• 한국세라믹학회지
• /
• 제36권9호
• /
• pp.982-990
• /
• 1999

YSZ/LSM composite cathode was fabricated by dip-coating of YSZ sol on the internal pore surface of a LSM cathode followed by sintering at low temperature (800-100$0^{\circ}C$) The YSZ coating significantly increased the TPB(Triple Phase Boundary) where the gas the electrode and the electrolyte were in contact with each other. Sinter the formation of resistive materials such as La2Zr2O7 or SrZrO3 was prevented due to the low processing temperature and TPB was increased due to the YSZ film coating the electrode resistance (Rel) was reduced about 100 times compared to non-modified cathode. From the analysis of a.c impedance it was shown that microstructural change of the cathode caused by YSZ film coating affected the oxygen reduction reaction. In the case of non-modified cathode the RDS (rate determining step) was electrode reactions rather than mass transfer or the oxygen gas diffusion in the experimental conditions employed in this study ($600^{\circ}C$-100$0^{\circ}C$ and 0,01-1 atm of Po2) for the YSZ film coated cathode however the RDS involved the oxygen diffusion through micropores of YSZ film at high temperature of 950-100$0^{\circ}C$ and low oxygen partial pressure of 0.01-0.03 atm.

• 한국세라믹학회지
• /
• 제47권2호
• /
• pp.195-198
• /
• 2010

It has been considered to apply GDC ($Gd_{0.1}Ce_{0.9}O_{1-X}$) for low-temperature SOFC electrolytes because it has higher ionic conductivity than YSZ at low temperature. However, open circuit voltage with using GDC ($Gd_{0.1}Ce_{0.9}O_{1-X}$) electrolyte in SOFCs, becomes lower than using YSZ (8 mol% Yttria stabilized Zirconia) electrolyte because GDC has electronic conductivity. In this work, the effect of changing GDC electrolyte thickness on the open circuit voltage has been investigated. Ni-GDC anode-supported unit cells were fabricated as follows. Mixed NiO-GDC powders were pressed and pre-sintered at $1200^{\circ}C$. And then, GDC electrolyte material was dip-coated on the anode and sintered at $1400^{\circ}C$. Finally the LSCF-GDC cathode material was screen-printed on the electrolyte and sintered at $1000^{\circ}C$. Electrolyte thickness was controlled by the number of dip-coating times. Open circuit voltage was measured depending on electrolyte thickness at $650^{\circ}C$ and found that the thicker GDC electrolyte was, the better OCV was.

• 한국세라믹학회지
• /
• 제56권2호
• /
• pp.173-177
• /
• 2019

Thermal properties of a SiO₂-B₂O₃-BaO ternary glass system depending on compositional change of BaO have been examined to find a proper sealing material for reversible oxide cells. Glass transition temperature and thermal expansion coefficients increased simultaneously up to 55 mol% of BaO content. The structural role of BaO with regard to the thermal properties has been discussed on the basis of Raman spectroscopy results. Flowability of the glass at sealing temperature has been examined with packed glass powders of 12 mm diameter along with a high temperature optical microscope. The practical sealing property of the glass was also examined with YSZ coated with NiO-yittria stabilized zirconia (NiO-YSZ) and it showed good adhesion without noticeable reaction with NiO-YSZ layer.

• 한국세라믹학회지
• /
• 제43권3호
• /
• pp.162-168
• /
• 2006

The perovskites with nominal compositions $La_{0.8}Sr_{0.2}Fe_{1-x}M_xO_3$ (M=Co, Mn, Ni, x=0.1-0.3) were fabricated by a solid-state reaction method as cathode materials of low-temperature operating Solid Oxide Fuel Cells (SOFCs). X-ray diffraction analysis and microstructure observation for the sintered samples were performed. The ac complex impedance were measured in the temperature range $600-900^{\circ}C$ in air and fitted with a Solatron ZView program. The electrical conductivity and polarization resistance of $La_{0.8}Sr_{0.2}Fe_{1-x}M_xO_3$ (M=Co, Mn, Ni, x=0.1-0.3) were characterized systematically. The porosities of the sintered samples were in the range of 25% to 38%. The polarization resistance of $La_{0.8}Sr_{0.2}Fe_{0.7}M_{0.3}O_3$ was $0.291{\Omega}cm^2\;at\;700^{\circ}C$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 D
• /
• pp.1312-1314
• /
• 1998

SOFC system is often subject to thermal cycle condition during normal start/stop, shutdown, and emergence state. Under the thermal cycle condition of heating and cooling, the SOFC components expand or shrink, which produces thermal stress and thermal shock. The SOFC performance is degraded by the thermal factors. To protect SOFC system from the thermal degradation, the optimum thermal condition must be clarified. In this study, to examine the thermal cycle characteristics, we fabricated single cells of planar SOFC with an area of $5{\times}5cm$. The electrolyte and PEN were tested under thermal cycle conditions in the range of$ 2-8^{\circ}C/min$. After thermal cycle test. crack creation of the components were examined using ultraviolet apparatus. No crack in the electrolyte and PEN were observed. The single cell system with alumina frame were also tested under thermal cycle conditions of 2, 3, $4^{\circ}C/min$. The single cell was fractured at the thermal cycle of 3 and $4^{\circ}C/min$ and the optimum condition of the thermal cycle to be found below $2^{\circ}C/min$.

• 전기화학회지
• /
• 제2권3호
• /
• pp.163-170
• /
• 1999

AFC 단전지에서 운전조건의 영향은 이제까지 자세히 연구된 바 없다. 본 연구에서는 초기 전해질 농도와 가스 운전압력의 영향을 살펴보기 위하여 1차원 등온 모델을 이용해 전산모사를 수행하였다. 결과에 의하면, base-case에서 최적 전해질 농도는 $3.0\~3.5M$사이에 있는 것으로 발견되었다. 전해질 농도에 따른 전지 성능의 변화는 주로 양쪽 전극의 전하전달 저항과 용해된 기체의 헨리상수 및 액상확산이 원인인 것으로 밝혀졌다. 또한, 운전 압력의 증가는 반응속도와 가스의 용해도를 증가시켰으며, 이것으로 인해 전지 성능이 상당히 향상되는 것으로 조사되었다

• Journal of Electrochemical Science and Technology
• /
• 제8권3호
• /
• pp.169-182
• /
• 2017

Iron and nitrogen codoped carbon (Fe-N/C) catalysts have emerged as one of the most promising replacements for state-of-the-art platinum-based electrocatalysts for oxygen reduction reaction (ORR) in polymer electrolyte fuel cells. During the last decade, significant progress has been achieved in Fe-N/C catalysts in terms of ORR activity improvement and active site identification. In this review, we focus on recent efforts towards advancing our understanding of the structure of active sites in Fe-N/C catalysts. We summarize the spectroscopic and electrochemical methods that are used to analyze active site structure in Fe-N/C catalysts, and the relationship between active site structure and ORR activity in these catalysts. We provide an overview of recently reported synthetic strategies that can generate active sites in Fe-N/C catalysts preferentially. We then discuss newly suggested active sites in Fe-N/C catalysts. Finally, we conclude this review with a brief future outlook.

• Journal of Electrochemical Science and Technology
• /
• 제9권2호
• /
• pp.133-140
• /
• 2018

$Sr_{0.92}Y_{0.08}Ti_{0.5}Fe_{0.5}O_{3-{\delta}}$ (SYTF0.5) is investigated as an alternative anode in $H_2$ fuels containing $H_2S$ (0-200 ppm). Although additional ionic conductivity is introduced by aliovalent substitution of $Ti^{4+}$ by $Fe^{3+}$ in the B-site, the SYTF0.5 has lower electrical conductivity than that of the $Sr_{0.92}Y_{0.08}TiO_{3-{\delta}}$. Due to the mixed ionic and electronic conductive (MIEC) property exhibited in the SYTF0.5 anode, the electrochemical performance of the SYTF0.5 anode is improved, as well as the sulfur tolerance. The maximum power densities in $H_2$ at $900^{\circ}C$ for the SYT anode and the SYTF0.5 anode were 56.9 and $98.6mW/cm^2$, respectively. The maximum power density in the SYTF0.5 anode at 200 ppm of $H_2S$ concentration decreased by only 12.9% (86.3 to $75.2mW/cm^2$).

• 공업화학
• /
• 제24권4호
• /
• pp.337-343
• /
• 2013

멤브레인 반응기는 멤브레인과 반응기를 결합하여 반응과 분리의 단위공정을 하나로 결합함으로써 전체공정을 단순화하고 반응효율을 높이고자 하는 혁신 기술로써, 멤브레인을 이용한 생성물의 선택적 제거를 통해 열역학적 평형을 뛰어넘는 전환율, 부반응물 생성 억제에 의한 반응 효율 및 선택성을 향상시킬 수 있다. 특히 이온전도성 세라믹을 이용한 멤브레인 반응기는 연료전지의 개발, 고순도 산소/수소의 분리/정제, 이산화탄소의 전환 및 다양한 화학제품제조에 까지 응용될 수 있기 때문에 시장의 확대와 더불어 크게 발전할 수 있을 것으로 기대된다. 본 총설에서는 수소이온 전도성 세라믹 멤브레인 반응기에 대한 연구동향과 다양한 응용분야 및 향후 전망 등에 고찰해 보고자 한다.

• Bulletin of the Korean Chemical Society
• /
• 제26권2호
• /
• pp.241-247
• /
• 2005

A series of proton conductive inorganic-organic hybrid membranes doped with phosphoric acid ($H_3PO_4$) and/or triethylphosphate (PO(OEt)$_3$) have been prepared by sol-gel process with 3-glycidoxypropyltrimethoxysilane (GPTMS), 3-aminopropyltriethoxysilane (APTES) and tetraethoxysilane (TEOS) as precursors. High proton conductivity of 3.0 ${\times}$ $10^{-3}$ S/cm with composition of 50TEOS-30GPTMS-20APTES-50$H_3PO_4$ was obtained at 120 ${^{\circ}C}$ under 50% relative humidity. Thermal stability of membrane was significantly enhanced by the presence of SiO$_2$ framework up to 250 ${^{\circ}C}$. XRD revealed that the gels are amorphous. IR spectra showed a good complexation of $H_3PO_4$ in the matrix. The conductivity under 75% relative humidity was significantly improved by addition of APTES due to the increase in concentration of defected site in hybrid matrix. The effect of PO(OEt)$_3$, humidifying time, and heat-treatment were also investigated. PO(OEt)$_3$ had no improvement on conductivity and conductivity increased with humidifying time, however, decreased with heating temperature.