• Journal of Environmental Science International
• /
• v.18 no.5
• /
• pp.509-515
• /
• 2009

The aim of this study is investigated greenhouse gas emissions of glass industry, and when calculates greenhouse gas emission, using formula(Tier 3) advising in IPCC(Intergovernmental Panel on Climate Change) and using self designed formula(Tier 3+) authors of this study. Studied to propose calculation formula that can compare these two calculation results and apply to domestic. Formula of Tier 3 calculated to theoretical composition of carbonate material, And Formula of Tier 3+ calculated on the basis of chemical substance formation table that get from glass manufacture company(The S company). As a result, Dolomite, Soda ash, Limestone, Industrial Barium carbonate is calculated value of Tier 3+ lower than value of Tier 3, And Industrial Potassium carbonate, Industrial Strontium carbonate was calculated value of Tier 3 lower than value of Tier 3. This study finding, formula of Tier 3+ has higher confidence than formula of Tier 3 when consider revision about purity of injection raw material. And hereafter, When calculate greenhouse gas emissions about nonmetallic mineral industry, use of Tier 3+ is considered that should be encouraged.

• Journal of People, Plants, and Environment
• /
• v.24 no.2
• /
• pp.195-207
• /
• 2021

Background and objective: While response measures to particulate matters in rural areas are limited due to poor inventory record keeping in the agricultural sector, it is necessary to control agricultural waste vinyl and the emission of precursors released from open burning and the secondary generation of particulate matters. Currently, the open burning emission calculation method uses the definition prescribed in CAPSS by the National Institute of Environmental Research. Methods: This study presented an open burning emission calculation formula for agricultural waste vinyl, which is included as agricultural waste. As for activity data, the open burning ratio of agricultural waste vinyl, and the annual incineration volume provided in the Status Survey by the Ministry of Agriculture, Food, and Rural Affairs were applied. The emission factor was generated through incineration tests on three agricultural plastic film samples collected by the Korea Environment Corporation. Results: Among precursors, SOx and NOx were selected and their emission features were monitored with incineration experiment infrastructure based on the EPA 5G method. The highest emission concentration by agricultural waste type was concentrated in the first and second quarters. As for emission factor of SO₂, it was calculated at 98.25 g/kg for mulching-use LDPE, 52.31 g/kg for greenhouse-use LDPE, and 14.40 g/kg for HDPE. As for NOx, it was calculated at 18.21 g/kg for mulching-use LDPE, 16.49 g/kg for greenhouse-use LDPE, and 10.67 g/kg for HDPE. Conclusion: This test confirmed the incineration features of PE-based plastics, ascertained the SOx emission factor that had not been included in open burning in the past, and established that low NOx emission concentration is interfered by soil mixed with livestock excretions. The findings from this study are expected to contribute to improving the system for controlling air pollutants in rural environments.

• Journal of The Korean Astronomical Society
• /
• v.41 no.4
• /
• pp.99-107
• /
• 2008

When a new counting experiment is proposed, it is crucial to predict whether the desired source signal will be detected, or how much observation time is required in order to detect the signal at a certain significance level. The concept of the a priori prediction of the detection limit in a newly proposed experiment should be distinguished from the a posteriori claim or decision whether a source signal was detected in an experiment already performed, and the calculation of statistical significance of a measured source signal. We formulate precise definitions of these concepts based on the statistical theory of hypothesis testing, and derive an approximate formula to estimate quickly the a priori detection limit of expected Poissonian source signals. A more accurate algorithm for calculating the detection limits in a counting experiment is also proposed. The formula and the proposed algorithm may be used for the estimation of required integration or observation time in proposals of new experiments. Applications include the calculation of integration time required for the detection of faint emission lines in a newly proposed spectroscopic observation, and the detection of faint sources in a new imaging observation. We apply the results to the calculation of observation time required to claim the detection of the surface thermal emission from neutron stars with two virtual instruments.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.10
• /
• pp.1147-1154
• /
• 2004

This paper is the third of several companion papers which compare the method of Air-Fuel ratio determination. In the previous works, Eltinge chart was expanded to arbitrary fuel composition as a reference exhaust composition. The compensation of unburned hydrocarbon in Eltinge chart and comparison of Spindt and Eltinge method were also discussed. In addition to Eltinge and Spindt's one, however, there are many methods which calculate Air-Fuel ratio from exhaust emission. Among these methods, carbon balance and oxygen balance are widely used in practice. In some applications, linear formula from statistical method is being used in the field due to its simplicity and convenience. In this paper, these various methods are evaluated and compared with Eltinge results and new linear formula is proposed for the gasoline fuel. The results show that the corrected carbon balance equation has excellent agreement with Eltinge and Spindt's one. On the other hands, the oxygen-balanced formula has a limitation according to the mixture state and AFR. For gasoline fuel, newly proposed linear equation has good compatibility with Eltinge and Spindt up to AFR 17.

• Journal of Korean Society of Rural Planning
• /
• v.19 no.4
• /
• pp.125-135
• /
• 2013

Analysis and evaluation of uncertainty is adopting the advanced methodology among the methods for greenhouse gas emission assessment that was defined in GPS2000 (Good practice guideline 2000) and GPG-LULUCF (GPG Land Use, Land-Use Change and Forestry). In 2006 IPCC guideline, two approaches are suggested to explain the uncertainty for each section with a national net emission and a prediction value on uncertainty as follows; 1) Spread sheet calculation based on the error propagation algorithm that was simplified with some assumptions, and 2) Monte carlo simulation that can be utilized in general purposes. There are few researches on the agricultural field including greenhouse gas emission that is generated from livestock and cultivation lands due to lack of information for statistic data, emission coefficient, and complicated emission formula. The main objective of this study is to suggest an evaluation method for the uncertainty of greenhouse gas emission in agricultural field by means of intercomparison of the prediction value on uncertainties which were estimated by spread sheet calculation and monte carlo simulation. A statistic analysis for probability density function for uncertainty of emission rate was carried out by targeting livestock intestinal fermentation, excrements treatment, and direct/indirect emission from agricultural lands and rice cultivation. It was suggested to minimize uncertainty by means of extraction of emission coefficient according to each targeting section.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.9 no.3
• /
• pp.170-178
• /
• 2007

Rapid increases in the concentrations of greenhouse gases and many other chemically important trace gases have occurred over the last several centuries. For understanding the roles of these important gases in global change, it is essential to identify their sources and sinks, to characterize biogenic gas fluxes between the biosphere and atmosphere, and to understand the processes that control them. In this paper, enclosure-based measurements are described in a practical manner for field experiments. Theoretical reviews of mass balance equation in the enclosure and sensitivity of the flow-through dynamic flux chamber technique are presented; specifically for the case of NO flux measurements from soil surface. The physical system and theory behind the flow-through dynamic flux chamber method are examined. New calculation flux formula was introduced by considering NO chemical loss on chamber wall and uncertainties of the NO flux calculation were discussed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.5
• /
• pp.3169-3175
• /
• 2014

In this paper, we have established the procedures for $CO_2$ emission estimation BIM libraries by using the material takeoff function that BIM tools fundamentally provide, and verified its availability by applying to steel structures. The BIM library set-up procedures were made up of $CO_2$ emission coefficients and parameter extraction, project unit setting, parameter setting, and $CO_2$ emission quantity calculation formula set-up. We used Revit Architecture 2013 as BIM tool, and established the steel members' family libraries as BIM libraries. It is possible to calculate the $CO_2$ emission quantity by following the proposed BIM library set-up procedures, and users have only to input the $CO_2$ emission coefficients and unit weights of steel members being used. We expect that the results contribute to practical use of BIM in field, and vitalizations of the eco-friendly construction.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.3
• /
• pp.316-323
• /
• 2013

This paper deals with the near-field to far-field calculation for far-field characteristics of antenna and electromagnetic compatibility(EMC) testing. Since the conventional EMC testing process is inefficient such as measurements of the wide band signals and mega structures, Stratton-Chu formula is used to predict the far-field emission by simple and direct process. The usefulness of Stratton-Chu formula is verified by comparing to the analytic solution of the uniform distribution aperture in free-space. In order to inspect the far-fields and to get the near-field values, full-wave simulation solver is utilized. Through the full-wave simulation about the patch antenna, calculated far-field results from Stratton-Chu formula are proven. The predicted magnitudes of the far-field are in error by less than 6 %.

• Journal of Advanced Marine Engineering and Technology
• /
• v.41 no.4
• /
• pp.323-329
• /
• 2017

Nowadays, considering global warming and enhanced prohibition to discharge pollutants at sea, all of existing operation-ships must lead to the reduction of fuel consumption. International standards of International Maritime Organization and EU rules governing harbor pollutants are being strengthened. Therefore, ship-owners and operators are seeking ways to reduce $CO_2$, SOx, and NOx emissions. Although world trade continues to expand, total fuel usage for sea transport tends to diminish. However, ICS(International Chamber of Shipping) has set a goal of reducing $CO_2$ emissions from shipping by 50% until 2050. In addition, with respect to the Paris Climate Change Accord in 2015, IMO proposes to set up a reduction target of GHG emission from existing operation-ships. For setting up a reduction target of GHG from international maritime transport, "A data collection system for fuel consumption" will be introduced in the near future. In order to effectively reduce the use of fuel in a ship in accordance with the trend of compulsory fuel saving from operation ships, this paper suggested adoption of an Incentive-Penalty scheme based on Emission-Trading-Scheme, Carbon Tax, and basic calculation formula after verifying the EEOI level for a year.