• The Korean Journal of Pesticide Science
• /
• v.10 no.4
• /
• pp.262-265
• /
• 2006

A series of N-[4-chloro-2-fluoro-5-(2-(substituted)pyrimidinyloxy)phenyl]-3,4,5,6-tetrahydrophthalimides was synthesized, and the herbicidal activities of those derivatives were evaluated through pre- and post-emergence application under upland conditions in a greenhouse. The results showed that most compounds resulted in stronger herbicidal activities on broadleaf weeds than on grass weeds. The N-[4-chloro-2-fluoro-5-(2-pyrimidinyloxy)phenyl]-3,4,5,6-tetrahydrophthalimide showed the best weed control efficacy and marginal corn safety at a rate of 60 g/ha through pre-emergence application.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.7
• /
• pp.1371-1378
• /
• 2009

We propose a low-power eFuse one-time programmable (OTP) memory cell based on a logic process. The eFuse OTP memory cell uses separate transistors optimized at program and read mode, and reduces an operation current at read mode by reducing parasitic capacitances existing at both WL and BL. Asynchronous interface, separate I/O, BL SA circuit of digital sensing method are used for a low-power and small-area eFuse OTP memory IP. It is shown by a computer simulation that operation currents at a logic power supply voltage of VDD and at I/O interface power supply voltage of VIO are 349.5${\mu}$A and 3.3${\mu}$A, respectively. The layout size of the designed eFuse OTP memory IP with Dongbu HiTek's 0.18${\mu}$m generic process is 300 ${\times}$557${\mu}m^2$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.8
• /
• pp.1877-1886
• /
• 2010

In this paper, we design a redundancy control circuit for 1T-SRAM repair using electrical fuse programming. We propose a dual port eFuse cell to provide high program power to the eFuse and to reduce the read current of the cell by using an external program supply voltage when the supply power is low. The proposed dual port eFuse cell is designed to store its programmed datum into a D-latch automatically in the power-on read mode. The layout area of an address comparison circuit which compares a memory repair address with a memory access address is reduced approximately 19% by using dynamic pseudo NMOS logic instead of CMOS logic. Also, the layout size of the designed redundancy control circuit for 1T-SRAM repair using electrical fuse programming with Dongbu HiTek's $0.11{\mu}m$ mixed signal process is $249.02 {\times}225.04{\mu}m^{2}$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.136-139
• /
• 2003

Copper has attractive properties as a multi-level interconnection material due to lower resistivity and higher electromigration resistance as compared with Alumina and its alloy with Copper(0.5%). Among a variety of agents in Copper CMP slurry, $H_2O_2$ has commonly been used as the oxidizer However. $H_2O_2$ is so unstable that it requires stabilization to use as oxidizer Hence, stabilization of $H_2O_2$ is a vital process to get better yield in practical CMP process. In this article the stability of Hydrogen Peroxide as oxidizer of Copper CMP slurry has been investigated. When alumina abrasive was used, $\gamma$-particle Alumina C had a better stability than $\alpha$-particle abrasive. As adding KOH as pH buffering agent, $H_2O_2$ stability in slurry decreased. Urea hydrogen peroxide was used as oxidizer, an enhanced stability was gotten. When $H_3PO_4$ as $H_2O_2$ stabilizer was added, the decrease of $H_2O_2$ concentration in slurry became slower. Even though adding $H_2O_2$ in slurry after bead milling lead to better stability than in advance of bead milling, it had a lower dispersibility.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.1288-1291
• /
• 2004

In this study, physical characteristics of alumina slurry on variation of pH value and the effect of non-ionic surfactants on alumina slurry for copper chemical mechanical planarization (CMP) slurry have been investigated. After pH value of the slurry with alumina abrasive was changed by adding various amount of $HNO^3$ or KOH, the differences of settling rate, particle size, and zeta-potential were estimated. Better settling rates were shown in slurries with alumina abrasive at near pH 1. Higher zeta-potential was shown at around pH 2 in alumina slurry and the point of zero charge (PZC) was measured at about pH $9\sim10$. Non-ionic surfactant was added in the slurry with 5wt% alumina abrasive to get its effect on slurry practically. Abrasive size was smaller increased when amount of surfactant increased in slurry with P-4 as abrasive; on the other side, it was smaller when amount of surfactant decreased with AES-12. Variation of zeta-potential has no tendency with adding surfactant; however, values of zeta-potential were between $35\sim50mV$. The proper amount of surfactant was $0.1\sim1.0wt%$ in slurry with P-4 and $0.5\sim1.0wt%$ in slurry with AES-12 respectively. Excellent dispersion stabilization was obtained by addition of non-ionic surfactant

• Journal of the Korean Society of Urban Environment
• /
• v.18 no.4
• /
• pp.495-502
• /
• 2018

In this study, the AERMOD air diffusing model was used to estimate the range of influence of Hazardous chemicals (hydrogen fluoride) in case of small accidents in Jeju area. The impact scope were in the order of Seogwipo Fire Station, Dongbu Fire Station, Jeju Fire Station, and Seobu Fire Station. Seasonal orders were summer, spring, autumn and winter. The correlation between the meteorological factors shows a strong positive correlation with the wind speed of 0.998 and has a negative correlation with the temperature of -0.463. Through the linear regression analysis, we could estimate the equation of Impact scope = 13.922WS (Wind Speed) - 5.195 and the reliability ($R^2$) was as high as 0.995.

• Journal of Soil and Groundwater Environment
• /
• v.18 no.5
• /
• pp.65-76
• /
• 2013

The water-table fluctuation (WTF) method has been often used for estimating groundwater recharge by analysis of waterlevel measurements in observation wells. An important assumption inherent in the method is that the water level rise is solely caused by precipitation recharge. For the observation wells located near a stream, however, the water-level can be highly affected by the stream level fluctuations as well as precipitation recharge. Therefore, in applying the WTF method, there should be consideration regarding the effect of stream-aquifer interactions. Analysis of water-level hydrographs from the National Groundwater Monitoring Wells of Korea showed that they could be classified into three different types depending on their responses to either precipitation recharge or stream level fluctuations. A simple groundwater flow model was used to analyze the errors of the WTF method, which were associated with stream-aquifer interactions. Not surprisingly, the model showed that the WTF method could greatly overestimate recharge, when it was used for the observation wells of which the water-level was affected by streams. Therefore, in Korea, where most groundwater hydrographs are acquired from wells nearby a stream, more caution is demanded in applying the WTF method.

• Journal of the Korean Geotechnical Society
• /
• v.25 no.9
• /
• pp.101-106
• /
• 2009

In this study we analyzed the seepage characteristics of meandering section of rivers commonly seen in domestic terrain. The seepage analysis is designed to be more realistic by considering a tangent and meandering section of levee. The levee was idealized to reflect the relevant characteristics by considering the curved angle of 90 degrees and 130 degrees in the spatial frequencies, water elevation conditions, and hydraulic conductivities. Seepage analysis becomes more detailed and precise with the seepage curve shape which is interpreted to indicate the flow of three-dimensional numerical analysis program using VisualFEA. As a result of the analysis, it is shown that the water level in the straight levee was constant, regardless of hydraulic conductivities, and the total head in the meandering section was increased by the overlapping of seepage. Consequently, it is found that the total head was increased more significantly in the case of 90 degrees curved levees than 130 degrees, and the total head showed similar characteristics In the straight levee.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.10
• /
• pp.69-76
• /
• 2006

A reliability-groundwater flow analysis is performed and the influence of flow parameters on the probability of exceeding the threshold value is examined. For this study, the 3-D numerical groundwater flow program, DGU-FLOW, is developed by extending the 2-D flow program and is coupled to the first and second order reliability program. The 3-D flow program is verified by solving the examples of groundwater flow through the underground excavation and comparing the results from commercial MODFLOW program. Reliability routine of the program is also verified by comparing the probability of failure with that of Monte-Carlo Simulation. The reliability analysis of the groundwater flow showed that the probability of failure from the first and second order reliability method are quite close to that of Monte-Carlo Simulation. from the parametric study of hydraulic conductivity of soil layers, the increase of both mean and variance of hydraulic conductivity results in the increase of probability of exceeding the threshold flow quantity. The probability of failure was more sensitive to constant head located at the end of the flow domain than the other parameters.

• Plant Breeding and Biotechnology
• /
• v.1 no.1
• /
• pp.1-8
• /
• 2013

Low-temperature stress is an important factor controlling the growth and development of rice (Oryza sativa L.) in temperate region. In this study, a molecular linkage map consisting of 136 SSR markers was employed to identify QTL associated with cold tolerance at the seedling stage. 80 recombinant inbred lines (RILs) from an intersubspecific cross between Milyang23 (O. sativa ssp. Indica) and Hapcheonaengmi3, a japonica weedy rice and the parents were evaluated for leaf discoloration and SAPD value of seedlings. Rice plants were grown for 15 days in the low-temperature condition (13/20℃ day/night) and the control condition (25/20℃ day/night) in the growth chamber. The degree of leaf discoloration showed a highly significant correlation with the SPAD value in the low-temperature plot (r = -0.708, P < 0.0001). A total of four QTLs for SPAD were identified and the phenotypic variance explained by each QTL ranged from 5.4 to 16.0%. Two QTLs detected in the control condition were located on chromosomes 2 and 5, respectively. Two QTL on chromosomes 1 and 4 were detected at the low-temperature condition and Hapcheonaengmi3 alleles increased the SPAD values at these loci. Substitution mapping was conducted to delimit the position of qSPA-4 using introgression lines derived from the same cross. Results indicated that qSPA-4 was located in a 810-Kb region flanked by RM16333 and RM16368. The results indicated that Hapcheonaengmi3 contains QTL alleles that are likely to improve cold tolerance of Indica rice.