling the temperature and relative humidity of the air returning to the test unit within ${\pm}0.7^{\circ}C$ and ${\pm}4%$ of their respective intended values. The verification test under the New European Driving Cycle demonstrated that detailed transient behavior of the mobile air conditioning system could be measured by using this dynamic simulator.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.11
• /
• pp.2045-2049
• /
• 2008

In this paper, we propose an novel architecture for H.264 High Profile Encoder Intra Prediction module. This designed module can be operated in 306 cycle for one-macroblock. To verify the Encoder architecture, we developed the reference C from JM 13.2 and verified the our developed hardware using test vector generated by reference C. We adopt plan removal and SAD calculation to reduce the Hardware cost and cycle. The designed circuit can be operated in 133MHz clock system, and has 250K gate counts using TSMC 0.18 um process including SRAM memory.

• Proceedings of the Korean Information Science Society Conference
• /
• 2010.06a
• /
• pp.283-284
• /
• 2010

• Journal of Korea Multimedia Society
• /
• v.18 no.1
• /
• pp.25-34
• /
• 2015

Recently, in distribution market, demand for electronic shelf label system is increasing gradually to provide the accurate price immediately and detailed product information to consumers and reduce operation costs. Most of electronic shelf label system companies develop the full-graphic display device to display a wide variety of product information as well as the exact price. Our system had introduced Go-Back-N retransmission method in the early. However, we encountered performance problems that it delayed updating of the electronic shelf label system and exhausted the battery life time. Proposed adaptive image retransmission technique based on the selective scheme is that tags of electronic shelf label system recognize idle time of transmission cycle and require partial image retransmission to sever by itself. As a result, it can acquire much more opportunities of partial image retransmission within the same period and increase reception rate of full image for each tags. The experimental result shows that adaptive image retransmission technique's reception rate of full image for each tags is approximately 4% higher than existing previous works. And total battery life time increases 30 hours because tag reduce wake-up time as it receive only lost data instead of whole data.

• Korean Journal of Computational Design and Engineering
• /
• v.16 no.4
• /
• pp.268-276
• /
• 2011

The product-level carbon footprint (PCF) is a comprehensive and widely accepted metric for sustainable product development. However, since a full PCF study in general is time and cost intensive, it is not feasible for the product development team to synchronize the activity to the main product development process. In addition, the current dedicated life cycle assessment (LCA) tools for calculating PCF, separated from the main product data management systems, have limitations to provide timely PCF information for design decision makings and collaborations between design and environment engineers. This paper examines the possibility of the extension of the current product data model that can support the PCF calculation with PDM (Product Data Management) databases. The product data model can represent not only the content of products but also context or system information of the products. The product data model can be implemented as a PDM database that can satisfy the needs for handy and timely PCF calculations from the consistent product data for dynamic design decision makings and engineering collaborations.

• Bulletin of the Korean Space Science Society
• /
• 2011.04a
• /
• pp.27.1-27.1
• /
• 2011

This study is about the ionospheric variation on the Korean Peninsula using GPS TEC data from Daejeon IGS GPS site. It has accumulated the 11 years GPS data from 2000. In this work, the hourly and daily averaged TEC data are used. Data period covers a full solar cycle from 2000 to 2010 (11 years) which the total observed days are 98%. The mean TEC data shows the annual/semiannual variation, solar cycle and 27 days. GPS TEC has a good correlation with solar F10.7 index. We also compare with planetary Kp and AE indices. The maximum of the daily mean GPS TEC is around 50 TECU at 2000 and that value of 2009 is near 10 TECU. we confirms that the GPS TEC is a good indicator for ionospheric variation for the mid-latitudinal region to understand the ionospheric climatology over Korea Peninsula.