• Journal of Environmental Science International
• /
• v.14 no.6
• /
• pp.577-582
• /
• 2005

Enormous apartment complexes in urban areas, temporary inversion state and heat island effect occur due to the strong sunshine and weak wind speeds which hinders the dispersion of air pollutants that are emitted from neighboring areas of apartment complexes. In this study, analysis were conducted by using the Fluent code based on the CFD(Computation Fluid Dynamics), including building layout, material, building height from the ground surface, the heat, analysis of flow field in the apartment complex. It was estimated that the temporal radiation inversion phenomenon during the daytime, which was caused by the weak wind speed and higher temperatures in the upper level, contributed to the stagnation of the air pollutants in the lower layer of the apartment complex.

• Proceedings of the KIEE Conference
• /
• 2001.10a
• /
• pp.233-235
• /
• 2001

On the active filter converter for power factor correction is used inverter for a air-conditioner's power supply to meet IEC standard In the active filter topology for power factor correction, extra switch only control the input current indirectly to satisfied with the IEC standard for reducing the cost and size. In this paper, by dividing the input current into two different modes, the current conduction period can be widened and harmonics can largely be canceled between the two modes. Hence, the harmonics characteristics can be significantly improved, whereby the lower order harmonics, such as the fifth and seventh orders, are much reduced. The results are confirmed by theoretical and experimental implementations.

• Journal of Ocean Engineering and Technology
• /
• v.19 no.1 s.62
• /
• pp.8-13
• /
• 2005

In a multiple array of vertical cylinders, flaw patterns are very complex and very interactive between cylinders. The patterns are turbulent and non-linear depending on various factors. The gap and flow incoming velocity of upstream can affect on the downstream cylinder. In this study, the flaw characteristics around two vertical cylinders are investigated numerically and experimentally. As the gap between cylinders is changed at fixed coming velocity, the pressure distributions around cylinders are observed and compared by experimental and numerical approaches. The F.D.M and multi-block method are applied in the study. The pressures at 12 points around the cylinder are measured in the experiment. The results can be applied in the understanding and design of multiple pile array structures.

• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1544-1546
• /
• 2003

In this study, composite materials were put to dry interfacial treatment by use of plasma technology. It has been presented that the optimum parameters for the best wettability of the samples at the time of generation of plasma were oxygen atmosphere, 0.1 torr of system Pressure, 100 W of discharge power, and 3 minutes of discharge time. The decrease in surface potential of charged samples by corona discharge indicates that the amount of accumulated electrical charges reduces and the charges that have been injected lessen rapidly when the duration of UV irradiation increases. The surface resistivity and the tensile strength of plasma treated samples, a longer UV irradiation time resulted in decreased insulation.

• Analytical Science and Technology
• /
• v.17 no.6
• /
• pp.532-535
• /
• 2004

A method on the determination of Co(II) after adsorbing of Co(II) on 2-mercaptobenzothiazole-loaded silica gel was studied. The conditions on the separation of Co(II) such as pH of solution, the amount of 2-mercaptobenzothiazole, the flow rate for adsorption, and the desorption solvent were optimized to 9.0, 0.05 g, $10mL\;min^{-1}$ and 1 M $HNO_3$ in ethanol, respectively. Under these optimum conditions, the calibration curve of Co(II) was obtained over concentration range of $2{\sim}120ng\;mL^{-1}$. The detection limit was $0.6ng\;mL^{-1}$. Recovery yields of Co(II) in various natural water samples were more than 90%.

• Proceedings of the KIEE Conference
• /
• 2002.11a
• /
• pp.6-8
• /
• 2002

In order to prepare magnetic recording layer with a good quality crystallographic characteristic. We prepared $Co_{77}Cr_{20}Ta_3$ layer for perpendicular magnetic recording media on slide glass substrate by Two-Step Methode. The thickness of magnetic layer was fixed 100 nm and buffer layer were varied from 10 to 50 nm, and input current was varied from 0.2[A] to 0.5[A]. The surface morphology and crystal orientation of the CoCrTa films were examined with XRD. Prepared thin films showed improvement of dispersion angle of c-axis orientation ${\Delta}{\theta}_{50}$ caused by inserting buffer layer.

• Proceedings of the KIEE Conference
• /
• 2002.11a
• /
• pp.124-126
• /
• 2002

In this study, composite materials were put to dry interfacial treatment by use of plasma technology. It has been presented that the optimum parameters for the best wettability of the samples at the time of generation of plasma were oxygen atmosphere, 0.1 torr of system pressure, 100 W of discharge power, and 3 minutes of discharge time. Also, the surface resistance rate, dielectric property and tensile strength were improved.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07a
• /
• pp.165-168
• /
• 2004

In this study, AZO(ZnO:Al) thin film were prepared by FTS(Facing Target Sputtering) system. The electrical, optical and crystallographic properties of AZO thin film with $O_2$ gas flow ratio have been investigated. The thickness, transmittance, crystal structure and resistivity of AZO thin film were measured by a-step, UV-VIS spectrometer, XRD and four-point probe, respectively. As a result AZO thin film deposited with the transmittance over 80% and the resistivity about $10^{-1}\Omega-cm$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.430-431
• /
• 2005

In this work, the ITO thin films were prepared by FTS (Facing Targets Sputtering) system under different sputtering conditions which were varying $O_2$ gas flow and input current. As a function of sputtering conditions, electrical and optical properties of prepared ITO thin films were measured. The electrical characteristics, surface roughness and transmittance of the ITO thin films were evaluated by Hall Effect Measurement, AFM, and UV-VIS spectrometer respectively. In addition, I-V properties of OLED cells were measured by 4156A(HP).

• Journal of Preventive Medicine and Public Health
• /
• v.19 no.2 s.20
• /
• pp.314-321
• /
• 1986

Forced vital capacities (FVC's) and forced expiratory volumes in one second $(FEV_{1.0}'s)$ of 26 pneumoconiosis patients were checked at admission and were followed up for 10 months through hospitalization. FVC's and $FEV_{1.0}'s$ were slightly improved in 10 months after admission. The improvement of FVC's was statistically significant. In the group of large opacities in chest radiographs, FVC's and $FEV_{1.0}'s$ were lower than those values in small opacity group at admission but improved more progressively. Similar finding was noted in the group of emphysema; those values were lower at admission but improved more progressively than those of non-emphysema group.