• Journal of the Korean Society of Safety
• /
• v.14 no.1
• /
• pp.101-107
• /
• 1999

$TiO_2$ and $xTiO_2-ySiO_2$ system photocatalysts were developed by sol-gel method based on the change of production parameters, and their structure of crystallization and the specific surface area was measured. Considering the efficiency of the ethanol decomposition using the catalyst, the conclusion was made as follows: 1) By means of X-ray analysis of $TiO_2$ powder that is obtained from water and Titanium alkoxide with various molar ratios, it is shown that structure of crystallization is a dominating structure and, on the other hand, the crystallization of rutile also partly exists. The specific surface area is at its maximum value at R=6, which is the molar ratio of water vs. alkoxide, whereas its value goes down as the molar ratio increases. In the reaction of using $TiO_2$ catalyst, the ethanol is decomposed into the extent of 15 ~30% in an hour and three hours are necessitated for 70% decomposition. 2) $TiO_2/SiO_2$ powder is developed from Titanium and Silicon alkoxide by a hetero-condensation process. The increase of SiO$_2$ contents causes the decrease of the degree of crystallization of the gel, whereas the specific surface area preferentially increases. In the decomposition reaction of the ethanol, the decomposition efficiency represents 25~60% in an hour. It is, however, examined that the efficiency inactively increases corresponding to the duration of reaction time. It is shown that more than 90% of ethanol is decomposed when reaction time is about three hours and the efficiency illustrates the maximum value for 60-$TiO_2/4O-SiO_2$ catalyst.

• Bulletin of the Korean Chemical Society
• /
• v.8 no.4
• /
• pp.261-264
• /
• 1987

Benoxaprofen (2-(4-chlorophenyl)-${\alpha}$ -methyl-5-benzoxazole acetic acid) is a nonsteroidal anti-inflammatory drug that causes acute cutaneous phototoxicity. The ability of benoxaprofen (BXP) and its photoproduct, decarboxybenoxaprofen (DBXP) to photosensitize the decomposition of tryptophan was evaluated in various media such as water, ethanol and aqueous micellar dispersions of surfactants. The weak photosensitization of BXP in water was found to be enhanced in cationic CTAB micelle system, but yielded little difference in anionic SDS micelles. In ethanol solution, BXP was determined to photosensitize the decomposition of tryptophan, but no photosensitization was observed with DBXP. All of these results implicate that the anion radical of BXP may play a major role in the photosensitization in hydrophobic micellar phase, forming superoxide through interaction with oxygen as demonstrated by observation that the photosensitization was inhibited by superoxide dismutase.

• Journal of Korean Society for Atmospheric Environment
• /
• v.17 no.4
• /
• pp.363-370
• /
• 2001

In this study, TiO$_2$, the popular photocatalyst, was used to decompose ethanol. TiO$_2$was prepared by the sol -gel method and coated on pyrex stick. A 15W, UV-A lamp was used as the UV light source and il gas chromatography (HP 5890) was used to confirm the concentrations of ethanol, $CO_2$and the intermediates. Variation of preparation parameters and calcination temperature for TiO$_2$photocatalysts in the sol -gel method caused changes of ethanol decomposition activity. The best ethanol photodecomposition activity was obtained on the sample when prepared with 0.14 mol of HCI, a mol of ethanol and 1.3 mol of TTIP ware mixed in sol-gel process and calcinated at 50$0^{\circ}C$ for 3 hours. Acetaldehyde was detected as an intermediate and decomposed to carbon dioxide and water at the end of the reaction.

• Korean Journal of Materials Research
• /
• v.8 no.2
• /
• pp.126-130
• /
• 1998

Aluminum sulfate, $AI_{2}(SO_4)_3\cdot18H_2O$ was prepared by adding of kaolin-dissolved sulphuric acid into ethanol and its thermal decomposition behavior was discussed. As-synthesized high purity precipitate particles were platelike shapes of $2\mu\textrm{m}$ size. With increasing drop rate of leach liquor into ethanol, the crystallite sizes of the precipitate decreased. The apparent activation energies for dehydration and sulfate decomposition of the precipitate were $11.9Kcal mol^{-1}$ and $48.2kcal mol^{-1}$ respectively.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.10
• /
• pp.116-124
• /
• 2011

In this work, the effect of the initial concentration of methanol and ethanol, and the addition of oxygen molecules were discussed to improve the hydrogen generation using non-thermal plasma reactor effectively. In addition, the effect of ozone decomposition catalyst of manganese dioxide and its quantity was investigated. First, hydrogen concentration increased until an initial concentration of about 40,000[ppm] of methanol and thereafter it was saturated. Henceforth, hydrogen concentration decreased with increasing the oxygen percent on the carrier gas of nitrogen about both substances. Related with the effect of catalyst, it increased upto 60[g], but it was not changed largely after that. Consequently, it is confirmed that the hybrid process using plasma process and catalytic surface chemical reaction is a very promising way to increase the efficiency of hydrogen generation as investigated in this work.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2012.05a
• /
• pp.100-103
• /
• 2012

The blending method that is an addition of small quantity of fuel was used to increase the performance of green propellant thruster. 90 wt.% hydrogen peroxide as a green propellant was selected, and ethanol was used as a blended fuel. The o/f ratio was chosen as 50 which has higher theoretical performance than 98 wt.% hydrogen peroxide. The chamber temperature of blended hydrogen peroxide was higher than adiabatic chamber temperature of hydrogen peroxide. Therefore, performance can be improved by ethanol blending. Several catalyst and its support were compared to find appropriate catalyst for decomposition and combustion of ethanol blended hydrogen peroxide. As a experimental results, Pt was suitable, but $MnO_2$ had a chamber instability when it was reused. The ${\alpha}-Al_2O_3$ which is high heat-resistant support showed very unstable performance in both Pt and $MnO_2$ catalyst since it has low decomposition performance.

• Journal of the Korean Chemical Society
• /
• v.19 no.6
• /
• pp.423-427
• /
• 1975

Changes in the electrical conductivity of gallium doped zinc oxide during the dehydrogenative oxidation of ethanol between 250 and $350^{\circ}C$ have been studied. Both dehydrogenation and dehydration of ethanol takes place on ZnO. At $300^{\circ}C$ and above formation of $CO_2$ was observed accompanied by an increase in the electrical conductivity. This seems to be due to oxidation of CO formed by the decomposition of acetaldehyde. Addition of oxygen to ethanol increases the amount of acetaldehyde formed, while no change is observed in ethylene formation. It may be that oxygen which is present primarily as $O^-$ provides a favorable site for the adsorption of ethanol and for subsequent hydrogen substraction.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.1
• /
• pp.141-146
• /
• 2014

A series of bimetallic Cu-Zn/$SiO_2$ catalysts were prepared via thermal decomposition of the as-synthesized $CuZn(OH)_4(H_2SiO_3)_2{\cdot}nH_2O$ hydroxides precursors. This highly dispersed Cu-solid base catalyst is extremely effective for hydrogenation of ethyl acetate to ethanol. The reduction and oxidation features of the precursors prepared by coprecipitation method and catalysts were extensively investigated by TGA, XRD, TPR and $N_2$-adsorption techniques. Catalytic activity by ethyl acetate hydrogenation of reaction temperatures between 120 and $300^{\circ}C$, different catalyst calcination and reduction temperatures, different Cu/Zn loadings have been examined extensively. The relation between the performance for hydrogenation of ethyl acetate and the structure of the Cu-solid base catalysts with Zn loading were discussed. The detected conversion of ethyl acetate reached 81.6% with a 93.8% selectivity of ethanol. This investigation of the Cu-Zn/$SiO_2$ catalyst provides a recently proposed pathway for ethyl acetate hydrogenation reaction to produce ethanol over Cu-solid base catalysts.

• Bulletin of the Korean Chemical Society
• /
• v.9 no.1
• /
• pp.55-59
• /
• 1988

The gaseous carbon dioxide has been irradiated with Co-60 gamma-radiation in the presence and absence of various alcohols, and the radiolysis products analyzed by gas chromatography. Experimental results indicate that no detectable amount of carbon monoxide is formed when pure carbon dioxide is irradiated. By adding small quantities of alcohols to carbon dioxide, however, considerable amount of carbon monoxide, ketones, alcohols and other organic products have been detected. By adding 0.1% of methanol, ethanol, 1-propanol, 2-propanol, 1-butanol, 2-methyl-l-propanol, 2-butanol, and 2-methyl-2-propanol, G(CO) values obtained are 4.4, 4.5, 5.2, 4.4, 5.2, 5.0, 4.7 and 4.1, respectively. These high yields of carbon monoxide suggest that the oxidation reactions of carbon monoxide may be suppressed by scavenging oxygen atom with the alcohols. The main radiolytic decomposition reactions of the alcohols present in small quantity in carbon dioxide may be supposed to be the reactions with the oxygen atom produced by the radiolysis of carbon dioxide. The decomposition reactions seems to follow pseudo-first order kinetics with respect to the alcohols. The decomposition rate measured with 2-propanol is the fastest and that with 2-methyl-2-propanol the slowest. The mechanisms of the radiolytic decomposition reactions of the alcohols present in carbon dioxide are discussed on the basis of the experimental results of the present study.

• Journal of Aerospace System Engineering
• /
• v.11 no.2
• /
• pp.9-15
• /
• 2017

In order to verify the possiblity of improving the combustion performance of ethanol using zeolite catalyst and the characteristics of nitrogen oxides and carbon monoxide emission, micro gas turbine experiments were performed using catalytic reaction products, ethanol and kerosene as fuels and the results were compared. The thrust of the catalytic reaction product was lower than that of kerosene, but it was improved by 5% on average compared with the use of ethanol. Nitrogen oxides and carbon monoxide emissions of the catalytic reaction products were measured to be very low overall compared to kerosene. As a result, when the ethanol was reformed using the zeolite catalyst, the engine performance could be improved while maintaining the environment friendliness of the ethanol.