• 대한전자공학회논문지
• /
• 제27권6호
• /
• pp.843-850
• /
• 1990

A numerical method is presented for determining the static charge distribution and the capacitance of a round disk capacitor. In the employed numerical scheme annular patch subdomains are introduced to reduce the matrix size and to mprove the accuracy of the numerical calculations. The method of moments is utilized to calculate the charge distribution, and the capacitance and equipotential lines are also found from the numerically computed charge distributions. To show the validity of the results the proposed method is applied to the round disk and the dielectric filled capacitor.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.183-184
• /
• 2008

In this paper, the THD(Total Harmonic Distortion) in distribution systems according to the ratio of non-linear loads was calculated and analyzed. The PCC(Point of Common Coupling) is selected to analyze THD of a 3-phase current and a neutral current.

• 한국안전학회지
• /
• 제4권1호
• /
• pp.83-90
• /
• 1989

Recently, due to the increase of 220V distribution lines and equipments preventive measures to cope with several kinds of electric accidents is revealed as an urgent problem. This study investigates the following matters; the cause and present condition of e1ectric shock accident, the influence of electric shock on human body, the safety limit of electric shock, the method of distribution voltage, the insulation of electrical load apparatus, the teachnics of electric shock prevention and foreign materials concerned with this subject etc. This paper present the fundamental cause of electric shock and syntbetic preventive counter measure of electric shock, too.

• 한국초전도ㆍ저온공학회논문지
• /
• 제4권1호
• /
• pp.89-93
• /
• 2002

We investigated the resistance distribution n 4"diameter SFCLS. $YBa_2CU_3O_7$ films coated in-situ with a gold layer were patterned into 3 mm wide 142 cm long meander lines by Photolithography. The limiters were tested with simulated fault currents. The resistance was uniform all over the film except at the edge. At lower source voltages, CFCLs did not quench simultaneously and the resistance distribution was less uniform. Compared with 2" diameter SFCLS 4" SFCLS had similar values and time dependence of resistivity at similar electric fields The resistance distribution was more uniform in 4" SFCLS. The area at the edge where the distribution was not uniform was around 3 mm wide in SFCLs of both sizes. The experimental results were quantitatively explained with a heat transfer concept.

• 조명전기설비학회논문지
• /
• 제26권7호
• /
• pp.77-83
• /
• 2012

Since power system is switching to smart grid, on-line monitoring technology has become necessary for underground distribution power cable. Therefore, the application of DTS(Distributed Temperature Sensing) technology using OFCPC(Optical Fiber Composite Power Cable) capable of monitoring underground distribution power cables has been developed. These can bring about reductions in faults and increases in operating capacity of underground distribution system. To date, the test-bed of optical fiber composite power cable on-line monitoring system has been constructed. Then, matters to be improved have been drawn through verification experiments. This paper presents the improvement and experiment results of the optical fiber composite power cable on-line monitoring system to apply to underground distribution lines in the field.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 A
• /
• pp.360-362
• /
• 2003

In operation of distribution system, DGs(Distributed Generations) are installed as an alternative of extension and establishment of substations, transmission and distribution lines according to increasing power demand. Optimal capacity and allocation of DGs improve power quality and reliability. This paper proposes a method for determining the optimal number, size and allocation of DGs needed to minimize operation cost of distribution system. Capacity of DGs for economic operation of distribution system can be estimated by the load growth and line capacity during operation planning duration. DG allocations are determined to minimize total cost with failure rate and annual reliability cost of each load point using GA(Genetic Algorithm).

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부A
• /
• pp.323-325
• /
• 1998

Distribution planning needs data of present loads, forecasted loads, sub-stations and distribution lines. Besides it needs a computer program for optimal analysis. In Kepco, The CADPAD system had been used for local distribution planning since 1989. Recently, we upgraded the I/O modules so easy to operate. And they can display optimal feeder planning on a real map. This paper is a case study of the West Inchun distribution planning using the CADPAD system. In this paper, not only optimal feeder designs and sub-station plannings, but also comparison and evaluation of various planning cases are suggested from the viewpoint of voltage drop and line losses.

• 천문학회보
• /
• 제39권1호
• /
• pp.63.2-63.2
• /
• 2014

As a part of the "Dust, Ice, and Gas In Time" (DIGIT) key program on Herschel, we observed GSS30-IRS1, a Class I protostar located in Ophiuchus (d =125 pc), with Herschel/Photodetector Array Camera and Spectrometer (PACS). More than 70 lines were detected within a wavelength range from 50 ${\mu}m$ to 200 ${\mu}m$: CO lines from J = 14-13 to 41-40, several $H_2O$ lines of Eup = 100 K to 1500 K, 16 transitions of OH rotational lines, and two atomic [O I] lines at 63 and 145 ${\mu}m$. The [C II] line, known as a tracer of externally heated gas by the interstellar radiation field, is also detected at 158 ${\mu}m$. All lines, except [O I] and [C II], are detected only at the central spaxel of $9^{\prime\prime}.4{\times}9^{\prime\prime}.4$. The [O I] emission is extended along a NE-SW orientation, which is consistent with the known outflow direction, while the [C II] line is detected over all spaxels. One possible explanation of the detection of the [C II] line and no correlation of its spatial distribution with any other molecular emission is the existence of the enhanced ISRF nearby GSS30-IRS1. One interesting feature of GSS30-IRS1 is that the continuum emission is extended beyond the point-spread function (PSF), unlike the molecular line emission, indicative of significant external heating. The best-fit continuum model of GSS30-IRS1 with the physical structure including flared disk, envelope, and outflow shows that the internal luminosity is 11 $L_{\odot}$, and the region is also externally heated by a radiation field enhanced by a factor of 25 compared to the local standard interstellar field.

• 한국정보과학회논문지:소프트웨어및응용
• /
• 제26권11호
• /
• pp.1342-1349
• /
• 1999

본 논문에서는 문서 내의 인접한 두 행 사이에는 일정한 두께의 공백 행이 존재하며 그 공백 행의 기울기는 실제 문서의 기울어진 정도를 반영한다는 사실에 기반하여, 선형적으로 기울어진 문서 영상의 기울기 추정을 위한 고속의 알고리즘을 제안한다. 먼저, 간단한 모폴로지 연산(dilation)을 이용하여 문자행 영역과 공백행 영역을 분리한 후, 이를 일정 간격으로 수직 샘플링하여 수직선 상에 있는 모든 공백행의 중심점(행간점)을 찾는다. 동일한 공백 행 상에 있는 인접한 두 행간점 간에 기울기를 계산하고, 전체 영상으로부터 이들의 분포를 조사하여 최대 빈도를 가지는 기울기를 입력 문서의 기울기로 추정한다. 실험에서는 제안한 알고리즘을 필기체 및 인쇄체를 포함하는 다양한 형태의 가로쓰기 문서에 적용한 결과를 보인다.Abstract In this paper, we propose a fast algorithm to estimate the skew angle of linearly skewed document images. This paper is based on the fact that there is a blank line with uniform thickness between two adjacent text lines and the slope of the line is the same as that of the document. Firstly, we apply a dilation operation to the image to separate blank lines from text lines, and we detect center points of blank lines along the vertically sampled lines. Then we calculate the slope between neighboring center points in the same blank line. Calculated slopes for the entire image are accumulated on the histogram to display the distribution of them. Finally, the peak in the histogram is detected and estimated as the slope of the document image. In the experiments, we adopted a lot of images of various format with hand-printed or machine-printed document to verify our algorithm.

• 조명전기설비학회논문지
• /
• 제27권7호
• /
• pp.37-44
• /
• 2013

Phase to ground faults are possibly one of the maximum number of faults in power distribution system. During a ground fault the maximum fault current and neutral to ground voltage will appear at the pole nearest to the fault. Distribution lines are consisted of three phase conductors, an overhead ground wire and a multigrounded neutral line. In this paper phase to neutral faults were staged at the specified concrete pole along the distribution line and measured the ground fault current distribution in the ground fault current, three poles nearest to the fault point, overhead ground wire and neutral line. A simplified equivalent circuit model for the distribution system under case study calculated by using MATLAB gives results very close to the ground fault current distribution yielded by field tests.