• Magazine of the Korea Concrete Institute
• /
• v.14 no.1
• /
• pp.53-60
• /
• 2002

매스 콘크리트 구조물에서는 콘크리트 타설 후 시멘트의 수화열로 인한 온도응력에 의해서 온도균열의 발생 가능성이 매우 높다. 따라서, 매스 콘크리트 시공시, 온도균열을 구조물의 내구성 관점에서 최대한 억제시킬 필요가 있다. 최근에는 국내에서도 단위시멘트량이 많은 배합을 이용하는 고강도 콘크리트 구조물의 시공이 증가되고 있다. 이와 같은 매스 콘크리트 구조물은 단위시멘트량이 많기 때문에 부재내 수화열에 의한 온도의 상승 속도가 빠르기 때문에 시공에 앞서 사전에 설계, 재료 및 시공 측면에서 온도균열 제어 대책을 검토할 필요가 있다.(중략)

• Progress in Superconductivity and Cryogenics
• /
• v.14 no.1
• /
• pp.30-33
• /
• 2012

A double pancake winding method is widely used to make the superconducting magnet, using high temperature superconductor (HTS) tape. In the double pancake winding method, the joints with contact resistances between double pancake coils are inevitably needed. The electrical joule heating on the contacts causes refrigerant loss during operation. And a space outside the winding, for splices and mechanical support, is more than that for its layer-wound equivalent. In this paper, a double pancake winding method in order to reduce the number of the joints was proposed. Both of the double pancake coils using the conventional winding method and the proposed winding method have been fabricated and tested to make the solution technically feasible in the double pancake winding method. Especially, critical-current tests of the fabricated double pancake coils were conducted in order to show the same performance and confirm contact resistances between double pancake coils.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.10 no.2
• /
• pp.134-142
• /
• 2010

A comparative study on the trade-off between the drive current and the total gate capacitance in double-gate (DG) and triple-gate (TG) FinFETs is performed by using 3-D device simulation. As the first result, we found that the optimum ratio of the hardmask oxide thickness ($T_{mask}$) to the sidewall oxide thickness ($T_{ox}$) is $T_{mask}/T_{ox}$=10/2 nm for the minimum logic delay ($\tau$) while $T_{mask}/T_{ox}$=5/1~2 nm for the maximum intrinsic gate capacitance coupling ratio (ICR) with the fixed channel length ($L_G$) and the fin width ($W_{fin}$) under the short channel effect criterion. It means that the TG FinFET is not under the optimal condition in terms of the circuit performance. Second, under optimized $T_{mask}/T_{ox}$, the propagation delay ($\tau$) decreases with the increasing fin height $H_{fin}$. It means that the FinFET-based logic circuit operation goes into the drive current-dominant regime rather than the input gate load capacitance-dominant regime as $H_{fin}$ increases. In the end, the sensitivity of $\Delta\tau/{\Delta}H_{fin}$ or ${{\Delta}I_{ON}}'/{\Delta}H_{fin}$ decreases as $L_G/W_{fin}$ is scaled-down. However, $W_{fin}$ should be carefully designed especially in circuits that are strongly influenced by the self-capacitance or a physical layout because the scaling of $W_{fin}$ is followed by the increase of the self-capacitance portion in the total load capacitance.

• Journal of Ocean Engineering and Technology
• /
• v.19 no.2 s.63
• /
• pp.19-28
• /
• 2005

The present paper outlines the numerical investigation of the incident wave interactions with fully submerged and floating dual double hull pontoon/vertical porous membrane breakwaters. Two dimensional five fluid-domains hydro-elastic formulation was carried out in the context of linear wave body interaction theory to study the wave interaction with the double hull of pontoon-membranes. The submerged circular pontoon is consisted of double hulls, which is filled with water in the void space between the outer structure and inner solid buoyant structure. Hydrodynamic characteristics of the proposed system with dual floating double-hull-pontoons filled with water have been studied numerically for the various incident waves. This study is a beginning stage research for the dual double hull porous pontoons/vertical porous membranes breakwaters which is ideally designed in order to suppress significantly the transmitted and reflected waves simultaneously.

• Bulletin of the Korean Mathematical Society
• /
• v.59 no.1
• /
• pp.167-177
• /
• 2022

A vertex v of a graph G = (V, E) is said to ve-dominate every edge incident to v, as well as every edge adjacent to these incident edges. A set S ⊆ V is called a double vertex-edge dominating set if every edge of E is ve-dominated by at least two vertices of S. The minimum cardinality of a double vertex-edge dominating set of G is the double vertex-edge domination number γ_dve(G). In this paper, we provide an upper bound on the double vertex-edge domination number of trees in terms of the order n, the number of leaves and support vertices, and we characterize the trees attaining the upper bound. Finally, we design a polynomial time algorithm for computing the value of γ_dve(T) for any trees. This gives an answer of an open problem posed in [4].

• Journal of Korean Society of Steel Construction
• /
• v.27 no.5
• /
• pp.423-433
• /
• 2015

A double split tee connection, which is a beam-column moment connection, shows different behavioral characteristics under the influences of the thickness of a T-stub flange, a high-strength bolt gauge distance, and the number and diameter of a high-strength bolt. A double split tee connection is idealized and designed that a flexural moment normally acting on connections can be resisted by a T-stub and a shear force by a shear tap. However, where a double split tee connection is adopted to a low-and medium-rise steel structure, a small-sized beam member can be adopted. Then, a shear tab may not be bolted to the web of a beam. This study was conducted to suggest the details of a connection to secure that a double split tee connection with a geometric shape has a sufficient capacity to resist a shear force. To verify this, this study was conducted to make a three-dimensional nonlinear finite element analysis on a double split tee connection.

• Journal of Environmental Science International
• /
• v.30 no.8
• /
• pp.659-671
• /
• 2021

The physicochemical properties of soil and the yield and quality of rice (Oryza sativa L. cv. Sailmi) were assessed using Italian ryegrass (Lolium multiflorum Lam. cv. Kowinearly)-rice double cropping systems in the paddy fields at Goseong and Miryang in southern Korea. The average temperatures during the ripening period were approximately 1 ℃ higher than the optimal temperature for rice ripening and the sunshine duration was reduced by frequent rainfall. Consequently, it was slightly below the optimal conditions required for rice ripening. In the soil at Goseong, winter Italian ryegrass cropping increased the pH, electrical conductivity, and the contents of organic matter, total nitrogen (T-N), available P₂O₅, K, Ca, and Mg than winter fallowing. Particularly, the contents of T-N and available P₂O₅increased significantly. In the soil at Miryang, Italian ryegrass slightly increased the electrical conductivity and the T-N, Mg, and Na contents. Therefore, winter Italian ryegrass cropping improved the physicochemical properties of paddy soils; however, Italian ryegrass-rice double cropping slightly reduced the culm length at both Goseong and Miryang, without markedly changing the panicle length or number compared to fallow-rice cropping. Furthermore, at Goseong, Italian ryegrass-rice double cropping slightly decreased the spikelet number and milled rice yield, and increased the ripened grain rate; however, at Miryang, contrasting results were observed. In addition, fallow-rice cropping revealed no differences in the head rice or opaque rice rates. The protein content was slightly increased in Italian ryegrass-rice double cropping, without significant changes in the amylose content or Toyo value, compared to that in fallow-rice cropping. The peak and breakdown viscosities were slightly decreased. These results indicate that winter Italian ryegrass cropping might alter rice taste but may not exhibit remarkable negative effects on rice cultivation. Therefore, Italian ryegrass-rice double cropping system is recommended for paddy fields in southern Korea. Nevertheless, to increase the rice yield and quality, fertilization standards for rice cropping that consider the changes in the T-N and organic matter contents in paddy fields caused by winter Italian ryegrass cropping need to be established.

• IMMUNE NETWORK
• /
• v.4 no.2
• /
• pp.81-87
• /
• 2004

Background: In the thymus, developing thymocytes continually interact with thymic epithelial cell components. Self MHC restriction of mature T cells are imposed in the thymus through interaction of immature double positive thymocytes and thymic cortical epithelial cells. The site of negative selection, however, is a matter of debate. Through systemic injection of anti-TCR antibody or antigenic peptides, investigators suggested that most of the negative selection occurs in the thymic cortex. But the requirements for negative selection, i.e cellular counterparts and costimulatory molecules are more available in the medulla or cortico-medullary junction rather than in the thymic cortex. Methods: The direct and indirect pathways of thymocyte death after systemic anti-TCR antibody injection were separated through several experimental systems. B6 mice were either adrenalectomized or sham-adrenalectomized to evaluate the role of endogenous glucocorticoids from adrenal gland. Role of TNF were evaluated through using TNF receptor double knockout mice. Results: We found that without indirectly acting mediators such as $TNF-\alpha$ or corticosteroid, double positive thymocyte death were minimal by systemic injection of anti-TCR antibody in TNF receptor double knockout neonatal mice. Also by analyzing neonatal wild-type mice with adoptively transferred mature T cells, only peripheral activation of mature T cells could induce extensive double positive thymocyte death. Conclusion: Thus, systemically injected anti-TCR antibody mediated thymocyte death are mostly induced through indirect pathway.

• Kyungpook Mathematical Journal
• /
• v.12 no.1
• /
• pp.119-128
• /
• 1972

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.5 no.2
• /
• pp.111-121
• /
• 1993

Double-diffusive convection during solidification process of the binary mixture was studied numerically. Enthalpy method and finite element method were implemented in the analysis. Calculation carried out for $R{\alpha}_T=10^3-10^4$ and $R{\alpha}_T=0-10^5$. The results show that the variation of thermal Rayleigh number changes the fields of velocity, temperature and concentration, but the variation of solutal Rayleigh number gives little effects on those. In conclusion, concentration gradient can be negligible compared with temperature gradient in macroscopic point of view, although concentration gradient plays a role in forming dendrite.