• ETRI Journal
• /
• v.45 no.4
• /
• pp.581-593
• /
• 2023

This paper proposes four-ring slot resonator-based MIMO antennas of 75×150 mm² without and with CSRR structures in the sub-6-GHz range. These orthogonal-fed antennas have shown diverse characteristics with dual polarization. L-shaped parasitic structures have increased the isolation (i.e., >40 dB) in the single-element antenna over the band of 3.4 GHz-3.8 GHz. A set of three CSRR structures in the MIMO antenna reduced the coupling between antenna ports placed in an inline arrangement and enhanced the isolation from 12 dB to 20 dB and the diversity characteristics. The S-parameters of both MIMO antennas are measured and used to evaluate MIMO parameters like ECC, TARC, MEG, and channel capacity loss. The simulation results show the variations in the gain and directivity on exciting linear and dual polarizations. The diversity performance of the reported MIMO antennas is suitable for 5G applications.

• Transactions on Electrical and Electronic Materials
• /
• v.8 no.5
• /
• pp.206-210
• /
• 2007

Carbon nanotubes(CNTs) are largely synthesized on Fe catalysts by catalytic chemical vapor deposition. The various shapes and compositions of these nanostructure CNTs were obtained by controlled parameters such as the reaction temperature, gas-mixing ratio. The influence of these parameters is investigated, together with observations of the produced materials after the purification processes. A diameter of CNTs, range from 2 to 10 nm, closely correlated with the size of the catalyst particle found attached to the tube end. The yield of CNTs was estimated to be 88.5 % and the purities of CNTs thus obtained were more than 80 %. The experimental results were documented with field emission scanning electron microscopy and raman spectroscopy and transmission electron microscopy, both before and after the purification.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.4
• /
• pp.1626-1634
• /
• 2015

LCL filters are widely used in three-phase PWM converter for its advantages of small volume, low cost and inhibition of high frequency current harmonic. However, it is difficult to optimize its design because its parameters are mutually influenced while the value of each parameter for LCL filter has impacts on the converter's cost and size. In this paper, the target of optimization is to minimize the parameter values of LCL filter, and an optimization method for parameters of LCL filter of three-phase PWM converter based on least square method is proposed. With this method, a quantitative calculation of the harmonic component of the converter’s side phase voltage is performed first, and then the quantitative relationship between phase voltage harmonics and grid phase current harmonics is analyzed. After that, the attenuation requirement of each harmonic is obtained by taking into account the requirements for each harmonic component of grid current. Then according to the optimization objective, the objective function with minimum harmonic attenuation deviation is established, and least squares method is adopted for three-dimensional global searching of parameters for LCL filter. Thus, the designed harmonic attenuation curve approximates the minimum attenuation requirements, and the optimized LCL filter parameters are obtained. Finally, the effectiveness of the method is verified by the experiments.

• Proceedings of the IEEK Conference
• /
• 2000.06b
• /
• pp.96-99
• /
• 2000

We presents a BGA(Ball Grid Array) package for RF circuit modules and extracted its electrical parameters. We constructed a BGA package of ITS(Intelligent Transportation System) RF module and examined electrical parameters with a HP5475A TDR(Time Domain Reflectometry) equipment and compared its electrical parasitic parameters with PCB RF circuits. With a BGA substrate of 3 $\times$ 3 input and output terminals, we have found that self capacitance of BGA solder ball is 68.6fF, self inductance 146pH, mutual capacitance 10.9fF and mutual inductance 16.9pH. S parameter measurement with a HP4396B Network Analyzer showed the resonance frequency of 1.55㎓ and the loss of 0.26dB. Thus, we may improve electrical performance when we use BGA package structures in the design of RF circuit modules.

• Journal of IKEEE
• /
• v.18 no.4
• /
• pp.523-531
• /
• 2014

In this paper, a fast single image blind denoising algorithm is presented, where noise parameters are estimated by local statistics of an observed degraded image without a prior information about the additive noise. The estimated noise parameters are used to define the constraints on the noise detection which is coupled with the 1st-order Markov Random Field. In addition, an adaptive modified weighted Gaussian filter is introduced, where variable window sizes and weighting coefficients defined by the constraints are used to control the degree of the smoothness of the reconstructed image. The experimental results demonstrate the capability of the proposed algorithm. Please put the abstract of paper here.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.7
• /
• pp.1452-1458
• /
• 2009

The change in the electronic absorption and emission energy of 7-aminocoumarin derivatives in binary solvent mixtures has been studied. The electronic transition energy along with the Stokes' shift is correlated with the orientation polarizability of the solvent as well as the empirical solvent polarity parameters $E_T$ (30). It is observed that the emission peak shift traces the change of $E_T$ (30) value very closely in binary solvent mixtures. The emission transition more strongly depends on the solvent polarity than the absorption, which indicates the dipole moment gets larger on excitation. From the dependence of the Stokes’ shift of 7-aminocoumarins with the solvent polarity parameters and the ground state dipole moment obtained by the semi-empirical calculations, the excited state dipole moment was estimated. The fluorescence lifetime change of 7-aminocoumarins in binary solvent mixtures was measured and the results are explained in terms of molecular conformation and solvent polarity. The study indicates the empirical solvent polarity $E_T$ (30) is a good measure of microscopic solvent polarity and it probes in general the non-specific solvent interactions.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 1998.06a
• /
• pp.685-690
• /
• 1998

This paper presents an explanation regarding on-line identification of a fuzzy system. The fuzzy system to be identified is assumed to be in the type of singletion consequent parts and be represented by a linear combination of fuzzy basis function (FBF's). For on-line identification, squared-cosine (SCOS) fuzzy basis function is introduced to reduce the number of parameters to be identified and make the system consistent and differentiable. Then the parameters of the fuzzy system are identified on-line by the gradient search method. Finally, a computer simulation is performed to illustrate the validity of the suggested algorithms.

• Journal of electromagnetic engineering and science
• /
• v.5 no.2
• /
• pp.61-65
• /
• 2005

In this paper, a numerical permissible disturbance model is proposed to preserve a throughput performance of a 2.4 GHz wireless LAN service. The model is composed of two parameters, a peak value and a time rate of noise signal. The model parameters are experimentally determined from an APD parameter measurement. The APD parameter is measured by using the APD measurement method which is recommended from CISPR/A/447/CD.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.04a
• /
• pp.245-248
• /
• 1997

The dielectric resonators(DRs) with dielectric properties are widely used in microwave integrated circuit(MICs) and monolithic microwave integrated circuits(MMICS). The variational method as numerical simulation scheme would be applied to calculate the resonant frequencies(fr) and Q-factors of microwave dielectric resonators. The dielectric resonator with a cylindrical “puck” structure of high dielectric material is modeled in this simulation. The parameters, such as the diameter, the height, and the dielectric constant of dielectric resonator, would determine the resonant frequency and the Q-factor. The relationship between these parameters would effect each other to evaluate the approximate resonant frequency. This simulation method by the variational formula is very effective to calculate fr, and Q-factor. in high frequency microwave dielectric resonator The error rate of the simulation results and the measured results would be considered to design the microwave dielectric resonators.

• Journal of Electrical Engineering and Technology
• /
• v.5 no.3
• /
• pp.415-422
• /
• 2010

The distributed flexible alternative current transmission system (D-FACTS) is a recently developed FACTS technology. Distributed Static Series Compensator (DSSC) is one example of DFACTS devices. DSSC functions in the same way as a Static Synchronous Series Compensator (SSSC), but is smaller in size, lower in price, and possesses more capabilities. Likewise, DSSC lies in transmission lines in a distributed manner. In this work, we designed a fuzzy logic controller to use the DSSC for enhancing transient stability in a two-machine, two-area power system. The parameters of the fuzzy logic controller are varied widely by a suitable choice of membership function and parameters in the rule base. Simulation results demonstrate the effectiveness of the fuzzy controller for transient stability enhancement by DSSC.