• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.1665-1666
• /
• 2008

There are three main devices such as boiler producing steam, turbine driving generator and generator producing electricity. An electrical generator in power plant is driven and maintained its speed at rated by steam turbine which is coupled into generator directly. Therefore after the steam turbine reaches its rated speed and the generator gets into parallel operation with power grid, the electrical power can be increased by turbine controller or governor. The first governor was invented by James Watts for the steam engine to be maintained at a constant speed. The first governor by him was mechanical type with fly balls. The electrical type governor was created due to the progress of electronic devices such as operational amplifiers or integrated circuits. and Today digital electronic type of governor is being widely used in most prime movers.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1996년도 추계학술대회 논문집
• /
• pp.113-116
• /
• 1996

The drain current of the MOSFET in the off state(i.e., Id when Vgs=0V) is undesired but nevertheless important leakage current device parameter in many digital CMOS IC applications (including DRAMs, SRAMs, dynamic logic circuits, and portable systems). The standby power consumed by devices in the off state have added to the total power consumed by the IC, increasing heat dissipation problems in the chip. In this paper, hot-carrier-induced degra- dation and gate-induced-drain-leakage curr- ent under worse case in P-MOSFET\`s have been studied. First of all, the degradation of gate-induced- drain-leakage current due to electron/hole trapping and surface electric field in off state MOSFET\`s which has appeared as an additional constraint in scaling down p-MOSFET\`s. The GIDL current in p-MOSFET\`s was decreased by hot-electron stressing, because the trapped charge were decreased surface-electric-field. But the GIDL current in n-MOS77T\`s under worse case was increased.

• Transactions on Electrical and Electronic Materials
• /
• 제17권1호
• /
• pp.21-24
• /
• 2016

A junction box used in a 3 kW photovoltaic power generation system plays a role in collecting and supplying the direct current voltage produced by photovoltaic modules to an inverter. It is also used for facilitating maintenance checks and protecting the module and inverter by keeping the voltage constant. As for the junction box, using it in a parallel connection creates a difference between the setup modules. In order to compensate, an inverse voltage diode is used. But the high-power created through the solar generator can be delivered to the inverter through the inverter regularly. Therefore, a component can break down due to excess heat. And consequently short circuits and electric leakage occurs. In this study, using a junction box that enabled the bypass of high electric power, it was possible to reduce heat generation by approximately 35℃ when compared to a standard junction box.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.731-736
• /
• 2001

Nowadays various simulation tools are widely used for the design and the analysis of power electronic converters. From the engineering point of view it is rather difficult to parameterize power semiconductor device models without the knowledge of basic physical parameters. In recent years some data sheet driven behavioral models or so called 'wizard' tools have been introduced to solve this problem. In this contribution some experiences with some user-friendly power semiconductor models will be discussed. Using special simulation test circuits it is possible to get information on the static and dynamic behavior of the parameterized models before they are applied in more complex schemes. These results can be compared with data sheets or with measurements. The application of these models for power loss analysis of inverter type arc welding power sources will be described.

• 한국자기학회지
• /
• 제5권5호
• /
• pp.606-609
• /
• 1995

Ferrite cores are often magnetized under DC-biased field because they have been intensively used in electronic circuits such as an inverter circuit and a switching regulator circuit. Thus we investigated the effects of DC-biased field on magnetic properties in the frequency range of DC-100kHz for two kinds of ferrite cores, TDK PC38 and TDK $H_{3}S$, which have different shapes of B-H loop from each other. The magnetic loss per cycle, W/f, in the $H_{3}S$ core decreased with increasing the strength of DC-biased field, although W/f in the PC38 core increased monotonically with DC-biased field. The observed decreasing tendency differs from the previous result for Si-Fe and ferrite cores, and can be attributed to decrease in eddy current loss as well as that in hysteresis loss.

• 전기학회논문지
• /
• 제65권12호
• /
• pp.2030-2036
• /
• 2016

This paper presents a hardware development procedure of the ASB(Active Seat Belt) control system to comply with ISO 26262. The ASIL(Automotive Safety Integrity Level) of an ASB system is determined through the HARA(Hazard Analysis and Risk Assessment) and the safety mechanism is applied to meet the reqired ASIL. The hardware architecture of the controller consists of a microcontroller, H-bridge circuits, passive components, and current sensors which are used for the input comparison. The required ASIL for the control systems is shown to be satisfied with the safety mechanism by calculation of the SPFM(Single Point Fault Metric) and the LFM(Latent Fault Metric) for the design circuits.

• 한국전자파학회논문지
• /
• 제8권1호
• /
• pp.83-93
• /
• 1997

본 논문은 고전압 실험실에서 시변성 전자계의 측정 및 평가에 관한 것으로 전자적 외란은 주로 전력장비의 지락고장 및 개폐조작에 의해 기인되며, 전자회로와 제어장비틀은 전자방해작용에 매우 민감하다. 주어진 전자환 경에 대한 전자방해작용의 레벨을 평가하는 것은 필수적이다. 전계는 40 Hz-2oo MHz 범위의 대역폭을 갖는 전계센서로 관측되었으며, 시변성 자계는 출력이 입사신호에 직접적으로 비례하는 루프형 센서로 측정되었다. 또한 진동성 과도전류와 차단파 임펄스전압에 의해 유도된 전자방해작용의 레벨파 전자 차폐의 외함설계에 관한 정보를 주는 사변성 전자계의 주파수 성분을 고속프리에변환으로 분석하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2011년도 제42회 하계학술대회
• /
• pp.1199-1200
• /
• 2011

The low voltage DC-DC Converter(LDC) is used for various electronic devices of electric vehicle. Depending on the growth of the car, the capacity of power conversion circuits must be increased. They have to provide the high efficiency and the high load capacity. The phase shift controlled full-bridge converter can be designed for LDC. The operating characteristics are considered through by simulation.

• 전자공학회논문지D
• /
• 제35D권7호
• /
• pp.63-71
• /
• 1998

Generally, electronic packaging designer uses HSPICE SOFTWARE TOOL to validate electric characteristics of traces layout before layout traces in PCB in hundreds Mb/s high speed digital circuits. We are in need of a plated through hole (PTH) model and a connector model to use HSPICE SOFTWARE TOOL. Those models have not been perfectly defined for HSPICE simulation. In this paper, we define a PTH model and a connector model for HSPICE simulation and discuss application range for these models. Th emodels are analytic models very applicable for HSPICE simulation and are used to analyze electric characteristic of the PTH and the connector in thetraces layout in high speed digital circuit.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 전력전자학술대회 논문집
• /
• pp.43-47
• /
• 1998

In this paper we present the method that improve alarm security system using the electronic circuits added the emergency lamp by our proposed Algorithms. In conventional method the emergency lamp of warning & alarm system was not executed perfectly its performance because of battery with short life. For improving this problem we, using Peripheral Interface Controller IC, designed the circuit added the emergency lamp for an warning & alarm system and for prevent from stopping the electric current, and compared our proposed method with conventional method. By designing the circuit to stop up over charge we can extend life of battery, use of a stoppage of electric current in emergency and according to the lightness around. Therefore we are very convenient and profitable in our life. In this future we will study the method to lower the cost of architecture for practical utilization.