• Korean Journal of Materials Research
• /
• v.17 no.6
• /
• pp.323-330
• /
• 2007

We fabricated thermaly evaporated 10 nmNi/(poly)Si films to investigate the energy saving property of silicides formed by rapid thermal annealing (RTA) at the temperature of $300{\sim}1200^{\circ}C$ for 40 seconds. Moreover, we fabricated $10{\sim}50$ nm-thick ITO/Si films with a rf-sputter as reference films. A four-point tester was used to investigate the sheet resistance. A transmission electron microscope (TEM) and an X-ray diffractometer were used for the determination of cross sectional microstructure and phase changes. A UV-VISNIR and FT-IR (Fourier transform infrared rays spectroscopy) were employed for near-IR and middle-IR absorbance. Through TEM analysis, we confirmed $20{\sim}70nm-thick$ silicide layers formed on the single and polycrystalline silicon substrates. Nickel silicides and ITO films on the single silicon substrates showed almost similar absorbance in near-IR region, while nickel silicides on polycrystalline silicon substrate showed superior absorbance above 850 nm near-IR region to ITO films. Nickel silicide on polycrystalline substrate also showed better absorbance in middle IR region than ITO. Our result implies that nano-thick nickel silicides may have exellent absorbing capacity in near-IR and middle-IR region.

• Atmosphere
• /
• v.19 no.4
• /
• pp.319-329
• /
• 2009

The intensive dust observation experiment has been performed at Korea Global Atmosphere Watch Center (KGAW) in Anmyeon, Korea during each spring season from 2007 to 2009. Downward and upward hyper-spectral spectrums over the dust condition were measured to understand the hyper-spectral properties of Asian dust using both ground-based Fourier Transform Infrared Spectroscopy (FT-IR) and space-borne AIRS/Aqua. To understand the impact of the Asian dust, a Line-by-Line radiative transfer model runs to calculate the high resolution infrared spectrum over the wave number range of $500-500cm^{-1}$. Furthermore, the radiosonde, a $PM_{10}$ Sampler, a Micro Pulse Lidar (MPL), and an Aerodynamic Particle Sizer (APS) are used to understand the vertical profile of temperature and humidity and the properties of Asian dust like concentration, altitude of dust layer, and size distribution. In this study, we found the Asian dust distributed from surface up to 3-4 km and volume concentration is increased at the size range between 2 and $8{\mu}m$ The observed dust spectrums are larger than the calculated clear sky spectrums by 15~60K for downward and lower by around 2~6K for upward in the wave number range of $800-1200cm^{-1}$. For the characteristics of the spectrum during the Asian dust, the downward spectrum is revealed a positive slope for $800-1000cm^{-1}$ region and negative slope over $1100-1200cm^{-1}$ region. In the upward spectrum, slopes are opposed to the downward one. It is inferred that the difference between measured and calculated spectrum is mostly due to the contribution of emission and/or absorption of the dust particles by the aerosol amount, size distribution, altitude, and composition.

• Asian-Australasian Journal of Animal Sciences
• /
• v.30 no.11
• /
• pp.1575-1589
• /
• 2017

Objective: This study was conducted to determine molecular structures related to carbohydrates and lipid in alfalfa hay cut at early bud, late bud and early flower and in the afternoon and next morning using Fourier transform infrared spectroscopy (FT/IR) and to determine their relationship with alfalfa hay nutrient profile and availability in ruminants. Methods: Chemical composition analysis, carbohydrate fractionation, in situ ruminal degradability, and DVE/OEB model were used to measure nutrient profile and availability of alfalfa hay. Univariate analysis, hierarchical cluster analysis (CLA) and principal components analysis (PCA) were conducted to identify FT/IR spectra differences. Results: The FT/IR non-structural carbohydrate (NSCHO) to total carbohydrates and NSCHO to structural carbohydrate ratios decreased (p<0.05), while lignin to NSCHO and lipid CH3 symmetric to CH2 symmetric ratios increased with advancing maturity (p<0.05). The FT/IR spectra related to structural carbohydrates, lignin and lipids were distinguished for alfalfa hay at three maturities by PCA and CLA, while FT/IR molecular structures related to carbohydrates and lipids were similar between alfalfa hay cut in the morning and afternoon when analyzed by PCA and CLA analysis. Positive correlations were found for FT/IR NSCHO to total carbohydrate and NSCHO to structural carbohydrate ratios with non-fiber carbohydrate (by wet chemistry), ruminal fast and intermediately degradable carbohydrate fractions and total ruminal degradability of carbohydrates and predicted intestinal nutrient availability in dairy cows ($r{\geq}0.60$; p<0.05) whereas FT/IR lignin to NSCHO and CH3 to CH2 symmetric stretching ratio had negative correlation with predicted ruminal and intestinal nutrient availability of alfalfa hay in dairy cows ($r{\geq}-0.60$; p<0.05). Conclusion: FT/IR carbohydrate and lipid molecular structures in alfalfa hay changed with advancing maturity from early bud to early flower, but not during the day, and these molecular structures correlated with predicted nutrient supply of alfalfa hay in ruminants.

• Korean Journal of Agricultural Science
• /
• v.48 no.2
• /
• pp.299-310
• /
• 2021

Glycerol is a non-volatile compound with no aromatic properties that contributes significantly to the quality of wine by providing sweetness and richness of taste. In addition, it is also the third most significant byproduct of alcoholic fermentation in terms of quantity after ethanol and carbon dioxide. In this study, Fourier transform infrared (FT-IR) spectroscopy was employed as a fast non-destructive method in conjugation with multivariate regression analysis to build a model for the quantitative analysis of glycerol concentration in wine samples. The samples were prepared by using three varieties of red wine samples (i.e., Shiraz, Merlot, and Barbaresco) that were adulterated with glycerol in concentration ranges from 0.1 to 15% (v·v^-1), and subjected to analysis together with pure wine samples. A net analyte signal (NAS)-based methodology, called hybrid linear analysis in the literature (HLA/GO), was applied for predicting glycerol concentrations in the collected FT-IR spectral data. Calibration and validation sets were designed to evaluate the performance of the multivariate method. The obtained results exhibited a high coefficient of determination (R²) of 0.987 and a low root mean square error (RMSE) of 0.563% for the calibration set, and a R² of 0.984 and a RMSE of 0.626% for the validation set. Further, the model was validated in terms of sensitivity, selectivity, and limits of detection and quantification, and the results confirmed that this model can be used in most applications, as well as for quality assurance.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.10
• /
• pp.930-934
• /
• 2006

This paper reports a change of carbon nanotubes(CNTs) properties by post-treatment process after growth of CNTs. CNTs were treated by thermal method and solution method, and then investigated in detail using field emission scanning electron microscopy(FE-SEM), high resolution transmission scanning electron microscopy(HR-TEM), RAMAN spectroscopy, and Fourier Transform Infrared Spectrometer (FT-IR). FT-IR spectra showed that the amount of hydroxyl generated on surface of CNTs were changed with post-treatment condition. FE-SEM and TEM images were shown CNTs diameter and density variations were dependent with their treatment conditions. RAMAN spectroscopy was shown that carbon nanotubes structure vary with treatment conditions.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.1112-1117
• /
• 2003

Polarized Fourier transform infrared (IR) absorption is used to probe molecular conformation in a ferroelectric liquid crystal (FLC) during the reorientation induced by the external field. Spectra of planar aligned cells of FLC W314 are measured as functions of IR polarizer orientation and electric field applied to the FLC. The time evolution of the dichroism of the absorbance due to biphenyl core and alkyl tail molecular vibration modes, is observed. Static IR dichroism experiments show a W314 dichroism structure in which the principal axis of dielectric tensor from molecular core vibration are tilted further from the smectic layer normal than those of the tail. This structure indicates the effective binding site in which the molecules are confined in the Sm-C phase has, on average, "zig-zag" shape and this zig-zag binding site structure is rigidly maintained while the molecular axis rotates about the layer normal during field-induced switching.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.37-37
• /
• 2011

반도체 칩의 빠른 성장에는 Si을 기본으로 한 산화막 또는 질화막 재료의 공헌이 크다. 하나의 반도체 소자를 만드는 데 있어, 산화막(SiO2)과 질화막(Si3N4)은 각각 다양한 두께와 다양한 방법으로 제조되고 있기 때문이다. 또한 차세대 소자제작을 위해 사용되는 미세 patterning 방법으로 dual patterning 방법을 사용하는데 이는 ALD나 CVD를 이용한 저온 SiO2 증착공정을 기반으로 하고 있다. 이러한 Si 기반 소재 개발이나 공정개발을 위해 많은 Si 전구체가 개발되어지고 있지만 적합한 전구체를 선별하기는 어려운 실정이다. 본 연구에서는 FT-IR (Fourier transform-infrared)을 이용하여 개발된 전구체의 기상안전성 및 반응성을 실시간으로 진단하여 기존의 전구체와의 차별성을 확인하고 우수한 전구체를 선별하기 위한 연구를 진행하였다. 이를 위해 특별히 제작된 가스셀을 사용하여 열 및 플라즈마 상태변화에서의 분자상태 변형을 진단하였다.

• Korean Journal of Materials Research
• /
• v.3 no.3
• /
• pp.272-275
• /
• 1993

To modify the toughness of epoxy for matrix, succinonitrile(SN) was introduced to diglycidy1 ether of bisphenol-A (DGEBA)/methylene dianiline(MDA)system. Cure reaction mdchanism of the DGEBA/MDA/SN system was strdied through Fourier transform infrared(FT-IR) spectrometry. As a result, the reaction of nitrile group of SN with secondary amine and with hydroxy1 group prevented the reaction of hydroxy1 group with epoxide group from crossoinding. Nitrile groups produced amide group by reacting with hydroxy1 groups and made a lowered crosslind density in chain networks.

• Proceedings of the PSK Conference
• /
• 2002.10a
• /
• pp.409.1-409.1
• /
• 2002

For the development of a biocompatible nano-scale drug carrier. hydrophilic polysaccharide pullulan was hydrophobized by the conjugation with fatty acid. The synthesized polymers were characterized by the measurements of fourier transform infrared (FT -IR) spectroscopy and 1H -nuclear magnetic resonance (NMR) spectroscopy. In aqueous solution. hydrophobically modified puliulan was self-assembled and structured into the core-shell type nanoparticles. (omitted)

• Journal of Plant Biotechnology
• /
• v.38 no.1
• /
• pp.9-14
• /
• 2011

To determine whether pattern recognition based on metabolite fingerprinting for whole cell extracts can be used to discriminate cultivars metabolically, leaves of nine commercial Orostachys plants were subjected to Fourier transform infrared spectroscopy (FT-IR). FT-IR spectral data from leaves were analyzed by principal component analysis (PCA) and Partial least square discriminant analysis (PLS-DA). The dendrogram based on hierarchical clustering analysis of these PLS-DA data separated the nine Orostachys species into five major groups. The first group consisted of O. iwarenge 'Yimge', 'Jeju', 'Jeongsun' and O. margaritifolius 'Jinju' whereas in the second group, 'Sacheon' was clustered with 'Busan,' both of which belong to O. malacophylla species. However, 'Samchuk', belong to O. malacophylla was not clustered with the other O. malacophylla species. In addition, O. minuta and O. japonica were separated to the other Orostachys plants. Thus we suggested that the hierarchical dendrogram based on PLS-DA of FT-IR spectral data from leaves represented the most probable chemotaxonomical relationship between commercial Orostachys plants. Furthermore these metabolic discrimination systems could be applied for reestablishment of precise taxonomic classification of commercial Orostachys plants.