• 말소리와 음성과학
• /
• 제4권4호
• /
• pp.109-115
• /
• 2012

This paper mainly aims to investigate how differently choral speech and altered auditory feedback (i.e., delayed auditory feedback, frequency-altered feedback) enhance speech fluency during sentence reading. To do this, a stuttering reduction rate was used and measured how much stuttering in frequency was reduced during each of the fluency enhancing conditions (i.e, typical choral reading, DAF, FAF) relative to typical solo reading. The results showed that stuttering frequency was reduced in the three fluency enhancing conditions and the highest mean value in stuttering reduction rate was observed during typical choral reading. Some discussion was provided in relation to the stuttering reduction rate observed during typical choral reading and its further speculation.

• 대한전자공학회논문지TC
• /
• 제47권2호
• /
• pp.25-33
• /
• 2010

양자화된 채널 상태 정보를 이용하는 공간 분할 다중 접속 방식은 제한된 되먹임 정보로도 다중 송신의 이득을 가질 수 있다. 그러나 되먹임 정보의 양은 사용자에 따라 선형적으로 증가하기 때문에, 공간 분할 다중 접속 방식은 제한된 되먹임 방식을 사용하더라도 여전히 높은 신호처리 부담을 갖게 된다. 그러므로 본 논문에서는 대상이 되는 사용자 수를 효과적으로 제어할 수 있는 새로운 되먹임 방식을 제안한다. 제안하는 방식에서는 성능 열화 없이 되먹임 정보량을 줄이기 위해 되먹임 요청 기준 조건을 제시하고 이에 미치지 못하는 열악한 통신 환경의 사용자들을 제한한다. 본 논문의 모의 실험에서는 제안하는 방식이 전송 효율 이득을 높일 뿐만 아니라 되먹임 정보를 합리적으로 감소시킬 수 있음을 보여준다.

• Journal of Communications and Networks
• /
• 제13권4호
• /
• pp.339-344
• /
• 2011

Base station coordination has received much attention as a means to reduce the inter-cell interference in cellular networks. However, this interference reducing ability comes at the expense of increased feedback, backhaul load and computational complexity. The degree of coordination is therefore limited in practice. In this paper, we explore the trade-off between capacity and feedback load in a cellular network with coordination clusters. Our main interest lies in a scenario with multiple fading users in each cell. The results indicate that a large fraction of the total gain can be achieved by a significant reduction in feedback. We also find an approximate expression for the distribution of the instantaneous signal to interference-plus-noise ratio (SINR) and propose a new effective scheduling algorithm.

• 대한기계학회논문집B
• /
• 제26권9호
• /
• pp.1234-1240
• /
• 2002

A new feedback control law is proposed and tested for suppressing the vortex shedding from a circular cylinder in a uniform flow. The lift coefficient ( $C_{L}$) is employed as a feedback control signal and the control forcing is given by a rotational oscillation of the cylinder. The influence of the feedback transfer function on the $C_{L}$ reduction is examined. The main rationale of the feedback control is that a feedback control forcing is imposed at a phase which is located outside the range of lock-on. By applying the feedback control law, $C_{L}$ is reduced significantly. Furthermore, the reduction mechanism of $C_{L}$ is analyzed by showing the vortex formation modes with respect to the forcing phase.e.ase.e.

• 한국정보전자통신기술학회논문지
• /
• 제13권1호
• /
• pp.42-47
• /
• 2020

OFDM 기반 초고속 통신시스템을 위한 IFFT/FFT 프로세서는 저면적 저전력이면서 데이터 처리량이 높고 프로세싱 지연이 적어야 한다. 따라서, 파이프라인과 병렬처리를 적용한 radix-2k 알고리즘 기반 MDF(multipath delay feedback) 구조가 적합하다. 기존의 MDF 구조에서 입력신호의 워드길이에 비례하여 커지는 피드백 메모리는 면적과 전력소모가 크다. 본 논문에서는 OFDM 응용을 위한 radix-22 MDF IFFT 프로세서의 피드백 메모리 크기 감소 방법을 제안한다. MDF 구조에서 첫 두 스테이지의 피드백 메모리의 크기는 전체 피드백 메모리의 75%를 차지하므로 첫 두 스테이지의 피드백 메모리 크기 감소에 초점을 맞춘다. OFDM 전송에서 IFFT 입력신호는 변조데이터와 파일럿과 널 신호로 구성된다는 특징을 이용하여 변조데이터와 파일럿/널 신호를 각각 부호있는 정수로 매핑하여 입력신호의 워드길이를 감소시키는 방법을 제안한다. 시뮬레이션을 통해 제안한 방법이 기존 방법보다 피드백 메모리의 크기를 약 39%까지 감소시킬 수 있음을 보인다.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제8권1호
• /
• pp.108-122
• /
• 2014

Massive antenna array is an attractive candidate technique for future broadband wireless communications to acquire high spectrum and energy efficiency. However, such benefits can be realized only when proper channel information is available at the transmitter. Since the amount of the channel information required by the transmitter is large for massive antennas, the feedback is burdensome in practice, especially for frequency division duplex (FDD) systems, and needs normally to be reduced. In this paper a novel channel feedback reduction scheme based on the theory of distributed compressive sensing (DCS) is proposed to apply to massive antenna arrays with spatial correlation, which brings substantially reduced feedback load. Simulation results prove that the novel scheme is better than the channel feedback technique based on traditional compressive sensing (CS) in the aspects of mean square error (MSE), cumulative distributed function (CDF) performance and feedback resources saving.

• 한국소음진동공학회논문집
• /
• 제16권12호
• /
• pp.1252-1261
• /
• 2006

This paper summarizes theoretical work on the multichannel decentralized feedback control of sound radiation from aircraft trim panels using piezoceramic actuators. The aircraft trim panels are generally honeycomb structures designed to meet the design requirement of low weight and high stiffness. They are resiliently-mounted to the fuselage for the passive reduction of noise transmission. It is motivated by the localization of reduction in vibration of single channel active trim panels. 12-channel decentralized feedback control systems are investigated in terms of the reduction of noise and vibration for three configurations of sensor actuator pairs. Local coupling of the closely-spaced sensor and actuator pairs was modeled using single degree of freedom systems. The multichannel control system is characterized using the state-space model. For the stability point of view, the relative stability or robustness is evaluated by comparing the real part of eigenvalues of the system matrix for the three configurations. The control performance is also evaluated and compared for the three configurations. It is found that the multichannel system can lead to the globalization of the reduction in vibration and radiated noise. It does not appear to yield a significant improvement in the vibration because of decreased gain margin. However, the reduction in the radiated noise is remarkably improved due to the variation of the vibration pattern with the actuation configurations.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2008년도 하계학술발표대회 논문집
• /
• pp.813-818
• /
• 2008

In order to reduce energy consumption, this study presents a way to energy reduction through energy-feedback which enables a household to self-recognize the need for energy reduction and respond to. The effect of this energy-feedback has been reported as $10{\sim}15%$ in average, and been actively investigated in abroad from 1970's while study in korea has been in its first step. In this study, examination on the cases of abroad study is made as it shows the effectiveness and applicability of energy feedback. And paradigms to consider for application to korea will be suggested anticipating the change of actions through energy feedback.

• International Journal of Control, Automation, and Systems
• /
• 제5권6호
• /
• pp.614-620
• /
• 2007

This paper considers vibration suppression of a mechanical transfer system, where the work is connected with the hand flexibly. We adopt the idea of jerk reduction of the hand. From the equation of motion, we first derive a state equation including the jerk and acceleration of the hand, but excluding the displacement and velocity of the work. Then, we design optimal state feedback for a suitable cost function, and show by simulation that jerk reduction of the hand is effective for vibration suppression of the work and improvement of the settling time. Since state feedback including the jerk and acceleration is not practical, we propose a computation method for optimal feedback using displacements and velocities in the state only.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2002년도 ICCAS
• /
• pp.39.3-39
• /
• 2002

In this paper, presented is a feedback control loop, for an in-plane gimbaled micro gyroscope based on methodology and state weighted model reduction technique. The micro gyroscope is the basic inertial sensors. To improve the performances such as stability, wide dynamic range, bandwidth and especially robustness, it is necessary to design a feedback control loop, which must be robust, because the manufacturing process errors can be large. Especially, to obtain wide bandwidth, the feedback controller is indispensable, because the gyroscope is high Q factor system and has small open loop bandwidth. Moreover, the feedback controller reduces the effect...