• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• 제36권2호
• /
• pp.128-133
• /
• 2010

Mesenchymal chondrosarcoma is very aggressive and represents approximately 1% of all chondrosarcomas. While it affects a very wide age range, the peak frequency is in the second decade of life. It may occur in the head and rib region with a predilection for the maxillofacial skeleton. The small cell undifferentiated component may assume a hemangiopericytoma-like vascular pattern and should be distinguished from hemangiopericytoma. Treatment is en bloc resection, the intended tissue margins of excision should be designed to extend well beyond the actual tumor margin, as mesenchymal chondrosarcomas. Aggressive behavior of mesenchymal chondrosarcoma of the jaw, with a tendency for delayed recurrence and metastasis even many years after treatment. The most frequent site of metastasis was the lung. Here we present 52 years old, female case of mesenchymal chondrosarcoma occurs on Rt. mandible.

• 대한기계학회논문집B
• /
• 제26권8호
• /
• pp.1123-1131
• /
• 2002

An experimental study on the performance and instability development characteristics of a centrifugal compressor equipped with a cambered variable diffuser has been performed with varying diffuser vane angles. The test was conducted at the design speed of 20,800 rpm and the 80% design speed of 16,640 rpm for 5 diffuser angles : 65$^{\circ}$, 70$^{\circ}$, 75$^{\circ}$, 77.5$^{\circ}$, 80$^{\circ}$ The steady performance test results showed that choking mass flow rate decreases and total pressure ratio increases with a narrowed surge margin as the diffuser vane angle increases. Unsteady pressures were measured using high-frequency pressure transducers at the inducer and the diffuser throat to investigate the instability phenomena such as rotating stall and surge inside the compressor. From the unsteady measurements, it is found that the transient process from rotating stall to surge was mainly affected by diffuser angles. The results of the present study can be applied to the instability control of the centrifugal compressors using a variable diffuser.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1991년도 하계학술대회 논문집
• /
• pp.720-725
• /
• 1991

In this thesis, the lead-lag compensator is designed to improve output characteristics of flyback zero voltage switching quasi-resonant converters. The switch and the diode are assumed ideally. And the SMPS is modelled by state equations with four operation modes. And the model for controller design is also achived by using a state space averaging method, which is continuous time average of state variables every period. The lag, the lead and the lead-lag compensator is designed the SMPS respectively. The time domain analysis and the frequency domain analysis are done for each compensated circuit. It is possible increasing the phase margin and improving the transient response by the compensators. The phase lag compensator has small overshoot comparatively. But the bandwidth is narrower than the others, so it has longest settling time. For the phase lead compensator, the response come to steady-state within short period. But the overshoot is the largest due to its large peak gain. Finally, the phase lead-lag compensator has medium characteristics in the overshoot and the settling time.

• 한국항공우주학회지
• /
• 제33권11호
• /
• pp.95-105
• /
• 2005

우주시스템연구실에서는 2008년 발사 예정으로 나노위성인 HAUSAT-2를 개발하고 있다. HAUSAT-2 구조-열 모델(STM)은 구조 및 열적 설계마진을 검증하기 위하여 개발한 시스템 모델이다. HAUSAT-2의 구조-열 모델을 이용하여 인증 수준의 진동시험과 열진공/평형시험을 수행하였다. 본 논문에서는 구조-열 모델의 구조해석과 진동시험의 결과를 비교하였고 이를 통해 해석조건을 변경해 재해석을 수행하였다. 인증수준의 진동시험 결과 구조-열 모델은 구조적인 손상 없이 설계 강성 요구조건을 만족하는 것을 확인하였다. 또한 구조 조립을 통해 조립성과 인터페이스를 확인하였다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2008년도 하계종합학술대회
• /
• pp.565-566
• /
• 2008

The high efficiency power management IC(PMIC) for Moblie application is proposed in this paper. PMIC is controlled with PWM control method in order to have high power efficiency at high current level. The saw-tooth generator is made to have 1.2 MHz oscillation frequency and full range of output swing from ground to supply voltage(VDD:3.3V). The comparator is designed with two stage OP amplifier. And the error amplifier has 70dB DC gain and $64^{\circ}$ phase margin. DC-DC converter, based on Voltage-mode PWM control circuits, achieved the high efficiency near 95% at 100mA output current. DC-DC converter is designed with LDO in stand-by mode which fewer than 1mA for high efficiency.

• 항공우주기술
• /
• 제2권1호
• /
• pp.108-116
• /
• 2003

본 연구는 통신위성 전력제어장치(Power control&Distribution Unit)의 설계 및 해석에 관한 내용을 기술한다. 위성체 전력제어장치는 임무기간동안 각 서브시스템과 탑재체에 충분한 전력을 공급하여야 하며, 또한 우주환경 하에서 높은 신뢰성 및 성능이 요구된다. 전력제어 및 분배장치의 제어회로를 위해 버스전압검출 및 필터회로, 오차신호 증폭회로 그리고 SAS 및 BPC 오차신호 회로가 포함되었다. 설계된 제어보상회로에 대한 주파수 응답특성분석을 통해 각 회로의 위상여유와 이득이 분석되었다. 또한 배터리 충/방전을 위한 BPC회로 분석을 통해 배터리 충전 연속모드, 배터리 방전 연속/불연속 모드에서의 입출력 전달함수가 제시되었다.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2002년도 춘계학술대회논문집
• /
• pp.251-259
• /
• 2002

The design concept of diesel engines for sea-going ships has been directed to Low-speed/Long-Stroke type to improve the efficiencies of combustion and propelling. But the time-delay property inevitable at such low speed engines gives much difficulties for governors to control the engine speed because they would be apt to go into unstable region especially when operating at low speed. The purpose of this paper is to study the problem of how the governor gain can be calculated dynamically in accordance with the variance of engine speed at least for an engine to be stable. In this study, the property of diesel engine was described as composed of combustion element including dead time and rotating element, and the ultimate gain for the speed control system to be located on the condition of stability limit was proposed based on the frequency characteristics. And the target gains with optimized stability also were proposed by giving proper margin to these ultimate conditions. The results were applied to a model system and the availability was confirmed to be satisfactory.

• 한국의류학회지
• /
• 제35권8호
• /
• pp.906-917
• /
• 2011

This study identified the present state of store and selection criteria of supplier from the regional fashion buyer point of view and examined the effects of the factors of relative impact between buyer and supplier on the relational bond. The interviews and questionnaires were administered to the owners or the sellers of 85 fashion retail stores in Gwangju. For analysis of data, frequency, means, factor analysis, Cronbach's ${\alpha}$ and regression analysis were applied. The results were as follows. First, in the results of examining the actual conditions of store managers for fashion buyers, fashion buyers complained about lengthy travelling and time consumption inconvenience. They also reported decrease in margin and monthly mean sales over last year. Second, the most important selection the criteria for the supplier were product power, followed by a convenient store layout. Finally, higher quality communication, more compromises, and higher dependence were affected with higher satisfaction, trust, and commitment in suppliers; conversely, the trust and commitment of the buyers decreased relative to the increased power of the suppliers.

• 전자공학회논문지A
• /
• 제32A권12호
• /
• pp.108-114
• /
• 1995

Recently, along wtih the advance of high-performance system, synchronous DRAM's (SDRAM's) which provide consecutive data output synchronized with an external clock signal, have been reported. However, in the conventional SDRAM's which utilize a multi-stage serial pipelined scheme, the column path is divided into multi-stages depending on CAS latency N. Thus, as the operating speed and CAS latency increase, new stages must be added, thereby causing a large area penalty due to additinal latches and I/O lines. In the proposed register-based parallel pipelined scheme, (N-1) registers are located between the read data bus line pair and the data output buffer and the coming data are sequentially stored. Since the column data path is not divided and the read data is directly transmitted to the registers, the busrt read operation can easily be achieved at higher frequencies without a large area penalty and degradation of internal timing margin. Simulation results for 0.32um-Tech. 4-Bank 64M SDRAM show good operation at 200MHz and an area increment is less than 0.1% when CAS latency N is increased from 3 to 4.. This pipelined scheme is more advantageous as the operating frequency increases.

• 한국초전도ㆍ저온공학회논문지
• /
• 제6권4호
• /
• pp.41-45
• /
• 2004

Rapid Single flux quantum (RSFQ) confluence buffer is widely used in complex superconductive digital circuits. In this work, we have improved the currently used confluence buffer and obtained a more soundly designed confluence buffer. In simulations, improvements in the bias margins of 11 % and the global margins of 10%, compared to the previously used confluence buffer, were achieved. Global margins are very important in estimating a process error range allowed in fabrications. We used two circuit simulation tools, WRspice and Julia, to design and optimize the confluence buffer. We used Xic to obtain a mask layout. We fabricated the improved circuits by using Nb technology. The test results at low frequency showed that the improved confluence buffer operated correctly and had a very wide main bias margin of +/-43% enhanced from +/-26% of the previously used confluence buffer.