• 한국화재소방학회논문지
• /
• 제19권1호
• /
• pp.80-86
• /
• 2005

본 연구는 지하역사 승강장 가판대에서 화재발생 시 자연풍의 영향과 강제배연 시스템의 작동 여부에 따른 열과 연기의 유동특성을 알아보기 위하여 수치해석을 수행하였다. 해석 조건으로는 1)자연풍이 없고 배연설비도 가동되지 않는 경우, 2) 자연풍은 불고 있으나 배연설비는 가동되지 않는 경우, 3) 자연풍은 없으나 배연설비가 가동되는 3가지 경우이다. 수치해석의 결과자연풍이 역사의 길이 방향으로 불고 있을 경우에는 길이방향으로 화재의 확산이 빠르게 진행되며 열과 연기가 승강장에 급속하게 확산되어 피난에 영향을 미치는 것으로 나타났으며, 배연설비가 가동될 경우 지하역사 승강장으로 열과 연기가 보다 빠르게 전파되었지만 호흡안전 높이까지 열 및 연기가 도달하는 데에는 배연설비를 작동하지 않는 경우에 비하여 훨씬 많은 시간이 소요되었다. 그리고 화재발생위치에서 자연풍이 불어오는 지하공간영역에서는 배연설비의 제연효과가 하류 측의 영역에 비하여 보다 크게 나타나는 것을 알 수 있었다. 배연설비의 작동은 연기와 열을 동시에 외부로 배출시키는 역할을 하여 승객의 시야 확보 및 피난 시간을 확보하여 주는 것으로 나타났다. 해석조건에서 가장 큰 차이를 보이는 조건2)와 조건3)에서 화재구역 내의 온도차는 약 2배 차이를 보였으며, 화재지점에서 200m 지점의 연기농도분포도 약 6배 정도의 차이를 보였다.

• 설비공학논문집
• /
• 제16권3호
• /
• pp.265-272
• /
• 2004

Based on the T-method, a new scheme for predicting air flow rate distribution in a bathroom exhaust system is developed. Introduction of individual duct route enables us to disintegrate a complicated multi-fan ductwork into a set of simultaneous single-fan subsystems. The scheme is validated via the analysis of a well-posed test problem, showing physical consistency. In order to demonstrate the utility and capability of our method, the bathroom ventilation system in a 20-story residential building is selected as an example. Under the typical design condition, the air flow rate of each exhaust fan at the balancing point is successfully predicted, and such information can lead to an engineering estimation for the overall system performance. While some deficiencies in ventilation are found at bathrooms at lower floors with 6mmAq-rated exhaust fans, they disappear over the whole building by using fans of enhanced static pressures, 7 and 8mmAq. Finally the present scheme seems to be useful for practical design of multi-branched, multi-fan ventilation systems.

• 설비공학논문집
• /
• 제15권12호
• /
• pp.996-1006
• /
• 2003

The objective of this study is to find major variables which influence the performance of kitchen and bathroom exhaust systems in high-rise apartment buildings. For this purpose, the influencing factors on the exhaust airflow rates from the kitchen or bathroom are identified and in every cases, which are made of combinations between the influencing factors, the exhaust airflow rates are calculated through the simulations. The results of the simulation show that the exhaust airflow rates from the kitchen and bathroom mainly depends on outdoor air temperature, number of floors, airtightness of the building envelope, fan on ratio, vertically connected to same shaft, exhaust fan capacity for kitchen or bathroom, roof ventilator capacity and shaft area for kitchen or bathroom exhaust.

• 터널과지하공간
• /
• 제28권1호
• /
• pp.38-58
• /
• 2018

갱내환기는 지하광산 안전성에 직접적인 영향을 미친다. 갱내환기는 정상시에는 작업공간내 유해물질의 희석을 위한 충분한 량의 급기를 통하여 쾌적한 환경을 유지하는 것이 목적이나 갱내화재와 같은 비상시에는 화재의 확산제어와 구조활동의 지원을 목적으로 한다. 본 연구를 통하여 작업공간 국부환기 뿐만 아니라 화재연 제어를 위한 방재팬을 개발하였다. 방재팬은 풍관없이 가동되며 작업공간내 유해물질의 희석 및 배기 기능을 갖추고 있으며 동시에 화재시 화재연 배기를 목적으로 한다. 본 논문은 개발된 방재팬과 기존 국부팬의 연결 운전을 통한 화재연의 배기효율 연구가 목적이다. 일련의 현장 실험 및 CFD분석을 통하여 맹갱도 작업공간내 방재팬의 화재연 배기효율을 분석하였으며 이를 위하여 SF6 추적가스를 이용한 공간내 기류 및 유해물질 유동을 검토하였다. 대단면 석회석 광산에서 수행한 현장실험과 CFD분석 결과를 비교한 결과, 갱내에서 가장 리스크가 큰 맹갱도 굴진 작업장에서 기존 국부팬 1대와 조합 운전하는 경우, 팬의 설치 위치 및 운전모드의 적절한 선택시에 효율적인 화재연 배기가 가능함을 보였다. 또한 CFD분석을 통하여 벤츄리효과에 의한 배기효율도 확인할 수 있었다. 팬 설치 위치 및 운전모드가 배기효율을 결정하는 가장 중요한 변수임을 보였다.

• 한국주거학회논문집
• /
• 제15권5호
• /
• pp.77-84
• /
• 2004

The mock-ups of ventilation system, which has been widely adopted for the bathroom with the area of 100 $m^2$ apartment housing, were established and tested to design mechanical ventilation for apartment housing bathroom where air supply exhaust are relatively important. These ventilation mock-ups were capable of controlling intake and exhaust, which has the size of supply openings as 40cm${\times}$1cm, 40cm${\times}$3cm, 40cm${\times}$5cm. They were established at five locations, spaced 40cm from each other at a height of 25cm from the floor. The exhaust fans were located at four corners and center of the ceiling. The results this ventilation effect measurement by different condition are showing that when the size of air supply is bigger and the location is lower, the effect of ventilation was relatively higher. In addition, as the distance between exhaust fan and air supply was farther, the ventilation effect were getting highly efficient.

• 설비공학논문집
• /
• 제23권2호
• /
• pp.139-146
• /
• 2011

The ventilation performance of a vertical exhaust duct system in the high riser public house has been evaluated by a commercial software, Fluid Flow, which solves pressure losses through the duct system including bathroom fans and a hybrid roof fan. During the numerical simulations, outdoor wind condition and stack effects in summer and winter were considered as well as the operating conditions of a basement damper and the roof fan. The results show that the bathroom ventilation in summer is the most unsatisfactory. The opening of the basement damper has a problem that the polluted air in the lower floors is exhausted to the underground parking lot, not to the rooftop. If the basement damper is closed, the exhaust flow rate in the lower floors is not sufficient due to the strong flow resistance in the long vertical duct even though the roof fan is under operating.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2008년도 하계학술발표대회 논문집
• /
• pp.889-894
• /
• 2008

Exhaust system used in toilet and cooking place of high riser public house is roof fan of two basic types : natural roof ventilator and natural/forced roof ventilator. Natural/forced roof ventilator has a motor in the rotary shaft. There are many high riser public house in Korea. These buildings were not viewed as being major contributors to exhaust pollutants producted in indoor. It was because many engineers thought that exhaust in high riser building depend on stack effect. This study investigates on stack pressure determined by exterior pressure and the difference pressure control in exhaust stack used in high riser public house. This paper focuses mainly on the effect of the time interval for power supply of motor installed in roof fan with function of natural wind velocity and of exhaust air volume of toilet. It is observed there are higher exhaust efficiency than the existing natural roof ventilator.

• 한국산업보건학회지
• /
• 제17권3호
• /
• pp.212-223
• /
• 2007

18 Local exhaust ventilation systems in 10 melting companies located in an industrial complex were tested to know the status of maintenance. Test items were fan flowrates, fan static pressures, rotational speeds and differential pressures of bag filters. Only 22% of the tested fans has more than 80% flowrate efficiency. 44% of the fans has lower than 60% efficiency. The performance of the fans are not in a good status. For the fans with lower than 60% efficiency, the analysis shows that the lower flowrate might be caused by the degradation of fan performance. On the other hand, for the fan s with higher than 60% efficiency, the main cause of flowrate reduction might be too much pressure losses due to clogging of filter bags. The degradation of fans usually lead the reduction of hood capture efficiency, resulting in the increase of contaminant concentrations in workplace. To keep fans in good status, self inspections should be periodically conducted. This inspection should include the measurements of flowrate and pressures. The most important thing to be performed is the initial test of local exhaust ventilation system because the initial test data should be used to know the level of system degradation.

• 한국환경과학회지
• /
• 제18권7호
• /
• pp.755-765
• /
• 2009

Some sections of the exhaust system to determine the shape of the duct is to suffer the difficulties by space constraints to install new equipment of the environment post-treatment for existing operation of the power plants. In this paper the large duct in flue gas desulfurization equipments of the 500MW coal-fired power plant on the current operation is numerically analyzed from induced draft fan exit to booster up fan inlet section which is in the narrow space of the exhaust system with four times bending and is connected to emergency duct to bypass the exhaust gas on the emergency operation. The procedure and method using computational fluid dynamics are proposed to maintain the stability of the guide vane with the uniform flow and a minimum pressure loss of exhaust gas in the case of normal and emergency operation between the direction of the flow of exhaust gas duct at different.

• 한국산업보건학회지
• /
• 제3권1호
• /
• pp.91-98
• /
• 1993

This study was carried out to investigate characteristic of vinyl chloride emissioned from poly vinyl chloride extrusion process and to evaluate the efficiency of local exhaust ventilation system. Before local ventilation facility was constructed in poly vinyl chloride extrusion process, the average worker exposure to vinyl chloride was 3.15 ppm, which exceeded Threshold Limit Value of American Conference of Gorvernmental Industrial Hygienists (ACGIH-TLV), 1 ppm. lt is possible that vinyl chloride residues in the poly vinyl chloride resin was released or degased due to extrusion heat. The larger the width of vinyl tube become, the higher worker exposure to vinyl chloride was. It is estimated that vinyl chloride from vinyl chloride resin increased as amount of poly vinyl chloride resin extruded in the extrusion process increased. Canopy hood was an appropriate type for poly vinyl chloride resin extrusion process. This local exhaust ventilation has fan static pressure of 7.65 inch wg($190mmH_2O$, total volumetric flowlate of 4,796 CFM ($135.8m^3$/min) and fan power requirement of 12 hp (8.952 Kw). After this local exhaust ventilation was constructed there, the average concentration of worker exposure to vinyl chloride was reduced to be 0.46 ppm, which was below the Threshold Limit Value, 1 ppm. Also, the removal efficiency rate of vinyl chloride attained by local exhaust ventilation was 85.3%. It was a statistically significant (p<0.01).