• 전자공학회논문지A
• /
• 제31A권8호
• /
• pp.34-45
• /
• 1994

We studied threshold voltages and I-V characteristics. considering short channel effect of the fully depleted thin film n-channel SOI MOSFET. We presented a charge sharing model when the back surface of short channel shows accumulation depletion and inversion state respectively. A degree of charge sharing can be compared according to each of back-surface conditions. Mobility is not assumed as constant and besides bulk mobility both the mobility defined by acoustic phonon scattering and the mobility by surface roughness scattering are taken into consideration. I-V characteristics is then implemented by the mobility including vertical and parallel electric field. kThe validity of the model is proved with the 2-dimensional device simulation (MEDICI) and experimental results. The threshold voltage and charge sharing region controlled by source or drain reduced with increasing back gate voltage. The mobility is dependent upon scattering effect and electric field. so it has a strong influence on I-V characteristics.

• Journal of Magnetics
• /
• 제10권4호
• /
• pp.149-151
• /
• 2005

The electric properties of a single crystal bismuth telluride doped with a small concentration of Erbium, $Bi_{z-x}Er_xTe_3$ with x = 0.002, are investigated as a function of temperature. The resistivity was obtained by using the van der Pauw method. The measured electrical resistivity is 78 ${\mu}{\Omega}cm$ at 4.2 K. The charge density of $Bi_{z-x}Er_xTe_3$ is found to be $2{\times}10^{19}/cm^3$ at 4.2 K. It turns out that $Bi_{z-x}Er_xTe_3$ is a p-type semiconductor. It is discussed that the high mobility and less density support that $Bi_{z-x}Er_xTe_3$ is a potential sensor with high energy resolution. Comparison with an established material (i.e. Au:Er alloy) is also discussed.

• Journal of Electrical Engineering and Technology
• /
• 제11권3호
• /
• pp.629-638
• /
• 2016

This paper proposes a State-of-Charge (SOC) balancing control of Battery Power Modules (BPMs) for a modularized battery for Electric Vehicles (EVs) without additional balancing circuits. The BPMs are substituted with the single converter in EVs located between the battery and the inverter. The BPM is composed of a two-phase interleaved boost converter with battery modules. The discharge current of each battery module can be controlled individually by using the BPM to achieve a balanced state as well as increased utilization of the battery capacity. Also, an SOC balancing method is proposed to reduce the equalization time, which satisfies the regulation of a constant DC-link voltage and a demand of the output power. The proposed system and the SOC balancing method are verified through simulation and experiment.

• KIEE International Transactions on Electrophysics and Applications
• /
• 제3C권3호
• /
• pp.81-85
• /
• 2003

This paper describes the results of experiments made to examine the behavior of water droplet on the polymer surface and influence of the charge. In this experiment, water droplet was put on the polymer surface in an applied AC electric field and the investigations of its behavior were done with a high-speed video camera. It can be observed that the droplet elongates and vibrates with being pulled towards the positive electrode in a wave synchronism with the frequency of the power source. The volume and conductivity of water droplet are shown to have a marked effect on the mode of discharge development. These behaviors may be caused by the change of electric field of applied AC voltage and induced charges in/on the water droplet.

• 전력전자학회논문지
• /
• 제12권4호
• /
• pp.324-331
• /
• 2007

본 연구에서는 슬라이딩 모드 관측기를 사용한 리튬 배터리의 충전량 예측방법에 대해서 논의한다. 배터리의 비선형 회로 모델링 기법이 소개되고 슬라이딩 모드 관측기를 사용한 충전량 예측기의 설계 방법이 논의된다. 기존의 복잡한 배터리 모델링 방법 대신, 단순화된 저항-커패시터 모델링 방법이 본 연구에서 사용되었다. 단순화된 모델에 의해 발생되는 오차나 불확실성은 슬라이딩 모드 관측기에 의해 보상되었다. 슬라이딩 모드 관측기의 구조는 단순하지만, 모델링 에러나 외란에 대해서 강인한 특성을 보여준다. 제안된 제어기의 수렴성은 등가제어 방법에 의해서 증명되었다. 제안된 시스템의 성능은 UDDS (Urban Dynamometer Driving Schedule) 시험에 의해서 증명되었다. 시험 결과 제안된 시스템은 실제 주행 환경에서도 우수한 추적 성능을 보여주었다.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 1996년도 재료학회 추계학술발표회
• /
• pp.69-69
• /
• 1996

• Nuclear Engineering and Technology
• /
• 제29권6호
• /
• pp.451-458
• /
• 1997

Signal shapes from a closed-ended coaxial HPGe detector are investigated by numerical methods. The detector used in this study has a volume of 72 ㎤ with relative efficiency of 15%. The electric field and potential distributions in the detector are determined by solving the Poisson equation at the depletion and operating bias. Hence the time dependent signal shapes induced on the electrode are obtained from the energy balance consideration and tv solving the equation of motion for the charge carriers. For various initial positions of a charge carrier pair, the collection times of induced charge vary in the range of 70 - 404 nsec.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 A
• /
• pp.89-91
• /
• 1995

This paper deals with calculation of surface charge density on current carrying conductors by FEM. The proposed algorithm is formulated by equation of continutity in conductor region and maxwell's equations outside, respectively, Surface charge density is calculated by electric scalar potential and boundary condition for electrostatic fields.

• Transactions on Electrical and Electronic Materials
• /
• 제7권5호
• /
• pp.224-229
• /
• 2006

Many studies have been done on the application of residual charge measurement in cable degradation diagnosis. In this paper, the behavior of residual charges measured with water-tree degraded XLPE sheets and cable are discussed. At charge injection process, the charge is injected by applying dc voltage as a conventional method, suddenly cut-off ac voltage or impulse voltage. Therefore the residual charge is influenced by the applying process. At charge release process, transient dc current flows when applying ac high voltage and also ac high voltage superimposed to dc low voltage. From the results, new diagnosis method is suggested.

• 한국세라믹학회지
• /
• 제36권9호
• /
• pp.923-929
• /
• 1999

The cause of optical nonlinearity induced in thermally poled silica glass is believed to be the space charge polarization. Since the second order optical nonlinearity (electro-optic effect) can be used in optical switches the optical nonlinearity in silica glass has drawn a large attention. Space charge polarization occurs when an ionic conducting material is subjected to dc electric field by the blocking electrode. Thermal poling performed to induce the optical nonlinearity in silica glass is basically identical to the process generating space charge polarization. As a first step to understand the mechanism of space charge polarization in silica glass hence the induced optical nonlinearity the absorption currents as functions of time were measured for various types of silica glasses and analyzed by the theory of space charge polarization. It was found that the electrical relaxation exhibited a step by the space charge polarization in the relatively long time range and dielectric loss peak showed a maximum at a specific temperature which is depending on type of silica glass. It was turned out that this relaxation might be a cause of nonlinearity in electrical conductivity of silica glass.