• Journal of the Korea Organic Resources Recycling Association
• /
• v.32 no.2
• /
• pp.15-25
• /
• 2024

In this study, the regeneration effect of pressurized water and ultrasonic cleaning was investigated for contaminated filter cloth from the sewage sludge filter press process. For this purpose, contaminated filter cloth was collected from a 3-ton sewage sludge hydrothermal carbon treatment filter press. First, the contamination characteristics were analyzed. According to the location of the filter cloth, air permeability and unit mass were measured, and compared with the values of a new filter cloth. Next, the results were mapped over the entire area to evaluate the contamination characteristics. Finally, pressure cleaning at 3 bar and ultrasound at frequencies of 34, 76, 120, and 168 kHz were performed on the contaminated filter cloth. In addition, the cleaning efficiency was evaluated by 3 levels of contamination degree. As a result, pore contamination occurred mainly at the bottom and both sides of the filter cloth, where the filter material was continuously injected and compressed. Surface contamination appeared evenly over the entire area. As a result of washing, air permeability increased by 1.3-3.1%p and contaminant removal was by 2.7-4.4% under pressure. In ultrasonic cleaning, air permeability increased by 12.5-61.5%p and contaminants were removed by 2.7-29.2%. In ultrasonic cleaning the lower the frequency, the higher air permeability and contaminant removal rate. Also, The higher pore contamination level, the better the air permeability improvement and contaminant removal.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.20 no.6
• /
• pp.561-567
• /
• 1987

The purpose of this study was to find out the removal capacity of harmful ammonia by different filter media in the submerged biological filters in a given space of chamber. Four materials, pile cloth, corrugated skylight roofing plate, embossed plastic plate, and gravel, were used as the experimental filter media. Each filter medium was placed in two aquariums, each aquarium measuring $90cm\times60cm\times60cm\;(depth)$. Under the normal operating condition, the average of mean ammonia removal rates during the first and second functioning periods by each filter material which occupied tile space in the filter chamber (aquarium) was as follows: 1. Pile cloth: $8.381\;g{\cdot}m^{-3}.\;day^{-1}$ 2. Corrugated skylight roofing plate: $7.834\;g{\cdot}m^{-3}.\;day^{-1}$ 3. Embossed plastic plate: $7.797\;g{\cdot}m^{-3}.\;day^{-1}$ 4. Gravel: $7.051\;g{\cdot}m^{-3}.\;day^{-1}$ Thus, there were no significant differences between the media, but at the time of practical application of these materials, some other factors such as investment cost, easiness for the removal of excess detritus accumulated in tile interstices of filter media, etc. should be fallen into consideration. When large units are required, in particular, removal of excess detritus from tile gravel bed is extremely difficult, and in case of pile cloth filters the installation work is much complicated and a problem in supporting the structure when drained also exists. In these respects, corrugated skylight roofing plate and embossed plastic plate seem to be more optimal, but again in practice the local situation for the availability and the price of the materials should be rechecked and the fitness of tile materials in the particular filter chambers under use or under consideration for construction must be taken into account.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2009.02a
• /
• pp.126.2-126.2
• /
• 2009

• Journal of Korean Society for Atmospheric Environment
• /
• v.11 no.4
• /
• pp.373-375
• /
• 1995

In order to turn the Bag Filter to the Purse Filter, the past system that the adverse reason is removed, the input of synthetic materiality of dust and air is placed down, and the output is placed up has been improved so that any adverse effect shall not be raised. The form of filteration mechanism is changed from a cylinder from, and the dust and air is mixed to make the entry velocity and one person can velocity of the mixed materiality become lower by the use of infinity, and the reception of filteration mechanism has been made reasonably. The dust separated from the filteration mechanism is desceded down, snd the mixde materiality is ascended up. So, a cross point is formed, and a collision and a friction is occurred from its process, and at its result, dust is scattered to stick to a filter cloth, therefore, the loss of pressure shall ont be appeared by cause of the increase of dust-loading.

• Korean Journal of Food Science and Technology
• /
• v.15 no.2
• /
• pp.133-134
• /
• 1983

Some metallic ions such as copper, manganese, iron, zinc and cadmium in ginseng extract, originated from white ginseng, were determined by atomic absorption spectrophotometry. The extracts were prepared with water, 35% ethanol, 50% ethanol or 75% ethanol solution followed by filtration or centrifugation. Greater amounts of metallic ions were found in the solution filtrated by filter paper (Toyo No. 5A) or by filter cloth than in that of centrifugation. The residual amount of metallic ions in the extract decreased with increasing concentration of ethanol. The percentages of each metallic ion in ginseng extracts on the basis of original amount of metallic ions were as follows: Cu, 10.4-31.9%, Fe,5.1-19.0%, Mn,3.0-12.2% Zn,7.4-12.0%, Cd,5.9-11.8%.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.7
• /
• pp.752-759
• /
• 2013

This paper presents a method for analyzing and designing an extremely miniaturized planar ring hybrid, using the combination of parallel and diagonally shorted coupled lines. In contrast to conventional miniaturized coupled line filters, it is proven that the required electrical length of transmission line can be largely reduced to even a few degrees, not only effectively suppressing the spurious passband but also approximately maintaining the same characteristic around the stable center frequency. A ring hybrid filter at center frequency of 1 GHz was fabricated on the FR4 epoxy glass cloth copper-clad plat (CCL) PCB substrate. The insertion loss of a ring hybrid filter with the die area of $30mm{\times}30mm$ is -4.68 dB. Simulated results are well agreed with the measurements.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.8
• /
• pp.995-999
• /
• 2014

In this paper, a new size-reduction approach for branch-line coupler is introduced which uses parallel end-shorted coupled lines with lumped capacitors. The characteristic of the new design was analyzed using even-odd mode method, and simulated on HFSS before fabricated on the FR4 epoxy glass cloth copper-clad plat (CCL) PCB substrate at center frequency of 1 GHz. The electrical length of transmission line was reduced to 15 degrees, therefore the size of branch-line coupler was largely reduced approximately maintaining the same characteristic around the stable center frequency. The insertion loss of the branch-line coupler filter was -4.39 dB. The size of the overall hybrid is $20mm{\times}20mm$. Measurements results were well agreed with the simulated ones.

• Resources Recycling
• /
• v.18 no.3
• /
• pp.55-61
• /
• 2009

Dewatering process to remove water from pigment sludge was important in the diverse aspects of the improvement of product quality, curtailment of the drying cost and the transportation. It was difficult to dewater pigment particles with the mechanical forces because the size was fine under $5{\mu}m$. Thermal filter press dewatering equipment composed of squeezing plate and a fixed heating plate was developed to improve the dewaterability of pigment the sludge as supplying the heat from the fixed heating plate to the cake. Several tests that estimate the dewaterability for pigment sludge as with or without squeezing process and the difference of dewatering time was conducted with this equipment. Dewaterability of thermal dewatering under squeezing process was increased about 20% compared with non squeezing process. Under squeezing process, thermal dewatering tests changing dewatering time with 70 and 80 minute were conducted respectively. The water content of cake was more reduced at dewatering time of 80 minute compared with 70 minute, and dewatering velocity was also decreased, which caused the productivity of thermal filter press to drop. It was observed that clogging of filter cloth didn't almost occur because the liquid was discharged from cake layer easily. In this research, it was resulted that the squeezing process and long dewatering time were effective to improve the dewaterability of pigment sludge. So, this thermal filter press equipment was useful for dewatering the fine particle sludge like pigment.

• Textile Coloration and Finishing
• /
• v.17 no.6 s.85
• /
• pp.42-50
• /
• 2005

Silk fabrics are widely used as high quality cloth, interior, quilting and bedding materials because of having excellent touch, drape, resilience and low specific gravity characteristics. But, many waste silk materials are produced during the reeling, spinning, weaving, dyeing and finishing processes. From this fact, the recycle of waste silks is interested in studying for the application of industrial textile materials such as filter, oil absorbent and wound protector. Thus, this research has surveyed the decolorizing and carding characteristics in order to recycle the colored waste silk materials. As the results, the carding condition of waste silk fabrics was optimized with different fiber lengths and curding passage. In addition, the fiber failure mechanism from the wasted silk microdamage caused by carding process was investigated. Also it was found that longitudinal and transverse cracks, abrasion and pilling were formed on the surface of wasted silk fibers.

• Journal of Korean Medical classics
• /
• v.24 no.4
• /
• pp.157-174
• /
• 2011

We derived following result by organizing research about processing of medicinal of before Han(漢) dynesty. The human being intake of natural substance for the purpose of treatment was what happened later than the use of natural substance as food. According to the record of by the early years of Shang(商) dynasty, we can assume that we cooked food with water and fire. The reason why there is no appearance of common production that can be included under the name of 'Tang Ye(湯液)' in the medical record discovered from Ma Wang Dui(馬王堆) is because 'Tang Ye' was yet developed. However, as the presentation of format of medicine process, there was gradual formation of medicinal fluid concept. There are quite of records on major details of cloth manufacture like washing and selection, grinding, processing of medicine from the recordings of "Wu Shi Er Bing Fang(五十二病方)", "Yang Sheng Fang(養生方)", "Za Liao Fang(雜療方)" discovered at Ma Wang Dui. It used words like 'Ze(擇)', 'Qu(去)' for the selection and 'Jiu(酒)', 'Zhuo(濯)' for the wash as a process method before cloth manufacture. When filter the processed medicine, it used words like 'Zhuo(捉)', 'Suo(索)', 'Jun(浚)' and used 'Yin Gan(陰乾)', 'Bao(暴)', 'Yang(暘)' for dry. The 'cutting(切削)' that crushes the medicine used different names based on the properties of medicines. The most frequent crush is 'Ye(冶)' and it means the powered medicine after dry. There was thermal process of mild fire(微火) and heating of 'Wen(溫)'. There are many states of medicine seen from the medical record discovered at Ma Wang Dui so they can be said as original medicine. 藥末劑 is relatively commercialized type then. Here, it includes later 湯劑 but there was no name such as 'decoction(湯)' or 'decoction of medical ingredients(湯液)'. Also, 'Fu Ju(㕮咀)' is the transformation of what was 'Fu Qie(父且)' at "Ja Liao Fang" of medical books of Ma Wang Dui with time flow. The original meaning of 'Fu Qie(父且)' is 'Fu Zu(斧俎)' and it means the crushing medicine with axe. The most important thing among the medical books of Han dynasty is "Shen Nong Ben Cao Jing(神農本草經)" and "Shang Han Za Bing Lun(傷寒雜病論)" of Zhang Zhong Jing(張仲景). "Shen Nong Ben Cao Jing" mentioned the dry method of medicine, collection and process production time, cooked and uncooked use of medicine and there are several types of medicine. Other than those, it mentioned 'Seven methods of combining herbs(七情合和)' to address cautions for combining medicines. Therefore, the 'processing of medicinal' in east Han dynasty period entered the theoretical step. However, there is only little recording on cloth manufacture of detailed medicine. From the "Shang Han Za Bing Lun" of Zhang Zhong Jing, the development in the way of 'processing of medicinal' reveled the cloth manufacture for each medicine. This tradition is continued until today and so it presents the development of purpose of 'processing of medicinal' is to greatly present the effect of medicine and to reduce the side-effect.