• Composites Research
• /
• v.29 no.4
• /
• pp.167-172
• /
• 2016

$Co_9S_8/reduced$ graphene (CSRG) has been prepared by a facile two step hydrothermal method and used as a supercapacitor electrode material. It is anticipated that the $Co_9S_8$ and reduced graphene oxide (RGO) would serve as a spacer material to each other to stop the agglomeration and simultaneous contribution of electrical double layer capacitance (RGO) and pseudocapacitance ($Co_9S_8$) would provide high electrochemical properties. The chemical analysis has been done by Fourier transform infrared spectroscopy and the morphology is characterised by field emission scanning electron microscopy. CSRG shows a high electrical conductivity of $98S\;m^{-1}$. The symmetric supercapacitor shows a specific capacitance of ${\sim}728F\;g^{-1}$ with a current density of $2A\;g^{-1}$. CSRG also showed an energy density of $25.2Wh\;kg^{-1}$ with a power density of $1000W\;kg^{-1}$.

• Atmosphere
• /
• v.22 no.2
• /
• pp.221-231
• /
• 2012

Representative Concentration Pathways (RCP) are the latest emission scenarios recommended to use for the fifth assessment report of Intergovernmental Panel on Climate Change. This study investigates the projection of extreme precipitation in South Korea during the forthcoming 21st Century using the generalized extreme value (GEV) analysis based on two different RCP conditions i.e., RCP 4.5 and 8.5. Maximum daily precipitation required for GEV analysis for RCP 4.5 and 8.5 are obtained from a high-resolution regional climate model forced by the corresponding global climate projections, which are produced within the CMIP5 framework. We found overall increase in frequency of extreme precipitation over South Korea in association with climate change. Particularly, daily extreme precipitation that has been occurred every 20 years in current climate (1980~2005) is likely to happen about every 4.3 and 3.4 years by the end of 21st Century (2070~2099) under the RCP 4.5 and 8.5 conditions, respectively.

• Proceedings of the Korean Society of Medical Physics Conference
• /
• 2002.09a
• /
• pp.396-399
• /
• 2002

Intense quasi-monochromatic x-ray irradiation from the linear plasma target is described. The plasma x-ray generator employs a high-voltage power supply, a low-impedance coaxial transmission line, a high-voltage condenser with a capacity of about 200 nF, a turbo-molecular pump, a thyristor pulse generator as a trigger device, and a flash x-ray tube. The high-voltage main condenser is charged up to 55 kV by the power supply, and the electric charges in the condenser are discharged to the tube after triggering the cathode electrode. The x-ray tube is of a demountable triode that is connected to the turbo molecular pump with a pressure of approximately 1 mPa. As electron flows from the cathode electrode are roughly converged to the molybdenum target by the electric field in the tube, the weakly ionized plasma, which consists of metal ions and electrons, forms by the target evaporating. In the present work, the peak tube voltage was almost equal to the initial charging voltage of the main condenser, and the peak current was about 20 kA with a charging voltage of 55 kV. When the charging voltage was increased, the linear plasma x-ray source grew, and the characteristic x-ray intensities of K-series lines increased. The quite sharp lines such as hard x-ray lasers were clearly observed. The quasi-monochromatic radiography was performed by a new film-less computed radiography system.

• Proceedings of the Korean Society for Quality Management Conference
• /
• 2010.04a
• /
• pp.262-268
• /
• 2010

Organic light emitting diode is developed fast from 1963 after discovering electric light emitting phenomenon. First PMOLED(passive matrix OLED) product is manufactured and AMOLED(active matrix OLED) using TFT(thin film ransistor) is now in the center. PMOLED is mainly mounted at sub display. but AMOLED is mounted at main display. Also AMOLED expand the market to PMP(portable multimedia players), navigation and TV. Even thought OLED's market is opening to many applications, OLED is worried about lifetime until now. That's appeared in market in a very short time and is not known well about result of OLED's lifetime and reliability test. And there is no standard ssessment method and not enough study to standardization the method. A study's purpose is reduce the time for life test by accelerated current and it can do production possible design by accelerated life model in design phase. It's must be add to process variables and design variables(like ratio of light emitting, organic material structure, condition of aging, etc) to make the best use of supplied accelerated lifetime model in this paper. In terms of lifetime it needs each criterion of applications because of image sticking. In conclusion, it's possible to discover new defect because there is not much time to be opened in market and develop a method of manufacturing process & materials, so we need to study on the subject of this paper continuously.

• Applied Chemistry for Engineering
• /
• v.26 no.6
• /
• pp.725-729
• /
• 2015

Organic light emitting diodes (OLEDs) are regarded as the next generation display and solid-state lighting due to their superb achievements from extensive research efforts on improving the efficiency and stability of OLEDs in addition to developing new materials. Herein, efficient green phosphorescent OLEDs were obtained by using hexaazatrinaphthylene (HAT) derivatives as a hole injection layer. External quantum and current efficiencies of OLEDs were enhanced from 8.8% and 30.8 cd/A to 13.6% and 47.7 cd/A, respectively by inserting a thin layer of HAT derivatives between the ITO and hole transporting layer. The enhancement of OLEDs was found to be originated from the inserted HAT derivatives, which resulted in the optimized hole-electron balance inside the emission layer.

• Journal of IKEEE
• /
• v.11 no.4
• /
• pp.257-264
• /
• 2007

The MM22 microtron has used as a cancer therapy machine from Nov. 1986 to Feb. 2006. This machine was moved and installed to a radiation research center to use as an education and research tool from treatment machine because of aging of MM22 microtron. In this paper, for extracting the electron beam from microtron, operation principle of the microtron, system characteristics of each module, and pulse structures were reviewed. The beam extraction and measurement were performed after measuring pulses of each major module and extraction trials in the beam line. After finishing the movement of MM22 microtron, the 30mA target current in the case of 10 MV X-ray beam was extracted and the beam flatness of radiation distribution was acquired within 3% error ratio after 100 MU was irradiated on X-omatV Film at SSD 100 cm and field size $10{\times}10cm^2$. As a result, the microtron movement and new installation was performed with success.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.8
• /
• pp.2505-2511
• /
• 2014

Indium oxide nanocrystals ($In_2O_3$ NCs) with sizes of 5.5 nm-10 nm were synthesized by hot injection of the mixture precursors, indium acetate and oleic acid, into alcohol solution (1-octadecanol and 1-octadecence mixture). Field emission transmission electron microscopy (FE-TEM), High resolution X-Ray diffraction (X-ray), Nuclear magnetic resonance (NMR), and Fourier transform infrared spectroscopy (FT-IR) were employed to investigate the size, surface molecular structure, and crystallinity of the synthesized $In_2O_3$ NCs. When covered by oleic acid as a capping group, the $In_2O_3$ NCs had a high crystallinity with a cubic structure, demonstrating a narrow size distribution. A high mobility of $2.51cm^2/V{\cdot}s$ and an on/off current ratio of about $1.0{\times}10^3$ were observed with an $In_2O_3$ NCs thin film transistor (TFT) device, where the channel layer of $In_2O_3$ NCs thin films were formed by a solution process of spin coating, cured at a relatively low temperature, $350^{\circ}C$. A size-dependent, non-monotonic trend on electron mobility was distinctly observed: the electron mobility increased from $0.43cm^2/V{\cdot}s$ for NCs with a 5.5 nm diameter to $2.51cm^2/V{\cdot}s$ for NCs with a diameter of 7.1 nm, and then decreased for NCs larger than 7.1 nm. This phenomenon is clearly explained by the combination of a smaller number of hops, a decrease in charging energy, and a decrease in electronic coupling with the increasing NC size, where the crossover diameter is estimated to be 7.1 nm. The decrease in electronic coupling proved to be the decisive factor giving rise to the decrease in the mobility associated with increasing size in the larger NCs above the crossover diameter.

• Journal of the Korean Society of Laryngology, Phoniatrics and Logopedics
• /
• v.16 no.1
• /
• pp.33-48
• /
• 2005

Differential diagnosis of articulation and resonance problems in the cleft lip and palate speech is required for evaluating various factors contribute to speech problems such as VPI, dental occlusion, palatal fistulae, learning. However, validity of speech stimuli is current issue to evaluate accurately each problem in cleft speech. This study was conducted to investigate speech stimuli using in the clinical setting and review the literatures and articles published 1990 to 2005 for helping develop standardized speech samples. The results were recommendation to evaluate properly velopharyngeal function when conducting a diagnostic evaluation as follows : 1) In identification hypernasality, the speech stimuli should be included low pressure consonants to eliminate effects of nasal emission, compensatory articulation. 2) Speech stimuli should be consist of visual, front sounds to eliminate compensatory articulation and to stimulate easily. 3) Regarding early diagnosis and treatment, speech stimuli need to develop for infants and preschooler. 4) Stimulus length on nasalance scores should be at least 6 syllables. 5) In phonetic context on nasalance scores, /i/ vowel should be take into consideration excluding paragraph. 6) Connected speech stimuli should be developed for evaluating intelligibility and VP function.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.12 no.2
• /
• pp.1-9
• /
• 2009

Due to the increase of carbon dioxide in the atmosphere and global warming, the importance of forest ecosystems, as a place of carbon accumulation and emission, has received a great amount of recognition lately. This study was performed to help understand and provide the current status of carbon cycle in the pinus densiflora stand, Korea. The samples were collected from average 35-years-old Pinus densifiora rands in Gongju, Youngdong, Chungsan, Muju, Mupung, and Jangsu regions. Total thirty aboveground sample trees were cut, and ten roots were sampled, and soil samples were collected. Average carbon concentrations in foliage, branch, stem bark, stem wood, and root were 55.7%, 56.0%, 56.0%, 57.3%, and 56.5%, respectively. Carbon content was estimated by the model $Wt=aD^b$ where Wt is oven-dry weight in kg and D is DBH in cm. Total carbon content (aboveground and root) was 42.39tonC/ha in the Pinus densiflora stand. The proportion of each tree component to total carbon content was high in order of stemwood, root, branch, stem bark, and foliage. Total net primary production (aboveground and root) was estimated at 6.51tonC/ha/yr in Pinus densiflora stand. The proportion of each tree component to total net primary carbon content was high in order of sternwood, root, branch, foliage and stembark. Soil carbon contents in the study sites was 43.51tonC/ha at 0-50cm soil depth.

• Journal of Power System Engineering
• /
• v.20 no.6
• /
• pp.93-98
• /
• 2016

Environmental problems are issued throughout all over the world and which are needed the strength management. In case of the diesel cars are also being developing and studying continuously about various after-treatments device such as EGR, LNT, SCR, DPF and DOC etc. which are used for decreasing $NO_X$ and PM. The air temperature goes up to $39^{\circ}C$ in summer and goes down to $-20^{\circ}C$ in winter because of the location. These changing of the temperature can effect to the engine and harmful exhaust gas discharged and it seems to make the increase - decrease different. The result of the evaluate while changing between the test-mode and the air temperature, which expresses that WLTC-mode is 2.2 times and FTP_75 mode is 4.1~6 times increase to the comparison NEDC-mode of the current regulation. The exhaust characteristic of $NO_X$ by the changing temperature increases in the low temperature and 4.3 times in $14^{\circ}C$ and 21.3 times in $-7^{\circ}C$ with maximum when it compares to $23^{\circ}C$. The fuel efficiency of the different weight car and engine with same data is about 5.7 % in maximum.