• 한국자동차공학회논문집
• /
• 제8권6호
• /
• pp.31-39
• /
• 2000

In this paper, characteristics of a port injection type LPG fuel system were investigated to adopt the system to a spark ignition engine through rig test. Engine combustion characteristics for limited conditions and the precise control method of LPG fuel supply were also studied. As a basic experiment, the effects and the relationships of parameters such as orifice area, fuel delivery pressure, fuel temperature and flow coefficient were established. From this, one dimensional compressible flow equation can be applied to control gaseous fuel flow rate by setting pressure difference between vaporizer and manifold to a certain range, for example about 1.2 bar in a naturally aspirated engine. The combustion analysis results of LPG engine were also compared with those of gasoline engine according to spark timing and load change. At part load and stoichiometric condition, the MBT spark timing of LPG fueled engine is retarded by 2$^{\circ}$ - 4$^{\circ}$CA compared to that of gasoline engine. On the contrary, the spark timing of LPG fueled engine can be advanced by 5$^{\circ}$- 10$^{\circ}$ CA at WOT, which results from higher Octane Number and burned fraction of LPG fuel compared to gasoline.

• 한국자동차공학회논문집
• /
• 제21권2호
• /
• pp.146-153
• /
• 2013

CNG buses has contributed to improve air quality in cities. But it is difficult to meet the next emission regulations such as EURO-VI without the help of additional post-processing device. Hydorgen has higher flame speed and lower combustion temperature that make it thermal efficiency increase with leaner operation. Using hydrogen natural gas blend (HCNG) fuel is promising technology which can reduce $NO_x$ and $CO_2$ emissions for a natural gas vehicle. However, fuel flow rate of HCNG should be increased since hydrogen's energy density per volume is much smaller than natural gas. In the present study, the characteristics of fuel supply system and its applicability were evaluated in a heavy duty natural gas engine. The results showed that the potential of fuel pressure regulator and fuel metering valve had enough capacity with HCNG. Employed mixer did not affect the distribution characteristics of mixture.

• 한국추진공학회지
• /
• 제16권6호
• /
• pp.92-97
• /
• 2012

발사체의 추진기관은 일반적으로 산화제와 연료를 연소실로 공급하여 추진력을 얻게 된다. 개발 중에 있는 한국형 발사체(KSLV-II) 2단 엔진의 경우 산화제로는 액체산소(Liquid Oxygen)를 사용하고 연료로는 JET-A1이 사용될 예정이다. 터보펌프 공급방식인 2단 엔진의 주요 구성은 연소기와 터보펌프, 엔진공급시스템 등으로 구성되어 있다. 액체 추진 엔진 개발을 위해서는 서브시스템인 연소기 개발이 선행되어야 하고 설계 및 제작된 연소기의 성능 검증은 연소기 연소시험설비(CCTF)에서 수행된다. 우주센터에 구축 예정인 연소기 연소시험설비에 대한 상세설계가 수행되었으며, 본 설계 결과를 기준으로 AMESim을 사용하여 산화제공급시스템에 대한 모델링을 수행하여 산화제 공급특성을 해석하였다.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2012년도 제38회 춘계학술대회논문집
• /
• pp.502-506
• /
• 2012

발사체의 추진기관은 일반적으로 산화제와 연료를 연소실로 공급하여 추진력을 얻게 된다. 개발 중에 있는 한국형 발사체(KSLV-II) 2단 엔진의 경우 산화제로는 액체산소(Liquid Oxygen)를 사용하고 연료로는 JET-A1이 사용될 예정이다. 터보펌프 공급방식인 2단 엔진의 주요 구성은 연소기와 터보펌프, 엔진공급시스템 등으로 구성되어 있다. 액체 추진 엔진 개발을 위해서는 서브시스템인 연소기 개발이 선행되어야 하고 설계 및 제작된 연소기의 성능 검증은 연소기 연소시험설비(CCTF)에서 수행된다. 우주센터에 구축 예정인 연소기 연소시험설비에 대한 상세설계가 수행되었으며, 본 설계 결과를 기준으로 AMESim을 사용하여 산화제공급시스템에 대한 모델링을 수행하여 산화제 공급특성을 해석하였다.

• 한국분무공학회지
• /
• 제12권1호
• /
• pp.38-44
• /
• 2007

Since the Liquid Phase LPG injection (LPLI) system has Advantages in power generation and emission characteristics compared to the mixer-type fuel-supply system, a variety of studies regarding LPLi system has been conducted and its applications are made in automobile industry. However, the heat extraction due to the evaporation of liquid fuel, causes not only a post-accumulation of fuel but also an icing phenomenon which is a frost of moisture in the air around the nozzle tip. Since there exists a difficulty in the accurate control of air fuel ratio in both fuel supply systems, it can result in poor engine performance and a large amount of harmful emissions. This research examines the characteristics of icing phenomenon and develops anti-icing bushing to prevent an icing on the surface of the injection tip. It was found that n-butane, which has a relatively high boiling point ($-0.5^{\circ}C$), was a main species of post-accumulation. Also the results show that the post-accumulation problem was allevaited the utilization of a large inner to outer bore ratio and smooth surface roughness. In addition, an icing phenomenon and its formation process were found to be mainly affected by the humidity and the temperature of inlet air in an inlet duct. Also, it was observed that an icing phenomenon is lessened using aluminum bushing whose end coincides with the end of fuel injection tip in length.

• 설비공학논문집
• /
• 제24권2호
• /
• pp.91-101
• /
• 2012

A 200 W portable polymer electrolyte membrane fuel cell (PEMFC) system is developed. The PEMFC system consists of an air-cooled fuel cell stack module, a fuel supply subsystem, a power management subsystem, and a control electronics subsystem. The control logic is designed for the stable system operation. The system-level performance evaluation discloses that the present PEMFC system provides a rated power output of 200.5 W at 13.4 V with the maximum balance-of-plant (BOP) efficiency of 72%, and maximum system efficiency based on lower heating value (LHV) is 37% at 120.7 W system power output.

• 방사성폐기물학회지
• /
• 제16권3호
• /
• pp.369-376
• /
• 2018

The ability to recover the nearly limitless supply of uranium contained within the world's oceans would provide supply security to uranium based fuel cycles. Therefore, in addition to U.S. national laboratories conducting R&D on a system capable of harvesting seawater uranium, a number of collaborative university partners have developed alternative technologies to complement the national laboratory scheme. This works summarizes the systems analysis of such novel uranium recovery technologies along with their potential impacts on seawater uranium recovery. While implementation of some recent developments can reduce the cost of seawater uranium by up to 30%, other researchers have sought to address a weakness while maintaining cost competitiveness.

• Journal of Electrical Engineering and Technology
• /
• 제12권4호
• /
• pp.1511-1518
• /
• 2017

Renewable energy hybrid systems look into the process of choosing the finest arrangement of components and their sizing with suitable operation approach to deliver effective, consistent and cost effective energy source. This paper presents hybrid renewable energy system (HRES) solar photovoltaic, downdraft biomass gasifier, and fuel cell based generation system. HRES electrical power to supply the electrical load demand of academic research building sited in $23^{\circ}12^{\prime}N$ latitude and $77^{\circ}24^{\prime}E$ longitude, India. Fuzzy logic programming discover the most effective capital and replacement value on components of HRES. The cause regarding fuzzy logic rule usage on HOMER pro (Hybrid optimization model for multiple energy resources) software program finds the optimum performance of HRES. HRES is designed as well as simulated to average energy demand 56.52 kWh/day with a peak energy demand 4.4 kW. The results shows the fuel cell and battery bank are the most significant modules of the HRES to meet load demand at late night and early morning hours. The total power generation of HRES is 23,794 kWh/year to the supply of the load demand is 20,631 kWh/year with 0% capacity shortage.

• 한국수소및신에너지학회논문집
• /
• 제14권4호
• /
• pp.348-358
• /
• 2003

According to Electricity Acceleration Law of Rural Area recently, the needs for replacement of a small scale diesel power generation facility which supplied electricity to 10-50 households Remote Islands has been revealed due to high operating and maintenance cost of Diesel Power Generation. Optimization of electric power system for Small Remote Islands must be made considering the economics, reliability and stability as power sources and estimation of total construction cost of those power stations. For its purpose, an assessment of power generation options such as Photovoltaic, Fuel cell, Wind-hybrid was implemented, economic evaluation of power supply shows the Photovoltaic, Fuel Cell for few household's islands and Diesel, Wind-hybrid for more inhabited islands. Power supplied by Diesel shows the best response to increasing electric demand and system reliability even with its lower economic value. Those who are in charge of power planning have to pay attention to system reliability, stability and operating characteristics of candidate's power supply besides its economics.

• 항공우주기술
• /
• 제12권1호
• /
• pp.200-206
• /
• 2013

액체로켓엔진에서 추진제 밀도와 공급 압력 변화에 대한 성능 민감도를 분석하였다. 해석 프로그램은 터보펌프-가스발생기 연계시험 결과와 비교하여 1% 오차를 가지는 것으로 확인되었다. 연료 공급압력이 증가하면 혼합비 감소로 인해 엔진 연소압이 감소하였고 연료의 밀도가 증가하면 혼합비 감소에도 불구하고 추진제 유량이 증가하므로 엔진 연소압이 증가하는 것으로 예측되었다. 또한 산화제의 밀도가 증가되거나 공급압력이 증가하면 엔진의 연소압이 증가할 것으로 분석되었다.