• Journal of the Korean Society of Marine Environment & Safety
• /
• v.27 no.6
• /
• pp.832-838
• /
• 2021

Recently, reports of marine accidents of small fishing vessels less than 10 tons have been increasing. In this study, the characteristics of the motion response in regular waves were analyzed using computations for these ships. Small vessels less than 10 tons are classified by size and used for marine accident investigations. Therefore, the motion response analysis was performed on three small fishing vessels of different sizes. In the case of the head sea, it was confirmed that as the speed of the vessel increased in the long wavelength region, the motion responses of heave and pitch became large. The motion response of the smallest 3-ton fishing vessel was greater than that of the other sizes of fishing vessels. The maximum value of the roll motion shifted to the long wavelength region as the speed gradually increased in the bow sea, regardless of the size of the ship. In all the three small fishing vessels, it was found that the roll motion was the greatest at 15 knots, the highest speed in both bow and beam seas. When sailing in the head sea and bow sea conditions, lowering the speed is one of the effective approaches to reduce the effects of the vertical and lateral plane motions. The roll motion caused by the beam wave showed a tendency to increase rapidly only at a specific wavelength regardless of the speed and the size of the vessel. It was confirmed that the roll motion was significantly reduced with forward speed in the stern wave compared to the bow wave. As there is a specific region where the maximum value of the hull motion response appears depending on the size and speed of the ship, an operation method that can minimize the effect of this motion should be considered and implemented.

• Science of Emotion and Sensibility
• /
• v.25 no.3
• /
• pp.77-90
• /
• 2022

This study seeks to develop a stretch sensor for measuring the wrist movements of people using fishing lures. In order to confirm wrist movement, a stretch sensor was attached to the wrist band, and measurements of the dorsiflexion, plantar flexion, and fishing landing motion were measured using a scale to gauge factor, tensile strength, and elongation recovery rate. A conductive sensor using CNT dispersion was developed and applied to the E-band under the same conditions. A total of 15 sensors of the same size and five types of impregnation once, twice, and three times each were used to measure the gauge factor using UTM. The sensor that was impregnated twice had the best gauge rate, and the prototypes were manufactured with three sensors with high gauge rates and tensile strength. The results of the operation test conducted by connecting to the Arduino showed that Sample 1, which had the highest tensile strength and gauge factor, had a stable graph wavelength in three operations. Samples 2 and 3 showed stable wavelengths in the dorsiflexion and the plantar flexion; however, signal noise appeared in the fishing landing motion. This showed stable wavelengths in the two motions, but the wavelengths of the graphs differ depending on the tensile strength and gauge factor in the fishing landing motion. As a result, it was possible to identify the conditions necessary for manufacturing a stretch sensor for measuring wrist movement. This study will contribute to the development of smart wearable products for lure fishing.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.45 no.1
• /
• pp.1-13
• /
• 2009

Experimental fishing operation by the shrimp beam trawl was carried out to investigate the bycatch in order to develop the selective fishing gear of the shrimp beam trawl fishery. The experimental trawling was performed by the prototype fishing gear in coast sea of Boryeong, Buan, Kangjin, Tongyeong and Geoje from 30 April to 13 November 2005. Bycatches of the experimental trawling were analyzed species composition, total length composition. The results obtained can be summarized as follows; Target fishes caught by the shrimp beam trawl were Palaemon gravieri, Crangon Hakodatei, Trachysalambria curvirostris, Parapenaeopsis tenellus, Rhynchocinetes uritai and Matapenaeus joyneri. And their fishing rate and total length range were 50.0%, 46.0%, 2.6%, 0.4%, 0.3%, 0.3% and 40-80mm, 40-80mm, 120-150mm, 60-80mm, 60-80mm, 60-120mm respectively. Bycatches caught by the shrimp beam trawl consisted of fishes of 30 kinds, 6 kinds of mollusk, 5 kinds of shellfishes and 3 kinds of crabs. The main fish was Engraulis japonicus, Platycephalus indicus, Paralichthys olivaceus, Leiognathus nuchalis and Conger myriaster, their occupied rate were 47.0%, 16.6%, 13.6%, 5.5%, 2.7% respectively, and their total length range were 60-150mm, 80-410mm, 80-600mm, 30-80mm and 150-460mm respectively. A number bycatch rates of shrimp beam trawl fishery were 99.7% in Buan, 60.0% in Kangjin, 14.6% in Boryeong, 10.6% in Tongyeong and 2.7% in Geoje, The weight bycatch rate were 99.9% in Buan, 75.1% in Kangjin, 57.1% in Tongyeong, 47.4% in Boryeong and 15.4% in Geoje.

• Journal of Fisheries and Marine Sciences Education
• /
• v.26 no.1
• /
• pp.98-107
• /
• 2014

As part of a series of studies about improving yellow croaker drift gill net fishing gear and the development of a labor-saving fishing system, we installed a labor-saving-type, five-step-drum net hauler, and a triple-V-type net hauler in 108 Daeheung-ho, a fishing boat which operates drift gill nets for yellow croakers mainly in the sea near Chu-ja Island. Net damage with the labor-saving-type, five-step-drum net hauler is lower than for the triple-V-type net hauler. In addition, there was a reduction in the standard operational crew of two people. The lead time for hauling the labor-saving net was approximately 10% and 19.2% less than for hauling the triple-V-type net hauler and for hauling by hand, respectively. It was found that there were fewer slip in fishing gear and less damage to the wing of the drum as well as less damage to the fish when the labor-saving-type, five-step-drum net hauler was used than when the triple-V-type net hauler was used. In the survey, the lead time for hauling the net was approximately 21.6% and 45.2% more effective than hauling with the triple-V-type net hauler and hauling by hand, respectively. The crew was reduced by approximately 18.2% and 25% than when hauling with the triple-V-type net hauler and hauling by hand, respectively. In addition, cessation of operation and damage to the fish were reduced when compared to the triple-V-type net hauler and hauling by hand.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.29 no.4
• /
• pp.260-271
• /
• 1993

Due to depletion of fish resources as time goes on, the trawl fishing industries which have caught the demersal fish is confronting with financial difficulties. For the purpose of breaking these difficulties, trawlers are expanding the fishing targets to the midwater from bottom stock. The trawlers become to be able to detect the fish schools not only vertical but also horizontal direction by equipping the sonar system on board. Even though the operator locates the fish school by sonar, it is not easy to make a desirable catch of the fish school which is detected, for the reason of the maneuverring characteristics of trawler. For the purpose of enhancing the efficiency of a fish catch, the auther performed a series of on board experiments to investigate the maneuverablilites of midwater trawaler. The obtained results are summerized as follows: 1. The higher the RPM of main engine, the smaller the magnitude of turning circle. And it is smaller in the right than in the left turning 2. Towing speed varies irregularly under turning novenment. When the RPM of main engine being 560, 680 the angular velocities are 11.3deg/min, 22.5deg/min respectively. 3. The difference of new course distance between calculated by maneuverring indices and measured by experimental ship is high when altering course being large and towing speed low. 4. The faster the towing speed is, the shorter the new course distance becomes. When towing speed is same in right and left turning movement, the now course distance is shorter in case of right turning movement than in left. 5. It is considered to be convenient for a navigator to utilize the curves for altering course in order to steer the ship rapidly and accurately.

• Journal of Fisheries and Marine Sciences Education
• /
• v.23 no.3
• /
• pp.361-373
• /
• 2011

In line with post-1970s industrialization, the manpower shortage in fishing villages has been fueled by rapid desertion; young adults and middle-aged people have tended to avoid fishing by migrating to cities, driving the emergence of a national issue in terms of securing fisheries management succession. For the fisheries industry to maintain competitiveness, we need to cultivate young adults and middle-aged people to be leaders of the domestic fishing industry through promoting inspiration for the fishing industry, teaching fisheries expert knowledge, and fostering the ability to promote business. In addition to safe supply of marine products through continued fisheries operation, securing young and skilful workers is essential in order to promote balance development of domestic industries, including job creation. The study therefore seeks to provide measures to foster specialists in order to enable the transfer of management through an opinion survey of fishermen. To cultivate specialists for enabling the transfer of management, the following solution should be promoted at the state level. First, to support the introduction of young and talented workers to the fisheries industry through transfer of management, Second, in order to enable the transfer of management, change is required first in the fisheries industry for it to become a value-added industry. Third, despite fisheries being a composite industry that is syncretized to tertiary industries from primary industries, the fisheries industry is still recognized as a labor intensive industry, which reflects the current status of fisheries education.

• Journal of Korea Port Economic Association
• /
• v.29 no.3
• /
• pp.209-232
• /
• 2013

Illuminating Japanese Fisharena Development Policy, we tried to find out some implications on the utilization of fishing port facilities as a way to accommodate uprising marine leisure demands of Korea. The major findings of this study are concentrated in the following three points. First, Japanese Fisharena Development Policy can be functionalized in Korea as a means of policy, but for the intervening difference of demand situation, precise forecasting on the marine leisure demands has to be preceded and Fisharena should be prepared as a supply buffer. Second, in the development stage of Fisharena, Software side is important as well as Hardware side. On the development and operation, utilizing civil organizations is necessary to bring down the wharfage of Fisharena to not suppress the marine leisure demands. Third, selection of the fishing port and decision of the development scale are additional important points. In particular, preferential consideration of utilizing inner-city fishing ports as small-scale Fisherinas to address the marine leisure demands would be desirable in Korea.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.50 no.3
• /
• pp.396-406
• /
• 2014

Shrimp beam trawl fishery is one of the important coastal fisheries in Korea. It has a regulation to the length of beam (8m) and wing net (7m) of shrimp beam trawl that has been used in the district of Junlanam-do and Gyungsangnam-do. This regulation was made in relation to the size of shrimp beam trawler of 3-ton class at that time. Now the shrimp beam fishing vessel has a limit not greater than 5 tons in gross ton. Recently, with improvement of fishing industry and fishing vessel fishermen asked the expansion of the length of beam and wing net, therefore it is necessary to investigate the effect of lengthening the beam and wing net length. Three different beams (8m, 10m and 12m in length) and three different wing net (7m, 10m and 13m in length) were made and the experiment was conducted near Narodo of Goheng by two fishing vessels of 4.98 and 4.88 tons in gross ton between June 2011 and October 2012. When the length of wing net was increased from 7m to 10m and 13m, the relative catch ratio in total biomass was increased 25% and 79% for shrimp, (17% and 22% in total), respectively. And when the beam length was increased from 8m to 10m and 12m, the relative catch ratio was increased 35% and 84% for shrimp, (21% and 37% in total), respectively. The force exerted to the iron guide of inhauler's with the beam length of 8m was about 30% greater than that with the beam length of 10m when hauling the shrimp beam trawl net.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.54 no.4
• /
• pp.279-286
• /
• 2018

The objective of this study was to quantitatively evaluate the influence of the netting hanging ratio on fishing performance of gillnet. A total of six tests was carried out using three kinds of gillnets with different horizontal hanging ratios (0.3, 0.5 and 0.7) on the basis commercial gillnet of mesh size of 60 mm used in Yeosu Dolsan. As a result of the test fishing operation, catches of the net with hanging ratio 0.3 and the shortest float length was 1.34 times larger than the net with hanging ratio 0.7. The caught species in experimental testes was lager in the net with hanging ratio 0.3 than the net with hanging ratio 0.7. The catch rate per unit area (CPUE) is on the silver croaker with the largest catches in tests as follows. The net with hanging ratio 0.3 net was $89.45g/m^2$, hanging ratio 0.5 net was $41.63g/m^2$, and hanging ratio 0.7 net was $24.50g/m^2$. The net with hanging ratio 0.3 (float line length of 45 m) exhibited the largest CPUE value.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.05a
• /
• pp.647-652
• /
• 2002

The main object of Maritime Safety Network is to prevent Marine Accidents in advance and avoid the loss of live and property efficiently. Our country's Marine Safety Network was widely changed with its concerned rules and the operation methods through the complete operation of GMDSS system. Thus, compared with the past, maritime safety equipment and its systems were enforced, but the loss of lives from marine accidents tends to increase against the general expectation. 80 percent of the total marine accidents in Korea is caused by small fishing boats that are capsized immediately from accidents. To minimize the loss of lives they are to require the help of rescue. Lately imported GMDSS communication equipment is operated very fast automatically to issue the rescue and inform the distress, but most general small fishing boats are under 5 ton vessel and excluded from the administration of GMDSS system. In this paper is to propose the proper solution for the efficient improvement of maritime safety network suitable for the our practical circumstance.