• 한국산업융합학회 논문집
• /
• 제3권4호
• /
• pp.337-343
• /
• 2000

Physical properties of matt georgette knitted fabrics, which has been developed recently, were investigated to provide fundamental information for the textile industry. Dimensional characteristics were examined with three different loop lengths, where the plain knitted fabrics were knitted with cotton yam and polyester yarn. The matt georgette plain knitted stitch was fully relaxed after wet relaxation treatment at $130^{\circ}C$ for 30minutes and subsequent tumble dry treatment at $70^{\circ}C$ for 90minutes. As the treatment temperature of wet relaxation became higher and the loop length did shorter, all of stitch density, course density and wale density were increased with 31 of $K_1$ 8.3 of $K_2$ and 3.8 of $K_3$. Also, The higher value of $K_4$ could be obtain with shorter loop length. When the loop length became longer, the $K_4$ value was varied in a wide range with the treatment of wet relaxation and subsequent tumble dry.

• 한국의류학회지
• /
• 제4권1_2호
• /
• pp.25-33
• /
• 1980

The studies on shrinkage and characteristics of the weft knitted fabrics were investigated under the various dry and wet treating conditions. Various relaxation values were found out according to treating conditions. The characteristics of knitted fabrics such as shrinkage rate, thickness, spirality, elongation and recovery were also measured. The used knitting yams were OE (open-end) cotton and POY (pre-oriented yarn)-DTY (draw textured yam) polyester. The conclusions obtained in this study are as follows. 1. In case of dry relaxation little change of Ks values was seen with increasing time after 48 hours. So it was found that relaxation shrinkage of dry relaxation reached its maximal state in about 48 hours. 2. In case of wet relaxation, higher Ks values were observed, in comparision with those of dry one and higher shrinkage rates were also observed. But when experimental temperature was constant, sudden marked increases in Ks values and shrinkage rates appeared through the initial 4 hours, and after that time little change was seen in them. 3. As Ks value increases, thickness also increased. But thickness showed to some degree stability around Ks value 23. 4. As Ks value increases, spirality values also increased gradually. But little change of spirality values was observed above a certain Ks values (cotton 22.5, polyester 21.5). 5. As Ks value increases, the elongation decreased under a certain load, and the recovery was random.

• 한국융합학회논문지
• /
• 제9권12호
• /
• pp.331-336
• /
• 2018

본 연구는 평소 자신의 업무에 대하여 지각하는 스트레스 지수가 높은 30~40대 직장 여성 50명을 대상으로 미용대체 요법이 스트레스 완화에 미치는 복합적인 영향을 분석하여 급변하는 현대사회에서 여성 직장인들이 받는 스트레스를 완화시켜 건강하고 아름다운 삶을 유지하는데 도움을 주고자 하였다. 미용요법은 향기요법과 건식 이완 마사지를 15분간 시행하였으며, 시행 전 설문을 통하여 스트레스 지수를 확인하였다. 실험은 주1회 4주간 시행되었고 결과 측정은 타액 내 코티졸의 농도로 분석하였다. 그 결과 실험 전 스트레스 지수 평균은 3.97로 높게 나타났으며, 실험 후 대상자들의 코티졸 농도는 유의하게(p<0.05) 낮아졌고 특히, 기혼과 부양책임을 가진 대상자들에게서 더 많은 변화를 보였다. 이상의 결과로 향을 이용한 건식이완 마사지는 스트레스가 심한 30~40대 여성들의 심신 안정에 매우 효과적인 것으로 판단되며 이러한 미용적 방안을 잘 적용한다면 스트레스 관리에 도움이 될 것으로 판단된다.

• 한국의류학회지
• /
• 제29권9_10호
• /
• pp.1274-1284
• /
• 2005

Effect of fixation methods and relaxation treatment on the dimensional stability and physical properties of MDPPA/HMM treated cotton knitted fabrics were studied. Combination of four different fixation methods - relaxation, swelling agent treatment, pad dry cure fixation, and wet fixation - were applied to flame retardant finish of 4 kinds of cotton knitted fabric with MDPPA/HMM. Then these fabrics were washed 10 times. As a result, In swelling treatment on 10G showed relatively higher value of length shrinkage than 14G. Length and width shrinkage were increased by initial washing treatment and no further change was shown after 6 washing cycles. After 10 washing cycles, length and width shrinkage decreased. The KES standardized basic value of B/W, 2HB/W and bursting strength of interlock were relatively larger than those of single jersey. The values of B/W and 2HB/W of cotton knitted fabrics were increased by relaxation and washing treatment but were decreased by swelling treatment. In addition, the bursting strength of the cotton knitted fabrics was decreased after fusing, washing and relaxation treatment.

• Fibers and Polymers
• /
• 제7권4호
• /
• pp.398-403
• /
• 2006

Dimensional constants (k values) of single jersey fabrics made from $LincLITE^{(R)}$ and conventional yams are calculated under dry, steam, full relaxation treatments. Fabrics were made under different tightness factors such as high, medium and low with different twist factors, twist directions and feeder blending. $LincLITE^{(R)}$ yarns made to get soft and bulkier effects with yam count of 39 tex and conventional yams made into 39 tex and 48 tex yam counts. Various effects on K values are analysed using correlation coefficients. K-values are increased with relaxation progression and have shown some differences between in $LincLITE^{(R)}$ and conventional fabrics, and feeder blended fabrics. Loop shape factor is highly affected by tightness factor, relaxation and feeder blending in $LincLITE^{(R)}$ fabrics, whereas twist factor not significantly effects on loop shape factor in conventional fabrics. Stitch density significantly increases with relaxation in conventional fabrics and no significant effect shows with $LincLITE^{(R)}$ fabrics.

• 한국의류산업학회지
• /
• 제5권3호
• /
• pp.273-282
• /
• 2003

Effect of fixation methods and relaxation treatment on the flame retardant(FR) and physical properties of MDPP/HMM treated cotton weft-knitted fabrics were studied. Combination of four different fixation methods - relaxation, swelling agent treatment, pad dry cure fixation, and wet fixation - were applied to flame retardant finish of cotton weft-knitted fabric with MDPP/HMM. As the results, 1. Swelling agent and wet fixation method helps FR agent penetrate the fiber efficiently. Interlock showed relatively higher values of LOI than single jersey. 2. Interlock showed relatively higher values of bending rigidity(B), shear rigidity(G) and coefficient of friction(MIU) than those of single jersey before and after flame resistant treatment. 3. An increase in internal volume of cotton fiber by relaxation treatment increased the bending rigidity(B), shear rigidity(G) and compressional energy(WC). 4. The cotton weft-knitted fabric treated wet fixation, which crossliked FR agent efficiently, showed higher bending rigidity, shear rigidity(G) and lower compressional energy(WC). Retention of swelling ability of cotton weft-knitted fabrics treated with MDPP/HMM, which increased the internal volume of cotton weft-knitted fabric, showed lower bending rigidity.

• 대한치과교정학회지
• /
• 제21권2호
• /
• pp.433-446
• /
• 1991

The present study was performed to evaluate the relaxation patterns of rubber elastics, elastomeric modules and chains stored in the water bath. Initial loading profiles were established for extension of $100\%,\;200\%$ of their original length for elastomeric chains and of 21, 28, 35, 42, 49mm for rubber elastics and elastomeric modules. The tests were performed on materials stored in distilled water at $37^{\circ}C$ and extraoral elastics stored in dry state at room temperature, at 0 hour, 1 hour, 6 hours, 1 day, 1 week, 2 weeks, 3 weeks, and 4 weeks, respectively. The following results were drawn: 1. The relaxation of rubber elastics manifested no correlation with increments of the extension distances, but showed correlation with time lapse. Remaining forces of rubber elastics carne out $84.6-98.52\%$ after 1 day, $70.92-89.31\%$ after 3 weeks of period. 2. The relaxation of elastomers manifested no correlation with increments of the extension distances, however represented considerable relaxation with time lapse as rapid relaxation after 1 hour and then gradual relaxations with time lapse. Modules relaxed much more than chains. $60.58-67.05\%$ of remaining forces for chains and $37.77-65.17\%$ for modules after 1 hour were turned out, and $51.48-62.22\%$ for chains and $8.04-25.15\%$ for modules after 3 weeks as well. 3. Permanent deformation rates of rubber elastics could not be measured with present investigation, but elastomers underwent severe deformations. 4. $3-9\%$ of permanent deformations for chains, $3-10\%$ for modules at 0 hour were turned out, and $25-30\%$ for chains, $96-145\%$ for modules after 3 weeks as well.

• 한국산업융합학회 논문집
• /
• 제16권2호
• /
• pp.47-52
• /
• 2013

Aim of this study is to investigate the dimensional and shrinkage characteristics of the weft knitted fabrics with Polylactic acid(PLA) knitted yarn. This PLA knitted yarn was made of the biodegradability fiber. The structure of weft knitted fabrics that was utilized for this study is the plain stitch, which is the most basic structure among all weft knitted fabrics. As the stitch length is shorter, the stitch density, courses density, and wales density are more increasing. The stitch density increased as pre-treatment process and dyeing process progressed. On the contrary, the heat setting process made it decreasing. The MR(Machine Relaxation) and DR(Dry Relaxation) standard area shrinkage were increasing as wet process progressed and as the stitch lengths are long.

• 한국지반공학회지:지반
• /
• 제14권5호
• /
• pp.39-52
• /
• 1998

본 논문은 정규압밀된 점성토 지반에서 강관 매입 말뚝의 수평 거동에 영향을 미치는 여러인자들 중에서 말뚝의 근입길이, 지반조건(건조단위 중량 $\gamma_4$), 말뚝 두부의 구속조건의 영향에 관하여 모형실험을 수행하였으며, 이러한 영향을 정량화 할 수 있는 경첩식을 그 결과들로부터 얻었다. 모형실험에 사용한 지반은 3종류의 정규압밀 점토이다. 2종류의 말뚝 근입길이와 말뚝 두부의 고정 자유조건의 모형실험결과들에 의하여 수평하중-변위 관계는 $\gamma_d/\gamma_{dmax}$=0.84 이하에서 완전 탄소성체의 거동형상을 보일 것으로 나타났으며, 각 실험에서 최대 수평하중(Q--) 이후의 수평하중 감소는 상당한 시간 의존성을 보였다. 본 연구에서는 수평 하중-변위관계(logo-logy/D)와 최대 휨 모멘트-변위관계($loaM_{max}$.-.-logy/D)에서 각각 구한 항복 수평하중(Qy)과 항복 최대 휭 모멘트(My)가 직선적인 관계로 밝혀졌다. Relaxation에 의한 수평하 중은 모형실험 결과들로부터 시간을 변수로 한 지수 함수식으로 회귀분석 하였다. 수평 극한하중과 항복하중에 대한 지반조건의 영향은 $\gamma_4$$/\gamma_{dmax}$의 변수로 한 지수함수식으로 모델화 하였으며, Broms와 Budhu et at.에 의한 결과와의 비교에서 예측결과가 26-78%정도 과대평가 되었다. 수평하중-변위 관계에 대한 말뚝 두부의 고정조건 영향에서 $Q_{mxed}/Q_{free}$-y/D의 관계는 상당히 비선형적으로 나타났으며, yiD를 변수로 한 지수함수식으로 모델화하였다.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권12호
• /
• pp.601-607
• /
• 2002

IPMC(Ionic Polymer Metal Composite)actuators were optimized for producing improved forces by changing multiple parameters including repetition of number of plating, surface electroding and additive(PVP)-treatment on reduction. The platinum electrode is deposited on the surface of the material where platinum particle stay in a dense form that appears to introduce a significant level of surface electrode resistance. Actuation tests were performed for such IPMC actuators under a low voltage. The test results show that the lower surface-electrode resistance generates higher actuation capability in the IPMC actuators. In order to investigate relaxation behavior of bending and repeatability in dry condition, the IPMC was coated by$rubber(KRATON^{TM})$to minimize the effect of water evaporation from IPMC. This actuator can be used in air with surface coating to avoid membrane drying.