• Journal of Information Display
• /
• v.9 no.4
• /
• pp.21-29
• /
• 2008

We studied both the wavelength and intensity dependent photo-responses (photofield-effect) in amorphous In-Ga-Zn-O (a-IGZO) thin-film transistors (TFTs). During the a-IGZO TFT illumination with the wavelength range from $460\sim660$ nm (visible range), the off-state drain current $(I_{DS_off})$ only slightly increased while a large increase was observed for the wavelength below 400 nm. The observed results are consistent with the optical gap of $\sim$3.05eV extracted from the absorption measurement. The a-IGZO TFT properties under monochromatic illumination ($\lambda$=420nm) with different intensity was also investigated and $I_{DS_off}$ was found to increase with the light intensity. Throughout the study, the field-effect mobility $(\mu_{eff})$ is almost unchanged. But due to photo-generated charge trapping, a negative threshold voltage $(V_{th})$ shift is observed. The mathematical analysis of the photofield-effect suggests that a highly efficient UV photocurrent conversion process in TFT off-region takes place. Finally, a-IGZO mid-gap density-of-states (DOS) was extracted and is more than an order of magnitude lower than reported value for hydrogenated amorphous silicon (a-Si:H), which can explain a good switching properties observed for a-IGZO TFTs.

• Journal of the Korean Vacuum Society
• /
• v.17 no.5
• /
• pp.435-441
• /
• 2008

In this paper, we investigated the electrical properties of triisopropylsilyl (TIPS) pentacene organic thin-film transistor (OTFT) depending on solvent type. We spin coated TIPS pentacene by using chlorobenzene, p-xylene, chloroform, and toluene as solvents. Fabricated OTFT with chlorobenzene shows field-effect mobility of $1.0{\times}10^{-2}cm^2/V{\cdot}s$, on/off ratio of $4.3{\times}10^3$ and threshold voltage of 5.5 V. In contrast, with chloroform, the mobility is $5.8{\times}10^{-7}cm^2/V{\cdot}s$, on/off ratio of $1.1{\times}10^2$ and threshold voltage of 1.7 V. Moreover we measured the grain size of each TIPS pentacene solvent by atomic force microscopy (AFM). From these results, it can be concluded that a solvent with higher boiling point results in better electrical characteristics due to large grain size and high crystallinity of TIPS pentacene layer. In this paper TIPS pentacene with chlorobenzene shows the best electrical properties.

• Journal of the Korean Vacuum Society
• /
• v.22 no.5
• /
• pp.270-275
• /
• 2013

Single-layer graphene layers have been synthesized by using chemical vapor deposition, subsequently transferred on 300 nm $SiO_2/Si$ and quartz substrates, and doped with $AuCl_3$ by spin coating for various doping concentrations ($n_D$) from 1 to 10 mM. Based on the $n_D$-dependent variations of Raman frequencies/peak-intensity ratios, sheet resistance, work function, and Dirac point, measured by structural, optical, and electrical analysis techniques, the p-type nature of graphene is shown to be strengthened with increasing $n_D$. Especially, as estimated from the drain current-gate voltage curves of graphene field effect transistors, the hole mobility is very little varied with increasing $n_D$, in strong contrast with the $n_D$-dependent large variation of electron mobility. These results suggest that $AuCl_3$ is one of the best p-type dopants for graphene and is promising for device applications of the doped graphene.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.9
• /
• pp.3061-3070
• /
• 2012

Novel 2-hexylthieno[3,2-b]thiophene-containing conjugated molecules have been synthesized via a reduction reaction using tin chloride in an acidic medium. They exhibited good solubility in common organic solvents and good self-film and crystal-forming properties. The single-crystalline objects were fabricated by a solvent slow diffusion process and then were employed for fabricating field-effect transistors (FETs) along with thinfilm transistors (TFTs). TFTs made of 5 and 6 exhibited carrier mobility as high as 0.10-0.15 $cm^2V^{-1}s^{-1}$. The single-crystal-based FET made of 6 showed 0.70 $cm^2V^{-1}s^{-1}$ which was relatively higher than that of the 5-based FET (${\mu}=0.23cm^2V^{-1}s^{-1}$). In addition, we fabricated organic photovoltaic (OPV) cells with new 2-hexylthieno [3,2-b]thiophene-containing conjugated molecules and methanofullerene [6,6]-phenyl C61-butyric acid methyl ester ($PC_{61}BM$) without thermal annealing. The ternary system for a bulk heterojunction (BHJ) OPV cell was elaborated using $PC_{61}BM$ and two p-type conjugated molecules such as 5 and 7 for modulating the molecular energy levels. As a result, the OPV cell containing 5, 7, and $PC_{61}BM$ had improved results with an open-circuit voltage of 0.90 V, a short-circuit current density of 2.83 $mA/cm^2$, and a fill factor of 0.31, offering an overall power conversion efficiency (PCE) of 0.78%, which was larger than those of the devices made of only molecule 5 (${\eta}$~0.67%) or 7 (${\eta}$~0.46%) with $PC_{61}BM$ under identical weight compositions.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.5
• /
• pp.21-28
• /
• 2007

In this paper, in order to derive the two-dimensional field effect of n-InAlAs/InGaAs HEMTs, we suggested analytical model by solving the two-dimensional Poisson's equation in both InAlAs and InGaAs regions by taking into account the longitudinal field variation, field-dependent mobility, and the continuity condition of the channel current flowing within the quantum well shaped channel. Derived expressions for long and short channel devices would be applicable to the entire operating regions in a unified manner. Simulation results show that the drain saturation current increases and the threshold voltage decreases as drain voltage increases. Compared with the conventional model, the present model may offer more reasonable explanation for the drain-induced threshold voltage roll-off, the Early effect, and the channel length modulation effect. Furthermore, it is expected that the proposed model would provide more reasonable theoretical basis for analyzing various long and short channel InAlAs/InGaAs HEMT devices.

• Korean Journal of Materials Research
• /
• v.14 no.1
• /
• pp.46-51
• /
• 2004

The annealing of a Cu(4.5at.% Mg)/$SiO_2$/Si structure in ambient $O_2$, at 10 mTorr, and $300-500^{\circ}C$, allows for the outdiffusion of the Mg to the Cu surface, forming a thin MgO (15 nm) layer on the surface. The surface MgO layer was patterned, and successfully served as a hard mask, for the subsequent dry etching of the underlying Mg-depleted Cu films using an $O_2$ plasma and hexafluoroacetylacetone [H(hfac)] chemistry. The resultant MgO/Cu structure, with a taper slope of about $30^{\circ}C$ shows the feasibility of the dry etching of Cu(Mg) alloy films using a surface MgO mask scheme. A dry-etched Cu(4.5at.% Mg) gate a-Si:H TFT has a field effect mobility of 0.86 $\textrm{cm}^2$/Vs, a subthreshold swing of 1.08 V/dec, and a threshold voltage of 5.7 V. A novel process for the dry etching of Cu(Mg) alloy films, which eliminates the use of a hard mask, such as Ti, and results in a reduction in the process steps is reported for the first time in this work.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.30 no.9
• /
• pp.566-571
• /
• 2017

A soft baking process was used to enhance the electrical characteristics of solution-processed indium-zincoxide (IZO) thin-film transistors (TFTs). We demonstrate a stable soft baking process using a hot plate in air to maintain the electrical stability and improve the electrical performance of IZO TFTs. These oxide transistors exhibited good electrical performance; a field-effect mobility of $7.9cm^2/Vs$, threshold voltage of 1.4 V, sub-threshold slope of 0.5 V/dec, and a current on/off ratio of $2.9{\times}10^7$ were measured. To investigate the static response of our solutionprocessed IZO TFTs, simple resistor load type inverters were fabricated by connecting a resistor (5 or $10M{\Omega}$). Our IZO TFTs, which were manufactured using the soft baking process at a baking temperature of $120^{\circ}C$, performed well at the operating voltage, and are therefore a good candidate for use in advanced logic circuits and transparent display backplanes.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.1254-1257
• /
• 2004

Comparative study on the effects of $H_2$ vs. $O_2$ plasma pretreatment of gate oxide on the degradation phenomenon of p-channel low-temperature polysilicon (LTPS) thin-film transistors (TFTs) were performed. After high drain current stress (HDCS) with $V_{gs}$ = $V_{ds}$, the p-channel TFTs pretreated by $O_2$ plasma showed increased immunity to the degradation of device characteristics such as threshold voltage and maximum field effect mobility because of the higher binding energy of Si-O bond than that of Si-H bond. The investigation of degradation phenomenon of these parameters with the applied power suggests that self-heating can be the major cause of degradation of polysilicon TFTs.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.03a
• /
• pp.129-129
• /
• 2003

최근에 능동 영역 액정 표시 소자(Active Matrix Liquid Crystal Display, AMLCD)에서 고해상도와 빠른 응답속도를 요구하게 되면서부터 다결정 실리콘(poly-Si) 박막 트랜지스터(Thin Film Transistor, TFT)가 쓰이게 되었다. 그리고 일반적으로 디스플레이의 기판을 상대적으로 저가의 유리를 사용하기 때문에 저온 공정이 필수적이다. 따라서 새로운 저온 결정화 방법과 부가적으로 최근 디스플레이 개발 동향 중 하나인 대화면에 적용 가능한 공정인 금속유도 결정화 (Silicide Mediated Crystallization, SMC)가 연구되고 있다. 이 소자는 top-gated coplanar구조로 설계되었다. (그림 1)(100) 실리콘 웨이퍼위에 3000$\AA$의 열산화막을 올리고, LPCVD로 55$0^{\circ}C$에서 비정질 실리콘(a-Si:H) 박막을 550$\AA$ 증착 시켰다. 그리고 시편은 SMC 방법으로 결정화 시켜 TEM(Transmission Electron Microscopy)으로 SMC 다결정 실리콘을 분석하였다. 그 위에 TFT의 게이트 산화막을 열산화막 만큼 우수한 TEOS(Tetraethoxysilane)소스로 사용하여 실리콘 산화막을 1000$\AA$ 형성하였고 게이트는 3000$\AA$ 두께로 몰리브덴을 스퍼터링을 통하여 형성하였다. 이 다결정 실리콘은 3$\times$10^15 cm^-2의 보론(B)을 도핑시켰다. 채널, 소스, 드래인을 정의하기 위해 플라즈마 식각이 이루어 졌으며, 실리콘 산화막과 실리콘 질화막으로 passivation하고, 알루미늄으로 전극을 형성하였다 그리고 마지막에 TFT의 출력특성과 전이특성을 측정함으로써 threshold voltage, the subthreshold slope 와 the field effect mobility를 계산하였다.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1238_1239
• /
• 2009

본 논문에서는 ELA poly-Si TFT보다 뛰어난 균일도를 갖고, a-Si:H TFT보다 전기적 안정도가 우수한 PMOS SPC-Si TFT의 특성을 연구하였다. SPC-Si의 계면 특성을 향상 시키기 위해 $SiO_2$ 게이트 절연막을 증착하기 전에 Solid Phase Crystalline 실리콘(SPC-Si) 채널 영역에 다양한 H2 플라즈마 처리를 해주었다. PECVD를 이용하여 100W에서 H2 플라즈마 처리를 5분 해주었을 때 SPC-Si TFT의 전기적 특성이 향상되는 것을 볼 수 있는데, $V_{TH}$가 약 -3.91V, field effect mobility가 $22.68cm^2$/Vs, 그리고 Subthreshold swing이 0.64 정도를 보였다. 또한 소자에 Hot carrier stress($V_{GS}$=14.91V, $V_{DS}$=-15V, for 2,000sec)를 주었을 때도 전기적 특성이 변하지 않았으며, 일정한 bias stress($V_{GS}$=-15V, $V_{DS}$=-10V, for 2,000sec)를 가하였을 때도 $V_{TH}$가 증가하지 않았다. 이러한 결과를 통해 SPC-Si가 poly-Si TFT보다 더욱 안정함을 알 수 있었다.