• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 추계학술대회 논문집
• /
• pp.192-192
• /
• 2009

AZO films were prepared by $Ar:H_2$ gas RF magnetron sputtering system with a AZO (2wt% $Al_2O_3$) ceramic target at a low temperature of $100^{\circ}C$. To investigate the influence of $H_2$ flow ratio on the properties of AZO films, $H_2$ flow ratio was changed from 0.5% to 2%. As a result, the AZO films deposited with 1% $H_2$ addition showed electrical properties with a resistivity of $5.06{\times}10^{-3}{\Omega}cm$. The spectrophotometer-measurements showed the transmittance of 86.5% was obtained by the film deposited with $H_2$ flow ratio of 1% in the range of 940nm for GaAs/GaAlAs LED.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1572-1574
• /
• 2000

In this paper, study on the properties of the thermal degradated epoxy resin which is used in cast resin transformer is performed to investigate the problems of the decreasing insulation characteristics and crack in the cast resin transformer. In the test, contact angle, weight loss, surface resistivity and relative dielectric constant are measured. As the results of the above measurements, the epoxy resin has increased to 150$^{\circ}C$ in the contact angle and surface resistivity but at the above 150$^{\circ}C$ the values have decreased. The relative dielectric constants have increased in the thermal treated samples with the degradation temperature. Consequently, the insulation properties of the epoxy resin which is used in cast resin transformer have increased by the 150$^{\circ}C$ but decreased in the above 150$^{\circ}C$.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1997년도 춘계학술대회 논문집
• /
• pp.78-81
• /
• 1997

The photocharge voltage technique is based on the measurement of a small electrical potential difference which appears on any solid body when subject to illumunation by a modulated laser light beam. This voltage is proportional to the induced change in the surface electrical charge and is nondestructively measured on various materials such as conductors, semicinductors and dielectrics. In this paper, photocharge voltage on conductors, semiconductors and dielectrics are measured nondestructively using a capacitative coupling. The test structures and the validity of this system to characterize the surface properties for soled materials are shown.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1702-1704
• /
• 2000

Molecular cis-trans switching in mono and multilayer systems containing azobenzene is of particular interest in physics. chemistry and electronics. because of the possible application of the switching. Molecular swiching in phospholipid and azobenzene mixed monolayers on a water surface was examined by Maxwell displacement current(MDC) measurements. As a result. It's phtoisomerization progressed by 8A5H in mixed films.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 춘계학술대회 논문집
• /
• pp.481-484
• /
• 1999

The undoped-InSe and Sn-doped InSe single crystals were grown by vertical Bridgman method and their properties were invesigated. These crystals were obtained by lowering the quartz ampoule for growth in the furnace and growth rate at optimum condition is 0.4mm/hr. The orientations and the crystallinites of these crystals were identified by X-ray diffraction(XRD), double crystal rocking curve(DCRC) and etch-pit density(EPD) measurements. From the Raman spectrum at room temperature, TO, LO modes together with their overtones and combinations were observed. Optical properties were investigated by photoluminescence at 12K and direct band gap of these crystals obtained from optical absorption spectrum. Compared with undoped-lnSe, electrical properties of Sn-doped InSe were increased and the electrical conductivity type were n-type. But electrical properties along growth direction of crystals and radial direction of wafer showed nearly uniform distribution.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 추계학술대회 논문집 Vol.18
• /
• pp.254-255
• /
• 2005

In this paper, we investigated electrical characteristics of the X-ray detector of mercuric iodide (HgI2) film fabricated by PIB(Particle-in-Binder) Method on ITO substrates 17cm$\times$20cm in size with thicknesses ranging from approximately 200${\mu}m$ to 240${\mu}m$. In the present study, using I-V measurements, their electrical properties such as leakage current, X-ray sensitivity, and signal-to-noise ratio (SNR),were investigated. The results of our study can be useful in the future design and optimization of direct active-matrix flat-panel detectors (AMFPD) for various digital X-ray imaging modalities.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2000년도 추계학술대회논문집
• /
• pp.36-39
• /
• 2000

A small electrical potential difference which appears on any solid body when subjected to illumination by a modulated light beam generated by laser is called photocharge voltage(PCV)[1,2]. This voltage is proportional to the induced change in the surface electrical charge and is capacitatively measured on various materials such as conductors, semiconductors, ceramics, dielectrics and biological objects. The amplitude of the detected signal depends on the type of material under investigation, and on the surface properties of the sample. In photocharge voltage spectroscopy measurements[3], the sample is illuminated by both a steady state monochromatic bias light and the pulsed laser. The monochromatic light is used to created a variation in the steady state population of trap levels in the surface and space charge region of semiconductor samples which does result in a change in the measured voltage. Using this technique the spatial variation of PCV can be utilized to evalulate the surface conditions of the sample and the variation of the PCV due to the monochromatic bias light are utilized to charactrize the surface states. A qualitative analysis of the proposed measuremen is present along with experimental results performed on amorphous silicon samples. The deposition temperature was varied in order to obtain samples with different structural, optical and electronic properties and measurements are related to the defect density in amorphous thin film.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 추계학술대회 논문집 학회본부
• /
• pp.258-260
• /
• 1996

We fabricated MIM device using copolymer LB films of $C_{18}MA-VE_2$. Electric and dielectric properties of MIM device were investigated. In our experimental results, the thickness of maleate copolymer LB film by elipsometry measurements was about $27{\sim}30[\AA]$. Conductivity was found to be $10^{+15}{\sim}10^{-14}[S/cm]$. The maleate copolymer LB film have the property of insulator like organic ultra-thin film. Frequency-dependent dielectric properties was orientational polarization by the dipole.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1988년도 추계학술대회 논문집
• /
• pp.46-46
• /
• 1988

Structural and magnetic properties of Co-Cr-Mo films were investigated in connection with sputtering conditions. Films were prepared using a convention RF sputtering system. X-ray diffractometry, scanning electron microscopy and transmission electron microscopy were employed to investigate structure properties. Vibrating sample magnetometry was used for coercivity and saturation magnetization measurements. Co-Cr-Mo films displayed reasonable values of perpendicular coercivity and saturation magnetization for perpendicular recording media and showed good perpendicular orientation of the hcp c-axis to the film surface. Perpendicular coercivity was strongly dependent upon substrate technique showed better c-axis orientation than hose using the stationary substrate. Co-Cr-Mo films of 2.9 at. % Mo content showed maximum perpendicular coercivity and saturation magnetization. The films deposited at lower Ar pressure showed good magnetic properties. There was no explicit relationship between the columnar structure and c-axis orientation. Co-Cr-Mo films was found to have suitable structural and magnetic properties for perpendicular recording media.

• ETRI Journal
• /
• 제35권2호
• /
• pp.200-206
• /
• 2013

Most of the literature on compressed sensing has not paid enough attention to scenarios in which the number of acquired measurements is insufficient to satisfy minimal exact reconstruction requirements. In practice, encountering such scenarios is highly likely, either intentionally or unintentionally, that is, due to high sensing cost or to the lack of knowledge of signal properties. We analyze signal reconstruction performance in this setting. The main result is an expression of the reconstruction error as a function of the number of acquired measurements.