• Journal of the Korean Society of Safety
• /
• v.20 no.4 s.72
• /
• pp.54-62
• /
• 2005

This Study is to find out how RC beam mixed with sawdust acts comparing with normal beam without sawdust mixture, and how they can be applied to the actual structural frame, despite a Int that they are mixed with waste material : saying sawdust. ED3H1, ED3H2, ED5H1, ED5H2, ED3H1UB, ED5H1UB, ED3H2L, ED5H2L and Normal without sawdust mixture are main factor to be tested here in order to apply them to the actual case. D and H means diameter 3cm or 5cm, and holes one and two respectively. And all variables are tested with each two for one variables. Test results are compared using crack diagrams and strain & loads. There are eleven(11)% capacity decrease between ED 3H1 and ED5H1 in rebar, strain. Left and right side crack shapes are much similar in variable ED3H2L having maximum capacity 14.5 tone. ED5H2L having maximum capacity thirteen(13)tone, in case of normal 19.6 tone. Two holes in beam rather on the longitudinal direction than on the forcing direction can be more effective to keep the original capacity of the beam because this case can distribute load more uniformly. There is 33% capacity decreased in case of diameter five(5)cm, compared to diameter three(3)cm. Two holes give thirty nine(39) percent capacity decrease than one of diameter three(3)cm.

• Journal of the Korean Society of Safety
• /
• v.21 no.1 s.73
• /
• pp.96-104
• /
• 2006

This study is to find out how the sawdust-mixed RC beam with holes acts compared to two case of normal one with sawdust without hole, without sawdust. variables are ED3H1, ED3H2, ED3H1UB, ED3H2L, ED5H1, ED5H1UB, ED5H2, ED5H2L, Normal with sawdust PLA without sawdust. All sand, aggregate, cement are in accordance with KS. mixing design is also in accordance with KS and done at D remicon company in order to decrease any error in mixing manually. ED3H1 showed 7tone of maximum load capacity having only minor tensile deformation around hole, compared to the center of the beam. ED5H2L showed almost same shape of tensile strain between hole area and center of two beam length, while having 9.5 tone load capacity, incase of two holes being in the longitudinal axis. But ED5H2 in case of two holes being in same forcing direction showed 8.4tone of load capacity while having minor tensile chape around hole and normal tensile shape in the center of beam length. Two diameter 3cm hole in longitudinal axis give more effective behavior than the other case, practically. Capacity decrease between 5cm and 3cm in eccentric position form the longitudinal axis is less than percents. There is minor capacity difference between hole diameter 3cm hole, but 13tone difference of load capacity between hole diameter 5cm.

• Journal of the Korea Society of Computer and Information
• /
• v.29 no.1
• /
• pp.1-9
• /
• 2024

This paper proposes an integration of the ED-H scheduling algorithm, known for optimal real-time scheduling, with the LoRaEnergySim simulator. This integration facilitates the simulation of interactions between real-time scheduling algorithms for tasks with time constraints in Class-A LoRaWAN Class-A devices using a super-capacitor-based energy harvesting system. The time and energy characteristics of LoRaWAN status and state transitions are extracted in a log format, and the task model is structured to suit the time-slot-based ED-H scheduling algorithm. The algorithm is extended to perform tasks while satisfying time constraints based on CPU executions. To evaluate the proposed approach, the ED-H scheduling algorithm is executed on a set of tasks with varying time and energy characteristics and CPU occupancy rates ranging from 10% to 90%, under the same conditions as the LoRaEnergySim simulation results for packet transmission and reception. The experimental results confirmed the applicability of co-simulation by demonstrating that tasks are prioritized based on urgency without depleting the supercapacitor's energy to satisfy time constraints, depending on the scheduling algorithm.

• Korean Journal of Veterinary Research
• /
• v.44 no.3
• /
• pp.329-334
• /
• 2004

Ischemia/reperfusion(I/R) injury of the rat testis causes germ cell death and infiltration of inflammatory cells. To investigate the mechanism of germ cell death in torsion of the rat testis, apoptosis and macrophage activation were studied using the terminal deoxynucleotidyl transferase-mediated dUTP nick end-labeling(TUNEL) method and immunohistochemistry in the testes of Sprague-Dawley rats subjected to 1.5 h of ischemia, followed by 0, 1, 3, 6, 12, 24, 48 and 96 h of reperfusion. Apoptotic, TUNEL-positive cells were found at the base of the seminiferous epithelia after I/R. TUNEL-positive cells were significantly increased 6 h after repair of the torsion, and there was a significant peak in apoptosis 24 h after reperfusion, as compared with normal or sham-operated controls. In contrast, histological evidence of germ cell necrosis in the seminiferous tubules was first visible 24 h after reperfusion. In the testis of sham-operated rats, ED2-positive resident macrophages were found diffusely in the interstitial space, while ED1-positive monocyte-like macrophages were rarely found. After I/R, ED1-positive cells were significantly increased beginning 12 h after reperfusion, while ED2-positive immunoreactivity did not change during the experimental period. Together, the results of this study confirmed that increased numbers of ED1-positive macrophages, but not resident ED2-positive macrophages, infiltrated the interstitial space surrounding damaged tubules and induced germcell death.

• Proceedings of the KIEE Conference
• /
• 2005.05a
• /
• pp.179-181
• /
• 2005

There is asymmetric in horizontal and vertical side of PDP cell. Every vertical line has BM(Black Mask) to improve luminance contrast. When error diffusion is processed in PDP system, these problems make an error bigger. In 4 inch PDP system, every red, green, blue color of test pattern is presented and each luminance is measured. That is called horizontal(H), diagonal right(R), diagonal left(L) and vertical(V). In red channel, high luminance descending order is V-H-R-L. In green channel, V-H-L-R. In blue channel, V-M-R=L. After average luminance of each direction is calculated. new weighted error diffusion(Weighted ED) is proposed. In digital image signal processing, the error in weighted ED is differ from ED's. The image of weighted ED is more less error compare to conventional ED and close to original image. As the gray level linearity and big size panel is adopted, weighted ED could produce good image.

• Microbiology and Biotechnology Letters
• /
• v.23 no.5
• /
• pp.609-616
• /
• 1995

Effects of lactate concentration, temperature, counter ions, pH as well as voltage (current) in batch electrodialysis (ED) experiments with a 3-compartment unit were investigated. The applied voltage was found to be the most critical factor as expected. The electrodialysis rate increased with the lactate concentration of the source solution. The amount of lactate transferred was limited by the lactate concentration difference between cathode and permeate compartments. The electrodialysis rate did not heavily depend on temperature change. The electrodialysis rate of NH$_{4}$-lactate was faster than that of Na-lactate and both lactates showed the highest electrodialysis rate at a pH of 4.0. A little amount of non-ionic glucose diffused through the anionic membrane to the permeate compartment. To test the effectiveness of the in situ recovery of lactic acid from fermentation broth by ED, three cases of batch culture were carried out; pH control only, ED only, and pH control and ED. The case with both pH control and ED was more efficient than that with pH control only in the aspects of productivity and product yield.

• International Journal of Quality Innovation
• /
• v.9 no.3
• /
• pp.1-14
• /
• 2008

Patient satisfaction with the Emergency Department(ED) in a hospital is related to the length of stay, and especially to the amount of waiting time for medical treatments. ED overcrowding decreases quality and efficiency, therefore affecting hospitals' profitability. This paper presents a forecasting and simulation model for resource management of the ED at Moses H. Cone Memorial Hospital. A linear regression forecasting model is proposed to predict the number of ED patient arrivals, and then a simulation model is provided to estimate the length of stay of ED patients, system throughput, and the utilization of resources such as triage nurses, patient beds, registered nurses, and medical doctors. The near future load level of each resource is presented using the proposed models.

• Journal of the Korea Society of Computer and Information
• /
• v.27 no.12
• /
• pp.17-27
• /
• 2022

In this paper, ED-H algorithm, an optimal real-time scheduling algorithm dealing with the characteristics of the integrated energy harvester system with a capacitor, is extended to satisfy the time constraint under the blackout state which is a deliberate power-off state by an intelligent power management unit adopted in the system. If the power supply system does not have enough energy, it temporarily shuts off the power supply to protect the circuit and capacitor and resumes the supply again when the capacitor is fully charged, which may delay the task execution during these blackout states by calculating the time according to the occurrence of the events. To mitigate the problem, even if task execution is delayed by the original ED-H algorithm, the remaining time of the subsequent time units no longer can afford to delay the execution of the task is predicted in the extended algorithm and the task is forced to be scheduled to meet the time deadline. According to the simulation results, it is confirmed that the algorithm proposed in this paper has a high scheduling performance increase of 0.4% to 7.7% depending on the characteristics of the set of tasks compared to the ED-H.

• YAKHAK HOEJI
• /
• v.48 no.2
• /
• pp.117-121
• /
• 2004

Ranunculin, a potent cytotoxic component of P. koreana, was synthesized by reacting (s)-(-)-5-(hydroxymethyl)-2(5H)-furanone with 2,3,4,6-tetra-O-acetyl-$\alpha$-D-glucopyranosyl bromide and successive removal of the acetyl protecting group by 0.5 M HCl/MeOH. A new deacetylation process of the intermediate tetraacetylranunculin was deviced giving a yield of 83% of ranunculin. Protoanemonin, the cytotoxic structural moiety of ranunculin, was synthesized by dehydration of (s)-(-)-5-hydroxymethyl-2(5H)-furanone. Ranunculin showed a moderate cytototoxic activity against A-549 (ED$_{50}$=7.53 $\mu\textrm{g}$/$m\ell$), NIH3T (ED$_{50}$=13.6$\mu\textrm{g}$/$m\ell$), and SK-OV-3 (ED$_{50}$=17.5 $\mu\textrm{g}$/$m\ell$). Meanwhile, protoanemonin also exhibited moderate cytotoxicity against A-549 (ED$_{50}$=9.38 $\mu\textrm{g}$/$m\ell$), NIH3T (ED$_{50}$=13.8 $\mu\textrm{g}$/$m\ell$), and SK-OV-3 (ED$_{50}$=15.1 $\mu\textrm{g}$/$m\ell$). It was found that both of the synthetic products showed a potenter cytotoxicity against A-549.ainst A-549.

• Membrane and Water Treatment
• /
• v.4 no.4
• /
• pp.237-249
• /
• 2013

Ultra-pure water (UPW), a highly treated water free of colloidal material and of a conductivity less than 0.06 ${\mu}S$, is an essential component required by modern industry. One of the methods for UPW production is the electrodialysis-ion exchange (ED/IE) system, in which the electrodialysis (ED) process is used as a preliminary demineralization step. The IE step can be replaced with electrodeionization (EDI) to decrease the volume of post-regeneration lyes. In this paper, the electrodialysis process carried out to relatively low diluate conductivity was investigated and the costs of UPW production were calculated. The optimal value of desalination degree by ED in the ED/IE and ED/EDI systems was estimated. UPW unit costs for integrated ED/IE and ED/EDI systems were compared to simple ion exchange and other methods for UPW production (RO-IE, RO-EDI). The minimal UPW unit costs in ED/EDI integrated system were estimated as $0.37/$m^3$ for feed TDS 600 mg/L and $0.36/$m^3$ for feed TDS 400 mg/L at 64 $m^3/h$ capacity, which was lower than in the comparable ED/IE integrated system ($0.42-0.44/$m^3$). The presented results suggest that an ED/EDI integrated system may be economically viable.