• Asian-Australasian Journal of Animal Sciences
• /
• v.18 no.1
• /
• pp.80-84
• /
• 2005

An experiment was conducted to study the performance, carcass traits, serum lipid profile and immune competence in commercial broilers (2 to 42 d of age) fed graded levels (25, 50, 75 and 100%) of finger millet (FM) (Elusine coracana) in place (w/w) of yellow maize (YM). Each diet was fed to eight replicates (five female Vencobb broilers/replicate) housed in stainless steel battery brooders. The estimated metabolizable energy content of FM was about 540 kcal less than the YM. FM contained more protein (10.42 vs. 9.05%) and fibre (9.52 vs. 2.24%) compared to YM. Body weight gain, ready to cook yield, relative weights of giblet, liver, intestine and length of intestine at 42 d of age was not affected due to replacing YM with FM. But, the feed efficiency decreased in broilers fed diets containing 75 and 100% FM in place of YM at both 21 and 42 d of age. The amount of fat deposited in abdominal area decreased and the relative weight of gizzard increased with increase in level of FM in the diet. The serum HDL cholesterol at 21 and 42 d of age and serum triglycerides at 42 d of age decreased with increase in level of FM in diet. The relative weight of spleen and antibody titers against sheep red blood cells (SRBC) at 5 d post inoculation (PI) decreased in broilers fed FM at 100% of YM. However, the relative weight of bursa, SRBC titers at 10 d PI, antibody titers against ND virus and mortality were not affected due to incorporation of FM in place of YM in diet. The fat content in thigh muscle and liver decreased, while the protein content in these tissues increased with increase in the level of FM in broiler diet. Based on the results, it may be concluded that YM can be replaced with FM up to 25% on weight basis without affecting weight gain, carcass yields and immunity in commercial broiler diet (up to 42 d of age). Further, inclusion of finger millet reduced the fat deposition in thigh muscle, liver and in abdominal area compared to those fed maize as the principal source of energy.

• Journal of the Korean Vacuum Society
• /
• v.18 no.2
• /
• pp.108-115
• /
• 2009

The superlattice infrared photodetector (SLIP) with an active layer of 8/8-ML InAs/GaSb type-II strained-layer superlattice (SLS) of 150 periods was grown by MBE technique, and the proto-type discrete device was defined with an aperture of $200-{\mu}m$ diameter. The contrast profile of the transmission electron microscope (TEM) image and the satellite peak in the x-ray diffraction (XRD) rocking curve show that the SLS active layer keeps abrupt interfaces with a uniform thickness and a periodic strain. The wavelength and the bias-voltage dependences of responsivity (R) and detectivity ($D^*$) measured by a blackbody radiation source give that the cutoff wavelength is ${\sim}5{\mu}m$, and the maximum Rand $D^*$ ($\lambda=3.25{\mu}m$) are ${\sim}10^3mA/W$ (-0.6 V/13 K) and ${\sim}10^9cm.Hz^{1/2}/W$ (0 V/13 K), respectively. The activation energy of 275 meV analyzed from the temperature dependent responsivity is in good agreement with the energy difference between two SLS subblevels of conduction and valence bands (HH1-C) involving in the photoresponse process.

• The Journal of the Korea Contents Association
• /
• v.14 no.4
• /
• pp.277-286
• /
• 2014

The research has been carried out to examine how sensory processing ability of children of multicultural families in farming areas can affect their social maturity. Short sensory profile and social maturity scale were conducted to fifty four children of multinational parents who live in Gyeongsangbuk-do and Jeollanam-do. The data were analysed by statistics process. The result of the analysis revealed three findings. Firstly, there exieted certain delays in sensory processing ability and social maturity. Multicultural children had an average point of $154.33{\pm}21.24$ regarding sensory processing ability and with regards to social age and social quotient of social maturity of them were 1.76 year old and $91.28{\pm}18.31$ point respectively. Another interesting finding is that significant differences of the influence, in which sensory processing ability of the example group affected social maturity, were found in categories of movement sensitivity, underresponsive/seeks sensation and low energy/weak of social age part(p<0.05). There were significant differences between auditory filtering as well as movement sensitivity, underresponsive sensation and low energy/weak of social quotient area(p<0.05). Finally, variables of the impact on social maturity of the group of children were analysed to examine to what extent sensory processing ability of the children had affected and the influencing rate of social age and social quotient of social maturity, with 45.3% and 66.3% respectively.

• Tunnel and Underground Space
• /
• v.22 no.2
• /
• pp.106-119
• /
• 2012

Roughness of rock joint has generally been characterized based upon geometrical aspects of a two-dimensional surface profile. The appropriate description of joint roughness, however, should consider the features of roughness mobilization at contact areas under normal and shear loads. In this study, direct shear tests were conducted on the replicas of tensile fractured gneiss joints and the influence of the shear direction on the shear behavior and effective roughness was examined. In this procedure, a joint surface was represented as a group of triangular planes, and the steepness of each plane was characterized using the concepts of the active and inactive micro-slope angles. The contact areas at peak strength which were estimated by a numerical method showed that the locations of the contact areas were mainly dependent on the distribution of the micro-slope angle and the shear behavior of joint was dominated by only the fractions with active micro-slope angles. Therefore, a three-dimensional coefficient for the quantification of rock joint roughness is proposed based on the distribution of active micro-slope angle: active roughness coefficient, $C_r$. Comparison of the active roughness coefficient and the peak shear strength obtained from the experiment suggests that the active roughness coefficient is the effective parameter to quantify the surface roughness and estimate the shear behavior of rock joint.

• Korean Journal of Community Nutrition
• /
• v.12 no.2
• /
• pp.133-141
• /
• 2007

Minerals play important roles in biological processes. Hair mineral analysis has the advantages of conveniences in sampling and observing the profiles of multiple minerals simultaneously. The purpose of this study was to compare hair mineral contents between urban and local middle school students, and to find out the relation with nutrient intakes and clinical symptoms. Ten nutritional minerals and 7 environmental mineral contents were analyzed in the hair samples of 44 and 37 male students who resided in urban and local area, respectively. And their nutrient intake and clinical symptom score were estimated from questionnaire. The average age, height, and weight were 15.1 years, 168.4 cm, 56.8 kg in urban subjects and 15.4 years, 169.1 cm, 61.9 kg in local subjects, respectively. The residence types were apartment (63.6%) and small-sized apartment (22.7%) in urban subjects and apartment (51.4%) and house (37.8%) in local subjects. The primary water sources were purified water (38.3%), running water (18.2%) in urban subjects and purified water (32.4%), underground water (27.0%) in local subjects, respectively. Daily energy and nutrient intakes were not significantly different between two groups. Among the surveyed 17 clinical symptoms, the scores of constipation, cold, anxieties and total score of clinical symptoms in urban subjects were significantly love. than those in local subjects. Hair contents of Na, Mg, Ca, Cu, V Al, As were significantly higher, while U was lower in urban subjects compared to those in rural subjects. Hair contents of Ni and U were significantly correlated with food intake, and Cr, V, Al, Sb, As, U showed a correlation with energy intake. Hair Mg level showed significantly negative correlation with total clinical symptom score. In conclusion, hair mineral profile between urban and local students was significantly different. And some of these minerals were significantly correlated with food and nutrient intakes. Especially hair magnesium was significantly correlated with total clinical symptom score. Therefore, hair mineral levels would be needed for more systematic study elucidating potentiality as a useful clinical tool.

• Journal of the Korean Electrochemical Society
• /
• v.4 no.4
• /
• pp.146-151
• /
• 2001

The Frumkin adsorption isotherm of the over-potentially deposited hydrogen (OPD H) for the cathodic $H_2$ evolution reaction (HER) at the poly-Ni|0.05M KOH aqueous electrolyte interface has been studied using the phase-shift method. The behavior of the phase shift $(0^{\circ}\leq{\phi}\leq90^{\circ})$ for the optimum intermediate frequency corresponds well to that of the fractional surface coverage $(1\geq{\theta}\geq0)$ at the interface. The phase-shift method, i.e., the Phase-shift profile $(-{\phi}\;vs.\;E)$ for the optimum intermediate frequency, can be used as a new method to estimate the Frumkin adsorption isotherm $(\theta\;vs.\;E)$ of the OPD H for the cathodic HER at the interface. At the poly-Ni|0.05M KOH aqueous electrolyte interface, the rate (r) of change of the standard free energy of the OPD H with $\theta$, the interaction parameter (g) for the Frumkin adsorption isotherm, the equilibrium constant (K) for the OPD H with $\theta$, and the standard free energy $({\Delta}G_{\theta})$ of the OPD H with ${\theta}$ are $24.8kJ mol^{-1},\;10,\;5.9\times10^{-6}{\leq}K{\leq}0.13,\;and\;5.1\leq{\Delta}G_{\theta}\leq29.8kJ\;mol^{-1}$. The electrode kinetic parameters $(r,\;g,\;K,\;{\Delta}G_{\theta})$ depend strongly on ${\theta} (0{\leq}{\theta}{\leq}1)$.

• Journal of the Korean Ceramic Society
• /
• v.41 no.6
• /
• pp.450-455
• /
• 2004

NiCr thin films were fabricated by thermal evaporation method using NiCr alloy as evaporating source. NiCr thin films were annealed at various temperatures in air atmosphere in order to investigate effects of annealing conditions on phase change, composition, and microstructures of NiCr films. Typical multilayer was formed after annealing in air atmosphere. This results from the diffusion and oxidation of Cr toward surface during annealing. In the case of annealing at 700$^{\circ}C$, large columnar grains of NiO were formed on Cr-oxide layer through the diffusion and oxidation of Ni over Cr-oxide layer. Especially, NiO layer was formed additionally on surface, sustaining the underlayer structure with the formation of porous Ni layer.

• Transactions of the Korean hydrogen and new energy society
• /
• v.10 no.1
• /
• pp.59-69
• /
• 1999

AlN thin films were fabricated by reactive sputtering for the application of MIS devices with Al/AlN/Si structure. It has investigated the surface morphology change, I-V characteristics, C-V characteristics, and chemical composition of AlN films with the intriducing time of hydrogen on the fixed deposition condition(RF power: 150W, sputtering pressure: 5mTorr, flow rate ratio of $Ar/N_2=1$, hydrogen concentration: 5%). By addition of the hydrogen the deposition rate decreased drastically whereas the surface morphology changed little. It has been found from the analysis of I-V and C-V characteristics curves that the films deposited with hydrogen addition in initial stage had lower leakage current density, lower flat band voltage and hystersis profile when compared with those with hydrogen addition in last stage. The oxygen concentration in AlN films decreased with addition of hydrogen gas, which suggesting a profitable role in the insulation and C-V characteristics of AlN films.

• Journal of the Korean Institute of Gas
• /
• v.14 no.2
• /
• pp.1-6
• /
• 2010

The strength safety of high pressure gas cylinder has been analyzed by using a finite element method. In this study, the internal gas pressures of a steel bombe include a service charging pressure of $9kg/cm^2$, high limit charging pressure of $18.6kg/cm^2$, high limit of safety valve operation pressure $24.5kg/cm^2$, and hydraulic testing pressure of $34.5kg/cm^2$. The computed FEM results indicate that the strength safety for a service charging pressure of $9kg/cm^2$ and high limit charging pressure of $18.6kg/cm^2$ is safe because the stress of a gas cylinder is within yield strength of steel. But the stress for a hydraulic testing pressure of $34.5kg/cm^2$ sufficiently exceeds the yield strength and remains under the tensile strength. If the hydraulic testing pressures frequently apply to the gas cylinder, the bombe may be fractured because a fatigue residual stress is accumulated on the lower round end plate due to a plastic deformation. The computed results show that the concentrated force in which is applied on a skirt zone does not affect to the lower round end plate, and the most weak zone of a bombe is a middle part of a lower round end plate between a bombe body and a skirt for a gas pressure. Thus, the FEM results show that the profile of a lower round end plate is an important design parameter of a high pressure gas cylinder.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2005.05a
• /
• pp.15-20
• /
• 2005

Defects of dam body which can be induced in seepage or leakage procedure can directly affect dam safety. Therefore, a proper inspection method should be carried out in the first place to find out their positions and sizes, After that, some reinforcement works such as grouting and the corresponding assessment could be taken in a proper way. The dam(center core type earth dam) issued in this study has been in need for intensive diagnosis and reinforcement work, because a lot of slumps similar to cracks, seepage and some boggy area have been observed on the downstream slope. High resolution seismic reflection method was performed on the crest profile twice before and after grouting work(Aug. 2001 and Nov. 2004) aimed at the dam inspection and the assessment of grouting efficiency as well. To enhance the data resolution, P-beam energy radiation technique which can reduce the surface waves and hence to reinforce the reflection events was used. Strong reflection events were recognized in the stack section before grouting work, It seems that the events would be caused by e.g. horizontal cracks with a considerable aperture, Meanwhile such strong reflection events were not observed in the section after grouting. That is, the grouting work was dear able to reinforce the defects of dam body. Hence, the section showed an well arranged picture of dam inner structure. In this sense, seismic reflection method will be a desirable technique for dam inspection and for monitoring dam inner structure as well.