• 한국농공학회논문집
• /
• 제54권5호
• /
• pp.103-111
• /
• 2012

In this study, the full-scale laboratory model test on utilization of recycled aggregates and crushed stone as vertical drains to use an alternative material of sand in soft ground is performed. The settlement and pore water pressure were measured to evaluate the discharge capacity and filed application, and the results were compared and analyzed through the finite element method. The measured and estimated settlement in all vertical drain materials decreases gradually with the load increase. The measured settlement 6.55~8.63 mm, and the estimated by the Hyperbolic model was 7.45~7.92 mm. So the model used for the analysis can be applied to the settlement estimation of the actual field. The variations of pore water pressure with time showed constantly regardless of the load in all vertical drainage materials. The pore water pressure was similarity to that of sand after rapid drawdown. Therefore, it was applicable to the field because discharge capacity was enough to be an alternative material to the sand which had been being used as the vertical drains.

• Wind and Structures
• /
• 제13권1호
• /
• pp.21-36
• /
• 2010

A new full scale testing apparatus generically named the Wall of Wind (WoW) has been built by the researchers at the International Hurricane Research Center (IHRC) at Florida International University (FIU). WoW is capable of testing single story building models subjected up to category 3 hurricane wind speeds. Depending on the relative model and WoW wind field sizes, testing may entail blockage issues. In addition, the proximity of the test building to the wind simulator may also affect the aerodynamic data. This study focuses on the Computational Fluid Dynamics (CFD) assessment of the effects on the quality of the aerodynamic data of (i) blockage due to model buildings of various sizes and (ii) wind simulator proximity for various distances between the wind simulator and the test building. The test buildings were assumed to have simple parallelepiped shapes. The computer simulations were performed under both finite WoW wind-field conditions and in an extended Atmospheric Boundary Layer (ABL) wind flow. Mean pressure coefficients for the roof and the windward and leeward walls served as measures of the blockage and wind simulator proximity effects. The study uses the commercial software FLUENT with Reynolds Averaged Navier Stokes equations and a Renormalization Group (RNG) k-${\varepsilon}$ turbulence model. The results indicated that for larger size test specimens (i.e. for cases where the height of test specimen is larger than one third of the wind field height) blockage correction may become necessary. The test specimen should also be placed at a distance greater than twice the height of the test specimen from the fans to reduce proximity effect.

• 산업경영시스템학회지
• /
• 제39권2호
• /
• pp.64-71
• /
• 2016

Recently, nanotechnology has grown as one of the leading science technology along with other converging technologies such as biology, information, medicine etc., bringing the continuous investment of the government in nano-related field. However, it is difficult to measure and evaluate the performance of the national research and development programs because of the multidimensional character of the expected outcomes. This study aims to measuring efficiency of the national nanotechnology research and development programs using DEA model. The decision making units are nine nano-related ministries including the Ministry of Science, ICT and Future Planning. The input variables are total expenditure, number of the programs and average expenditure per program. The output variables are science, technology and economic indicator, and the combination of these outputs are respectively measured as seven different DEA cases. The Ministry of Science, ICT and Future was the first efficient ministry in total technical efficiency. Ministry of Agriculture, Food and Rural Affairs and the Ministry of Food and Drug Safety were efficient in pure technical efficiency, when the Ministry of Commerce Industry and Energy took the first in the scale efficiency. The program efficiency was affected by organizational characteristics such as the institution's scale, the concentration of the research paper or the patent, technology transfer or the commercialization. The result of this study could be utilized in development of the policy in the nanotechnology and the related field. Furthermore, it could be applied for the modification of expenditure management or the adjustment of the research and development programs' input and output scale for each ministry.

• 한국멀티미디어학회논문지
• /
• 제17권9호
• /
• pp.1104-1114
• /
• 2014

In large-scale crowd simulations, it is very important for the decision-making system of manipulating interactive behaviors to minimize the computational cost for controlling realistic behaviors such as collision avoidance. In this paper, we propose a large-scale realtime crowd simulation method using the affordance and navigation potential fields such as attractive and repulsive forces of electromagnetic fields. In particular, the model that we propose locally handles the realistic interactions between agents, and thus radically reduces the cost of expensive computation on interactions which has been the most problematic in crowd simulation. Our method is widely applicable to the expression and analysis of various crowd behaviors that are needed in behavior control in computer games, crowd scenes in movies, emergent behaviors of evacuation, etc.

• Structural Engineering and Mechanics
• /
• 제23권4호
• /
• pp.353-367
• /
• 2006

Two full-scale, precast, pretensioned box girders were subjected to shear-dominated loading, one under monotonic loads to failure and the other subjected to one-half million cycles of fatigue loads followed by monotonic ultimate loads. The number of cycles was selected to allow for comparison with previous research. The fatigue loads were applied in combination with occasional overloads. In the present study, fatigue loading reduced the shear capacity by only six percent compared to the capacity under monotonic loading. However, previous research on flexure-dominated girders subjected to the same number of repeated loads showed that fatigue loading changed the mode of failure from flexure to shear/flexure and the girder capacity dropped by 14 percent. The comparison of the measured data with calculated shear capacity from five different theoretical methods showed that the ACI code method, the compression field theory, and the modified compression field theory led to reasonable estimates of the shear strength. The truss model led to an overly conservative estimate of the capacity.

• 한국전산구조공학회논문집
• /
• 제28권1호
• /
• pp.63-69
• /
• 2015

본 연구에서는 페이즈 필드법을 기반으로 하는 위상 최적설계 방법을 통하여 적외선 스텔스 효과를 위한 적외선 반사층의 설계를 진행하였다. 이를 위하여 수직으로 입사하는 적외선 파를 반사층에서 반사되어 원하는 방향으로 전파되도록 모델링을 하였다. 전파 방향에 측정 영역을 설정하여 해당 영역에서의 목적함수 값을 최대화하도록 설계가 진행되었으며, 이때 목적함수는 전자기파의 에너지 흐름을 나타내는 포인팅 벡터(Poynting vector)로 설정하였다. 페이즈 필드법 기반의 방법에서의 여러 파라미터 값들을 변경해 가며 설계 결과를 도출하였고, 목적함수 값을 최대화하는 모델을 최적 모델로 선정하였다. 선정된 최적 모델에서 gray scale을 cut-off 방법으로 제거한 경우 더 좋은 결과를 얻을 수 있었다. 또한 중적외선 영역에서의 효과를 고려하기 위하여 입사되는 파장을 바꿔가며 얻은 해석결과를 검토하였다. 본 연구의 유한요소해석 및 최적화 과정은 상용 프로그램인 COMSOL과 Matlab을 연동하여 수행하였다.

• Steel and Composite Structures
• /
• 제37권2호
• /
• pp.229-251
• /
• 2020

In this paper, dynamic buckling of a smart sandwich nanotube is studied. The nanostructure is composed of a carbon-nanotube with inner and outer surfaces coated with ZnO piezoelectric layers, which play the role of sensor and actuator. Nanotube is under magnetic field and ZnO layers are under electric field. The nanostructure is located in a viscoelastic environment, which is assumed to obey Visco-Pasternak model. Non-local piezo-elasticity theory is used to consider the small-scale effect, and Kelvin model is used to describe the structural damping effects. Surface stresses are taken into account based on Gurtin-Murdoch theory. Hamilton principle in conjunction with zigzag shear-deformation theory is used to obtain the governing equations. The governing equations are then solved using the differential quadrature method, to determine dynamic stability region of the nanostructure. To validate the analysis, the results for simpler case studies are compared with others reported in the literature. Then, the effect of various parameters such as small-scale, surface stresses, Visco-Pasternak environment and electric and magnetic fields on the dynamic stability region is investigated. The results show that considering the surface stresses leads to an increase in the excitation frequency and the dynamic stability region happens at higher frequencies.

• Wind and Structures
• /
• 제32권2호
• /
• pp.143-159
• /
• 2021

The 246.8-m-tall Beijing Olympic Tower (BOT) is a new landmark in Beijing City, China. Its unique architectural style with five sub-towers and a large tower crown gives rise to complex dynamic characteristics. Thus, it is wind-sensitive, and a double-stage pendulum tuned mass damper (DPTMD) has been installed for vibration mitigation. In this study, a finite-element analysis of the wind-induced responses of the tower based on full-scale measurement results was performed. First, the structure of the BOT and the full-scale measurement are introduced. According to the measured dynamic characteristics of the BOT, such as the natural frequencies, modal shapes, and damping ratios, an accurate finite-element model (FEM) was established and updated. On the basis of wind measurements, as well as wind-tunnel test results, the wind load on the model was calculated. Then, the wind-induced responses of the BOT with the DPTMD were obtained and compared with the measured responses to assess the numerical wind-induced response analysis method. Finally, the wind-induced serviceability of the BOT was evaluated according to the field measurement results for the wind-induced response and was found to be satisfactory for human comfort.

• 대한기계학회논문집
• /
• 제11권3호
• /
• pp.444-453
• /
• 1987

본 연구에서는 난류구조에 대한 유선곡률의 영향을 명확히 반영하는 적절한 곡률수정 2-방정식모델을 개발하고자 한다. 이 연구에서 제안된 모델의 타당성은 다 음의 2차원 재순환유동에 대한 실험결과와 계산결과의 비교를 통해서 입증될 것이다. (1) Moss와 Bake에 의하여 맥동열선 풍속계로 측정된 두꺼운 수직벽주위의 유동` (2) 레이저 도플러 속도계로 Fraser와 Siddig에 의해 측정된 얇은 수직벽유동` (3)맥동열 선 풍속계로 Eaton이 실험한 후면벽유동` (4)맥동열선 풍속계로 Moss와 Baker가 측정 한 전면벽유동. 새로운 곡률수정 2-방정식모델은 2장에서 설명되고 있으며, 3장에서 는 경계조건과 수치계산 과정이 간단이 기술되어 있다. 그 뒤에 4장에는 계산결과와 실험치에대한 비교검토가 설명되어 있고 마지막으로 5장에서는 본 연구에 대한 결론을 맺고 있다.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2009년도 학술발표회 초록집
• /
• pp.540-544
• /
• 2009

Hydrologic pattern under climate change has been paid attention to as one of the most important issues in hydrologic science group. Rainfall and runoff is a key element in the Earth's hydrological cycle, and associated with many different aspects such as water supply, flood prevention and river restoration. In this regard, a main objective of this study is to evaluate design flood using simulation techniques which can consider a full spectrum of uncertainty. Here we utilize a weather state based stochastic multivariate model as conditional probability model for simulating the rainfall field. A major premise of this study is that large scale climatic patterns are a major driver of such persistent year to year changes in rainfall probabilities. Uncertainty analysis in estimating design flood is inevitably needed to examine reliability for the estimated results. With regard to this point, this study applies a Bayesian Markov Chain Monte Carlo scheme to the NWS-PC rainfall-runoff model that has been widely used, and a case study is performed in Soyang Dam watershed in Korea. A comprehensive discussion on design flood under climate change is provided.